• Geomechanics and Engineering
• /
• v.17 no.2
• /
• pp.145-156
• /
• 2019

Since behaviors of loose, dense, silty sands vary under seismic loading, understanding the liquefaction mechanism of sandy soils continues to be an important challenges of geotechnical earthquake engineering. In this study, 36 deformation controlled cyclic simple shear tests were performed and the liquefaction potential of the sands was investigated using three different relative densities (40, 55, 70%), four different effective stresses (25, 50, 100, 150 kPa) and three different shear strain amplitudes (2, 3.5, 5%) by using energy based approach. Experiments revealed the relationship between per unit volume dissipated energy with effective stress, relative density and shear strain. The dissipate energy per unit volume was much less affected by shear strain than effective stress and relative density. In other words, the dissipated energy is strongly dependent on relative density and effective stress. These results show that the dissipated energy per unit volume is very useful and may contain the non-uniform loading conditions of the earthquake spectrum. When multiple regression analysis is performed on experiment results, a relationship is proposed that gives liquefaction energy of sandy soils depending on relative density and effective stress parameters.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.11
• /
• pp.3291-3296
• /
• 2010

A gelastatins (1), natural MMP inhibitors, and their hydroxamate analogues (2) in TACE enzyme evaluated for discovery of potent TACE inhibitors. We have employed molecular dynamics simulations to compute the relative free energy of hydration and binding to TACE for gelastatin (1) and its hydroxamate analogue (2). The relative free energy difference is directly described in this article using the free energy perturbation approach as a means to accurately predict the TACE inhibitor of gelastatin analogues. The results show that the good agreement between the experimental and theoretical relative free energies of binding, gelastatin hydroxamate (2) binds stronger to TACE by -3.37 kcal/mol. The desolvation energy costs significantly reduced binding affinity, hydroxamate group associated with high desolvation energy formed strong favorable interactions with TACE with more than compensated for the solvation costs and therefore led to an improvement in relative binding affinity.

• KIEAE Journal
• /
• v.12 no.4
• /
• pp.21-30
• /
• 2012

This study aims to set up Energy self-sufficiency urban planning system responding climate change by reducing fossil energy consumption and carbon emission, and to suggest effective application method. This study has 3 levels. First, it defines energy self-sufficient city responding climate change theoretically. Second, it set up planning system of Energy Self-sufficient city responding climate change. Third, ANP method was applied to introduce priority of application according to relative importance of planning section. As ANP method has to construct network to show interrelation among elements, 1st questionnaire survey was carried out to figure out interrelation. 2nd questionnaire survey introduced to judge relative importance of planning aspects and sections. In conclusion, this study shows interrelation among planning sections. By considering the relative importance, Energy environment and Energy consumption was derived as important planning aspects, and Architecture, Landuse, and Production of renewable energy was estimated as s important planning elements.

• Asian-Australasian Journal of Animal Sciences
• /
• v.3 no.3
• /
• pp.231-242
• /
• 1990

A study is reported which investigated the additive nature of digestible energy (DE) from dietary nutrients and to estimate the relative energy values of different energy-yielding nutrients in practical trout diets. A growth study was conducted over 12 weeks with 6 diets. Rainbow trout (Oncorhynchus mykiss) were fed diets once a day ad libitum. Digestible energy values determined and calculated had direct relationship indicating additive nature of such values for feed ingredients. Overall growth performance was best in a diet containing 33% digestible protein (DP) with a DP/DE ratio of 18.6. A reduction in digestible protein level with the same DP/DE rat io led to a significant decrease in growth and feed efficiency. The increase of 7% of lipid with concomitant decrease in protein resulted in the relative gain of 130% in growth and nutrient retention, suggesting that 1 g of lipid is equal to about 1.3 g of proteins in terms of net energetic value. Replacement of 10% of dietary lipid by carbohydrates led to a slight decrease in energy retention efficiency but to a great increase in lipid retention efficiency (130%) showing that dietary carbohydrates led to increased lipogenesis.

