• Journal of Environmental Science International
• /
• v.18 no.3
• /
• pp.271-281
• /
• 2009

In order to reduce the uncertainties and improve the air flow field, objective analysis using observational data is chosen as a method that enhances the reality of meteorology. To improve the meteorological components, the radius influence and nudging coefficient of the objective analysis should perform a adequate value on complex area for the objective analysis technique which related to data reliability and error suppression. Several numerical experiments have been undertaken in order to clarify the impacts of the radius influence and nudging coefficient of the objective analysis on meteorological environments. By analyzing practical urban ground conditions, we revealed that there were large differences in the meteorological differences in each case. In order to understand the quantitative impact of each run, the Statistical analysis by estimated by MM5 revealed the differences by the synoptic conditions. The strengthening of the synoptic wind condition tends to be well estimated when using quite a wide radius influence and a small nudging coefficient. On the other hand, the weakening of the synoptic wind is opposite.

• Geomechanics and Engineering
• /
• v.13 no.2
• /
• pp.285-300
• /
• 2017

Shallow coal resources are increasingly depleted, the mining has entered the deep stage. Due to "High stress, high gas, strong adsorption and low permeability" of coal seam, the gas drainage has become more difficult and the probability of coal and gas outburst accident increases. Based on the flow solid coupling theory of coal seam gas, the coupling model about stress and gas seepage of coal seam was set up by solid module and Darcy module in Comsol Multiphysics. The gas extraction effects were researched after applying hydraulic technology to increase permeability. The results showed that the effective influence radius increases with the expanded borehole radius and drainage time, decreases with initial gas pressure. The relationship between the effective influence radius and various factors presents in the form: $y=a+{\frac{b}{\left(1+{(\frac{x}{x_0})^p}\right)}}$. The effective influence radius with multiple boreholes is obviously larger than that of the single hole. According to the actual coal seam and gas geological conditions, appropriate layout way was selected to achieve the best effect. The field application results are consistent with the simulation results. It is found that the horizontal stress plays a very important role in coal seam drainage effect. The stress distribution change around the drilling hole will lead to the changes in porosity of coal seam, further resulting in permeability evolution and finally gas pressure distribution varies.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 1999.03a
• /
• pp.22-25
• /
• 1999

'There are a lot of process variables, exerted influence on the formability of products, in deep drawing process. Particularly, it is important that the punch and die shape radius of the process variables. Though researches have been performed on the deep drawing of sheet metal forming, like this study, but it is insufficient the actual circumstances that researches for process variables of the non-axisymmetric deep drawing products. In this study, An effect on thickness distribution is grasped as alteration of the punch and die shape radius in the process of non-axisyrnmetric deep drawing products, and then the optimal punch and die shape radius were presented, they were verified by the numerical analysis method (FEM).

• Journal of the Korean Society of Safety
• /
• v.19 no.1
• /
• pp.56-59
• /
• 2004

In this paper, we investigated the influence of gap length and tip radius on breakdown of mineral based insulation oil. Applied voltages were DC and AC voltage. Electrode system was needle-plane structure. The tip radius of needle electrode was 5, 10, 20 and 25${\mu}m$, respectively. We measured breakdown voltage for each of tip radius with increasing electrode gap, 2mm to 12mm. Electric breakdown strength at tip was calculated using Mason's equation contained geometric figure. As gap length increased, breakdown strength increased linearly. But, as tip radius of needle increased, breakdown strength decreased exponentially. It can be explained by the phenomenon that electron is easily injected, as tip radius increases, and effective work function decreases. When appling DC voltage, breakdown strength was higher when polarity of needle was negative than positive. It is because of the space charge effect in accordance with the influence of liquid motion.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.15 no.2
• /
• pp.800-813
• /
• 2021

With the advent of 5G communications, internet of vehicles technology has been widely used in vehicles. Then the dynamic spread of information between vehicles began to come into focus with more research. It is well known that the identification of nodes with great spread influence has always been a hot topic in the field of information spreading. Most of the existing work measures the propagation influence by degree centrality, betweenness centrality and closeness centrality. In this paper, we will identify influential vehicle nodes based on the mobility characteristics of vehicles to explore the information spreading between vehicles in VANETs. Different from the above methods, we mainly explore the influence of the radius of gyration and vehicle kilometers of travel on information spreading. We use a real vehicle trajectory data to simulate the information transmission process between vehicles based on the susceptible-infected-recovered SIR model. The experimental results show that the influence of information spreading does not enhance with increasing radius of gyration and vehicle kilometers of travel. The fact is that both the radius of gyration and the distance travelled have a significant influence on information spreading when they are close to the median. When the value of both is large or small, it has little influence on information spreading. In view of this results, we can use the radius of gyration and vehicle kilometers of travel to better facilitate the transmission of information between vehicles.

