• 한국해양공학회지
• /
• 제5권2호
• /
• pp.58-66
• /
• 1991

Not only difference of fatigue crack growth and propagation behavior resulted from the grain size, the hardness ratio and volume fraction in M.E.F. dual phase steel composed of martensite in hard phase and ferrite in soft phase, but also the effects of the plastic constraint were investigated by fracture mechanics and microstructural method. The main results obtained are as follows: 1) The fatigue endurance of M.E.F. steel increases with decreasing the grain size, increasing the ratio of hardness and volume fraction. 2) The initiation of slip and crack occures faster as the stress level goes higher. These phenomena result from the plastic constraint effect of the second phase. 3) The crack propagation rate in the constant stress level is faster as the grain size gets larger, the ratio of hardness lower and volume fraction smaller.

• Nuclear Engineering and Technology
• /
• 제20권1호
• /
• pp.1-8
• /
• 1988

상업용 발전소의 가동시, 출력 변화에 의해 1차 계통 보론 농도의 변화가 요구되었을 때 CVCS보충 시스템에서의 보충 유량이 연속 방정식과 질량 평형 방정식을 이용하여 측정된다. 이를 위하여, 1차 계통, 가압기, 그리고 volume control tank가 각각 질량과 보론 농도를 가진 control volume으로 그리고 1차측과 가압기, CVCS를 연결하는 파이프들이 시간 지연 요소로 모델화 되었다. 14-2-6-2 (출력변화 100-50-100) 부하 추종운전의 경우(7호기 EOL에서)를 이 모델을 이용하여 계산하였다.

• 대한수의학회지
• /
• 제36권1호
• /
• pp.75-82
• /
• 1996

Erythrocyte sedimentation rate is influenced by plasma protein, red cell itself and physiological conditions and it is clear that the measurement of erythrocyte sedimentation rate varies with technique and various environmental factors. The effect of temperature, angle of test tube, and osmobility with different percent of NaCl solution on erythrocyte sedimentation rate on sheep was determined by modified Westergren method. In sheep, as the angle of Westergren tube was decreased from $90^{\circ}$ to $45^{\circ}$, erythrocyte sedimentation rate was increased in both diluted plasma and NaCl solutions. As temperature was increased from $4^{\circ}C$ to $20^{\circ}C$ at $45^{\circ}$ angle. erythrocyte sedimentation rate was increased. In ruminants, this modified Westergren methods, erythrocyte 1 : plasma 9 instead of erythrocyte 4 : plasma 6(whole blood), enable them to have meanings as dog therefor, using this method, clinical can determine the erythrocyte sedimentation rate of ruminants for diagnosis. Because erythrocyte sedimentation rate was changed according to the angle of Westergren tube, temperature as erythrocyte diluted with NaCl, this study detected that the change of temperature, the angle of Westergren tube could change erythrocyte sedimentation rate by effecting red cell itself. The increase of osmobility owing to change of NaCl percent resulted in the decrease of rapid erythrocyte sedimentation rate. So this fact indicate that deformibility and the change of red cell volume have meaning in the change of erythrocyte sedimentation rate.

• 유통과학연구
• /
• 제21권3호
• /
• pp.93-100
• /
• 2023

Purpose: The purpose of this paper is to confirm whether stocks belonging to the distribution industry in Korea have reversals, following large daily stock price changes accompanied by large trading volumes. Research design, data, and methodology: We examined whether there were reversals after the event date when large-scale stock price changes appeared for the entire sample of distribution-related companies listed on the Korea Composite Stock Price Index from January 2004 to July 2022. In addition, we reviewed whether the reversals differed depending on abnormal trading volume on the event date. Using multiple regression analysis, we tested whether high trading volume had a significant effect on the cumulative rate of return after the event date. Results: Reversals were confirmed after the stock price shock in the Korean distribution industry and the return after the event date varied depending on the size of the trading volume on the event day. In addition, even after considering both company-specific and event-specific factors, the trading volume on the event day was found to have significant explanatory power on the cumulative rate of return after the event date. Conclusions: Reversals identified in this paper can be used as a useful tool for establishing a trading strategy.

• 한국의류학회지
• /
• 제34권1호
• /
• pp.67-78
• /
• 2010

This paper analyzes how to measure breast volume and the change in breast volume after wearing a brassiere. Measurement using a breast replica is used to measure the breast volume of 41 women in their twenties. The rate of persons having flat and hemispherical breast are high. The majority of subjects are size 75A, 80A, and 75B, and their under-bust size is 70. The current size specification should be refined for fitting according as the girth under bust decreases. The correlation between breast volume and the circumference of the breasts was high. It was more reliable to set up the cup size of a brassiere using the breast circumference. The mean breast volume is 263.68cc (nude) and the total volume wearing brassiere is 342.05cc. The volume difference according to wearing a brassiere is 78.37cc, which is less than the brassiere volume itself. The results show, the less breast volume of a subject, then the greater volume in wearing a brassiere.

