• New & Renewable Energy
• /
• v.9 no.4
• /
• pp.40-50
• /
• 2013

This study was performed to investigate the potential of torrefied tulip tree (TT) for the production of pellets. For this purpose, chemical composition and fuel characteristics of torrefied TT were examined. In addition, pellets were fabricated by using sawdust of torrefied TT chip, and durability of the pellet was measured. Lignin content of torrefied TT was higher than that of non-torrefied TT, and increased with the increases of torrefaction temperature and time. Fuel characteristics of torrefied TT were affected by torrefied conditions, and the characteristics were influenced more by torrefaction temperature than by torrefaction time. Higher heating value (HHV) and ash content (AC) of torrefied tulip tree increased with increasing torrefaction temperature, and the values were much higher than HHV and AC values of non-torrefied TT. Durability of pellets fabricated with $230^{\circ}C$- and $250^{\circ}C$-torrefied TT was higher than that of $270^{\circ}C$-torrefied TT, and the value exceeded the minimum requirement (-97.50%) of the 1st-grade pellet standard designated by Korea Forest Research Institute. Based on the results, torrefaction treatment of $250^{\circ}C/50min$ to TT might be a optimal condition for the production of TT pellets considering the mass balance and fuel characteristics of TT as well as the durability of the pellets. Thus, it is confirmed that torrefied TT can be used as a raw material for the production of bio-pellets.

• Plant Journal
• /
• v.12 no.3
• /
• pp.39-45
• /
• 2016

Each of fuel consumption per hour was measured at the 320 MW and 380 MW generator output while changing mixing ratio of bio fuel oil to 50%, 80% and 100%. Fuel consumption per hour was increased from 11.0% to 20.4% as mixing ratio of bio fuel oil was changed from 50% to 100% at the 320 MW generator output comparing with fuel consumption per hour in case of bunker-C oil single firing. Fuel consumption per hour was also increased from 12.0% to 21.1% as mixing ratio of bio fuel oil was changed from 50% to 100% at the generator output 380 MW. Furthermore, it was confirmed that plant efficiency was decreased as mixing ratio of bio fuel oil was increased from 50% to 100% as a result that plant efficiency was calculated using the measured fuel consumption per hour, the generator output and the gross heating value.

• New & Renewable Energy
• /
• v.9 no.1
• /
• pp.33-43
• /
• 2013

The objective of this paper is to provide a review on the latest development on the main initiative and approaches for the sustainability criteria for biofuels. A large number of national and international initiative lately experienced rapid development in the review of the biofuels targets announced in the European Union (EU), United States (US) and other countries worldwide. The global biofuel targets are likely to have a strong impact on land use and agricultural markets. Although biofuels production provides new options for using agricultural crops, there are environmental, social and economic concerns associated with biofuel production. The diversity of feedstock, large number of biofuels pathway an their complexity lead to a high uncertainty over the greenhouse gas (GHG) performances of biofuels, in terms of GHG emission reductions compared to the fossil fuels, expecially if land use change is involved. This paper describes an overview of current status of ongoing certification initiative in Europe and worldwide for biofuels sustainability. It also provides mandatory requirements as part of an sustainability scheme in EU, United Kingdom, US and international approaches and should be reviewed to introduce based on global trends in Korea.

• Transactions of the Korean hydrogen and new energy society
• /
• v.27 no.4
• /
• pp.447-461
• /
• 2016

Recently, the Renewable Fuel Standard(RFS) has been commenced from July 31, 2015 in the New and Renewable Energy Act for expanding the supply of renewable energy and reduction of national GHG target in Korea. The biodiesel is only a means of implementation for the RFS, therefore the biodiesel supply expansion is important for fulfilling the RFS obligation policy. The major key points of the biodiesl supply are expanding domestic feedstocks due to the over 60% dependence on foreign feedstock and reducing the price of feedstock because of the over 70% occupation of feed stock price in the biodiesl production cost. Therefore, we estimated actual amount of potential feedstocks which are possible to use for biodiesl production in Korea and investigated technical and political improvements for expanding biodiesl. For estimating a potential feedstocks, first selected the potential biodiesl feedstocks by investigating the status of global biodiesl feedstocks and then analyzed the possible potential amount of each feedstock by surveying the generation situations, the distribution structures and the technical level.

