• Journal of Food Hygiene and Safety
• /
• v.8 no.1
• /
• pp.9-15
• /
• 1993

In an attempt to quantitate and qualitate residual antibiotics and antibacterial agents in meat simultaneously, we studied a gas chromatography-mass spectrometry(GC/M8) analysis. For a simultaneous analysis of penicillin G, chloramphenicol and thiamphenicol in meat, a simple and rapid clean-up procedure including extraction with 0.01 M EDTA-2Na Mcilvaine buffer (pH 4.0), defatting with n-hexane, and elution with 0.01M-methanolic oxalic acid from Bond Elute $C_{18}$ cartridge, and quantitation by selected ion monitoring (SIM) mode after derivatization was performed. The recoveries (%) of penicillin G, chloramphenicol and thiamphenicol (CV, %) at 1 ppm fortification level were 63.5 (7.6), 76.3 (8.1) and 84.7 (2.0), and the detection limits of those were 0.6, 0.085 and $0.084\;\mu\textrm{g}$ beef, respectively. This method using 81M mode allows excellent detection and quantitation of residual antibiotics and antibacterial agents in meat. Moreover, confirmation by a full scan electron impact mass spectrum is possible if residual level in the sample in above 1 ppm.

• Journal of Food Hygiene and Safety
• /
• v.30 no.4
• /
• pp.366-371
• /
• 2015

This work was conducted to apply the multi class pesticide multiresidue method for determining the use of hexaconazole in the agricultural products using GC-NPD. The multi class pesticide multiresidue method results were validated for the assay of hexaconazole by using linearity, accuracy, precision, limit of detection and quantitation. The linearity in the concentration ranged from 0.025 to 5.0 mg/L ($R^2$ > 0.999). Lettuce recoveries ranged from 89.42% to 94.15% with relative standard deviations below 7.78%, for spiking levels from 0.04 to 4.0 mg/kg. The limit of detection was 0.04 mg/kg, and the limit of quantitation was 0.11 mg/kg. The intra- and inter-day precisions were 2.42~3.49% and 4.90~7.78%, respectively. We suggested that the multi class pesticide multiresidue method for determining hexaconazole was highly accurate and reproducible, and it will be used as a routine analysis in agricultural products.

• Journal of Pharmaceutical Investigation
• /
• v.39 no.1
• /
• pp.73-78
• /
• 2009

A simple LC-MS/MS method of rabeprazole in human plasma was developed and validated. Rabeprazole and Internal standard (I.S), omeprazole, were extracted from human plasma by liquid liquid extraction, chromatographic separation of rabaprazole in plasma was achieved at $45^{\circ}C$ with a Shiseido UG120 $C_{18}$ column and methanol-10 mM ammonium acetate buffer (pH 9.42 with ammonium water), as mobile phase. Rabeprazole produced a protonated precursor ion [$(M+H)^+$] at m/z 360.10 and corresponding product ion at m/z 242.21. Internal standard produced a protonated precursor ion [$(M+H)^+$] at 346.09 and corresponding product ion at m/z 198.09. This method showed linear response over the concentration range of $1{\sim}500\;ng/mL$ with correalation coefficient greater than 0.99. The lower limit of quantitation (LLOQ) using 0.2 mL plasma was 1 ng/mL, which was sensitive enough for pharmacokinetics studies. The method was specific and validated with a limit of quantitation of 1 ng/mL. The intra-day and inter-day precision and accuracy were acceptable for all samples including the LLOQ. The applicability of the method was demonstrated by analysis of plasma after administration of a single 10 mg dose to 36 healthy subject. From the plasma rabeprazole concentration versus time curves, the mean $AUC_t$ (The area under the plasma concentration-time curve from time 0 to 12 hr ) was $691.36{\pm}321.88\;ng{\cdot}hr/mL$, $C_{max}$ (maximum plasma drug concentration) of $353.21{\pm}131.52\;ng/mL$ reached $3.4{\pm}1.1\;hr$ after adiministration. The mean biological half-life of rabeprazole was $1.37{\pm}0.75\;hr$. Based on the results, this simple method could readily be used in pharmacokinetics studies.

