• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2021년도 추계학술대회
• /
• pp.119-120
• /
• 2021

국내 어선의 해상업무용 무선설비 및 항해 장비는 IEC 60945를 준용한 KN60945_60533의 성능기준을 따르도록 규정하고 있다. LTE-M 송수신기는 해상업무용 무선설비에 포함되지 않아 기존 선박용 장비들과 동일한 기준을 적용받지 않기 때문에, 방사 방출 또는 전도 방출에 의한 간섭으로 기존 해상업무용 무선설비에 가청 소음을 발생하는 원인이 되고 있다. 본 논문에서는 초고속해상무선통신망 무선설비를 소형선으로 확대보급하기 위해 선결 사항으로 위와 같은 간섭 영향의 원인을 분석하고 관련 대책을 검증 제안한다.

• Journal of Power Electronics
• /
• 제4권1호
• /
• pp.46-55
• /
• 2004

This paper presents a high-frequency ZVS-PWM boost chopper-fed DC-DC converter with a single active auxiliary edge resonant snubber in the load-side which can be designed for power conditioners such as solar photovoltaic generation, fuel cell generation, battery and super capacitor energy storages. Its principle operation in steady-state is described in addition to a prototype setup. The experimental results of ZVS-PWM boost chopper-fed DC-DC converter proposed here, are evaluated and verified with a practical design model in terms of its switching voltage and current waveforms, the switching v-i trajectory, the temperature performance of IGBT module, the actual power conversion efficiency and the EMI of radiated and conducted emissions. And then discussed and compared with the hard switching scheme from an experimental point of view. Finally, this paper proposes a practical method to suppress parasitic oscillation due to the active auxiliary resonant switch at ZCS turn off mode transition with the aid of an additional lossless clamping diode loop, and reduced the EMI conducted emission in this paper.

• 대한조선학회논문집
• /
• 제55권4호
• /
• pp.281-288
• /
• 2018

Acoustic radiation efficiency is a crucial factor to estimate Underwater Radiated Noise (URN) of ships accurately. This paper describes a numerical method to analyse acoustic radiation efficiency of one side-wetted rectangular Mindlin plate with simply supported boundaries excited by a harmonic point force. Transverse displacements of plate and acoustic radiation pressures are evaluated by the mode superposition method. The acoustic radiation efficiencies analyzed by both Mindlin and thin plate theories show little differences at monopole and corner modes of low frequency regions but relatively large differences at edge and critical modes of high frequency regions. Especially, the critical frequency with the highest acoustic radiation efficiency evaluated by the Mindlin plate theory is higher than that of thin plate theory. In addition, the acoustic loading effect of fluid also increases bending wave-number of plate and its critical frequency. Finally, the acoustic radiation characteristics of plates with different aspect ratios and thicknesses through numerical analyses are investigated and discussed.

• 한국음향학회지
• /
• 제6권3호
• /
• pp.5-16
• /
• 1987

본 논문에서는 충격으로 인한 점탄성층을 가진 경계가 고정된 원형 평판으로부터의 음압복사에 대해 이론적, 실험적으로 연구한다. 층을 가진 평판의 운동을 모우드 해석법과 회전 관성효과와 전단력에 의한 변형을 고려한 Mindlin 의 평판이론으로부터 구한 고유치를 이용하여 구한다. 탄성구와 평판사이의 접촉력은 Hertz 이론으로 구하고 평판의 진동으로부터 복사되는 음압은 Rayleigh integral에 의해 구한다. 또한 층을 가진 평판으로부터 복사되는 음의 파형과 발생되는 음을 감소시키는 방법을 예측한다.

• 오토저널
• /
• 제14권5호
• /
• pp.69-82
• /
• 1992

Vibration of intake menifold is important as it could worsen the noise levels radiated from surface itself and support bracket, and it eventually leads to the failures of a Throttle Position Sensor and an Idle Air Control Valve. In this study, structural modification method is proposed to reduce structural vibration of an intake manifold system. At first, vibration problems are identified through tests on a running engine. Then modal data acquired by modal testing and finite element analysis are helpful to understand vibration mechanism of the system, and used as the design guide when structural modifications are attempted. After the system model is validated by comparison of the modal data obtained from analysis and experiment, iterative calculations are performed to find optimized structure of the system by finite element analysis. As a result, a newly designed plenum bracket is suggested in such a way that the intake manifold is stiffened, and that design of the support bracket is suggested in such a way that the intake manifold is stiffened, and that design of the support bracket is changed in terms of bolting position, thickness, shape, and minimum weight increase. Finally, it is shown that a new design achieves a significant reduction of vibration of an intake manifold system and it is confirmed by tests on a running engine.

