• 전기학회논문지
• /
• 제59권5호
• /
• pp.904-911
• /
• 2010

This paper presents the design of acoustic resonance free and over current limit during transient state consideration electronic ballast for 1.5kW Metal-Halide Lamp(MHL) that employs frequency modulation (FM) technique. The proposed ballast consists of a Full-Bridge(FB) rectifier, a passive power factor correction (PFC) circuit, a full-bridge inverter, an ignitor using LC resonance and a control circuit for frequency modulation. The frequency modulation technique is the most effective solution to eliminate acoustic resonance among other technique. It spreads power spectrum of lamp to reduce the supplied power spectrum under the energy level of eigen-value frequency. Moreover, the proposed ballast is simple and cost effective above conventional ballast. A new PFC circuit is proposed which combines with LCD type and PCSR filter. A new PFC circuit has higher PF and lower THD than conventional LCD type and secure high reliability. Finally, to protected switching components in transient state, the surge current into ballast is limited by increase the switching frequency. Performance of the proposed ballast was validated through computer simulation using Pspice, experimentation and by applying it to an electronic ballast for a prototype 1.5kW MHL.

• The Korean Journal of Physiology and Pharmacology
• /
• 제1권2호
• /
• pp.169-183
• /
• 1997

We have investigated the two types of voltage-dependent outward potassium (K) currents, i.e. delayed rectifier K current ($I_{K(V)}$) and 'A-like' transient outward K current ($I_{to}$) with patch-clamp technique in single smooth muscle cells (SMCs) isolated from rabbit basilar artery, and investigated the characteristics of them. The time-courses of activation were well fitted by exponential function raised to second power ($n^2$) in $I_{K(V)}$ and fourth power ($n^4$) in $I_{to}$. The activation, inactivation and recovery time courses of $I_{to}$ were much faster than that of $I_{K(V)}$. The steady-state activation and inactivation of $I_{K(V)}$ was at the more hyperpolarized range than that of $I_{to}$ contrary to the reports in other vascular SMCs. Tetraethylammonium chloride (TEA; 10 mM) markedly inhibited $I_{K(V)}$ but little affected $I_{to}$. 4-Aminopyridine (4-AP) had similar inhibitory potency on both currents. While a low concentration of $Cd^{2+}$ (0.5 mM) shifted the current- voltage relationship of $I_{to}$ to the positive direction without change of maximum conductance, $Cd^{2+}$ did not cause any appreciable change for $I_{K(V)}$.

• The Korean Journal of Physiology and Pharmacology
• /
• 제5권5호
• /
• pp.413-421
• /
• 2001

An impaired smooth muscle cell (SMC) relaxation of coronary artery by alteration of $K^+$ channels would be the most potential explanation for reduced coronary reserve in left ventricular hypertrophy (LVH), however, this possibility has not been investigated. We performed morphometrical analysis of the coronary artery under electron microscopy and measured $Ca^{2+}-activated\;K\;(K_{Ca})$ currents and delayed rectifier K $(K_{dr})$ currents by whole-cell and inside-out patch-clamp technique in single coronary arterial SMCs from rabbits subjected to isoprenaline-induced cardiac hypertrophy. Coronary arterial SMCs underwent significant changes in ultrastructure. The unitary current amplitude and the open-state probability of $K_{Ca}$ channel were significantly reduced in hypertrophy without open-time and closed-time kinetic. The concentration-response curve of $K_{Ca}$ channel to $Ca^{2+}$ is shifted to the right in hypertrophy. The reduction in the mean single channel current and increase in the open channel noise of $K_{Ca}$ channel by TEA were more sensitive in hypertrophy. $K_{dr}$ current density is significantly reduced in hypertrophy without activation and inactivation kinetics. The sensitivity of $K_{dr}$ current on 4-AP is significantly increased in hypertrophy. This is the first study to report evidence for alterations of $K_{Ca}$ channels and $K_{dr}$ channels in coronary SMCs with LVH. The findings may provide some insight into mechanism of the reduced coronary reserve in LVH.

