• Journal of Electrical Engineering and Technology
• /
• v.7 no.3
• /
• pp.429-435
• /
• 2012

In this study, a real-time architecture for the detection of clock jumps in the GPS clock behavior is proposed. GPS satellite atomic clocks have characteristics of a second order polynomial in the long term showing sudden jumps occasionally. As satellite clock anomalies influence on GPS measurements which could deliver wrong position information to users as a result, it is required to develop a real time technique for the detection of the clock anomalies especially on the real-time GPS applications such as aviation. The proposed strategy is based on Teager Energy operator, which can be immediately detect any changes in the satellite clock bias estimated from GPS carrier phase measurements. The verification results under numerous cases in the presence of clock jumps are demonstrated.

• Journal of Advanced Navigation Technology
• /
• v.15 no.6
• /
• pp.953-961
• /
• 2011

IGS (International GNSS Service) predicted orbits contained in IGS ultra-rapid orbits is suitable for real-time or near-real-time precise positioning. In this paper, we analyzed orbit anomalies of the IGS predicted orbits and detected the anomalies NANU (Current Notice Advisories to NAVSTAR Users) messages and IGS BRDC (Broadcast Ephemerides). As a results, the orbit anomalies of the predicted orbits were observed 93 times in 2010. In case of using the NANUs, we could get detection performance of 88% about the IGS predicted orbits's anomalies. And we could achieve 95% detection performance when the NANUs and BRDCs were used together.

• Smart Structures and Systems
• /
• v.29 no.1
• /
• pp.129-140
• /
• 2022

The effectiveness of system identification, damage detection, condition assessment and other structural analyses relies heavily on the accuracy and reliability of the measured data in structural health monitoring (SHM) systems. However, data anomalies often occur in SHM systems, leading to inaccurate and untrustworthy analysis results. Therefore, anomalies in the raw data should be detected and cleansed before further analysis. Previous studies on data anomaly detection mainly focused on just single type of data anomaly for denoising or removing outliers, meanwhile, the existing methods of detecting multiple data anomalies are usually time consuming. For these reasons, recognising multiple anomaly patterns for real-time alarm and analysis in field monitoring remains a challenge. Aiming to achieve an efficient and accurate detection for multi-type data anomalies for field SHM, this study proposes a pattern-recognition-based data anomaly detection method that mainly consists of three steps: the feature extraction from the long time-series data samples, the training of a pattern recognition neural network (PRNN) using the features and finally the detection of data anomalies. The feature extraction step remarkably reduces the time cost of the network training, making the detection process very fast. The performance of the proposed method is verified on the basis of the SHM data of two practical long-span bridges. Results indicate that the proposed method recognises multiple data anomalies with very high accuracy and low calculation cost, demonstrating its applicability in field monitoring.

• Journal of Korea Multimedia Society
• /
• v.24 no.1
• /
• pp.30-39
• /
• 2021

Research in the field of health lighting has continued to advance to reproduce the color temperature of natural light which periodically changes. However, most of this research could only reproduce a uniform circadian color temperature of natural light, therefore failing to realize the characteristics of the circadian cycle of color temperature difference by latitude and longitude. To reproduce the color temperature of natural light on which the characteristics of a region are reflected, the collection technology of real-time characteristics of natural light is needed. If the color temperatures which are not within a periodical pattern due to climate changes, etc., are measured, it will be difficult to judge the occurrence (presence) of the anomalies and to reproduce the circadian cycle of the color temperature of natural light. Therefore, this study proposes an algorithm for judging the anomalies in real time based on the sliding window to reproduce the color temperature of natural light. First, the natural light characteristics DB collected through the on-site measurement were analyzed, the differential values at a one-minute interval were calculated and examined, and then representative color temperature circadian patterns by solar terms were drawn. The anomalies were then detected by the application of the sliding window that calculated the deviation of the color temperature for the measured color temperature data set, which was collected through RGB sensors, while moving along the time sequence. In addition, the presence of anomalies was verified through the comparison study between the detection results and the representative circadian cycle of the color temperature by solar term. The judgment method for the anomalies from the measured color temperature of natural light was proposed for the first time, confirming that the proposed method was capable of detecting the anomalies with an average accuracy of 94.6%.

• The KIPS Transactions:PartC
• /
• v.12C no.1 s.97
• /
• pp.19-28
• /
• 2005

Recently, it has been sharply increased the interests to detect the network traffic anomalies to help protect the computer network from unknown attacks. In this paper, we propose a new anomaly detection scheme using the simple linear regression analysis for the exported LetFlow data, such as bits per second and flows per second, from a border router at a campus network. In order to verify the proposed scheme, we apply it to a real campus network and compare the results with the Holt-Winters seasonal algorithm. In particular, we integrate it into the RRDtooi for detecting the anomalies in real time.

