• Journal of IKEEE
• /
• v.24 no.3
• /
• pp.814-820
• /
• 2020

In the M-ary DCSK system up to now, as M increases, the distance between constellation signal points becomes closer and performance deteriorates. we propose a hybrid modulation scheme based on PPM and DCSK to improve the BER performance. one part of the bit is modulated by the PPM and the other part by DCSK. Thus, the information bearing signal is modulated simultaneously according to the selected pulse position of the PPM determined by the information bit and the additional information bit. The analytical BER performance of the proposed plan is derived and verified by simulation. The results show that the proposed scheme outperforms conventional M-DCSK, code index modulation DCSK and rectified code index DCSK in additional white Gaussian noise and multipath Rayleigh fading channels.

• Journal of Convergence for Information Technology
• /
• v.9 no.5
• /
• pp.125-129
• /
• 2019

This paper describes the jamming effect of phase-coded pulse compression(PCPC) radar. Barker code radar, a typical PCPC radar, separates transmission pulses into 13 or 31 small pulses and phase modulates and transmits each pulse signal to increase radar detection efficiency and reduce the influence of jamming. Generally, when the radar is subjected to jamming, the detection distance becomes shorter and the detection error rate becomes higher. In the case of noise jamming or carrier jamming on the PCPC radar, the jamming effect is very small for no phase-coded convergence. However, the jamming effect is large in the case of synchronous jamming using the pulse-coded signal as a jamming signal with DRFM. It can be seen that the jamming effect increases when the storage time of the pulse-coded signal is prolonged. This study is considered to be useful for PCPC radar and EW jamming system design.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1995.06a
• /
• pp.76-80
• /
• 1995

Differential pulse code modulation 구조의 Line spectrum pairs 양자화기에 높은 차수 LSP 파라미터 값은 낮은 차수 LSP 파라미터 값보다 커야한다는 LSP 파라미터의 순서화 특징을 이용하여 양자화하는 방법을 제시한다. 31 비트/프레임에서 1 dB 이하의 스펙트럴 왜곡을 갖는 명료한 음질을 보였다. 또한 LSP 주파수의 순서화 특성은 벡터-스칼라 결합 양자화기에 적용하였다. 벡터-스칼라 결합 양자화기에서는 26비트/프레임에서 명료한 음질을 보였다. 새로운 LSP 양자화 방법들은 전송에러 발생시 성능을 시험하고, 전송 에러에 강인하도록 프레임간 예측을 위해 Moving Average 예측기를 사용한다.

• Transactions of The Korea Fluid Power Systems Society
• /
• v.8 no.1
• /
• pp.19-25
• /
• 2011

This study presents the design of digital amplifier.controller for a proportional control valve and the development of PID discrete control scheme by using RCP(Rapid Controller Prototyping) system. RCP system is the device to embed the control code developed in PC into the microcontroller on-site. Ramp input test using the digital amplifier.controller developed in this study was carried out for the proportional control valve of domestic production and Bosch Rexroth respectively. The instability problem occurred around maximum displacement of localized valve spool at ramp input test was solved by supplementing offset current to the duty ratio of PWM(Pulse Width Modulation) driving signal to the solenoid. The comparison of test results between localized proportional control valve and Bosch Rexroth's product shows that the characteristics obtained by ramp input test and static flow gains are alike each other. Two valves are about the same in dead bands and hysteresis characteristics.

• 한국정보통신설비학회:학술대회논문집
• /
• 2009.08a
• /
• pp.314-319
• /
• 2009

In this paper, the network performance of a turbo coded optical code division multiple access (COMA) system with cross-layer, which is between physical and network layers, concept is analyzed and simulated We consider physical and MAC layers in a cross-layer concept. An intensity-modulated/direct-detection (IM/DD) optical system employing pulse position modulation (PPM) is considered In order to increase the system performance, turbo codes composed of parallel concatenated convolutional codes (PCCCs) is utilized. The network performance is evaluated in terms of bit error probability (BEP). From the simulation results, it is demonstrated that turbo coding offers considerable coding gain with reasonable encoding and decoding complexity. Also, it is confirmed that the performance of such an optical COMA network can be substantially improved by increasing the interleaver length and the number of iterations in the decoding process. The results of this paper can be applied to implement the indoor optical wireless LANs.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37C no.10
• /
• pp.859-869
• /
• 2012