• Journal of Electrical Engineering and Technology
• /
• 제12권1호
• /
• pp.151-160
• /
• 2017

This paper presents a new technique of reference current generator based on Kalman filter (KF) estimator for three-phase shunt active power filter (APF). The stationary reference frame (d-q algorithm) is used to transform the load currents into DC component. The harmonics of load currents are extracted and the three-phase reference currents are generated using KF estimator. The work is simulated using Matlab/Simulink platform. To validate the simulation results, an experimental test-rig have been perform using real-time control dSPACE DS1104. In addition, hysteresis current control was used to generate the switching signal for the correction of the harmonics in the system. The non-linear load were constructed with three-phase rectifier which connected in series with inductor and parallel with resistor and capacitor. The results shows that the new technique of shunt APF embedded with KF is proven to eliminate the harmonics created by the non-linear load with some improvement on the total harmonics distortion (THD).

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 F
• /
• pp.2653-2655
• /
• 1999

A technique to suppress the low frequency ripple voltage of the DC output voltage in three-phase buck diode rectifiers is presented. A pulse frequency modulation method is employed to regulate the output voltage of the rectifier and guarantee zero-current switching of the switch over the wide operating range. The pulse frequency control method used in this paper shows generally good performance such as low THD of the input line current and unity power factor. In addition, the pulse frequency method can be effectively used to suppress the low frequency voltage ripple appeared in the dc output voltage. The proposed technique illustrates its validity and effectiveness through the respective simulations and experiments.

• Journal of electromagnetic engineering and science
• /
• 제17권4호
• /
• pp.191-196
• /
• 2017

Microwave wireless power transmission (MWPT) is a promising technique for low and medium power applications such as wireless charging for sensor network or for biomedical chips in case with long ranges or in dispersive media such. A key factor of the MWPT technique is its efficiency, which includes the wireless power transmission efficiency and the radio frequency (RF) to direct current (DC) voltage efficiency of RF-DC converter (which transforms RF energy to DC supply voltage). The main problem in designing an RF-DC converter is the nonlinear characteristic of Schottky diodes; this characteristic causes low efficiency, higher harmonics frequency and a change in the input impedance value when the RF input power changes. In this paper, rather than using harmonic termination techniques of class E or class F power amplifiers, which are usually used to improve the efficiency of RF-DC converters, we propose a new method called "optimal input impedance" to enhance the performance of our design. The results of simulations and measurements are presented in this paper along with a discussion of our design concerning its practical applications.

• 전기학회논문지
• /
• 제57권7호
• /
• pp.1187-1194
• /
• 2008

This paper presents a high-power electronic ballast for a metal-hallide lamp(MHL) that employs frequency modulation(FM) technique to eliminate acoustic resonance(AR). The proposed ballast consists of a full-bridge rectifier, a power factor correction(PFC) circuit, a full-bridge(FB) inverter, an ignitor using LC resonance and an FM control circuit. Whereas a manual PFC provides advantages in terms of high reliability and low cost for constructing the circuit, it is difficult to supply a stable voltage because of the output voltage ripple that occurs with a period of 120Hz. Although the ballast can be designed with a small size and a light weight if it is driven at a switching frequency between 1 and 100 kHz, AR will occur if the eigen-value frequency of the lamp coincides with the inverter's operation frequency. The operation frequency was modulated in real time according to the output voltage ripple to compensate for the variation in power supplied to the lamp and eliminate AR. Performance of the proposed technique was validated through numerical analysis, computer simulation using PSPICE and by applying it to an electronic ballast for a prototype 1kW MHL.

• Journal of Power Electronics
• /
• 제14권3호
• /
• pp.413-420
• /
• 2014

The conventional Phase-Shift Full-Bridge (PSFB) converter has a serious voltage spike because of the ringing between the leakage inductance of the transformer and the parasitic output capacitance of the secondary side rectifier switches. To overcome this problem, an asynchronous active clamp technique employing an auxiliary DC/DC converter has been proposed. However, an exact analyses for designing the auxiliary DC/DC converter has not been presented. Therefore, the amount of power that is supposed to be handled in the auxiliary DC/DC converter is calculated through a precise mode analyses in this paper. In addition, this paper proposes a lossy snubber circuit with hysteresis characteristics to reduce the burden that the auxiliary DC/DC converter should take during the starting interval. This technique results in optimizing the size of the magnetic component of the auxiliary DC/DC converter. The operational principles and the theoretical analyses are validated through experiments with a 48V-to-30V/15A prototype.

