• Geotechnical Engineering
• /
• v.12 no.5
• /
• pp.117-126
• /
• 1996

In spite of many advantages such as the simplicity in test procedure, Standard Penetration Test(SPT) results contain some errors caused by the variability of test equipment, instruments and test procedures. Especially, it is inevitable that the measured SPT hammer energy is different from the theoretical value because of energy loss. In this paper, the hammer energy level is measured during the performance of the field SPT in Korea by using a ultra-sonic system and PC.program. As the results of this study, the average hammer energy ratio of the R-P hammer and the Trip hammer is calculated at 64.2%, and at 75.0% respectively. The average energy ratio of the SPT for the R-P hammer is calculated at 46% and at 54% for the Trip hammer, by applying the rod energy ratio 0.72.

• Journal of Astronomy and Space Sciences
• /
• v.26 no.1
• /
• pp.1-8
• /
• 2009

We present new B, V, and R CCD photometric light curves for the low mass ratio contact binary FP Boo. A new photometric solution and absolute physical dimensions of the system were derived by applying the Wilson-Devinney program to our observed light curves and to previously published Rucinski et al.'s radial velocity curves. From the H-R diagram of 24 low mass ratio contact binary system including FP Boo, the evolutionary stage of FP Boo was found to coincide with those of the general low mass ratio contact binary systems. The light curves obtained in this season show a small asymmetry in their shapes.

• Journal of Korean Medicine Rehabilitation
• /
• v.19 no.4
• /
• pp.115-126
• /
• 2009

Objectives : The aim of this study was to evaluate whether the foot pressure distribution correlates with the lumbo-sacral curvature, and the Oswestry Disability Index in chronic low back pain patients. Methods : We measured the fore foot pressure and the rare foot pressure using the foot analyzer in 28 women subjects with chronic low back pain. The lumbo-sacral curvature and the Oswestry Disability Index(ODI) were also measured. Results : 1. Subjects with higher ODI(%) had significantly lower Fore foot pressure/Rare foot pressure ratio(F/R ratio) (p<0.01). 2. Lumbar lordotic angle and Ferguson angle were inversely related to ODI(%) (p<0.05, p<0.01). 3. Lumbar lordotic angle and Ferguson angle were positively related to F/R ratio (all p<0.05). Conclusions : Using the Foot Analyzer(FA-48S, Tech storm Inc.) we have shown that F/R ratio has significant correlation with the lumbo-sacral curvature and the Oswestry Disability Index. These result suggest that the Foot analyzer may be used in assessing back pain in chronic low back pain patients.

• Journal of Ocean Engineering and Technology
• /
• v.13 no.4 s.35
• /
• pp.55-62
• /
• 1999

Cold rolled steel has much plastic strain in the material surface produced by manufacturing process. The strain causes the variation of surface residual stress, in which influences the fatigue behavior under repeated loading. As experimental results, it was confirmed that the behavior of residual stress ${\sigma}_r$, with cycle N consisted of three stages except stress amplitude near fatigue limit in SPCC steel. On the first stage compressive residual stress decreased rapidly, on the second stage gradually, and on the last stage slightly. The relation between ${\sigma}_r$, and log N appeared linear behavior except the early part of cycle ratio $N/N_f$. The average gradient of ${\sigma}_r$, with respect to log N seemed to take a constant value without initial cycle ratio. On the other hand, the $N_f$ line was regressed by the first-order polynomial equation on ${\sigma}_r-log\;N_f$ diagram. Therefore, this study showed that both the gradient of ${\sigma}_r$, with respect to log N and the $N_f$ line was useful in predicting the cycle ratio $N/N_f$.