• Journal of Food Hygiene and Safety
• /
• v.31 no.6
• /
• pp.432-438
• /
• 2016

Ethoxyquin (EQ, 1,2-dihydro-6-ethoxy-2,2,4-trimethyl-quinoline) is quinoline-based antioxidant used in the animal feed and food industry to protect the raw materials and final products against oxidation. In recent years the use of synthetic antioxidants in fishmeal ingredients carry-over to farmed fish fillets has received increasing attention in food safety. This study was conducted to develop an analytical method to determine EQ in aquatic products. The analytes were confirmed and quantified via liquid chromatography-tandem mass spectrometry (LC-MS/MS) in the positive ion mode using multiple reaction monitoring (MRM). The sample was extracted with 1 N HCl (in case of flatfish extracted with 1 N HCl containing 10% acetonitrile). Then, solid phase extraction (SPE) was used for the cleanup. Standard calibration curves presented linearity with the correlation coefficient ($r^2$) > 0.99, analyzed at 0.005-0.2 mg/kg concentration. The developed method was validated according to the Codex Alimentarius Commission (CAC) guideline. The limits of quantitation for EQ were 0.01 mg/kg. Average recoveries ranged from 81.3% to 107%. The repeatability of measurements, expressed as the coefficient of variation (CV, %), was below 10%. The analytical method was characterized with high accuracy and acceptable sensitivity to meet CODEX guideline requirements and would be applicable to analyze the EQ residue in aquatic products.

• Analytical Science and Technology
• /
• v.27 no.4
• /
• pp.201-212
• /
• 2014

Polycyclic aromatic hydrocarbons (PAHs) that are carcinogenic and persistent will be restricted in consumer products from December 27, 2015 by EU REACH regulation. Pretreatment using Soxhlet extraction and quantitative analysis by GC-MS were studied to develop the method for analyzing 18 PAHs in consumer products as well as to detect the amounts and the kinds of PAHs in consumer products such as grips of a bag and a hammer, a cable and a plastic sandal. Linearity and precisions were evaluated by analyses of the standard PAH solutions ranging from 0.3125 mg/L to 5.00 mg of each of 18 PAHs. Linearity of resulting standard curves for all 18 PAHs were obtained with $R^2$ above 0.999. Precisions of the retention times and the peak areas were found to be 0.00%~0.05% and 1.16%~3.69% of relative standard deviations, respectively. The recoveries for spiked samples were all around 95%~105% after Soxhlet extration using three different solvents such as dichloromethane, hexane and toluene. The limits of quantitation for 18 PAHs in solutions and polymer samples by GC-MS were evaluated to be 0.327 mg/L (Benzo[ghi]perylene)~0.464 mg/L (Acenaphthylene) and 1.635 mg/kg (Benzo[ghi]perylene)~2.32 mg/kg (Acenaphthylene) based upon dilution factor of 5, respectively. Under the developed analytical method, only trace amounts of phenanthrene were detected in three samples while 15 kinds of PAHs including phenanthrene were detected in a grip of hammer with concentrations of maximum 83.4 mg/kg of Phenanthrene and minimum 8.5 mg/kg of Acenaphthylene. Further studies are needed to decrease the quantitation limit and to check the feasibility of decreasing Soxhlet time as well as to demonstrate cases that the clean up is required.

• The Korean Journal of Pesticide Science
• /
• v.13 no.4
• /
• pp.223-231
• /
• 2009

This study was performed to develop a precise single residue analytical method of fungicide fenhexamid in representative crops for general residue analytical method which could be applied to most of crops. Korean cabbage, mandarin, apple and green pepper were selected, macerated, extracted with acetone, concentrated and partitioned with dichloromethane. Then the extracts were concentrated and cleaned-up through Florisil column with ethyl acetate/0.1% acetic acid in hexane [15:85, (v/v)] before concentration and analysis with HPLC. LOQ (Limit of Quantitation) of fenhexamid was 1 ng (S/N>10) and MQL (Method Quantitative Limit) was 0.01 mg/kg. Recoveries were measured at two fortification levels (10 MQL and 50 MQL) on crop samples and ranged from 85.2% to 94.8% (mean recoveries) and coefficients of variation were <10% regardless of sample type.