• The Korean Journal of Physiology and Pharmacology
• /
• 제24권1호
• /
• pp.111-119
• /
• 2020

In vascular smooth muscle, K⁺ channels, such as voltage-gated K⁺ channels (Kv), inward-rectifier K⁺ channels (Kir), and big-conductance Ca²⁺-activated K⁺ channels (BK_Ca), establish a hyperpolarized membrane potential and counterbalance the depolarizing vasoactive stimuli. Additionally, Kir mediates endothelium-dependent hyperpolarization and the active hyperemia response in various vessels, including the coronary artery. Pulmonary arterial hypertension (PAH) induces right ventricular hypertrophy (RVH), thereby elevating the risk of ischemia and right heart failure. Here, using the whole-cell patch-clamp technique, we compared Kv and Kir current densities (I_Kv and I_Kir) in the left (LCSMCs), right (RCSMCs), and septal branches of coronary smooth muscle cells (SCSMCs) from control and monocrotaline (MCT)-induced PAH rats exhibiting RVH. In control rats, (1) I_Kv was larger in RCSMCs than that in SCSMCs and LCSMCs, (2) I_Kv inactivation occurred at more negative voltages in SCSMCs than those in RCSMCs and LCSMCs, (3) I_Kir was smaller in SCSMCs than that in RCSMCs and LCSMCs, and (4) I_BKCa did not differ between branches. Moreover, in PAH rats, I_Kir and I_Kv decreased in SCSMCs, but not in RCSMCs or LCSMCs, and I_BKCa did not change in any of the branches. These results demonstrated that SCSMC-specific decreases in I_Kv and I_Kir occur in an MCT-induced PAH model, thereby offering insights into the potential pathophysiological implications of coronary blood flow regulation in right heart disease. Furthermore, the relatively smaller I_Kir in SCSMCs suggested a less effective vasodilatory response in the septal region to the moderate increase in extracellular K⁺ concentration under increased activity of the myocardium.

• 한국산학기술학회논문지
• /
• 제17권10호
• /
• pp.719-724
• /
• 2016

본 논문에서는 돌입전류로부터 전원변환장치를 보호하고 오동작을 예방하기 위해서 돌입전류 제한회로의 성능 향상방법에 관해 서술하였다. 군용 레이더의 전원변환장치를 운용하던 도중 회로차단기가 간헐적으로 동작하여 장비운용에 불편함이 초래되었다. 돌입전류 제한회로의 출력 전류를 측정해 본 결과 간헐적으로 250A이상 과전류가 발생하여 회로차단기가 동작하였다. 돌입전류 제한회로에 사용된 SCR(Silicon Controlled Rectifier) 분석, 돌입전류 제한회로의 동작원리 분석을 통해 의도치 않게 dv/dt triggering 방식으로 SCR이 도통되면서 과도한 전류가 발생한다는 것을 알 수 있었다, 분석한 원인을 바탕으로 SCR 양단에 급격한 전압 변화가 생기지 않도록 하고, SCR이 gate triggering 이외의 방식으로 도통 되어도 의도한 전류이상으로 돌입전류가 발생하지 않도록 SCR 앞단에 저항이 위치 하도록 회로를 변경하여 순간적인 전압 변화를 방지하였다. 마지막으로 돌입전류 제한회로의 전류 측정을 통해 의도한 전류 이상으로 돌입전류가 발생하지 않음을 입증 하였고, 상위체계에 부착시험을 통해 체계 영향성을 확인 하였으며, 전원변환장치에 적용하여 1년 이상 야전에서 운용결과 회로차단기가 동작하는 경우가 발생하지 않았다.