• Journal of Environmental Science International
• /
• v.12 no.6
• /
• pp.615-626
• /
• 2003

The applied model for this study area is WINFLOW using mite element method, It is thought that the simulation result by WINFLOW model under the steady flow state reflects well the ground water distribution within the reliability level which shows the error range of 1.1% to 8.0% from the comparison between the computed values and the observed, and analyzed that the constant head distribution is shown along the east-west direction and gentle and stable head gradient along the north-south direction. Ground water of the study area shows stable movement from the south to the stream area, and the particle trace for each location shows relatively linear shape from the upstream to the pumping location while the radius of influence according to the pumping amount shows a significant difference at the down stream area from the pumping location. The simultaneous pumping from P and P1 shows more complicated appearance, not the increase of the radius of influence than pumping from a single well P or P1, and it is analyzed that the particle path takes nearly linear form. It is known that the flow direction of the ground water and the velocity of the flow affect on the magnitude of the radius of influence of the wells from the fact that the more decreasing pattern of the ground water head is observed at the side of the well and the down stream area than the upstream area when the ground water moves from south to north regarding the radius of influence according to the pumping amount. Satisfactory results in analyses of ground water movement are obtained through the significant reduction of the physical uncertainties in the flow system as well as the relatively convenient model application using WINFLOW model which is proposed in this study.

• Journal of the Korean Society of Manufacturing Technology Engineers
• /
• v.7 no.5
• /
• pp.72-84
• /
• 1998

In order ot study the influence of a circular inclusion on a stress field near a crack tip, mutual interference of a slant crack and the circular inclusion is analyzed of a bimaterial inclusion. As the crack emanates at the equivalent slant crack angle the correction factors FⅠ and FⅡ for the inclusion wit small Young's modulus were found to decrease as the inclusion radius increased. The correction factors for inclusion with large Young's modulus increase as the inclusion radius increases at the equivalent radius of the inclusion, the correction factors decrease as the slant crack angle increases for the aspect ratio $\frac{c}{W}$ = 0.1 irrespective of the Young's modulus. For $\frac{c}{W}$ greater than 0.2, they increase as the slant crack angle increases. There is no influence of stress mutual interfce after crack emanates beyond the inclusion radius.

• Journal of Korean Society for Atmospheric Environment
• /
• v.25 no.1
• /
• pp.1-14
• /
• 2009

Wind energy has been recognized as one of the most important and fastest growing energy resources without emission of air pollutant. Thus, it is necessary to predict wind speed and direction accurately both in time and space toward the efficient usage of wind energy. Numerical simulation experiments using the Fifth-Generation Mesoscale Model (MM5) are carried out to clarify the impact of surface observation data assimilation on the estimation of wind energy resources. The EXP_Radius run was designed with respect to the radius of influence in the Four-Dimensional Data Assimilation (FDDA), and the EXP_Impact run was made by changing the nudging coefficient that determines the relative magnitude of the nudging term. The simulation period covers a clear-sky event on 3 - 5 June 2007 and another is on 2 - 4 December 2006. It is found that the simulated results are very sensitive to the radius of influence and nudging parameters in the FDDA. The further analysis of the results shows that the impact of the radius of influence tends to be stronger in weak synoptic flow episode than that in strong synoptic flows episode. The nudging factor is also sensitive to the intensity of the synoptic flows.

• Honam Mathematical Journal
• /
• v.18 no.1
• /
• pp.59-77
• /
• 1996

In this paper, we study how the second coefficient in the power series expansion of functions in $P_n$(a; b, M), $F_n$(a; b, M) and $G_n$(a; b, M) influences certain properties like distortion, ${\gamma}-spiral$ radius and radius of starlikeness of these classes.

• Journal of Advanced Marine Engineering and Technology
• /
• v.26 no.6
• /
• pp.646-652
• /
• 2002

The influence of reciprocating frequency and radius on heat transfer in the roughened rectangular channel is experimentally investigated. The aspect ratio (width/height) of the duct is 2.33 and the rib height is one fifteenth of the duct height. And the ratio of rib-to-rib distance to rib height is 10. The discrete ribs were periodically attached to the button wall of the duct with a parallel orientation. The parametric test matrix involves Reynolds number, reciprocating, and reciprocating radius, in the ranges, 1,000∼6,000, 1.7∼2.5 HB and 7∼15cm, respectively. The combined effects of reciprocating frequency and reciprocating radius have considerable influence on the heat transfer due to the modified vortex flow structure.