• 한국자동차공학회논문집
• /
• 제19권5호
• /
• pp.58-66
• /
• 2011

A 2-loop waste heat recovery system with Rankine steam cycles for the improvement of fuel efficiency of gasoline vehicles has been investigated. A high temperature loop(HT loop) is a system to recover the waste heat from the exhaust gas, a low temperature loop(LT loop) is for heat recovery from the engine coolant cold relatively. This paper has dealt with a layout of a LT loop system, the review of the working fluids, and the design of the cycle. The design point and the target heat recovery of the LT boiler, a core part of a LT loop, has been presented and analytically investigated. Considering the characteristics of the cycle, the basic concept of the LT boiler has been determined as a shell-and tube type counterflow heat exchanger, the performance characteristics for various design parameters were investigated.

• 한국자동차공학회논문집
• /
• 제20권2호
• /
• pp.21-29
• /
• 2012

A dual loop waste heat recovery system with Rankine steam cycles for the improvement of fuel efficiency of gasoline vehicles has been investigated. A high temperature loop (HT loop) only recovers the heat of the exhaust gas. A low temperature loop (LT loop) recovers the residual heat from the HT loop, the coolant heat and the remaining exhaust gas heat. The two separate loops are coupled with a heat exchanger. This paper has dealt with a layout of the dual loop system, the review of the working fluids, and the design of the cycle. The design point and the target heat recovery of the HT boiler, a core part of a HT loop, have been presented. The prototype of the HT boiler was evaluated by experiment. For the performance evaluation of the HT boiler, inlet temperature of the HT boiler working fluid was set equal to the temperature degree of sub-cool of $5^{\circ}C$ at the condensing pressure. The exit condition was the degree of super-heat set at $5^{\circ}C$. The characteristics of the HT boiler such as heat recovery and pressure drops of fluids were evaluated with varying flow rates and inlet temperatures of exhaust gas under various evaporating pressure conditions.

• 항공우주기술
• /
• 제11권1호
• /
• pp.145-157
• /
• 2012

상평면상에서 추력기를 사용하는 자세제어 시스템의 리밋 사이클을 해석하는 새로운 기법이 논문에 의해서 제안되었다. 그러나 이것은 소프트 시뮬레이션상에서 Haloulakos 방식보다 제안 방식이 정확함을 보였지만, 실제 시스템으로 검증하지는 못하였다. 그래서 저자의 제안 방식을 KSLV-I 추력기 자세제어 시스템에 대한 실시간 모의시험으로 검증하고, 리밋 사이클 해석에 대하여 실시간 모의시험 결과와 이론적으로 구한 값을 비교/분석하였다.

• 한국의류학회지
• /
• 제46권4호
• /
• pp.638-656
• /
• 2022

This study aimed to identify characteristics of Generation MZ's consumer purchase decision journey to develop the new fashion CDJ model. The initial stage was affected by habit, online community, social media, aesthetics, circumstantial need, and proxy. In the search and consideration stage, mobile channels were used actively. In the active search and evaluation stage, online media, experiential data, and personal information were employed. In the purchase stage, zoomers took plenty of time in search and evaluation before spending, contrary to millennials who made their purchases more quickly. In the post-purchase experience stage, zoomers actively displayed follow-up behaviors depending on their satisfaction, such as retaining or deleting the app. While, millennials did not turn away from the store or brand, but followed up on their purchases even when they had an unsatisfactory experience. Based on the characteristics of CDJ, iterative cycle CDJ models were developed. Zoomers CDJ model was presented as a search loop that consists of the search and evaluation process, in which information accumulates, and a purchase loop in which the actual purchase occurs. The iterative cycle CDJ model was presented connected to the loyalty loop as the main section, which is accelerated in millennials' CDJ model.

