• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.7
• /
• pp.730-735
• /
• 2004

This paper describes what brings about DC offset and the impact or the DC offset on the performance or direct-conversion mobile receiver in WCDMA system. The performance degradation of $E_{b}/N_{o}$ due to the DC offset is presented through simulation result. Direct-conversion RF Transceiver which has the function of DC offset control is implemented and then applied to the WCDMA test-bed for the performance evaluation. The receiver performance degradation of $E_{c}/I_{o}$ is evaluated and analyzed by varying DC offset value. The practical test showed the minimum requirement of DC offset value to meet system performance.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.13 no.2
• /
• pp.321-326
• /
• 2018

This study describes the design and implementation of TRM(Transmit and Receiver Module) for detection for targets of small RCS(Radar Cross Section). Through the pre-simulation analysis of radar system about RF, the main specifications of TRM are verified. After the fabrication of TRM, the main characteristics such as the maximum output, noise figure, spurious were confirmed. In the future, the radar system test will be carried out by assembling TRMs, antenna radiator, and the transceiver that generates and receivers the radar waveform reflected.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.38 no.7
• /
• pp.479-485
• /
• 2001

In this paper, we propose optical subcarrier mutiplexing(SCM) transceiver module for base station(BS) that has no optical source and can be used for full-duplex communication over single optical fiber. In this method we retransmit optical modulated signal to the central office(CO) using loop-back system with a ring type Mach-Zehnder modulator(MZM) in BS, where optical source is transmitted from the CO. We have modeled the ring type MZM and were conformed that the measured results were in good agreement with the modeling. In the ring type MZM, the optical symmetric position of the MZM is very important in RF signal transmission.

• Journal of Korean Society for Geospatial Information Science
• /
• v.17 no.1
• /
• pp.113-120
• /
• 2009

Through the automatic sensing of the environment, USN technology can give the best services. In this work, we have developed an active RFID system and examined its performance. By implementing it into water quality sensors, we constructed a system that can detect diverse indoor/outdoor environment and provide information about the pollution level obtained from the temperature and PH sensors. Our RF system had an internal Print-on-PCB antenna for the miniaturization of the tag. We used a RF transceiver CC2510 chipset of TI company to realize the active RFID function. By using RSSI constants obtained, we performed the evaluation of real time location accuracy with a software written in Labview. Among 10 arbitrary locations, we obtained average measurement errors of 1.69 m in x axis and 1.66 m in y axis. This technology can be applied to logistics, environmental monitoring, prevention of missing children and various applications.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.1
• /
• pp.70-75
• /
• 2014

This paper presents a IR-UWB(Impulse Radio Ultra-Wide Band) transceiver circuit for data communication and real time location system. The UWB receiver is designed to OOK(On-Off Keying) modulation for energy detection. The UWB pulse generator is designed by digital logic. And the Gaussian filter is adopted to reject side lobe in transmitter. The measured sensitivity of the receiver is -65 dBm at 4 GHz with 1 Mbps PRF(Pulse Repetition Frequency). And the measured energy efficiency per pulse is 20.6 pJ/bit. The current consumption of the receiver and transmitter including DA is 27.5 mA and 25.5 mA, respectively, at 1.8 V supply.

• Journal of Korea Society of Digital Industry and Information Management
• /
• v.8 no.4
• /
• pp.91-98
• /
• 2012

This paper implements 2X2 MIMO Long Term Evolution (LTE) base station using Software defined radio (SDR) technology. The implemented base station system processes baseband signals on a Graphics Processor Unit(GPU). GPU is a high-speed parallel processor which provides very important advantage of using a very powerful C-based programming environment that is Compute Unified Device Architecture (CUDA). The implemented software-based base station system processes baseband signals through GPU. It utilizes USRP2 as its RF transceiver. In order to guarantee a real-time processing of LTE baseband signals, we have adopted well-known signal processing algorithms such as frame synchronization algorithms, ML detection, etc. using GPU operating in parallel processing.

• Information and Communications Magazine
• /
• v.14 no.3
• /
• pp.75-86
• /
• 1997

This manuscript describes the high level system design for the DCP system. The DCP HS and BS transceivers are composed of five systems, including the RF/IF unit, the Analog Front End(AFE), the baseband modem, the voice codec and the micro-controller. In the following, the core transceiver architecture with the primary functions at these subsystem is described.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.6
• /
• pp.749-756
• /
• 2015

In this paper, we propose a unique systolic structure and communication algorithm that maintains a solid link between nodes using synchronous digital communication and enables low power communication. This system was designed by using CC2500 RF transceiver, CC2590 RF front end and C8051F330 low power microcontroller. The measurement of power consumption in the network link shows below $400{\mu}W$ in data transfer rate 320bps. The system constitutes the base unit of low power wireless network that was composed of each seven link nodes having eight sensor nodes. Results of the experiments show that link nodes using a 4Ah battery could operate over 3 years without replacement.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.5
• /
• pp.558-565
• /
• 2013

In this paper, modeling and simulation for performance analysis of high resolution SAR system has been carried out in the time, frequency and numeric domain using ADS Ptolemy simulation tool of Agilent corporation. SAR system consists of antenna, controller and transceiver. Error parameters affecting SAR system performances have been defined, modeled and simulated such as phase noise of frequency synthesizer, amplitude and phase characteristic of TWTA, sampling frequency of waveform generator and I/Q imbalance. Finally, the development requirements of SAR system based on the impulse response function have been derived.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.11
• /
• pp.2021-2026
• /
• 2007

In the parer, we design a non-coherent UWB system by adopting the architecture of a simplified asynchronous transmission and the edge-triggered pulse transmission, which makes e system performance independent of the share of the transmitted waveform, robust to multipath channels. The designed non-coherent UWB transceiver architecture has an advantage of the simple realization since any mixer, high-speed correlator, and high-sampling A/D converter are not necessary at the cost of performance degradation of about 3dB. Further, the designed non-coherent UWB transceiver is actually implemented with the wireless CANVAS prototype testbed in short range indoor application environments such as a lecture room. The implemented prototype testbed is proven to offer the data rate of 115kbps on the conditions of Peer-to-Peer(P-to-P) in the indoor channel within the range of about 10m.