• Journal of Biosystems Engineering
• /
• v.30 no.2 s.109
• /
• pp.110-113
• /
• 2005

Relative humidity of air In the greenhouse has to be maintained at 70 to 80 percents to provide a better growth condition of crops. To control relative humidity of air in the greenhouse, a dehumidifier functioning by refrigeration cycle was designed and manufactured in this study. And, results of its performance test in the greenhouse site were reported. The developed dehumidifier has separated condenser and evaporator in the heat exchanger part in order to increase dehumidifying capacity at a low temperature condition. When the conditions of incoming air into the dehumidifier were temperature of $15\~25^{\circ}C$ and relative humidity of $0\~95\%$, quantity of condensed water per hour, ie, dehumidification rate was $4.7\~7.0\;kg/hr$. Relative humidity difference was not greater than 5 percents at various locations in the greenhouse due to proper distributing of dehumidified air through vinyl duct. Thermal energy output from the developed dehumidifier was about 8,5000 kcal/hr that was 7 percents of maximum greenhouse heating load of 10 a.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2001.05a
• /
• pp.947-952
• /
• 2001

The prediction model is proposed to estimate the variation of compressive strength of fly ash concrete with aging. After analyzing the experimental result with the model, the regression results are presented according to fly ash replacement content and water/cement ratio. Based on the regression results, the influence of fly ash replacement content and water/cement ratio on apparent activation energy was investigated. According to the analysis, the model provides a good estimate of compressive strength development of fly ash concrete with aging. As the fly ash replacement content increases, the limiting relative compressive strength and initial apparent activation energy become greater. The concrete with water/cement ratio smaller than 0.40 shows that the limiting relative compressive strength and apparent activation energy are nearly constant according to water/cement ratio. But, the concrete with water/cement ratio greater than 0.40 has the increasing limiting relative compressive strength and apparent activation energy with increasing water/cement ratio.

• The Korean Journal of Ecology
• /
• v.15 no.4
• /
• pp.345-354
• /
• 1992

Allocation patterns of energy and mineral elements were investigated with phaseolus multiflorus grown in the environmental gradients. The result showed different energy allocation patterns according to relative light intensities and nutrients. The optimal switching time of energy allocation from vegetative to resproductive growth was delated as decreasing relative light intensity. The switch of the shift to reproduction was timed earlier in phosphorus treatment and delayed in nitrogen treatment. Analyzing the mineral elements to various organs, patterns of energy allocation were different from those of mineral allocation. There was no significant difference for allocation patterns in relative light intensity gradients. it was shown that n and p were distributed over the reproductive organs, k mainly in stems, ca in leaves and na in roots. mg was evenly distributed in each organs.

• Nuclear Engineering and Technology
• /
• v.7 no.3
• /
• pp.223-226
• /
• 1975

The relative detection efficiency of ${\gamma}$-ray full-energy Peaks was obtained by a pair-point method using the $^{56}$ Co source whose ${\gamma}$-ray relative emission rates were well measured. Three Ge(Li) detectors with active volumes of 43.8cc, 32.6cc, and 6cc were calibrated over the ${\gamma}$-ray energy energy range 800-5, 500keV.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.48 no.6
• /
• pp.59-67
• /
• 2006

Particles of soil are crushed when soil is compacted in the in-situ or lab. Among many factors that affect the crush of particles, compaction energy is a major factor. Because the crush of particles can change physical properties, the analysis of effect of compaction energy is very important. In this study, the fragmentation fractals were used for determining the change in grain size distribution and the effect due to change in grain size distribution was estimated. Compaction energy was increased by 50, 100, 200 and 300% based on the energy of standard A compaction test. As a result, grain size distribution curves were changed and fine particles increased as compaction energy were increased. Relative compaction were ranged between $93.38{\sim}107.67$. Fractal dimension of each site increased as compaction energy increased. Relative compaction is proportional to the fractal dimension but coefficients of permeability were in inverse proportional to the involution of fractal dimension.

• Korean Journal of Food Science and Technology
• /
• v.29 no.1
• /
• pp.65-71
• /
• 1997

The energy supplied by motor of extruder, being known mostly to be dissipated as heat, was classified into two kinds of energy: a thermal energy by heat dissipation and a purely mechanical energy. The thermal energy was defined as a energy in terms of temperature rise and the mechanical energy as the motor energy minus the heat dissipated energy. A method to derive the thermal energy and the relative mechanical energy (the mechanical energy calculated regarding the mechanical energy at the lowest screw speed as zero) under the condition of constant barrel temperature was developed by which an extrusion case was analyzed. When extruding com grits with moisture $(27{\sim}37%)$ at low barrel temperature $({\leq}80^{\circ}C)$, the thermal energy slightly increased with increase in the moisture content, whereas the relative mechanical energy increased to a great extent. When increasing the screw speed, the thermal energy was nearly kept constant, whereas the relative mechanical energy largely varied. It is concluded that as the moisture content increases, the role of the mechanical energy becomes more effective than the heat energy dissipated from the motor energy.