• 에너지공학
• /
• 제21권4호
• /
• pp.402-410
• /
• 2012

본 연구에서는 가솔린 엔진 자동차에서 엔진 폐열 회수를 위한 이중 회로 랭킨 사이클 성능 해석이 수행되었다. 고온(HT)의 엔진 배기가스 열회수를 위해서는 물을 사용하는 스팀사이클이 적용되었고, 엔진 냉각수열과 고온 사이클로부터의 응축열을 활용하는 저온(LT) 사이클은 R-134a를 사용하는 유기랭킨사이클이 적용되었다. 고온 및 저온 열원을 동시에 활용하는 이중 회로 시스템의 특성을 파악하기 위해 에너지 및 엑서지 분석이 수행되었다. 고온 및 저온 사이클에 사용되는 용적형 팽창기의 체적이 차량적용을 위한 시스템 최적화에 매우 중요하며 시스템 최적화를 위해서는 반드시 고려되어야 한다. 목표로 하는 엔진 운전 조건에서 고온(HT) 팽창기와 저온(LT) 팽창기의 체적을 고려하면서 고온(HT) 사이클의 팽창비와 저온(LT) 사이클의 응축온도가 시스템의 성능에 미치는 영향을 파악하였다. 본 연구에서는 이러한 이중 회로 랭킨 사이클 시스템에 의해 목표 엔진 운전조건에서 엔진 폐열로부터 약 21%의 추가 동력을 얻을 수 있는 것으로 예측되었다.

• 설비공학논문집
• /
• 제29권3호
• /
• pp.119-126
• /
• 2017

Recently, ground source heat pump systems are being used in buildings for cooling and heating to reduce greenhouse gas and save energy. However, ground source heat pump systems mainly use the vertical closed-loop geothermal system design rather than the open-loop geothermal system design. This is due to a lack of knowledge and few research feasibility studies. In this research, a dynamic thermal analysis numerical simulation based on a standard house model was conducted for an open-loop geothermal system. Based on heating load analysis results, the life cycle costs of a standard house using an open two-well geothermal system were analyzed and compared with a vertical closed-loop geothermal system, and a diesel boiler. As a result, it was found that using an open two-well geothermal system shows economic return on investment after three years.

• 한국경영과학회지
• /
• 제23권2호
• /
• pp.67-81
• /
• 1998

An Automated Guided Vehicle System (AGVS) with a unidirectional loop guide path is modeled as a discrete-time stationary Markov chain. It is discussed how to estimate the mean response time, the utilization, and the cycle time of AGV for a delivery order. Three common operation strategies for idle vehicles - central zone positioning rule, circulatory loop positioning rule and point of release positioning rule - are analyzed. These different operation strategies are compared with each other based on the performance measures.

• 한국자동차공학회논문집
• /
• 제18권2호
• /
• pp.122-128
• /
• 2010

To meet the NOx limit without a penalty of fuel consumption, urea-SCR system is currently regarded as promising NOx reduction technology for diesel engines. SCR system has to achieve maximal NOx conversion in combination with minimal $NH_3$ slip. In this study, the performance characteristics of urea-SCR system with open loop control were assessed in the European Transient Cycle(ETC) for heavy duty diesel engine. The SCR inlet temperaure varied in the range of 200 to $340^{\circ}C$ in the ETC cycle. Open loop control calculated the urea flow rate based on the NOx and NSR map which gave for each combination of SCR inlet temperature and space velocity the normalized $NH_3$ to NOx stoichiometric ratio which resulted in a steady-state $NH_3$ slip of 20ppm. During the ETC cycle, the open loop control with the optimized NSR offset achieved NOx reduction of 80% while keeping the average $NH_3$ slip below 10ppm and maximum 20ppm. It was also found that NOx sensor was cross-sensitive to $NH_3$ and a control strategy for cross-sensitivity compensation was required in order to use a NOx sensor as feedback device.

• Nuclear Engineering and Technology
• /
• 제29권4호
• /
• pp.299-309
• /
• 1997

The neutronic feasibility of typical Korean three-loop 900MWe class PWR core loaded with mixed oxide fuels for both annual and 18-month cycle strategies has been investigated as a means for spent fuel management. For this study, a method of determining equivalent plutonium content was developed under the equivalence concept which gives the same cycle length as uranium fuel. Optimal plutonium zoning within the MOX assembly was also designed with the aim of minimizing the peak md power. Conceptual core designs hate hen developed for equilibrium cycle with the following variations: annual and 18-month cycle, 1/3 and full MOX loading schemes, and typical and high moderation lattice. The analysis of key core physics parameters shows that in all cases considered satisfactory core designs seem to be feasible, though addition of control rod system and change in Technical Specification for soluble boron concentration are required for full MOX loading in order to meet the current design requirements.

• 한국수소및신에너지학회논문집
• /
• 제28권3호
• /
• pp.295-299
• /
• 2017

In this study, computer simulation and optimization works have been performed for an open-loop Rankine cycle to generate power using five cases of liquefied natural gas compositions. PRO/II with PROVISION V9.4 from Schneider electric company was used, and the Soave-Redlich-Kwong equation of the state model was utilized for the design of the power generation cycle. It was concluded that more power was obtained from less molecular weight liquefied natural gas since there was more volumetric flow rate with less molecular weight.