• 비파괴검사학회지
• /
• 제25권1호
• /
• pp.9-14
• /
• 2005

표면 거칠기가 다른 유리시편에 대해 후방 복사된 초음파 세기의 입사각 의존성(프로파일)이 측정되었다. 후방복사 세기와 레일리(Rayleigh) 표면파 속도는 표면 거칠기에 비례하였고 이 경향은 각기 초음파의 산란규칙과 경화현상으로 설명되었다. 후방복사 프로파일의 면적 역시 표면 거칠기에 민감함을 보여 표면상태에 대한 새로운 비파괴적 평가 변수의 가능성을 보였다. 레일리 각 C-스캔 기법은 화상 명도의 반전과 높은 신호대 잡음비(S/N)를 보여주었다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 E
• /
• pp.2028-2030
• /
• 1999

In this paper, partial discharge(PD) was generated under the two types of needle -plane electrodes in the air. Using a monopole antenna to detect the radiated electromagnetic waves by stream of charge between the electrodes. the progress of partial discharge was studied. To analyze the progress of PD, statistical re-search was introduced. It was executed by personal computer and it can be possible to visualize the progress of PD. The t-test was used for lower voltage applied. The population of background noise spectrum and applied voltage spectrum showed the difference. The new method was introduced to analyze the spectrum. According tho the magnitude of applied voltage, the different statistical methods were used. The results obtained from this work will provide the useful information on partial discharge in time to come.

• The Journal of the Acoustical Society of Korea
• /
• 제24권3E호
• /
• pp.87-89
• /
• 2005

The acoustical sources of intake and exhaust systems in fluid machines are often characterized by the source impedance and strength using linear frequency-domain modeling. In the case of the sources which are nonlinear and time-variant, however, the source parameters were sometimes incorrectly obtained. In this paper, the source model and direct measurement technique are modified in order to evaluate the effect due to nonlinear and periodically time-varying source character as well as the linear property of the reflectivity of in-duct fluid machine source. With a priori known kinematical information of the source, the types of nonlinear time-variant terms can be presumed by a simple physical model, in which there is practically no restriction on the form of the model. The concept of source impedance can be extendable by introducing the linear frequency response function for each nonlinear or time-variant input. Extending the conventional method and adapting the reverse MISO technique, it is possible to develop a direct method that can deal with the nonlinear time-variant source parameters. The proposed direct method has a novel feature that there is no restriction on the probability or spectral natures of the excited sound pressure data. The present method is verified by the simulated measurements for simplified fluid machines. It is thought that the proposed method would be useful in predicting the insertion loss or the radiated sound level from intake or exhaust systems.

• 한국음향학회지
• /
• 제19권5호
• /
• pp.84-90
• /
• 2000

수중음향 측정 및 수동형 탐지에서는 표적 방사음향의 방위 탐지가 매우 중요하다. 표적의 방사음향이 다수 개의 청음 센서에 수신되면서 각 센서마다 시간적으로 지연되어 도달한다. 이와 같은 시간지연을 추출함으로서 표적 방위 추출이 가능하다. 본 연구에서는 시간지연 추정을 위해 RSSL 적응필터를 이용한 새로운 RLSLTDE 알고리즘을 제안한다. RLSLTDE는 표적 방사음향에 대한 정보가 제한적이거나 추정하려는 시간지연 정보가 시변인 경우에 효율적이다. 신호대 잡음비에 따른 시뮬레이션에 결과, 기존 LMS 적응필터 알고리즘 보다 수렴특성 및 시간지연추정 속도면에서 우수하여 제안 알고리즘이 수중음향 입사방위 추정에 유용함을 확인하였다.

• 대한의용생체공학회:학술대회논문집
• /
• 대한의용생체공학회 1995년도 춘계학술대회
• /
• pp.179-182
• /
• 1995

Although air, water, and noise pollutions have been widely recognized, electromagnetic forces(EMF) hazard has been rarely recognized as a pollution and very little studies has been done in this country. Thus, in this study electromagnetic forces radiated by various home appliances, once machines, and communication equipments were measured and so were several places radiating strong EMF such as subway stations and electric substations. Among the home appliances microwave oven senates lots of magnetic field and microwaves, and electric mattress does strong magnetic field. In video game room strong magnetic and considerable electric fields were measured. It was observed strong magnetic field inside of electric powered train and very strong magnetic and electric fields on some platforms. Hand-phone and car-phone radiate very hazardous level of microwaves to brain and that they rapidly come into wide use. In this study data base for various electric machines and places radiating strong EMFs were constructed and could be used for future epidemiological studies.