• 디지털산업정보학회논문지
• /
• 제10권3호
• /
• pp.237-247
• /
• 2014

This paper describes a 2D discrete-time wavelet transform for which the Q-factor is easily specified. Hence, the transform can be tuned according to the oscillatory behavior of the image signal to which it is applied. The tunable Q-factor wavelet transform (TQWT) is a fully-discrete wavelet transform for which the Q-factor, Q, of the underlying wavelet and the asymptotic redundancy (over-sampling rate), r, of the transform are easily and independently specified. In particular, the specified parameters Q and r can be real-valued. Therefore, by tuning Q, the oscillatory behavior of the wavelet can be chosen to match the oscillatory behavior of the signal of interest, so as to enhance the sparsity of a sparse signal representation. The TQWT is well suited to fast algorithms for sparsity-based inverse problems because it is a Parseval frame, easily invertible, and can be efficiently implemented. The TQWT can also be used as an easily-invertible discrete approximation of the continuous wavelet transform. The transform is based on a real valued scaling factor (dilation-factor) and is implemented using a perfect reconstruction over-sampled filter bank with real-valued sampling factors. The transform is parameterized by its Q-factor and its oversampling rate (redundancy), with modest oversampling rates (e. g. 3-4 times overcomplete) being sufficient for the analysis/synthesis functions to be well localized. Therefore, This method services good performance in image processing fields.

• 대한전자공학회논문지SD
• /
• 제45권11호
• /
• pp.89-94
• /
• 2008

본 논문에서는 서브샘플링 기법을 이용한 직접변환 수신단에 이용할 수 있는 광대역 증폭기와 높은 Q-factor 값을 가지는 대역통과 필터(BPF) 회로를 0.18um CMOS 공정을 이용하여 구현하였다. 광대역 증폭기는 5.4GHz의 대역폭 및 12dB의 파워 이득 특성을 가지며, 대역통과필터는 2.4GHz Bluetooth 규격에서 동작할 수 있도록 설계하였다. RF 신호가 안테나를 통해 광대역 증폭기와 BPF를 통과한 후의 주파수응답 측정결과를 살펴보면, 2.34GHz에서 18.8dB의 파워이득파 31MHz의 대역폭을 갖는다. 이는 대역통과 필터의 Q-factor 값이 75로써 매우 높은 선택도(selectivity) 특성을 나타낸다. 또한, 전체 칩은 8.6dB의 noise-figure 특성과 대역폭 내에서 -12dB 이하의 입력 임피던스 매칭 (S11) 특성을 보이며, 전력소모는 1.8V 단일 전원전압으로부터 64.8mW 이고, 칩 면적은 $1.0{\times}1.0mm2$ 이다.

• Journal of electromagnetic engineering and science
• /
• 제2권2호
• /
• pp.124-127
• /
• 2002

A RF tunable bandpass filter using dielectric resonators and varactor diodes is redesigned to improve the passband flatness. Since the tunable liters are generally of narrow bandwidth and the Q value of the varactor diode is usually very low, the passband flatness is strongly deteriorated by sizeable distortion loss. To remedy this problem, we construct modified Chebyshev type filter by use of network synthesis techniques. The key of modified Chebyshev type filter is the rearrangement of the passband poles to improve the passband flatness. To maintain the constant passband bandwidth, design techniques of input/output stage and coupling windows are also applied. Experimental results show that the passband flatness can be improved by purposed method without any additional RF amplitude equalizer.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2000년도 전력전자학술대회 논문집
• /
• pp.417-420
• /
• 2000

In order to the torque control the indirect flux control was performed by controlling the ratio of e/f and the q-axis flux was estimated by the slip command and q-axis flux was estimated by the slip command and q-axis current in the rotor circuits. Also the frequency was controlled to keep on the q-axis flux to be zero and the constant torque characteristics could be obtained by generation the preset torque. In the induction motor driven by the boltage source inverter with the constant voltage and frequency the speed variation is expressed as a slip So the speed control can be achieved by slip compensation The slip was calculated with a q-flux current filtered by first-order filter and as the result the error problem which may occur in current detection was eliminated

