• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2002.04a
• /
• pp.62-65
• /
• 2002

Permeable reactive barriers (PRBs) are in-situ barriers constructed in a subsurface to treat contaminated groundwater using various reactive media. The common reactive medium used in PRB is zero-valent iron, which has been widely used to treat chlorinated solvents (i.e., PCE, TCE). A disadvantage of iron media is high cost. In this study, waste foundry sands were tested to determine the feasibility of their use as a low cost reactive medium. Batch and column tests were conducted with TCE to determine transport parameters and reactivity of the foundry sands. The reactivities of foundry sands for common groundwater contaminants are comparable to or slightly higher than those for Peerless iron, a common medium used in PRBs. In addition, the TOC and clay in foundry sands can significantly retard the movement of target contaminant, which may result in lower effluent concentration of contaminant due to biodegradation. In general, PRBs 1-m thick can be constructed with many foundry sands to treat TCE provided the zero-valent iron content in the foundry sand is higher than 1%.

• Journal of the Mineralogical Society of Korea
• /
• v.31 no.4
• /
• pp.227-234
• /
• 2018

In this work, we have prepared the reactive media with the pyrophyllite based using ceramic extrusion process. The characteristics of pyrophyllite were analyzed using XRD, XRF, DSC-TGA and Zeta-potential analysis. The study of pyrophyllite based ceramic reactive media were conducted under various roasting temperature (500 to $1,300^{\circ}C$) conditions. With increasing the roasting temperature, strength was increased but BET surface area was decreased. Thermally treated pyrophyllite were analyzed by means of weight loss and structural changes as detected by using XRD, DSC-TGA and SEM analysis. Pyrophyllite primarily transforms to pyrophyllite dehydroxylate after roasting at $1,000^{\circ}C$. Pyrophyllite dehydroxylate transforms to mullite and cristobalite at $1,300^{\circ}C$. This study demonstrates that pyrophyllite could be used as a reactive media for ceramic support layers from Permeable Reactive Barriers.

• Journal of the Korean Society of Combustion
• /
• v.8 no.1
• /
• pp.46-56
• /
• 2003

The present paper is concerned with the development of the computational biology in the past half century and its relationship with combustion. The modem computational biology is considered to be initiated by the work of Alan Turing on the morphogenesis in 1952. This paper first touches the life and scientific achievement of Alan Turing and his theory on the morphogenesis based on the reactive-diffusive instability, called the Turing instability. The theory of Turing instability was later extended to the nonlinear realm of the reactive-diffusive systems, which is discussed in the framework of the excitable media by using the Oregonator model. Then, combustion analogies of the Turing instability and excitable media are discussed for the cellular instability, pattern forming combustion phenomena and flame edge. Finally, the recent efforts on numerical simulations of biological systems, employing the detailed bio-chemical knietic mechanism is discussed along with the possibility of applying the numerical combustion techniques to the computational cell biology.

• International journal of advanced smart convergence
• /
• v.11 no.2
• /
• pp.88-94
• /
• 2022

The relationship between sound and vision was experimentally confirmed by physicist Ernst Florens Friedrich Chladni as early as the 18th century and formally entered into systematic research. With the development of emerging media technology, sound reactive type visual content is not limited to a single visual interaction based on the vibration of sound, and its visual content shows a diversified and scalable development trend according to different purposes in many fields. This study analyzes the development and changes of sound visual art contents from early stage to modernization, and analyzes the development characteristic of sound visual art content in different fields and scene environments influence by interactive media, new media technologies and devices by means of case analysis. Through this research, it is expected that the sound reactive type visual art content can continue to develop and extend in the existing fields, while explore the scalability of the application of sound reactive type visual art content in more fields.

• Membrane and Water Treatment
• /
• v.14 no.2
• /
• pp.95-106
• /
• 2023

In the developing country like India, groundwater is the main sources for household, irrigation and industrial use. Its contamination poses hydro-geological and environmental concern. The hazardous waste sites such as landfills can lead to contamination of ground water. The contaminants existing at such sites can eventually find ingress down through the soil and into the groundwater in case of leakage. It is necessary to understand the process of migration of pollutants through sub-surface porous medium for avoiding health risks. On this backdrop, the present paper investigates the behavior of pollutants' migration through porous media. The laboratory experiments were carried out on a soil-column model that represents porous media. Two different types of soils (standard sand and red soil) were considered as the media. Further, two different solutes, i.e., non-reactive and reactive, were used. The experimental results are simulated through numerical modeling. The percentage variation in the experimental and numerical results is found to be in the range of 0.75- 11.23 % and 0.84 - 1.26% in case of standard sand and red soil, respectively. While a close agreement is observed in most of the breakthrough curves obtained experimentally and numerically, good agreement is seen in either result in one case.