• Journal of Environmental Science International
• /
• v.5 no.1
• /
• pp.93-102
• /
• 1996

Hydrodynamic characteristics such as gas holdup, liquid circulation velocity and bed expansion in a hexagonal inverse fluidized bed were investigated using air-water system by changing the ratio ($A_d$/$A_r$) of cross-sectional area between the riser and the downcomer, the liquid level($H_1$/H), and the superficial gas velocity($U_g$). The gas holdup and the liquid circulation velocity were steadily increased with the superficial gas velocity increasing, but at high superficial gas velocity, some of gas bubbles were carried over to a downcomer and circulated through the column. When the superficial gas velocity was high, the $A_d$/$A_r$ ratio in the range of 1 to 2.4 did not affect the liquid circulation velocity, but the maximum bed expansion was obtained at $A_d$/$A_r$ ratio of 1.25. The liquid circulation velocity was expressed as a model equation below with variables of the cross-sectional area ratio($A_d$/$A_r$) between riser to downcomer, the liquid level($H_1$/H), the superficial gas velocity($U_g$), the sparser height[(H-$H_s$)/H], and the draft Plate level($H_b$/H). $U_{ld}$ = 11.62U_g^{0.75}$${(\frac{H_1}{H})}^{10.30}$${(\frac{A_d}{A_r})}^{-0.52}$${(\frac({H-H_s}{H})}^{0.91}$${(\frac{H_b}{H})}^{0.13}$

• Geomechanics and Engineering
• /
• v.33 no.3
• /
• pp.261-269
• /
• 2023

In this study, the compressive strength of cement stabilized soil was predicted using the electrical resistivity measurement. The effects of the water to cement (w/c) ratio and recovered Carbon Black (rCB) contents were examined. A series of electrical resistivity and compressive strength tests were conducted on two types of stabilized soil after 28 days of curing. Multiple nonlinear regression (MNLR) analysis was used to evaluate the relationship between the compressive strength and the electrical resistivity in terms of the rCB, C_u (uniformity coefficient), and w/c ratio. The results showed that the w/c ratio and C_u have a strong influence on the compressive strength and electrical resistivity of the cement stabilized soil compared to the rCB content. The use of a small amount of rCB led to a decrease in the void space in the specimen and was attributed to the increase strength and decrease electrical resistivity. A high w/c ratio also induced a low electrical resistivity and compressive strength, whereas 3% rCB in the cemented soil provided the optimum strength for all w/c ratios. Finally, a prediction equation for the compressive strength using the electrical resistivity measurement was suggested based on its reliability, time effectiveness, non-destructiveness, and cost-effectiveness.

• Korean Journal of Human Ecology
• /
• v.4 no.1
• /
• pp.36-45
• /
• 2001

This study was performed to determine the changes of maternal iron status during pregnancy cross sectionally, and to evaluate the appropriateness of the cut-off points of hemoglobin (Hb). hematocrit (Hct), serum transferrin receptor (sTfR) and sTfR : ferritin ratio for assessing iron deficiency status based on serum ferritin level (< 12${\mu}g$/L). Serum Hb concentrations in the first trimester were significantly higher (p < 0.05) than those in the second and third trimester. Serum levels of iron and ferritin in the third trimester were significantly lower (p < 0.05) than those in the first and second trimester. On the other hand, sTfR:ferritin ratios in the third trimester were significantly higher (p < 0.05) than those in the first and second trimester. sTfR concentrations did not change significantly during pregnancy. The appropriate cut-off points of Hb were 11.5g/dL for whole period of pregnancy. 12.0g/dL for 1st trimester. and 11.5g/dL for both 2nd and 3rd trimester. The good cut-off points of Hct were 34% for whole period of pregnancy. 36% for 1st trimester. and 34% for both 2nd and 3rd trimester The suitable cut-off points of TIBC were 400${\mu}g$/dL for whole period of pregnancy. 360${\mu}g$/dL for 1st trimester, and 400${\mu}g$/dL for both 2nd and 3rd trimester. Any cut-off point of sTfR could not be selected because of its low sensitivity and specificity. The proper cut-off point of sTfR : ferritin ratio was 600 or 650 for all the periods determined except the first trimester. In conclusion, there were no reliable cut-off levels of sTfR and those of sTfR : ferritin ratio showed low specificity. The cut-off values of Hb and Hct for assessing iron deficiency were slightly higher than the values used to evaluate anemia. Thus, if appropriate cut-off levels were applied, Hb. Hct, or TIBC might be useful indices for evaluating iron deficiency as well as anemia.

