• Journal of Korea Multimedia Society
• /
• v.18 no.9
• /
• pp.1027-1038
• /
• 2015

For last several decades, the color correction methods have been proposed for HDR(high dynamic range) images. However, color distortion problems take place after correcting the colors such as halos, dominant color as well known. Accordingly, this article presents a novel approach in which the method consists of tone-mapping method and cone response function. In the proposed method, the tone mapping method is used to improve the contrast in the given HDR image based on chromatic and achromatic based on the CIEXYZ tristimulus value, expressed in c/m². The cone response function is used to deal with mismatch between corrected image and displayed image as well as to estimate various human visual effects based on the CMCAT2000 color appearance model. The experimental results show that the proposed method yields better performance of color correction over the conventional method in subjective and quantitative quality, and color reproduction.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.04a
• /
• pp.181-184
• /
• 2000

A new photo-alignment material, copoly (PM4Ch-ChMA), copoly (poly (4-methacryloyloxy) chalcone-chalconemethacryl) was synthesized and the electro-optical (EO) characteristics for the photo-aligned vertically aligned (VA)-LC display (LCD) were investigated. The monodomain alignment of the NLC for the photo-aligned VA-LCD by linearly polarized UV exposure on the photo-dimerized copoly (PM4Ch-ChMA) surfaces was observed. Excellent voltage-transmittance characteristics for the photo-aligned VA-LCD by UV exposure for 1 min. on the copoly (PM4Ch-ChMA) surfaces were achieved. The response time of the photo-aligned VA-LCD by UV exposure on for 1 min. the copoly (PM4Ch-ChMA) surfaces was about 39.3 ms. The response time for the photo-aligned VA-LCD decreased with increasing UV exposure time.

• The Journal of Internal Korean Medicine
• /
• v.21 no.3
• /
• pp.487-493
• /
• 2000

Objective : This experimental studies were done to research the effects of Bojungikgi-tang added Magnoliae Flos on the pulmonary thromboembolism and delayed allergy response. Methods : Healthy rats were devided into each group. This test is to inject sodium arachidonic acid to one group, and ADP(adenocine diphophate) to the other one afterward to compare the survival rate between each other. Delayed allergy response test is to inject PC(picryl chloride) to one group and measure the thickness of their ears, to inject SRBC(sheep red blood cell) allergen to the other, and measure their foot edema, and compare the each other rates Results : The extract of the Bojungikgi-tang added Magnoliae Flos revealed significant effect on the pulmonary thromboembolism induced by sodium arachidonate, or adenocine diphophate(ADP). And the extract of the Bojungikgi-tang added Magnoliae Flos revealed significant effect on delayed type hypersensitivity induced by picryl chloride(PC), or sheep red blood cell(SRBC). Conclusions : According to the above findings it is suggested that the extract of the Bojungikgi-tang added Magnoliae Flos revealed significant effect on the delayed type hypersensitivity and effect on the pulmonary thromboembolism.

• Korean Journal of Biological Psychiatry
• /
• v.7 no.2
• /
• pp.131-139
• /
• 2000

Even the pharmacotherapy is more effective than placebo for the treatment of depression, the outcome of pharmacoltherapy remains unsatisfactory for many patients. Apart from side effects, there are two major limitations of antidepressant therapy. One is the delayed onset of improvement and another is partial response. In order to address these clinical dilemmas, many psychiatrists more commonly employ add-on therapy. In past, the practice of using multiple drugs to enhance treatment response was called polypharamcy, and was disparaged as poor clinical practice. However, with improved understanding of how drugs affects the central nervous system and increased communication in journals and on computer networks about the relative merits of specific combinations, the scientific basis for the combining drugs is being defined. Indeed, the use of multiple medications as a stratege to enhance response has become both acceptable and widespread now a days. It is now referred to more positively as add-on therapy, co-medication, combination therapy, or drug augmentation. Thus, as the methods of practical strategies for treatment of depression, switching classes antidepressant drugs, combination therapy, augmentation strategies and brief treatment algorithm will be presented with items of considerations. However, when combination of drugs being tried, knowledges about the action of mechanism, pharamcokinetics, and pharmacodynamics are essential to cope with the possible adversive reactions and to get the appropriate responses for the treatment of depressive symptoms.

• 한국전산유체공학회:학술대회논문집
• /
• 2000.05a
• /
• pp.159-165
• /
• 2000

In this paper, numerical study has been done for the improvement of the superdetonative ram accelerator performance and for the design optimization of the system. The objective function to optimize the premixture composition is the ram tube length required to accelerate projectile from initial velocity $V_o$ to target velocity $V_e$. The premixture is composed of $H_2,\;O_2,\;N_2$ and the mole numbers of these species are selected at design variables. RSM(Response Surface Methodology) which is widely used for the complex optimization problems is selected as the optimization technique. In particular, to improve the non-linearity of the response and to consider the accuracy and efficiency of the solution, design space stretching technique has been applied. Separate sub-optimization routine is introduced to determine the stretching position and clustering parameters which construct the optimum regression model. Two step optimization technique has been applied to obtain the optimal system. With the application of stretching technique, we can perform system optimization with a small number of experimental points, and construct precise regression model for highly non-linear domain. The error to compared with analysis result is only $0.01\%$ and it is demonstrated that present method can be applied more practical design optimization problems with many design variables.