• KSBB Journal
• /
• v.8 no.2
• /
• pp.150-155
• /
• 1993

This study describes biodegradation of dyes which are used in textile industries. Dyes released into the environment from industrial waste water are considered to be a serious pollution problem because of the wide spread into environment with a variety of colors. The microorganisms used in this experiment were Pseudomonas species, which had been screened from aeration tank of waste water treatment. It was found that optimum concentrations for culture media were 14g of glucose, 6g of peptone, 160 mg of Na2HPO4, 200mg of KCl, 140mg of MgSO4,.7H2O,1.0g of KH2PO4, 400mg of NaCl, 200mg of CaCl2 and dye 10ppm per litre of distilled water. The high efficiency of dye degradation was obtained at pH 7-8 and $30-35^{\circ}C$. Strains screened are excellent for removal of azo and reactive dyes, which are relatively stable and difficult to degrade. Dyes of 10ppm such as mono-azo (Lot No. 180), di-azo (Lot No. 138) and reactive red(Lot No. 2) were mostly decolorlzed within 2 days and di-azo (Lot No. 151) and reactive red(Lot No. 34, No. 00166) were decolorized within 5 days in the controlled fermenter. In the case of reactive dyes, oxygen supplies showed lower biodegradability compared to anaerobic culture.

• Textile Coloration and Finishing
• /
• v.13 no.2
• /
• pp.42-42
• /
• 2001

Following the prior studs regarding that 1.0g of cotton fabric cound be dyed uniformly with a reactive dye in the solvent mixture of 2㎖ of water and 23㎖ of dichloromethane, silk fabric was dyed with C. I. Reactive Blue 203 in the water/dichloromethane two-phase immiscible solvent media. In order to minimize dye loss due to its hydrolysis, the reactive dyeing was carried out in dichloromethane containing a small amount of water. With only 3㎖ of water in 22㎖ of dichloromethane, 1.0g of silk fabric could be dyed perfectly. The uptake ratio was increased greatly, compared with that of normal reactive dyeing in a water medium. It would seem that the one of hydrophobic solvents, dichloromethane, can assist the even dyeing as it disperses a small amount of dye-dissolved water phase and conveys this water phase to the fabric entirely and uniformly.

• Textile Coloration and Finishing
• /
• v.13 no.2
• /
• pp.128-134
• /
• 2001

Following the prior studs regarding that 1.0g of cotton fabric round be dyed uniformly with a reactive dye in the solvent mixture of $2m\ell$ of water and $23m\ell$ of dichloromethane, silk fabric was dyed with C. I. Reactive Blue 203 in the water/dichloromethane two-phase immiscible solvent media. In order to minimize dye loss due to its hydrolysis, the reactive dyeing was carried out in dichloromethane containing a small amount of water. With only $3m\ell$ of water in $22m\ell$ of dichloromethane, 1.0g of silk fabric could be dyed perfectly. The uptake ratio was increased greatly, compared wish that of normal reactive dyeing in a water medium. It would seem that the one of hydrophobic solvents, dichloromethane, can assist the Even dyeing as it disperses a small amount of dye-dissolved phase and conveys this water phase to the fabric entirely and uniformly.

• Environmental Engineering Research
• /
• v.10 no.1
• /
• pp.1-6
• /
• 2005

Hexavalent chromium in aqueous solutions was successfully removed via sorption and reduction in the presence of waste leaves. Cr(VI) removal followed a first-order reaction, and removal rates were proportional to the amount of waste leaves used in the tests. Most of Cr(VI) were removed via sorption in early stages of the tests, but the reduction reaction played a significant role in Cr(VI) removal later. Solution pHs were continuously decreased due to the microbial activity, which was induced from the microorganisms attached on waste leaves. The decreased solution pHs further enhanced the sorption and reduction of Cr(VI). To characterize the microorganisms found in the tests, a denaturing gradient gel electrophoresis (DGGE) method was used. The majority of microorganisms were composed of Bacillus sp. which can reduce Cr(VI). Thus, waste leaves can be effective reactive media for the treatment of Cr(VI) in the subsurface.

• Journal of Preventive Medicine and Public Health
• /
• v.42 no.1
• /
• pp.29-34
• /
• 2009

Objectives : This study was performed to evaluate the relationship between C-reactive protein(CRP) and carotid intima-media thickness(carotid IMT) in a population of middle-aged Koreans. Methods : A total of 1,054 men and 1,595 women(aged 40-70 years) from Kanghwa County, Korea, were chosen for the present study between 2006 and 2007. We measured high-sensitivity CRP and other major cardiovascular risk factors including anthropometrics, blood pressure, blood chemistry, and carotid ultrasonography. Health related questionnaires were also completed by each study participant. Carotid IMT value was determined by the maximal IMT at each common carotid artery. The relationship between CRP level and carotid IMT was assessed using multiple linear and logistic regression models after adjustment for age, body mass index, menopause(women), systolic blood pressure, total/HDL cholesterol ratio, triglyceride level, fasting glucose, smoking, and alcohol consumption. Results : Mean carotid IMT values from the lowest to highest quartile of CRP were 0.828, 0.873, 0.898, and 0.926 mm for women(p for trend<0.001), and 0.929, 0.938, 0.949, and 0.979 mm for men(p for trend=0.032), respectively. After adjustment for major cardiovascular risk factors, the relationship between CRP and carotid IMT was significant in women(p for trend=0.017), but not in men(p for trend=0.798). Similarly, adjusted odds ratio of increased IMT, defined as the sex-specific top quartile, for the highest versus lowest CRP quartiles was 1.55(95% CI=1.06-2.26) in women, but only 1.05(95% CI=0.69-1.62) in men. Conclusions : CRP and carotid IMT levels appear to be directly related in women, but not in men.