• Transactions of The Korea Fluid Power Systems Society
• /
• v.2 no.2
• /
• pp.1-7
• /
• 2005

For the reliability evaluation of the track drive unit(TDU), firstly, we analyzed the major failure modes through FMEA(failure mode & effects analysis), FTA(failure tree analysis), and 2-stage QFD(quality function deployment), and then quantitatively determined the priority order of test items. The Minitab analysis was also performed for prediction of life distribution and parameters of TDU by use of field failure data collected from 430 excavators for two years. In addition, we converted the fluctuation load in field conditions into the equivalent load, and for evaluation of the accelerated lift by the cumulative fatigues, the equivalent load is again divided into the fluctuation load by reference of test time. And then, by use of the test method in this paper, the acceleration factor(AF) of needle bearing inside planetary gear which is the most weakly designed part of TDU is achieved as 5.3. This paper presents the quantitative selection method of test items for reliability evaluation, the determination method of the accelerated life test time, and the method of non-failure test time based on a few of samples. And, we proved the propriety of the proposed methods by experiments using a TDU for a 30 ton excavator.

• Clinical and Experimental Reproductive Medicine
• /
• v.45 no.4
• /
• pp.189-194
• /
• 2018

Objective: The aim of this study was to compare the rate of maturation, fertilization, and embryo development of in vitro-matured human oocytes derived from pregnant and non-pregnant women. Methods: Immature oocytes were obtained by needle aspiration from 49 pregnant women (group 1) who underwent a cesarean section at term and 77 non-pregnant women (group 2) who underwent a gynecological operation during the same period (8 months). Healthy immature oocytes (530 in group 1 and 539 in group 2) were cultured and assessed for maturation 36 hours later. Mature oocytes were inseminated by intracytoplasmic sperm injection and cultured up to 144 hours. Results: The percentage of degenerated oocytes was significantly higher (12.1% vs. 6.3%; p<0.001) in group 1 than in group 2. There was no significant difference in the maturation rate (66.8% vs. 68.1%; p=0.698), fertilization rate (66.7% vs. 67.6%; p=0.857), or the rate of formation of good-quality blastocysts (46.2% vs. 47.2%; p=0.898) in oocytes obtained from pregnant and non-pregnant women. Conclusion: The developmental competence of immature oocytes did not differ between pregnant and non-pregnant women.

• The Journal of Korean Obstetrics and Gynecology
• /
• v.36 no.2
• /
• pp.1-19
• /
• 2023

Objectives: The purpose of this health promotion project for Korean medicine is to promote the health of climacteric women in Boeun-gun. Methods: During the project, pressure needle acupuncture treatment, herbal medicine treatment, meditation pore therapy, and health education were conducted. To evaluate the results, basic health surveys (body height, body composition test, blood pressure etc.), female hormone tests, Kupperman's index (KI), Menopause-specific quality of life questionnaire (MENQOL), and Perceived stress scales (PSS) were conducted. Results: No significant change was observed in the body composition test and blood pressure after the project. Follicle stimulating hormone (FSH) was significantly increased after the project, but Luteinizing Hormone (LH) and total estrogen levels were not significantly changed. KI and MENQOL scores significantly decreased after the project, and significantly decreased in 4 out of 11 items of KI and 3 out of 4 domains of MEMQOL. No significant change was observed in the PSS score after the project. Conclusions: From the results of this project, it can be seen that the Korean medicine health promotion project can help alleviate symptoms of climacteric syndrome and postmenopausal syndrome.