• Proceedings of the KSR Conference
• /
• 2005.05a
• /
• pp.712-717
• /
• 2005

When the weight if a concrete member makes problems, or when the cost of the concrete is relatively high, it may be economical to use a hollow concrete member. But a hollow R.C column may have poor ductility because of the brittle failure at the inner face of the hollow R.C column. This brittle failure results from the absence of the confinement at the inner face of the hollow R.C column. To avoid this brittle failure an internally confined hollow R.C column by a steel tube was developed before. In this study, a hollow R.C column is internally confined by a corrugated steel tube instead of a general flat steel tube. And a column ductility is performed. Test results show that the energy ductility ratio of a internally confined hollow R.C column by a by a corrugated steel tube corresponds to $80\%$ of the energy ductility ratio of a general solid R.C column.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.5 no.1
• /
• pp.44-52
• /
• 2002

To understand the relationship among different quantitative traits, correlation studies were performed by utilizing eighty-eight inbred strains of silkworm, Bombyx mori L. on twelve economic characters. Analysis resulted in correlation of 5th instar period with total larval period (r ＝ 0.7882), cocoon weight with shell weight (r ＝ 0.8326), shell weight with shell ratio (r ＝ 0.5067), shell ratio with raw silk ％ (r ＝ 0.7570), raw silk ％ with filament length (r ＝ 0.3490), filament size (denier) with reelability (r ＝ 0.3193) and boil-off loss % (r ＝ 0.2792). Negative correlation was observed among filament length with filament size (r ＝ 0.7582) and reelability with boil-off loss % (r ＝ -0.3236). Correlation of different quantitative characters for quality silk production is discussed.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.9 no.3
• /
• pp.59-65
• /
• 2009

To investigate a posttraumatic stress, social support and work burden and to identify high risk group and related factors which were exerted influence on posttraumatic stress of firefighters. Data were gathered from total 264 firefighters consisting of 85 fire distinguishers & rescue workers, 96 emergency medical personnel and 83 in ambulance & fire truck drivers in C province and were analyzed 22 items by IES-R, 20 work burden items by Choi(2000), 8 social support items by Oh(2006) using SPSSWIN 14.0 program. Posttraumatic stress of general characteristics by work was showed significant difference in age, marriage status, education, position, office duration, mobilization frequency and experience of traumatic events. Posttraumatic stress were showed significant difference in 3 groups and fire distinguishers & rescue workers is the highest group. Posttraumatic stress was correlated with work burden(r=.317, p<0.01) for fire distinguishers & rescue workers, social support(r=-.331, p<0.01) and work burden(r=.522 p<0.001) for emergency medical personnel and work burden(r=.454, p<0.01) for ambulance & fire truck drivers. The high risk groups are fire distinguishers & rescue workers(60%), emergency medical personnel(55.2%)and ambulance & fire truck drivers(45.8%). Related factors are the experience seeing victim's danger for fire distinguishers & rescue workers(odds ratio=1.216, 95% confidence interval:1.068-1.383), and are work burden(odds ratio=1.100, 95% confidence interval:1.043-1.159) and office duration(odds ratio=1.010, 95% confidence interval 1.001-1.018) for emergency medical personnel, and are the experience seeing victim's danger(odds ratio=1.178, 95% confidence interval:1.010-1.373), age(odds ratio=1.129, 95%confidence interval:1.020-1.249), work burden(odds ratio=1.103, 95% confidence interval:1.034-1.177) for ambulance & fire truck drivers.