• Journal of the Korean Institute of Landscape Architecture
• /
• v.31 no.2
• /
• pp.48-57
• /
• 2003

The objective of this study is to review and verify whether the functions and effect of roadside trees generally hewn in theory are actually realized in urban roads and how well they are performed if the function and effect are realized. The study was conducted with a focus on 3 functions and effects including roadside tree's urban landscape improvement function (green area visibility ratio), effect of introducing green area within a city, and urban green network building function. The major study results are as follows: First, the average green area visibility ratio of 41 study areas is currently about 25.90%. The green area visibility ratio of commercial area within downtown was lowest among 5 road types. It showed that it is possible to raise the average green area visibility ratio up to 32.49% through roadside tree management and additional plantation. Second, in a section between Paldal Mountain and Suwon City Hall where there is no forest fragments and parks at all, a green area of 4,826 roadside trees represented 2.4% of total area and served as the only linear green area. Third, an analysis of 15 cities in Kyonggi province showed that urban forests are concentrated in outskirts. The suey showed that because forest fragments and parks exist in a form of points in urban areas, roadside trees are the only green areas that link each other and build a network.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.39 no.3
• /
• pp.107-116
• /
• 2011

One of the major factors which increase urban temperature is roads. This paper is aimed to investigate the effect of urban roadside vegetation on the road surface temperature. For this, surface temperature was measured at 18 spots using the thermal imaging camera in terms of road components including use of roadside land use, roadway, sidewalk, roadside vegetation and vegetation median barrier. The size of the roadside vegetation and related urban road characteristics were also measured. In terms of the effect of roadside vegetation on a decrease in road surface temperature, the roadside land use as a green area or open space was the highest, followed by the size of vegetation median barrier and the size of roadside vegetation. Besides road surroundings, an increase in the green zone such as roadside vegetation and median strip vegetation has a significant impact on lowering road surface temperature. Therefore, a good solution for reducing urban heat island effects would be to increase the area of roadside vegetation and green areas along roads.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.6 no.3
• /
• pp.17-28
• /
• 2003

The objective of this study is to review and verify whether the functions and effect of roadside trees generally known in theory are actually realized in urban roads and how well they are performed if the function and effect are really realized. The study was conducted with a focus on air purification effect of roadside trees. The m헤r study result is as follows. First, calculation of air purification effect of roadside trees showed that it is minimal. However, 7.4 units of broad-leaved trees is necessary in order to purify $SO_2$ discharged by one passenger car and 1,803.3 trees to purify $NO_2$. Second, regarding pollutant absorption capacity, air pollutant absorption capacity increased as the number of rows planted gets higher (i.e., 2-row plantation absorbs pollutant better than I-row plantation). In particular, "2-row plantation + lower-level shrub + buffer green belt" was as eight times high as "I-row plantation" in absorption capacity. Third, out of 30 roads with over 8 lanes in 15 cities, only 33.3% or a total of ten roads in seven cities had a median strip. Out of these ten roads, nine roads were planted in a double-layer consisting forest trees, shrubs, ground plants (grass). Analysis showed that out of six tree species planted along these roads, about a half of them were weak to air pollution. Also, based on the outcome of this study, charging a "plantation due" when people purchase a new car, improving layout of roadside trees, and reinforcing plantation of air purification tree species when selecting tree species for roadside trees were proposed.

• Journal of Environmental Science International
• /
• v.14 no.12
• /
• pp.1081-1085
• /
• 2005

This study is carried out for obtaining the basic materials for presentation of creation and desirable management of urban roadside trees through analyse the existence effect of trees on people who operate th commercial areas along the streets. Roadside tree and green areas are recognized comfort space in addition to simple planting area. Therefore various trees and flowering plants should be introduced in addition to roadside facilities for convenience. Planted roadside trees should be maintained. We will propose an method that residents plant and manage the trees and flowering plants on the two lane of one way road. However main lines more than four lane of one way have more public property beside the residents space. Therefore these should be maintained mainly by related government agencies.

• Journal of the Korea Safety Management & Science
• /
• v.13 no.1
• /
• pp.51-58
• /
• 2011

The uniformity of lighting distribution on the roadway is essential factor for drivers and pedestrians's safety during nighttime in urban streets. Also, the importance of roadside trees is one of the growing concern for better citizens' health and mitigating environmental impact on the urban street. But roadway lightings and roadside trees have different design or planting standards and they are not integrated in the systemic viewpoint for better safety of users during nighttime. The purpose of this study is to propose a simulation approach which assesses lighting quality in the view of illumination uniformity distribution of roadway lighting from design step and consider the layout of roadside trees. For improving lighting quality of roadway, simulation approach is needed for assessing the impact of diverse planting situation of trees and encouraged from beginning of design step for roadway construction.