• The Research Journal of the Costume Culture
• /
• v.12 no.6 s.53
• /
• pp.945-952
• /
• 2004

Shrink-resist effects and properties of the knitted fabrics from wool/acrylic(W/A) fiber blends were determined to find out an optimal blending ratio keeping the quality properties of wool products. The test fabrics were knitted by a weft knitting machine with all needle knitting structure ($0{\times}0$ rib) under the same knitting conditions with five different types of yarns: $W100\%,\;A100\%$, and W/A blended yarns(70/30, 50/50, 30/70). Shrinkage during repeated washing, electrostatic propensity, thermal resistance and pilling propensity of W/A knits. The shrink resistance was significantly enhanced on repeated washing of W/A knits, especially, over $50\%$ acrylic blended knits. Addition of strong physical force and alkali detergent applied in this washing experiment brought about superior effects with the low shrinkage rate although it was very severe washing conditions for wool fabrics. The results from the washing experiment implies that W/A blend knits can be machine washed at individual households with other ordinary laundry. There was some changes and variation found in thermal resistance, electrostatic propensity, and pilling. W/A 50/50 blended knits did not bring serious changes to other physical properties comparing with original wool, which helps consumers care wool knitted clothes more conveniently.

• Journal of Sensor Science and Technology
• /
• v.21 no.2
• /
• pp.156-166
• /
• 2012

Over the past 15 years productive BCI research programs have arisen. Current mainstream EEG electrode setups permit efficient recordings but most of electrodes has the disadventages of need for skin preparation and gel application to correctly record signals. The new gel-free probe was adapted for EEG recording and it can be fixed to the scalp with the micro needle without neuro-gel. It use standard EEG cap for wearing electrodes on scalp so it is compatible with standard EEG electrodes. A comparison between electrode characteristics is achieved by performing simultaneous recordings with the gel electrodes and gel-free probe placed in parallel scalp positions on the same anatomical regions. The quality of EEG recordings for all two types of experimental conditions is similar for gel-electrodes and gel-free probe. Subjects also reported not having special tactile sensations associated with wearing of gel-free probes. According to our results, it is expected that gel-free probe can be adapted to BCI, BMI(Brain Machine Interface), HMI(Human Machine Interface) because of its simple application and comfortable wearing process.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.12 no.3
• /
• pp.45-50
• /
• 1998

This paper presents experimental results on the application of very low frequency(VLF) voltage to replace conventional DC test as an after laying test for underground distribution cables. We carried out several tests to prove defects detecting ability of VLF test on the 5m length real cables having knife-cut or needle type defects which is made in our La.. Through this experiment we proved it is very difficult to initiate electrical tree from the defects inside of the cable insulation but once the electrical tree is initiated it grows very fast and VLF does not make new defects and expand the defect. Therefore VLF test equipment for quality inspection test of manufacture is more effective than field application for underground distribution cables.

• Journal of Biosystems Engineering
• /
• v.28 no.5
• /
• pp.395-402
• /
• 2003

Standard ginseng seedling, selected after one year's rearing in the seedling bed has been conventionally transplanted in Korea. Recently, the direct seeding areas have been increasing to product high quality ginsengs for red-ginseng processing. Reciprocating push-rod brush, holed-roller and vacuum suction seeders, planting with 30 ${\times}$ 30mm spacings and adjustable to the folds were designed and theirs performances were evaluated. The developed three types of seeders reliably performed at the success rate over 95% with less than 10% in slip rate, and could be used a seeder for the greater spacings by adjusting metering parts. The research concluded that the vacuum suction seeder was the most feasible and practical with the greatest metering success and the least slip among three type seeders of the reciprocating push-rod brush, holed-roller and vacuum suction seeders. The vacuum suction seeder holds a seed with each needle nozzle using the negative pressure created by a vacuum pump. The capacity was 24.5 times greater than a man power at the speed of 5 m/min.

