• Journal of Powder Materials
• /
• v.17 no.1
• /
• pp.59-64
• /
• 2010

8 mol% Y-doped $SrTiO_3$ powder was synthesized by Pechini method from titanium isopropoxide, strontium nitrate, yttrium nitrate, citric acid and ethylene glycol. A $Y_2Ti_2O_7$ pyrochlore phase-free perovskite powder was obtained by calcining a polymeric resin, which was prepared from a precursor solution, at $500^{\circ}C$ in an air atmosphere. Low temperature calcination could lead to a fine-grained microstructure. In the case of a solid-state reaction, an extended heat-treatment at high temperature in a reduced atmosphere needed to obtain a single phase perovskite $SrTiO_3$.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.8 no.2
• /
• pp.128-133
• /
• 2008

Phase-change random access memory (PRAM) chip cell phase of amorphous state is rapidly changed to crystal state above 160 Celsius degree within several seconds during Infrared (IR) reflow. Thus, on-board programming method is considered for PRAM chip programming. We demonstrated the functional 512Mb PRAM with 90nm technology using several novel core circuits, such as metal-2 line based global row decoding scheme, PN-diode cells based BL discharge (BLDIS) scheme, and PMOS switch based column decoding scheme. The reverse-state standby current of each PRAM cell is near 10 pA range. The total leak current of 512Mb PRAM chip in standby mode on discharging state can be more than 5 mA. Thus in the proposed BLDIS control, all bitlines (BLs) are in floating state in standby mode, then in active mode, the activated BLs are discharged to low level in the early timing of the active period by the short pulse BLDIS control timing operation. In the conventional sense amplifier, the simultaneous switching activation timing operation invokes the large coupling noise between the VSAREF node and the inner amplification nodes of the sense amplifiers. The coupling noise at VSAREF degrades the sensing voltage margin of the conventional sense amplifier. The merit of the proposed sense amplifier is almost removing the coupling noise at VSAREF from sharing with other sense amplifiers.

• The Journal of Korean Obstetrics and Gynecology
• /
• v.19 no.4
• /
• pp.216-224
• /
• 2006

Purpose : This study was conducted to investigate the effect of Mokhyangsaenghwa-tang beverage on postpartum recovery and lactation. One theory of oriental medical treatment for postpartum care is focused on increasing vitality and building up blood. Saengwha-tang are representative remedies for these respective principle of treatment. This experiment was carried out to evaluate the clinical effects of Mokhyangsaenghwa-tang on blood components, Body weight, BMI and prolactin level in postpartum. Methods : 65 postpartum women applied for this study, and 30 of them were included in this study. They were divided two groups. The experimental group were treated by Mokhyangsaenghwa-tang beverage, the control group were treated by citron beverage during 40 days. Then we observed the changes of the body weight, BMI, complete blood cell count, liver function test, renal function test, level of serum prolactin, Urine analysis and general conditon Questionnaire among baseline(before treatment), 1st phase(after 20 days treatment) and 2nd phase(after 40 days treatment). Results : After taking Mokhyangsaenghwa-tang beverage, body weight, body water, edema index, prolactin ana general condtion became better, but they were not statistically significant. Conclusion : This study shows that Mokhyangsaenghwa-tang can improve postpartum recovery, but more research is needed.

• Journal of the Korean Institute of Gas
• /
• v.10 no.2 s.31
• /
• pp.22-26
• /
• 2006

In this study, modeling and simulation works using Aspen Plus were carried out for DME separation and purification process of pilot plant for the daily production of 50 kg of DME. For modeling of the entire DME separation unit, NRTL liquid activity coefficient model was used for the prediction of liquid phase non-idealities, Henry's law option was also used for the estimation of solubilities of light gases in solvents and SRK equation of state model was utilized for the description of vapor phase non-idealities. DME having over 98 wt% purity was obtained as a side distillate product in a DME purification column.

• Journal of the Korean Institute of Gas
• /
• v.7 no.3 s.20
• /
• pp.32-43
• /
• 2003

As this paper is observed the phase equilibrium diagram of mono- (methane) and multi-component(natural gas) hydrates, and the hydrate growth behavior is analysed and compared by the experiments during the reaction. The difference of mono and multi-component hydrates is an induction delay time and a plateau region. And the concentration of component of gases is changed during the reaction in multi-component hydrates and the concentration of components is changed during the decomposition of hydrate according to each decomposing rates of gases. At 6 MPa, 276.65 K and 600 rpm, the induction delay time of multi-component hydrate formation is observed shorter than that of mono-component hydrate formation because the hydrate nuclei of gases except methane form faster than those of methane. And the plateau region of mono-component hydrate is observed distinctly at 0.055 mole of $CH_4$/mole of water and that of multi-component hydrate is observed at 0.04 mole of $CH_4$/mole of water.