• Computers and Concrete
• /
• v.14 no.2
• /
• pp.193-209
• /
• 2014

Cyclic test of the columns is of practical relevance to the performance of compression members during an earthquake loading. The strength, ductility and energy absorption capabilities of reinforced concrete (RC) columns subjected to cyclic loading have been estimated by many researchers. These characteristics are not normally inherent in plain concrete but can be achieved by effectively confining columns through transverse reinforcement. An extensive experimental program, in which performance of four RC columns detailed according to provisions of ACI-318-08 was studied in contrast with that of four columns confined by a new proposed technique. This paper presents performance of columns reinforced by standard detailing and cast with 25 and 32 MPa concrete. The experimentally achieved load-displacement hysteresis and backbone curves of two columns are presented. The two approaches which work in conjunction with Response 2000 have been suggested to draw analytical back bone curves of RC columns. The experimental and analytical backbone curves are found in good agreement. This investigation gives a detail insight of the response of RC columns subjected to cyclic loads during their service life. The suggested analytical procedures will be available to the engineers involved in design to appraise the capacity of RC columns.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.11a
• /
• pp.463-470
• /
• 2000

In tunnel excavation by blast beneath the surface structures in urban area, the characteristics of ground vibration induced by blast and its influence on surface structures are analyzed by the field test and the numerical analysis on dynamic behaviors of the structure. According to the field test on the propagating characteristics of blast vibration through the rock mass and the concrete foundation pile. the attenuation index of peak particle velocity with distance shows the range of 1.7∼2.0 for the rock mass and the range of 2.0∼2.3 for the concrete pile. This shows that the blast vibration reduces more rapidly in the concrete pile. It is known from the numerical analysis on dynamic behavior of the structure that the coefficient of response, velocity ratio of structure response to input wave, is different according to the story of the structure. It can be said from this research that the characteristics of the ground vibration and the dynamic behavior of the structure should be well evaluated and be considered as important factors for safe blasting design especially in underground excavation at shallow depth in urban area.

• Journal of computational fluids engineering
• /
• v.5 no.2
• /
• pp.55-63
• /
• 2000

In this paper, the numerical study has been done for the improvement of the superdetonative ram accelerator performance and for the design optimization of the system. The objective function to optimize the premixture composition is the ram tube length, required to accelerate projectile from initial velocity V/sub 0/ to target velocity V/sub e/. The premixture is composed of H₂, O₂, N₂ and the mole numbers of these species are selected as design variables. RSM(Response Surface Methodology) which is widely used for the complex optimization problems is selected as the optimization technique. In particular, to improve the non-linearity of the response and to consider the accuracy and the efficiency of the solution, design space stretching technique has been applied. Separate sub-optimization routine is introduced to determine the stretching position and clustering parameters which construct the optimum regression model. Two step optimization technique has been applied to obtain the optimal system. With the application of stretching technique, we can perform system optimization with a small number of experimental points, and construct precise regression model for highly non-linear domain. The error compared with analysis result is only 0.01% and it is demonstrated that present method can be applied to more practical design optimization problems with many design variables.

• International Journal of Quality Innovation
• /
• v.1 no.1
• /
• pp.89-96
• /
• 2000

Evolutionary operation (EVOP) is a continuous improvement system which explores a region of process operating conditions by deliberately creating some systematic changes to the process variable levels without jeopardizing the product. It is aimed at securing a satisfactory operating condition in full-scale manufacturing processes, which is generally different from that obtained in laboratory or pilot plant experiments. Information on how to improve the process is generated from a simple experimental design. Traditional EVOP procedures are established on the assumption that the variance of the response variable should be small and stable in the region of the process operation. However, it is often the case that process noises have an influence on the stability of the process. This process instability is due to many factors such as raw materials, ambient temperature, and equipment wear. Therefore, process variables should be optimized continuously not only to meet the target value but also to keep the variance of the response variables as low as possible. We propose a scheme to achieve robust process improvement. As a process performance measure, we adopted the mean square error (MSE) of the replicate response values on a specific operating condition, and used the Kruskal-Wallis test to identify significant differences between the process operating conditions.

• Journal of Korean Academy of Fundamentals of Nursing
• /
• v.10 no.1
• /
• pp.14-22
• /
• 2003

Purpose: To improve self-management in elderly people with hypertension, the researcher examined the effects of an abdominal relaxed breathing exercises using biofeedback on blood pressure. These exercises regulate physical response to stress and lessen the activity of sympathetic nerves. Method: A single-experimental pre-and post-test design was used. Eight elderly people with hypertension participated in the study from April, 6 to June, 14, 2000. Biofeedback was done with soft ware by developed by J & J Company (1-410 form for abdominal respiration training). The abdominal relaxed breathing exercises are based on Mason's suggestion (1985) and were modified by Yu & Song(2001). This program consisted of 4 sessions once a week for four weeks. Data were analysed using SPSSPC+(10.0). Result: There was a significant decrease in systolic and diastolic blood pressure over three different times. There was a significant difference in the level of total stress response, overall health and quality of life but no significant difference in the level of emotional condition over three different times. Conclusion: The results of this study will contribute to the development of nursing strategies for the regulation of blood pressure in older people as the exercises are easy to learn and are a nonpharmacologic approach.