• Journal of Fashion Business
• /
• v.2 no.4
• /
• pp.102-111
• /
• 1998

The purpose of this study is to present the basic material for the competitive, high-quality products by analyzing employees' attitude toward their job and some factors which influence the enhancement of productivity, education of workers, and facilities. This project was mainly conducted the conditions of women's wear manufacturing industries in Taegu by interviewing 143 employees in the sewing department. The result of this dissertation can be summarized as follows; 1. When it comes to the division of task in the sewing department, one team is composed of chairpersons (33.5%), assistant members (27.4%) and sub-assistant members (26.6%). The inspection of commodities as well as the enhancement of work on ironing for elaboration was divided as completion (12.6%) and finally the forms of task were made up of design sampling team (49%) and contracting team (51%). 2. Among the needle workers, as many as 60% employees had received technical education, which was by means of being passed down from the predecessors (81.6%). In terms of the period of education, from 2 to 5 years topped the list. The contents of education comprise patterning, sewing (65.2%) and ironing (20.3%). 3. The department of design takes charge of the report on working directions up to 88.2% and the working directions were used by 69.9 % of technicians. The directors of working conditions and methods were chiefs of designing department (37.7%) and those of sewing department (30.8%). The factors of defective goods were low-quality materials (50.0%), the deficiency in skills of workers. In terms of methods for preventing defects, technical education of workers, standardization of task and investment for factory automation were suggested. 4. As for their perception of present work, most of employees (80%) look upon it as a way of earning a living and 11% of them wanted to derive many things from their work. 59.2% of workers were satisfied with the product. When it comes to the incentive system provided by company, 67.0% responsed that it was not bad, and 23.9% evaluated it as 'satisfactory'.

• Journal of Acupuncture Research
• /
• v.36 no.2
• /
• pp.72-79
• /
• 2019

Background: The aim of this study was to review clinical efficacy of acupuncture treatment of mild cognitive impairment. Methods: Randomized controlled trials that performed acupuncture treatment for mild cognitive impairment were retrieved from 6 online databases (PubMed, Cochrane Library, EMBASE, CNKI, NDSL, OASIS) on September $30^{th}$, 2018. Studies were selected according to inclusion and exclusion criteria, and were reviewed by Risk of Bias assessment. Results: In total, 21 studies were included in this review. All studies were Chinese (19 studies published in Chinese and 2 in English). The sample size, 50 to 100, and the number of treatment times, 20 to 30, were the largest range in all studies. The most treatments performed was 30. The longest treatment period was 56 days, which accounted for 33% of the studies. The most frequently used evaluation index was the Mini Mental State Examination followed by the Montreal Cognitive Assessment, each used 17 times and 15 times, respectively. The most frequently used acupoints were GV20, EX-HN1, GB20, and GV24, which accounted for 47% of total number of acupoints used. In 48% of the studies, needle retention time was 30 minutes. Western medicine treatment was the most common control group. Most studies reported that the intervention group was statistically significantly different to the control group. Conclusion: These results suggest that acupuncture for mild cognitive impairment was effective. However, it is difficult to confirm this conclusion because the quality of most of these studies were of low quality.

• Quality Improvement in Health Care
• /
• v.3 no.1
• /
• pp.78-93
• /
• 1996

Background : The goal of this study was to establish the QA items and guidelines for preventing and improving of safety management. Therefore we investigated the nurses' recognition and knowledge of the safety and risk procedures and policies, and the agreement between the nurses beliefs on the degree of importance of those procedures and policies, with actual implementation in hospitals. Method : The subjects of this study were 201 nurses who participated in a program called continuing education for nurses, which held in December, 1993. Result: The results of this study were as follows: 1. Among 18 types of hospital risks, the items that scored highest or the need of closer attention in safety management was the needle stick, medication errors, falling, and bed sores. 2. In most questions of the 18 incidences, the nurses showed that the estimated result would have positive signs except for hospital infections, burns, and bed sores. 3. Even though the survey shows that incidences and types of occurences varies according to the person's age and the time of incident, they mostly occur between midnight to 6AM. Falls and bed sores can be seen more in the elderly. Medications errors, hospital infections and burns are frequently found between the ages of one through twenty. 4. There was a higher mean score for recognizing the importance of those items than the importance of implementing them. Conclusion : In summary, nurses did perceive the need of safety management but the hospital policy for proper safety management was not established. So we recommended that the hospital administration would undertake an early detection and proper management system for hospital precautions, based on QA items & guidelines presented in this study.