• Journal of the Korea Society of Computer and Information
• /
• v.28 no.4
• /
• pp.13-20
• /
• 2023

In this paper, the actual data of VOC reduction facilities was analyzed through a model that detects and predicts data anomalies. Using the USAD model, which shows stable performance in the field of anomaly detection, anomalies in real-time data are detected and sensors that cause anomalies are searched. In addition, we propose a method of predicting and warning, when abnormalities that time will occur by predicting future outliers with an auto-regressive model. The experiment was conducted with the actual data of the VOC reduction facility, and the anomaly detection test results showed high detection rates with precision, recall, and F1-score of 98.54%, 89.08%, and 93.57%, respectively. As a result, averaging of the precision, recall, and F1-score for 8 sensors of detection rates were 99.64%, 99.37%, and 99.63%. In addition, the Hamming loss obtained to confirm the validity of the detection experiment for each sensor was 0.0058, showing stable performance. And the abnormal prediction test result showed stable performance with an average absolute error of 0.0902.

• Proceedings of the KSRS Conference
• /
• 1998.09a
• /
• pp.236-241
• /
• 1998

The NOAA AVHRR remote sense SST data, collected by the National Fisheries Research and Development Institute (NFRDI), are analyzed in order to understand the spatial and temporal distributions of SST in the seas adjacent to Korea. Our study is based on 10-day SST images during last 7 years (1991-1997). For a time series analysis of multiple 557 images, all of images must be aligned exactly at the same position by adjusting the scales and positions of each SST image. We devised an algorithm which yields automatic detections of cloud pixels from multiple SST images. The cloud detection algorithm is based on a physical constraint that SST anomalies in the ocean do not exceed certain limits (we used $\pm$ 3$^{\circ}C$ as a criterion of SST anomalies). The remote sense SST data are tuned by comparing remote sense data with observed SST at coastal stations. Seasonal variations of SST are studied by harmonic fit of SST normals at each pixel. The SST anomalies are studied by statistical method. We found that the SST anomalies are rather persistent with time scales between 1 and 2 months. Utilizing the persistency of SST anomalies, we devised an algorithm for a prediction of future SST Model fit of SST anomalies to the Markov process model yields that autoregression coefficients of SST anomalies during a time elapse of 10 days are between 0.5 and 0.7. We plan to improve our algorithms of automatic cloud pixel detection and prediction of future SST. Our algorithm is expected to be incorporated to the operational real time service of SST around Korea.

• Korean Journal of Remote Sensing
• /
• v.17 no.2
• /
• pp.183-188
• /
• 2001

The NOAA AVHRR remotely sensed SST data, collected by the National Fisheries Research and Development Institute (NFRDI), are analyzed in order to understand the spatial and temporal distributions of SST in the sea near korea. Our study is based on 10-day SST images during last 7 years (1991-1997). For a time series analysis of multiple SST images, all of images must be consistent exactly at the same position by adjusting the scales and positions of each SST image. We devised an algorithm which automatically detects cloud pixels from multiple SST images. The cloud detection algorithm is based on a physical constraint that SST anomalies in the ocean do not exceed certain limits (we used $\pm$3$^{\circ}C$ as a criterion of SST anomalies). The remotely sensed SST data are tuned by comparing remotely sensed data with observed SST at coastal stations. Seasonal variations of SST are studied by harmonic fit of SST normals at each pixel and the SST anomalies are studied by statistical method. It was found that the SST anomalies are rather persistent for one or two months. Utilizing the persistency of SST anomalies, we devised an algorithm for a prediction of future SST. In the Markov lprocess model of SST anomalies, autoregression coefficients of SST anomalies during a time elapse of 10 days are between 0.5 and 0.7. The developed algorithm with automatic cloud pixel detection and rediction of future SST is expected to be incorporated to the operational real time service of SST around Korea.

• Transactions on Electrical and Electronic Materials
• /
• v.14 no.2
• /
• pp.71-77
• /
• 2013

Advanced semiconductor manufacturing technology requires methods to maximize tool efficiency and improve product quality by reducing process variability. Real-time plasma process monitoring and diagnosis have become crucial for fault detection and classification (FDC) and advanced process control (APC). Additional sensors may increase the accuracy of detection of process anomalies, and optical monitoring methods are non-invasive. In this paper, we propose the use of a chromatic data acquisition system for real-time in-situ plasma process monitoring called the Plasma Eyes Chromatic System (PECS). The proposed system was initially tested in a six-inch research tool, and it was then further evaluated for its potential to detect process anomalies in an eight-inch production tool for etching blanket oxide films. Chromatic representation of the PECS output shows a clear correlation with small changes in process parameters, such as RF power, pressure, and gas flow. We also present how the PECS may be adapted as an in-situ plasma arc detector. The proposed system can provide useful indications of a faulty process in a timely and non-invasive manner for successful run-to-run (R2R) control and FDC.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.63 no.3
• /
• pp.376-382
• /
• 2014

E-Actuator is an essential part of an eVGT, it receives the command from the main ECU and controls the vane. An e-Actuator failure can cause an abrupt change in engine output and it may induce an accident. Therefore, it is required to detect anomalies in the e-Actuator in real time to prevent accidents. In this paper, an e-Actuator fault detection method using on-line parameter identification is proposed. To implement on-line fault detection algorithm, many constraints are considered. The test input and sampling rate are selected considering the constraints. And new recursive system identification algorithm is proposed which reduces the memory and MCU power dramatically. The relationship between the identified parameters and real elements such as gears, spring and motor are derived. The fault detection method using the relationship is proposed. The experiments with the real broken gears show the effectiveness of the proposed algorithm. It is expected that the real time fault detection is possible and it can improve the safety of eVGT system.