• Journal of Navigation and Port Research
• /
• v.37 no.3
• /
• pp.269-273
• /
• 2013

Underwater acoustic channels are generally recognized as one of the most difficult communication media because of the multipath propagation, dispersion, and so on. MIMO (Multiple-input multiple-output) techniques have been actively pursued in underwater acoustic communications recently to increase the data rate over the bandwidth-limited channels. The transmit diversity techniques can be applied in this case, and one of them is Alamouti's scheme. In this paper the performances of the transmit diversity technique are evaluated via experiment. Two transmitters and two receivers were used in experiment, and the experiment was performed in indoor water tank. The error rate 5~8% was confirmed in experimental results, and these are the improved values than the error rate 14.8% for SISO(Single-input single-output) channel under same data rate condition.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.7
• /
• pp.528-537
• /
• 2014

As the data traffic between ships and a land station continuously increase through the shipbuilding-IT convergence, several wireless communication technologies are being studied to process large amounts of data traffic. In particular, the multi-antenna system is one of the most expected technologies to provide high throughput. This paper proposes an algorithm for the base station to select the ship in consideration of channel characteristics and the transmission angle for a beam of the land station in spatial multiplexing marine communication systems. We increase the system capacity by maximizing the received signal strength of the ship using clustering characteristic of the radio channel. Also, we reduce the time to select the ship by excluding the ship with the large interference between the beams. On our computer simulation, the proposed scheme dramatically reduces the computational complexity with a little sacrifice of the throughput.

• Journal of KIISE:Information Networking
• /
• v.36 no.2
• /
• pp.118-129
• /
• 2009

The ISO 18000-7 Active RFID standard, a single channel system operating in the 433Mhz, faces technical difficulties in supporting some recently introduced application demands because of its low transmission rates and radio interference between readers. We propose a new multi-channel active RFID system operating in the 2.4Ghz. The special feature of the proposed system is that a reader makes use of multiple interfaces to improve its performance like a multi-core processor. However if only a small part of interfaces are actually used, the performance improvement would not meet the expectation. To overcome this problem, a new multi-channel multi-interface active RFID protocol, which balances communication loads among all available interfaces, is necessary. 3 protocols, named as "Aggregated", "LP-Combined", "AP-Balanced", are proposed. Through simulation, we compare them for various conditions by changing number of tags, number of interfaces, tag data size. AP-Balanced shows the best performance and its performance increases almost linearly as the number of interface increases, which meets our expectation.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.3
• /
• pp.1263-1269
• /
• 2012

This paper is the research on the heated CWDM optical transmitter for the wavelength compensation at the low temperature. In general, the wavelength deviation of DFB laser is around 0.1 nm/C. The wavelength of DFB laser shifts to longer(shorter) wavelength according to the temperature increase(decrease). Typical CWDM optical communication network has 20 nm channel spacing from reference center wavelength per each channel. There is some limitation problem in the range of operating temperature due to the channel interference. For solving the limited temperature range problem, especially at the low temperature, we use the heater on the DFB laser. As a result, we could realize the CWDM optical transmitter to meet +/-6.5 nm from reference center wavelength in the range of temperature at $-40{\sim}+85^{\circ}C$, which is applicable to the industrial field.

• The Journal of the Acoustical Society of Korea
• /
• v.15 no.6
• /
• pp.12-15
• /
• 1996

An array often has faulty elements in real operation. The faulty elements, producing no output or highly reduced gain than other normal elements, cause an elevated sidelobe level and fail to reject the interference signals in an adaptive beamformer. In this paper we have presented the beamforming algorithm for arrays with faulty elements. In the ideal case, an autocorrelation matrix computed from array output data is the toeplitz. However, the inverse of the autocorrelation matrix computed from array with faulty elements can not be obtained due to deficient values of matrix. To overcome this problem, an adaptive beamforming algorithm using the average values of the diagonal terms of matrix is proposed. The computer simulations have been performed to study the performance of the presented method. We have been able to solve the degrees-of-freedom problem that is the drawback of the previous subaperture processing technique.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2017.11a
• /
• pp.193-195
• /
• 2017

This paper focuses on development status of eLoran system which is an representative backup PNT system in order to overcome the vulnerability of GNSS signals by radio frequency interference such as jamming. eLoran testbed system consists of new transmitting system for amplifying the signal through signal generation and modulation, differential Loran (dLoran) reference stations for calculating the signal errors received from transmitters, an integrated operation and control system (IOCS) for eLoran service. Therefore we present the configuration of testbed architecture for trial operation of eLoran service and the development status, and discuss about the next step toward backup PNT service using eLoran system.

• The KIPS Transactions:PartA
• /
• v.18A no.3
• /
• pp.115-122
• /
• 2011

It is very hard to obtain a general algorithm for solution of all the constraint satisfaction optimization problems. However, if the whole problem is separated into subproblems by characteristics of decision variables, we can assume that an algorithm to obtain solutions of these subproblems is easier. Under the assumption, we propose a problem classifying rule which subdivide the whole problem, and develop backtracking algorithms fit for these subproblems. One of the methods of finding a quick solution is efficiently arrange for any order of the search tree nodes. We choose the cluster head positioning problem in wireless sensor networks in which static characteristics is dominant and interference minimization problem of RFID readers that has hybrid mixture of static and dynamic characteristics. For these problems, we develop optimal variable ordering algorithms, and compare with the conventional methods. As a result of classifying the problem into subproblems, we can realize a backtracking framework for systematic search. We also have shown that developed backtracking algorithms have good performance in their quality.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.14 no.6
• /
• pp.440-448
• /
• 2009

Facility power-line electromagnetic interference (EMI) filters are used to provide radio frequency(RF) isolation between dedicated power distribution services and noise sensitive local power distribution systems. This type of EMI filters generally needs a high current capacity and, in some special applications, a high insertion loss of a minimum 100dB from 14kHz through 10GHz per MIL-STD 220 is required. This paper deals with an analysis and design of a wideband facility power-line EMI filter with the above requirements. The characteristics of the inductor and capacitor at high frequencies are investigated. The characteristics and design method of the facility EMI filter with a high order LC network are also presented. The prototype filter is finally implemented and its performance is verified from the experimental results.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.48 no.5
• /
• pp.1-6
• /
• 2011

LED(Light Emitting Diode) components have advantages of longer lifetime, lower power consumption and easy-to-control, compare to normal lamp and fluorescent light, according to the development of recent technologies. Thus, lots of illuminations which utilize LED components could be used. Recently, Visible Light Communication(VLC) which is a part of communication technologies, utilizing high speed response characteristic of LED components, started receiving public attention. In case of VLC, there is no need of frequency allocation due to no use of radio, but also no interference exists during data transmission, much different in ISM((Industrial Scientific Medical band). This is the reason why a lot of research results about VLC are becoming issued. In this paper, a survey of feasibility for using VLC utilizing an original LED illumination for underwater applications has been done and a primitive possibility of its application has been examined.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.45 no.7
• /
• pp.574-580
• /
• 2017

Static dischargers should be installed on air vehicle to emit a static electricity during flight. Especially, If static electricity is not removed by static discharger on the air vehicle, it makes ionization and corona effect on the edge of antenna and wing. Those phenomenon bring about performance degradation for radio communication and equipment operation. In this paper, the conditions such as climate, air vehicle's speed and frontal area were analyzed to design static dischargers. As a result, the static dischargers would be optimally designed for air vehicles and the performance of the static dischargers can verify according to the functional experiment. Therefore the result of this research will be used to make static discharger installation design for new air vehicle that have different size and mission.