• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.1
• /
• pp.174-179
• /
• 2013

This paper presents a capacitor loaded tunable bandpass chip filter using multiple split ring resonators (MSRRs) with two transmission zeros. To obtain high selectivity and minimize the chip size, asymmetric feed lines are adopted to make a pair of transmission zeros located on each side of passband. Compared with conventional filters using cross-coupling or source-load coupling techniques, the proposed filter uses only two resonators to achieve high selectivity through a pair of transmission zeros. In order to optimize selectivity and sensitivity (insertion loss) of the filter, the effect of the position of asymmetric feed line on transmission zeros and insertion loss is analyzed. The SOI-CMOS switched capacitor composed of metal-insulator-metal (MIM) capacitor and stacked-FETs is loaded at outer rings of MSRRs to tune passband frequency and handle high power signal up to +30 dBm. By turning on or off the gate of the transistors, the passband frequency can be shifted from 4GH to 5GHz. The proposed on-chip filter is implemented in 0.18-${\mu}m$ SOI CMOS technology that makes it possible to integrate high-Q passive devices and stacked-FETs. The designed filter shows miniaturized size of only $4mm{\times}2mm$ (i.e., $0.177{\lambda}g{\times}0.088{\lambda}g$), where ${\lambda}g$ denotes the guided wave length of the $50{\Omega}$ microstrip line at center frequency. The measured insertion loss (S21)is about 5.1dB and 6.9dB at 5.4GHz and 4.5GHz, respectively. The designed filter shows out-of-band rejection greater than 20dB at 500MHz offset from center frequency.

• Korean Journal of Optics and Photonics
• /
• v.15 no.4
• /
• pp.361-368
• /
• 2004

We separated the multilayer structure of CD-R(compact disk-recordable) and investigated optimal spot marking conditions and physical and chemical transitions in response to various laser beam energh levels. Spot marking(80 ${\mu}{\textrm}{m}$ spot size) was produced on the surface of each layer using a Q-switched Nd:YAG laser between 27 mJ and 373mJ. By investigating resulting pit formation with Optical Microscopy(OM) and Optical Coherence Tomography(OCT), we analyzed the formation process of spot marking in the multilayer structure of different chemical composition. The localized heating of the substrate in the multilayer thin film caused the short temporal thermal expansion, and absorbed optical energy between reflective and dye interfaces melted dye and increased the volume. During the cooling phase, formation of pit and surrounding rim can be explained by three distinct processes; effect of surface tension, evaporation by spontaneous temperature increase due to laser energy, and mass flow from the recoil pressure. Our results shows that the spot marking formation process in the multilayer thin film is closely related to the layers' physical, chemical, and optical properties, such as surface tension, melt viscosity, layer thickness, and chemical composition.

• Asian-Australasian Journal of Animal Sciences
• /
• v.24 no.11
• /
• pp.1552-1559
• /
• 2011

Real time PCR was used in this study to determine the effect of triticale dried distillers grains with solubles (TDDGS) as a replacement for grain or barley silage in finishing diets on the presence of six classical ruminal bacterial species (Succinivibrio dextrinosolvens, Selenomonas ruminantium, Streptococcus bovis, Megasphaera elsdenii, Prevotella ruminicola and Fibrobacter succinogenes) within the rumen contents of feedlot cattle. This study was divided into a step-wise adaptation experiment (112 days) that examined the effects of adaptation to diets containing increasing levels of TDDGS up to 30% (n = 4), a short-term experiment comparing animals (n = 16) fed control, 20%, 25% or 30% TDDGS diets over 28 days, and a rapid transition experiment (56 days) where animals (n = 4) were rapidly switched from a diet containing 30% TDDGS to a barley-based diet with no TDDGS. It was found that feeding TDDGS as replacement for barley grain (control vs. 20% TDDGS) decreased 16S rRNA copy numbers of starch-fermenting S. ruminantium and S. bovis (p<0.001 and p = 0.04, respectively), but did not alter 16S rRNA copy numbers of the other rumen bacteria. Furthermore, feeding TDDGS as a replacement barley silage (20% vs. 25% and 30% TDDGS) increased 16S rRNA copy numbers of S. ruminantium, M. elsdenii and F. succinogenes (p<0.001; p = 0.03 and p<0.001, respectively), but decreased (p<0.001) the 16S rRNA copy number of P. ruminicola. Upon removal of 30% TDDGS and return to the control diet, 16S rRNA copy numbers of S. ruminantium, M. elsdenii and F. succinogenes decreased (p = 0.01; p = 0.03 and p = 0.01, respectively), but S. dextrinosolvens and S. bovis increased (p = 0.04 and p = 0.009, respectively). The results suggest that replacement of TDDGS for grain reduces 16S rRNA copy numbers of starch-fermenting bacteria, whereas substitution for barley silage increases 16S rRNA copy numbers of bacteria involved in fibre digestion and the metabolism of lactic acid. This outcome supports the contention that the fibre in TDDGS is highly fermentable.