• 한국산학기술학회논문지
• /
• 제5권6호
• /
• pp.580-587
• /
• 2004

본 논문의 목적은 주가지수 선물시장에서 선물의 가격과 거래량간 관계를 분석하는 것이다. 이를 위하여 선물수익률과 거래량 변화율을 이용하여 거래량과 선물가격간의 관계를 분석하였다. 거래량 변화율과 선물수익률간의 관계를 검증하기에 앞서 각각의 시계열에 대한 안정성 검증을 실시한 결과, 거래량 변화율과 선물수익률은 모두 안정적인 시계열인 것으로 나타났다. VAR모형을 이용한 선물수익률과 거래량 변화율간 관계에 대한 분석결과, 기간별 분석결과에서는 전체기간에서 주가지수 선물수익률이 거래량 변화율을 -3차에서 강하게 선도하는 것으로 나타났으며, 선물시장의 추세에 따른 분석결과는 선물가격의 상승시에는 거래량 변화율이 선물수익률을 선도하는 반면, 선물가격이 하락하는 경우는 선물수익률이 거래량을 선도하는 것으로 나타나고 있다. 또한, 상승기에 거래량변화율이 선물수익률을 선도하는 정도보다는 하락기에 선물수익률이 거래량 변화율을 선도하는 계수의 크기가 크게 나타나고 있다.

• Geomechanics and Engineering
• /
• 제23권6호
• /
• pp.561-573
• /
• 2020

The creep and consolidation behaviors of clays subjected to thermal cycles are of fundamental importance in the application of energy geostructures. This study aims to numerically investigate the physical mechanisms for the temperature-triggered volume change of saturated clays. A recently developed thermodynamic framework is used to derive the thermo-mechanical constitutive model for clays. Based on the model, a fully coupled thermo-hydro-mechanical (THM) finite element (FE) code is developed. Comparison with experimental observations shows that the proposed FE code can well reproduce the irreversible thermal contraction of normally consolidated and lightly overconsolidated clays, as well as the thermal expansion of heavily overconsolidated clays under drained heating. Simulations reveal that excess pore pressure may accumulate in clay samples under triaxial drained conditions due to low permeability and high heating rate, resulting in thermally induced primary consolidation. Results show that four major mechanisms contribute to the thermal volume change of clays: (i) the principle of thermal expansion, (ii) the decrease of effective stress due to the accumulation of excess pore pressure, (iii) the thermal creep, and (iv) the thermally induced primary consolidation. The former two mechanisms mainly contribute to the thermal expansion of heavily overconsolidated clays, whereas the latter two contribute to the noticeable thermal contraction of normally consolidated and lightly overconsolidated clays. Consideration of the four physical mechanisms is important for the settlement prediction of energy geostructures, especially in soft soils.

• 한국경영과학회:학술대회논문집
• /
• 대한산업공학회/한국경영과학회 1995년도 춘계공동학술대회논문집; 전남대학교; 28-29 Apr. 1995
• /
• pp.316-323
• /
• 1995

This paper presents an image processing technique to get traffic information such as vehicle volume, velocity, and occupancy for measuring the traffic congestion rate. To obtain these information, two horizontal lines are previously set on the screen. A moving vehicle is detected using the gray level difference on each line, and also template matching method at night. Threshold values are determined by sampling pavement grey level, and updated dynamically to cope with the change of ambient light conditions. These technique is successfully used to calculate vehicle volume, occupancy, and velocity. This study can be applied to traffic signal control system for minimizing traffic congestion in urban areas.

• 대한의용생체공학회:의공학회지
• /
• 제36권4호
• /
• pp.115-122
• /
• 2015

A standard air flow generator system was developed to generate air flows of various levels simultaneously applied to two different air flow transducer modules. Axes of two identical standard syringes for spirometer calibration were connected with each other and driven by a servo-motor. Linear displacement transducer was also connected to the syringe axis to accurately acquire the volume change signal. The user can select either sinusoidal or square waveform of volume change and manually input any volume as well as maximal flow rate levels ranging 0~3 l and 0~15 l/s, respectively. Various volume and flow levels were input to operate the system, then the volume signal was acquired followed by numerical differentiation to obtain the air flow signal. The measured volumes and maximal air flow rates were compared with the user input data. The relative errors between the user-input and the measured stroke volumes were all within 0.5%, demonstrating very accurate driving of the system. In case of the maximal flow rate, relatively large error was observed when the syringe was driven very fast within a very short time duration. However, except for these few data, most measured flow rates revealed relative errors of approximately 2%. When the measure and user-input stroke volume and maximal flow rate data were analyzed by linear regression analysis, respectively, the correlation coefficients were satisfactorily higher than 0.99 (p < 0.0001). These results demonstrate that the servo-motor controls the syringes with enough accuracy to generate standard air flows. Therefore, the present system would be very much practical for calibration process as well as performance evaluation and comparison of two different air flow transducer modules.

• 한국가시화정보학회지
• /
• 제9권4호
• /
• pp.74-79
• /
• 2011

In this study the change of free surface vortex is represented at different times according to height of water and with or without curtain wall installation. The air volume fraction is investigated at each condition of water level and the influence about creation of vortex is analyzed. The height of sump intake is taken as 100mm and the water level is divided into 5 steps. The sump model is the TSJ model and the curtain wall is applied by HI standard of America. The results shows that the free surface vortex can be identified on the isotropic surface at air volume fraction 1%~5% and the vortices make an air column from the free surface to the sump intake and are created and destroyed repeatedly. In the higher water level, less air is absorbed into the intake pipe. After curtain wall installation, the suction rate of the air volume fraction is decreased by 6.7%. The result of the vortex motion according to time, works on a cycle.