• Journal of Sensor Science and Technology
• /
• v.32 no.5
• /
• pp.328-333
• /
• 2023

This study experimentally verified the etch rate of the SiO₂ sacrificial layer etching process with a single etch hole using vapor-phase hydrogen fluoride (VHF) etching. To fabricate small-sized polysilicon etch holes, both circular and triangular pattern masks were employed. Etch holes were fabricated in the polysilicon thin film on the SiO₂ sacrificial layer, and VHF etching was performed to release the polysilicon thin film. The lateral etch rate was measured for varying etch hole sizes and sacrificial layer thicknesses. Based on the measured results, we obtained an approximate equation for the etch rate as a function of the etch hole size and sacrificial layer thickness. The etch rates obtained in this study can be utilized to minimize structural damage caused by incomplete or excessive etching in sacrificial layer processes. In addition, the results of this study provide insights for optimizing sacrificial layer etching and properly designing the size and spacing of the etch holes. In the future, further research will be conducted to explore the formation of structures using chemical vapor deposition (CVD) processes to simultaneously seal etch hole and prevent adhesion owing to polysilicon film vibration.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08a
• /
• pp.307-310
• /
• 2007

We describe effects of ionic and neutral additives on phase and structural behavior of the lyotropic chromonic liquid crystals used in preparation of optical elements such as polarizers and compensators.

• BMB Reports
• /
• v.31 no.5
• /
• pp.508-514
• /
• 1998

We studied the effects of ASC-17D rat Sertoli cell-conditioned media (rSCCM) on the proliferation of the DU145 prostate cancer cells. rSCCM was prepared from ASC-17D cells cultured in DMEM/F-12 serum-free media at a nonpermissive temperature of $40^{\circ}C$, which is the condition for the high expression of c1usterin. We found that rSCCM could inhibit the proliferation of DU145 cells by arresting the cell cycle in the G1 phase in a dose-dependent manner. This growth arresting activity was abolished by boiling rSCCM for 5 min. The G1 growth-inhibiting activity of rSCCM was also detected in other prostate-originated cancer cells examined (i.e., LNCaP and PC-3) but not in other cells (ASC-17D, HepG2, SK-N-SH, and NIH3T3). Western blot analysis of partially purified growth inhibiting fractions with the clusterin antibody showed that the cytostatic factor in rSCCM was not c1usterin. This cytostatic factor was semi purified by DEAE-Sepharose, ammonium sulfate precipitation, and Phenyl-Sepharose column chromatography, and was estimated to have a molecular weight of 88 kDa by Sephacryl S-300 gel filtration.

• Korean Journal of Optics and Photonics
• /
• v.32 no.3
• /
• pp.120-125
• /
• 2021

We have developed a linearly polarized high-power Yb-doped fiber laser in the master oscillator power amplifier (MOPA) scheme for efficient spectral beam combining. We modulated the phase of the seed laser by pseudo-random binary sequence (PRBS), with the bit length optimized to suppress stimulated Brillouin scattering (SBS), and subsequently amplified seed power in a 3-stage amplifier system. We have constructed by coiling the polarization-maintaining (PM) Yb-doped fiber, with core and cladding diameters of 20 ㎛ and 400 ㎛ respectively, to a diameter of 9-12 cm for suppression of the mode instability (MI). Finally, we obtained an output power of 1.004 kW with a slope efficiency of 83.7% in the main amplification stage. The beam quality factor M² and the polarization extinction ratio (PER) were measured to be 1.12 and 21.5 dB respectively. Furthermore, the peak-intensity difference between the Rayleigh signal and SBS signal was observed to be 2.36 dB in the backward spectra, indicating that SBS is successfully suppressed. In addition, it can be expected that the MI does not occur because not only there is no decrease in slope efficiency, but also the beam quality for each amplified output is maintained.

• KIEE International Transaction on Electrical Machinery and Energy Conversion Systems
• /
• v.5B no.3
• /
• pp.277-282
• /
• 2005

This paper describes a step-down AC voltage regulator using an AC chopper and auxiliary transformer, which is a series connected to the main input. The detail design of the AC regulator, logic and PWM pattern of the AC chopper is described and the three-phase AC regulator using two single­phase AC choppers with a three transformer configuration is proposed for three-phase application. The proposed three-phase system has the advantages of lower system cost due to reduced switch number and gate driver circuit as well as advantages of decreased size and weight because it uses a series compensated scheme. The proposed AC regulator has many benefits such as fast voltage control, high efficiency and simple control logic. Experimental results indicate that it can be used as a step-down AC voltage regulator for power saving purposes very efficiently.