• The Korean Journal of Pesticide Science
• /
• v.17 no.2
• /
• pp.107-116
• /
• 2013

Polar pesticides like pymetrozine (log $P_{ow}$: -0.18) are known to be difficult to analyze. The analytical method of pymetrozine using hydromatrix included in the official method of KFDA was uncommon and provided ambiguous evidence to confirm both the identity and the quantity. Therefore, precise single residue analytical method was developed in representative crops for using liquid-liquid extraction (LLE). The pymetrozine residue was extracted with methanol from 11 representative crops which comprised apple, blueberry, broccoli, cabbage, cherry, crown daisy, hulled rice, Korean cabbage, potato, rice and watermelon. The extract was purified serially by liquid-liquid extraction (LLE) and silica solid phase extraction (SPE). For rice and hulled rice samples, n-hexane partition was additionally adopted to remove nonpolar interferences, mainly lipids. The residue levels were analyzed by HPLC with DAD, using $C_8$ column. LOQ (limit of quantitation) of pymetroizinie was 1 ng (S/N > 10) and MQL (method quantitation limit) was 0.01 mg/kg. Mean recoveries from 11 crop samples fortified at three levels (MQL, 10 ${\times}$ MQL and 50 ${\times}$ MQL) in triplicate were in the range of 83.1~98.5% with coefficients of variation (CV) of less than 10%, regardless of sample type, which satisfies the criteria of KFDA. The method established in this study could be applied to most of crops as an official and general method for analysis of pymetrozine residue.

• The Korean Journal of Pesticide Science
• /
• v.17 no.2
• /
• pp.84-93
• /
• 2013

Validated analytical methods for isopyrazam are meager or lacking. In the present study, a single residual analytical method was developed for isopyrazam in selected commodities. Isopyrazam was analyzed in brown rice, soybean, green pepper, mandarin, cucumber, and Korean melon. We tried different solvents and methods through extraction, partition and purification steps to obtain best analytical results. For isopyrazam samples were extracted with acetonitrile, concentrated and partitioned with n-hexane, clean-up using florisil with n-hexane/ethylacetate (70/30) and analyzed with HPLC/UVD. The limit of quantitation (LOQ) for isopyrazam was 1.0 ng (S/N > 10) and method LOQ (MLOQ) was 0.04 mg $kg^{-1}$. Recovery ranged through 81.0~105.3% (syn-isomer) and 80.8~105.6% (anti-isomer) at fortification level of 0.04 (MLOQ), 0.4 (10 ${\times}$ MLOQ), and 2.0 (50 ${\times}$ MLOQ). The coefficient of variation (CV) for isopyrazam was less than 10% regardless of sample types. These results were further confirmed with LC/MS, respectively. The proposed method is highly reproducible and sensitive and is suitable for routine analysis.

• Journal of the Korean Chemical Society
• /
• v.51 no.1
• /
• pp.36-42
• /
• 2007

Hepatitis B is a serious public health problem leading to chronic infection and liver cancer. Quantitation of circulating hepatitis B virus (HBV) is important for monitoring disease progression and for assessing the response to antiviral therapy. In this study, by using Real-Time PCR and novel Micro-PCR assay method, we measured HBV concentration in the clinical sample. A total of 120 serum samples from patients with HBV infection collected was in Dankook university hospital to compare the detection limit, sensitivity, specificity and reproducibility of the two assay methods. These findings of this study suggest that Micro-PCR and Real-Time PCR assay methods are comparable to each other in there detection limit, sensitivity, and reproducibility for HBV DNA quantitation. However, Micro-PCR assay is more efficient than Real-Time PCR method, because Real-Time PCR is not so time - consuming, technically easy and need to reagent of a small quantity. It will be useful for rapid and reliable clinical diagnosis of HBV in many countries.

• Korean Journal of Food Science and Technology
• /
• v.52 no.1
• /
• pp.26-30
• /
• 2020

This study was undertaken to determine the characteristics of xanthoangelol, the major chalcone constituent derived from the extracts of different parts of Lespedeza bicolor. Xanthoangelol was isolated from the root extract using column chromatography and used as a standard for quantitative analysis. The structure of the isolated compound was established based on spectroscopic evidence. The HPLC-DAD method was validated for specificity, linearity, precision, accuracy, limit of detection, and limit of quantitation. The calibration curve of xanthoangelol had significant linearity (R²>0.9999). Limit of detection and limit of quantitation 0.018 and 0.059 ㎍/mL, respectively. The relative standard deviation values of precision test, and intra- and inter-day tests were less than 0.22 and 0.40%, respectively. In the recovery test, the accuracy ranged from 98.98-102.78% with RSD values less than 0.13%. The method validation parameters indicate the applicability of the HPLC method for quality control of food or drug formulations containing L. bicolor.