• Particle and aerosol research
• /
• v.8 no.3
• /
• pp.111-120
• /
• 2012

In Daegu, a road cleaning system was constructed in the central part of the city and has been operated from April, 2011. We evaluated the effect of the system on the concentration of $PM_{10}$ at a roadside monitoring site. The ambient $PM_{10}$ concentration data were logged every 1 min for a period of 20 weeks from May to October, 2011, by means of light scattering method, and then every 5 min data were used in the statistical analysis. The measured data were verified by comparing them with beta-ray data obtained at the same site. Correlation coefficient between the two groups was highly significant (r=0.79), though the absolute levels of light scattering data appeared to be approximately 2.8 times higher than the beta-ray data. Diurnal, daily, weekly, and monthly variations of $PM_{10}$ data did not show any evidence of decreasing effect owing to the clean road system. A comparison of roadside $PM_{10}$ data with non-roadside data also revealed very similar pattern, implying the variation of the $PM_{10}$ concentrations is mainly affected by the traffic conditions near the monitoring site. However, if the operating conditions of the clean road system can be improved, i.e. increasing the frequency and duration of water cleaning, the road cleaning effect may improve the air quality indirectly by means of removing the resuspended particles from the road.

• Economic and Environmental Geology
• /
• v.32 no.1
• /
• pp.53-62
• /
• 1999

The possibility of heavy metal pollution by contaminated roadside soils was studied under controlled conditions. The soil samples from roadside and those from a retention pond consisting of settling particles were characterized by the XRD analyses and the sequential extraction experiments. Characterization by sequential extraction, for roadside soil indicates elevate total concentrations of heavy metals. The leaching behavior of the samples under different pH and time conditions were also studied. Differences between both types of samples result mainly from the buffering effect of carbonates, present in roadside soils and lacking from settling particles. Acid leaching of the settling particles is equivalent to the sum of FI+FII+FIII, while the amounts leached from roadside soil are lower probably from kinetic reasons. The buffering effects of carbonates were found to greatly delay the onset of the leaching reactions and the extent of dissolution in most metals except for Ca and Mn. The study of leaching kinetics at pH of 6.5 and 5 showed that Cd and Zn reached the maximum possible concentration within 3 days, while Pb did not show any sign of dissolution at both ph values. The absolute amounts of dissolved Cd and Zn increased by 7 to 9 times by decreasing the pH from 6.5 to 5, indicating slightly acidified rain may result in significant metal dissolution. As deduced from both sequential extraction and leaching experiments, the relative mobility of heavy metals is found to be : Mn=Cd>Zn>>Pb>Fe, in spite of large differences in heavy metal contents and localizations.

• Journal of Plant Biology
• /
• v.15 no.3
• /
• pp.9-13
• /
• 1972

This report deals with lead and zinc contamination of roadside soil and plants caused by motor vehicles as a function of distance from the road edge. The concentrations of Pb and Zn in roadside soil and plant samples from several locations decrease regularly with increasing distance from traffic. Soil samples up to 24m distance from the road edge are contaminated with more than 12.99ppm lead, and 13.40ppm zinc. The decrease in Pb and Zn contamination with increasing distance from the road is characteristically curvilinear; the relative coefficiency of Pb and Zn with distance is -0.69, -0.48, respectively. The average contents of Pb and Zn in plants are 21.5ppm and 30.00ppm. It is suggested that the contamination is related to the composition of gasoline, motor oil and to roadside of the residues of this metals.

• Fashion & Textile Research Journal
• /
• v.24 no.4
• /
• pp.471-478
• /
• 2022

In roadside workplaces, more attention should be paid to the safety of workers. The roadside workers underestimate the effect of the brightness of their clothes and judge that drivers will recognize them easily, and the drivers misjudge that the roadside workers are far away and that the vehicle can be stopped in sufficient time. Therefore, customized safety education reflecting this and wearing work clothes with certified visibility functions are required. In Korea, it is not compulsory for roadside workers and vehicle guide attendants to wear work clothes with a visibility function. In this study, the distance ahead perceived by drivers was measured using manikins wearing certified and non-certified reflective safety vests. The perception distance of the non-certified reflective safety vest was 1.4 times longer than that of the certified reflective safety vest, thus confirming the importance of wearing a certified reflective safety vest. To prevent roadside workers from suffering traffic accidents, we propose the enactment of a law that makes it mandatory for them to wear high-visibility safety clothing. Specifically, Article 32 of the Enforcement Regulation of the Road Traffic Act should include high-visibility safety clothing in life protection equipment, and additionally, to prevent secondary accidents, we propose the enactment of a law requiring the installation and wearing of certified reflective safety vests in vehicles.

• Journal of Korean Society of Forest Science
• /
• v.61 no.1
• /
• pp.69-79
• /
• 1983

To develope the fundamental models suitable for slope stabilization and scenic effect improvement of the roadside slopes, this study has continuously been conducted for last about 10 years through the field survey and observations on the roadside slopes of 100 plots located in the Capital region. The results obtained could be summarized as follows: 1) In general, due to unsuitable treatments and constructions to the man-made bare slope characteristics of the roadsides, the treatment aims for stabilizing and improving the scenic beauty of the slopes have not been successfully reached in the surveyed regions. 2) Particularly, because of insufficiency of the follow-up maintenance techniques to the roadside slopes treated, denudations of slope scenery established as well as the withering of the vegetation planted have been accelerated for the most part of the slopes treated. 3) 6 fundamental models for the roadside slope treatments have been developed and could be edaptable to the nation-wide purposes. The fundamental models are the model of forest scenery match plantation, roadside scenery establishment, denuded land rehabilitation, rock slope greenification, absolute stabilization, and environmental plantation belt establishment, respectively.