In this paper, a new method to efficiently generate the 3-D(three-dimensional) video holograms for 3-D moving scenes, which is called here the TSR-N-LUT method, is proposed by the combined use of temporal-spatial redundancy(TSR) of 3-D video images and novel look-up table(N-LUT) technique. That is, in the proposed scheme, with the differential pulse code modulation (DPCM) algorithm, temporally redundancy redundant data in the inter-frame of a 3-D video images are removed between the frames, and then inter-line redundant data in the inter-frame of 3-D video images are also removed by using the DPCM method between the lines. Experimental results show that the proposed method could reduced the number of calculated object points and the calculation time of one object point by 23.72% and 19.55%, respectively on the average compared to the conventional method. Good experimental results with 3-D test moving pictures finally confirmed the feasibility of the proposed method to the fast generation of CGH patterns of the 3-D video images.

• Journal of Advanced Navigation Technology
• /
• v.23 no.5
• /
• pp.452-459
• /
• 2019

In this paper, we describe a PCM encoder structure that can update the telemetry system parameters in real time. In the PCM encoder, an analog signal control unit for FPGA, flash memory, and sensor data acquisition was constructed. UART communication, analog signal control, flash memory control, and frame generation are possible through logic inside FPGA of PCM encoder. UART communication allows the PC to transmit parameter data to the PCM encoder, and flash memory is controlled to update the parameter of the telemetry system in real time and finally the frame is formed. Simulation and verification were performed to confirm whether the parameter data is updated in real time, and the proposed structure was used to construct a telemetry system with enhanced flexibility and convenience.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.7
• /
• pp.423-429
• /
• 2019

Recently, a variety of methods for the performance improvement of ultra-high speed wideband wireless transmission systems have been suggested. This paper proposes a space-frequency (SF) block coded single side band (SSB) single carrier (SC)-frequency division multiple access (FDMA) transmission system. In the proposed SSB SC-FDMA system, SF block code is implemented with the complex conjugates, which are formed from discrete Fourier transform (DFT) spreading of pulse amplitude modulation (PAM) signals. As a result, transmit diversity gain can be obtained in the proposed SF block coded SSB SC-FDMA system without any significant increase of the system computational complexity. The simulation result shows that the signal-to-noise power ratio (SNR) performance of the proposed SF block coded SSB SC-FDMA system is approximately 4 dB better than the SNR performance of the conventional SSB SC-FDMA system with single transmit antenna at a symbol error rate (SER) of $10^{-2}$.

• The Journal of the Acoustical Society of Korea
• /
• v.6 no.3
• /
• pp.52-59
• /
• 1987

In this paper, we present a method of realizing an infinite impulse response (IIR) digital filter (DF)using linear delta modulation (LDM) as a simple analog/digital (A/D) converter. This method makes the realization of IIR digital filters much simpler than that of conventional ones because it does not require hardware multipliers and a pulse code modulation (PCM) A/D converter. Compared to the finite impulse respponse (FIR) LDMDF of Lee and Un [1] , this IIR LDMDF requires significantly less computation time.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.6
• /
• pp.937-943
• /
• 1990

In this paper, a subband coding scheme using the human visual system(HVS) model for encoding monochrome images is proposed to produce perceptually higher quality images compared with the regular subband coding scheme. The proposed approach first transforms the intensity image to the density image by a point nonlinear transformation. A frequency band dexomposition of the density image is carried out by means of 2-D seaprable quadrature mirror filters, which split the density image spectrum into 16 equall rate subbands. Bits are allocated among the subbands to minimize the weighted mean squar error (WMSE) for differential pulse code modulation(DPCM) coding of the subbands. The weight for each subband is calculated from the modulation transfer function (MTF) of the HVS model at corresponding frequencies. The performances of the proposed approach are evaluated for 256 * 256 monochrome images at the bit rates of 0.5, 0.75 and 1.0 bita per pixel. Computer simulation results indicate that using the HVS model yields more pleasing reconstructed images than regular subband coding approach which does not use HVS model.