• Journal of the Korean Wood Science and Technology
• /
• v.46 no.5
• /
• pp.577-596
• /
• 2018

ASEAN countries consist of vast coastal areas and thousands of islands that are vulnerable to the effects of climate change on sea level rise. It is believed that this will play an important role in reducing greenhouse gas emissions globally in order to minimize the damage suffered by ASEAN countries. To overcome this issue, biofuels have been used to minimize the impact on the environment by replacing fossil fuels and to reduce greenhouse gas emissions. In those cases of United States, Brazil and Europe, where biofuels are highly utilized, research, development and investment in this field have been actively conducted in the past. In ASEAN countries, however, it has not been a long time since the biofuel policies were established. To overcome this problem, we investigated the renewable fuel policy in the United States, Brazil and the European Union. Based on this, we suggested the utilization plan and prospect of biofuel policy in ASEAN countries.

• 한국신재생에너지학회:학술대회논문집
• /
• 2011.05a
• /
• pp.185.2-185.2
• /
• 2011

1900년대 이후 산업발전에 따른 인구의 도시 집중화로 인한 하수량 증가에 따라 하수슬러지 발생량이 점차 증가하게 되면서 하수슬러지 처리에 관한 문제 등이 제기되기 시작하였다. 국내의 경우 2003년 하수슬러지의 매립이 금지된 후, 발생슬러지 대부분을 해양투기 등을 통해 처리하여왔다. 2009년 기준으로 국내에서 발생되는 하수슬러지량과 처리 분포를 살펴보면 전국 433개소 하수처리장에서 1일 평균 8,295톤(3,028천톤/년)이 발생되고 있으며, 이 중 47%가 해양투기 되고 있는 실정이다. 그러나 해양투기마저도 런던협약'96의정서 가입으로 2012년부터 금지됨에 따라 국내에서는 슬러지처리 및 재활용 방안과 관련한 연구개발이 활발히 진행되고 있는 중이다. 하수슬러지 처리 및 재활용기술의 경우 다양한 공법 등이 개발 중에 있으나 설비의 불안정 및 높은 투자비 등으로 인해 아직까지 상용화 된 설비 등은 많지 않은 실정이다. 이에 따라 본 연구에서는 POSCO 건설에서 개발한 슬러지 연료화 기술을 통해 생산된 슬러지 탄을 석탄 화력발전소 등에 석탄 보조연료로 활용할 수 있는 방안을 강구하여 상용화 가능한 혼소 기술을 개발하고자 하였다. 슬러지탄(발열량 3.000kcal 이상)을 석탄 화력발전소 보일러에 일정 비율로 혼소하여 슬러지탄의 품질평가, 중금속 용출시험 및 함량분석, 잔재물의 중금속 용출시험 등을 실시하였으며, 그 결과 모든 시험항목에서 연료화 관련 법적기준을 만족하는 것으로 나타났다. 슬러지탄을 화력발전소에 혼소하여 사용할 경우, 2012년부터 시행예정인 RPS(Renewable Portfolio Standard)법 대응 및 석탄사용량 저감 등을 통한 $CO_2$ 저감으로 저탄소 녹색성장의 자원순환사회를 구축하는 데 이바지 할 것으로 판단된다.

• Journal of the Korean Solar Energy Society
• /
• v.32 no.3
• /
• pp.153-161
• /
• 2012