• 항공우주기술
• /
• 제3권2호
• /
• pp.104-115
• /
• 2004

본 논문에서는 FTS 수신기(Receiver)의 기저대역(Baseband)부에 적용되어 신호에 포함되는 불필요한 잡음성분을 제거하기 위한 용도의 저역통과필터(Low-Pass Filter)와 톤(Tone)신호를 검출해 내기 위한 톤 필터로 적용 가능한 여러 종류의 필터에 대해 고찰하였고, 이를 바탕으로 Simulation을 통해 적용 가능성을 검토하였다. 서로 다른 형태의 필터는 각각의 목적과 용도에 따라 특성의 차이가 있으므로 어느 하나의 필터 특성이 좋다는 절대적인 기준은 없고 적용하려는 목적과 성능의 필요성에 따라 필터의 형태가 결정되는 상대적인 기준에 의해 결정되게 된다. 이에 따라 본 논문에서는 적용되는 부품 소자의 수를 줄여 무게의 경량화와 소형화를 얻으면서도 요구하는 성능을 만족시킬 수 있는 최적의 필터형태를 제시하였다.

• 한국정보통신학회논문지
• /
• 제15권10호
• /
• pp.2065-2071
• /
• 2011

본 논문에서는 마이크로스트립 선로 공진기와 입출력 단자의 결합 위치에 따른 공진기의 외적 양호도를 위상 특성을 이용하여 구하는 방법을 제시한다. 마이크로파 필터 설계에서 단자 접속 구조로 많이 이용되는 접합 선로 구조와 결합 선로 구조에 대해 단자의 위치와 선로의 폭과 간격에 따른 결과를 제시한다. 이 방법으로 정확한 $Q_e$ 값을 얻을 수 있었고, 이 결과는 결합공진기 필터 설계에 응용될 수 있다.

• 전자공학회논문지C
• /
• 제35C권8호
• /
• pp.42-51
• /
• 1998

An 8th-order elliptic low-pass filter with cutoff frequency of 3.13kHz is presented. The design procedure is based on teh 1/s impedance transformation which is applied to a minimum capacitor LC ladder network.The tranformed network is implemented with resistors and high Q frequency-dependent negative resistors (FDNR's). The high Q FDNR is realized with two transadmittance amplifiers. Detailed SPICE simulations show that the iflter has pass-band ripple of 0.18dB, stop-band attenuation over 100dB, cutoff frequency of 3.13 khz, and cutoff frequency temperature coefficient of 8.5ppm/.deg. C at supply voltage of .+-.5V.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 C
• /
• pp.2383-2385
• /
• 2005

In this paper we discuss the design and fabrication of two millimeter wave filters, in bandpass and bandstop topologies for wireless communications applications. The filters are made using a high Q MMIC transmission line, which consists of a 100 micrometers tall, surface micromachined, air filled inverted microstrip structure on a quartz substrate, made by using a JSR THB-151N negative photoresist sacrificial layer mold and electroplating technology. The filter topologies include a new, very compact, four pole, cross-coupled filter, that presents a single transmission zero at the lower side of the passband, which provides a very sharp out of passband rejection at this region.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2002년도 추계학술대회 논문집
• /
• pp.152-157
• /
• 2002

This paper describes the implementation of 3-phase 3-wire active power filter system with a instantaneous PSD for distorted and unbalanced power conditions. The positive sequence voltage of the distorted and the unbalanced power system Is calculated by the instantaneous PSD, and phase transformation matrix of the instantaneous power theory is achieved with detected positive sequence voltage. Finally, the proposed method is experimented and tested under unbalanced nonlinear load as well as unbalanced/distorted condition in power system.

• 전기학회논문지
• /
• 제57권11호
• /
• pp.2127-2130
• /
• 2008

In this paper, a tunable bandpass filter with mutual inductive coupling circuits is newly designed and demonstrated for UHF TV tuner ranged from Ch.14(473MHz) to Ch.69(803MHz) applications. Conventional HF tuning circuit with an electromagnetic bandpass filter has several problems such as large size, high volume and high cost, since the electromagnetic filter is comprised of several passive components and air core inductors to be assembled and controlled manually. To address these obstacles, peaking chip inductor was newly applied for constructing the mutual inductive coupling circuit. The proposed circuit was newly and optimally designed, since the chip inductor showed lower components Q-value than the air core inductor. A varactor diode has been also used to fabricate the proposed tunable bandpass filter for RF tuning circuit. The fabricated tunable filter exhibited low insertion loss of approximately -3dB, high return loss of below -10dB, and large tuning bandwidth of 330MHz.