• Korean Journal of Optics and Photonics
• /
• v.5 no.1
• /
• pp.74-79
• /
• 1994

The characteristics of the type I and type II SHG in LiB305 crystals grown by TSSG method have been investigated using 1064 nm beam from a Q-switched Nd:YAG laser. The measured phase matching angles and angular acceptance bandwidths were $\theta_m=90^{\circ}, \phi_m=11.6^{\circ}$, <$\delta\theta_{int}L_{1/2}=3.3^{\circ}-cm^{1/2}, \theta\phi_{int}L=0.27^{\circ}-cm^{1/2}$ for type I SHG and $\theta_m=20^{\circ}, \phi_m=90^{\circ}$, TEX>$\delta\theta_{int}L_=0.65^{\circ}-cm, \theta\phi_{int}L^{1/2}=3.5^{\circ}-cm^{1/2}$ for type II SHG, respectively. Thp. type I NCPM temperature of 1064 nm beam was found to be $149^{\circ}C$ with the temperature bandwidth $\DeltaTL$of $4.8^{\circ}C-cm$. An energy conversion efficiency of about 1.8% with 2.6 mm thick LBO crystal at an incident power of TEX>$171 MW/\textrm{cm}^2$ was demonstrated. The measured $d_{32} was 0.74\pm0.05 pm/V$..

• Korean Journal of Optics and Photonics
• /
• v.10 no.2
• /
• pp.95-101
• /
• 1999

We have studied the 1.54$\mu\textrm{m}$ forward and backward stimulated Raman scattering (SRS) and stimulated Brillouin scattering (SRS) for various $CH_4$pressures by 1.06$\mu\textrm{m}$ Q-switched Nd:YAG laser pumping under a repetition rate of Hz in single pass. We obtained that the output of backward SRS was more efficient than that of the forward SRS. The output energy and conversion efficiency of forward and backward SRS were higher than those of SBS since SRS is a steady state, but SBS is a transient state. In a $CH_4$gas uncirculating system, the output energy of the backward SRS and SBS were reduced the about 47% due to a thermal heating of $CH_4$medium in a focusing region for a repetition rate of 5 Hz. But, the output energy of forward SRS was slightly enhanced by about 8.5% due to the increase of the undepleted pump beam in the backward SRS generation. Inthe Raman half resonator using a dichromatic focusing lens, the conversion efficiency of SRS was more than 37% for a input pump laser energy of 40 mJ.

• Journal of KIISE:Information Networking
• /
• v.30 no.4
• /
• pp.559-571
• /
• 2003

ENUM(tElephon NUmbering Mapping) is protocol that brings convergence between PSTN Networks and IP Networks using a unique worldwide E.164 telephone number as an identifier between different communication infrastructure. The mechanism provides a bridge between two completely different environments with E.164 number; IP based application services used in PSTN networks, and PSTN based application services used in IP networks. We propose a new way to organize and handle ENUM Tier 2 name servers to improve performance at the name resolution process in ENUM based application service. We build an ENUM based network model when NAPTR(Naming Authority PoinTeR) resource record is registered and managed by area code at the initial registration step. ENUM promises convenience and flexibility to both PSTN and IP users, yet there is no evidence how much patience is required when users decide to use ENUM instead of non-ENUM based applications. We have estimated ENUM response time, and proved how to improve performance up to 3 times when resources are managed by the proposed mechanism. The proposition of this thesis favorably influences users and helps to establish the policy for Tier 2 name server management.