This study conducted a survey and field investigation on the application of the Public Obligation System for new & renewable energy in public buildings, as well as energy consumption of each building according to their uses. The findings are as follows: (1) Since the introduction of the Public Obligation System (until June 30, 2011), there was average 1.4 new & renewable energy facilities established at 1,433 places. Preference for solar energy facilities was the highest at 57.8%. (2) The revised act sets the obligatory supply percentage of new & renewable energy for each public building: it is 9.0% for a tax office, 4.2% for a dong office, 8.2% for a public health center, and 12.6% for a fire station. All the public buildings except for fire stations failed to meet 10% expected energy consumption, a revised standard. (3) Energy consumption of each public building was 120.6TOE for a tax office, 124.3TOE for a dong office, 166.4TOE for a public health center, and 174.6TOE for a fire station. The energy consumption was comprised of 80% electric power, 18% urban gas, and 1% oil. (4) Electric power consumption per person in the room was high at a dong office, and fuel consumption per person in the room was high at a public health center. In addition, electric power consumption per unit space was high at a public health center, and fuel consumption per unit space was high at a fire station. (5) In all the four public buildings, power load had the highest basic unit percentage at average 55%, being followed by heating load (21.2%), cooling load (15%), and water heating load (7%). A tax office and fire station had 2% load due to cooking facilities.

• Current Photovoltaic Research
• /
• v.2 no.4
• /
• pp.182-188
• /
• 2014

For the dissemination of new and renewable energy, Korean government introduced a renewable portfolio standard (RPS) scheme in 2012 after terminating feed-in tariff (FIT) scheme that was introduced in 2004. With the RPS scheme, 64.7% of its own goal (95.7% in PV and 63.3% in non-PV) was achieved in 2012 and 67.2% of that (94.9% in PV, 65% in non-PV) was achieved in 2013. The deployment of PV systems met the goal very well and that of non-PV did not. Recently, Korean government revised the target year of supplying 10% electricity from new and renewable energy from 2022 to 2024 and released a couple of measures on PV area. Recent studies showed that the bankability of a project plays a key role for PV dissemination. Therefore, the dissemination should be assessed from the point of bankability under the RPS scheme and a little adjustment is necessary to achieve the goal. Especially, installing a small size PV (<100 kwp) system needs a minimum REC price or a FIT scheme. In non-PV area, permission process is a common bottleneck and the related regulation should be eased. In addition, to achieve the long term goal, an implementing scenario has to be prepared. Currently, the portion of the waste-gas energy originated from fossil fuel is too large among the new and renewable energy sources and the portion should be lowered or eliminated in the 10% of electricity supply goal. Seoul Metropolitan Government (SMG) has its own FIT scheme for PV dissemination from 2014 SMG and revised the PV tariff from 50 to 100 won/kwh in effective of 2015. It is worth to spread the other provinces.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.11a
• /
• pp.82.1-82.1
• /
• 2010

Recently, Molten carbonate fuel cells(MCFCs) have been developing to get a good durability and economic feasibility for commercialization. To achieve these objectives, the cost of nickel based electrodes should be reduced. Regular anode thickness used in MCFCs is normally 0.7mm. Thus, in our study, the purpose was to reduce anode thickness up to 0.3 mm keeping MCFC performance on standard levels. In-situ sintering has been used, with 2 different fabrication methods (method A and B) and 2 different supports (support 1 and 2). Voltage losses at different temperature (600,620,640,$650^{\circ}C$) and after 1000 hours showed the higher performance that can be obtained using method B and support 2. After single cell test, an open-circuit voltage(OCV) of 1.075 V and a closed-circuit voltage(CCV) of 0.829V were obtained, at current density of $150mV/cm^2$. Also the voltage loss ratio at different cell temperature was lower in the case of method B and support 2. According to these results, the cost of anode fabrication can be reduced in the future, contributing for the economical feasibility of MCFCs.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.06a
• /
• pp.341-344
• /
• 2009

In this paper, protective function evaluation was conducted to determine the performance and safety of a power conditioning system(PCS) for 1kW residential fuel cell system. It is essential to have a power quality, grid-connection and safety of PCS. Even though it is under 500ms by KGS-A410 standard, it is shown a rapid response time of 25ms from input under-voltage test. In terms of output over/under-voltage test, it is shown 29.15 and 79.4ms. Especially using anti-islanding test, it is shown all times under 100ms for combination cases of real and reactive power. We confirmed a rapid response characteristics and safety of PCS. The results of this evaluation are being used to develop a new test protocols of PCS.