• The Journal of the Korea institute of electronic communication sciences
• /
• v.18 no.5
• /
• pp.817-826
• /
• 2023

In this paper, a fault determination methodology based on an artificial neural network was proposed to protect the system from faults on the lines in the smart grid distribution system. In the proposed methodology, first, it was designed to determine whether there is a low impedance line fault (LIF) based on the magnitude of the current RMS value, and if it is determined to be a normal current, it was designed to determine whether a high impedance ground fault (HIF) is present using Normal/HIF classifier based on artificial neural network. Among repetitive DSP module-based algorithm verification tests, the normal/HIF classifier recognized the current waveform as normal and did not show reclosing operation for the cases of normal state current waveform simulation test where the RMS value was smaller than the minimum operating current value. On the other hand, for the cases of LIF where RMS value is greater than the minimum operating current value, the validity of the proposed methodology could be confirmed by immediately recognizing it as a fault state and showing reclosing operation according to the prescribed procedure.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.16 no.4
• /
• pp.108-116
• /
• 2002

This paper presents the measurements and evaluation of voltage waveforms due to human electrostatic discharge(ESD). The principle of operation and design rule of a new device for measuring the ESD fast transient voltages with very fast rise time were described. Peak values and rise time of ESD voltages derived from a charged human body under a variety of experimental conditions were examined. The frequency bandwidth of the proposed voltage measuring system ranges from DC to 400[㎒]. The ESD voltage waveform is nearly equal to the ESD current waveform and the peak amplitude of ESD current waveform is roughly proportional to the ESD voltage in each experimental conditions. A rapid approach results in a discharge voltage with a faster initial rise time than for a slow approach. The voltages caused by direct finger ESDs have an initial slope with a relatively long, 10∼30[ns] rise time, but the amplitude is small. On the other hand, the voltages caused by direct hand/metal ESDs have a steep initial s1ope with 1 ∼3[ns] rise time, but an initial spike is very big. As a consequence, it was found that the ESD voltage and current waveforms strongly depend on the approach speed and material of intruder. These measurement results would be useful to design the ESD protective devices.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.409-409
• /
• 2014

Recently hexagonal boron nitride (h-BN), III-V compound of boron and nitrogen with strong covalent $sp^2$ bond, is a 2 dimensional insulating material with a large direct band gap up to 6 eV. Its outstanding properties such as strong mechanical strength, high thermal conductivity, and chemical stability have been reported to be similar or superior to graphene. Because of these excellent properties, h-BN can potentially be used for variety of applications such as dielectric layer, deep UV optoelectronic device, and protective transparent substrate. Ultra flat and charge impurity-free surface of h-BN is also an ideal substrate to maintain electrical properties of 2 dimensional materials such as graphene. To synthesize a single or a few layered h-BN, chemical vapor deposition method (CVD) has been widely used by using an ammonia borane as a precursor. Ammonia borane decomposes into hydrogen (gas), monomeric aminoborane (solid), and borazine (gas) that is used for growing h-BN layer. However, very active monomeric aminoborane forms polymeric aminoborane nanoparticles that are white non-crystalline BN nanoparticles of 50~100 nm in diameter. The presence of these BN nanoparticles following the synthesis has been hampering the implementation of h-BN to various applications. Therefore, it is quite important to grow a clean and high quality h-BN layer free of BN particles without having to introduce complicated process steps. We have demonstrated a synthesis of a high quality h-BN monolayer free of BN nanoparticles in wafer-scale size of $7{\times}7cm^2$ by using CVD method incorporating a simple filter system. The measured results have shown that the filter can effectively remove BN nanoparticles by restricting them from reaching to Cu substrate. Layer thickness of about 0.48 nm measured by AFM, a Raman shift of $1,371{\sim}1,372cm^{-1}$ measured by micro Raman spectroscopy along with optical band gap of 6.06 eV estimated from UV-Vis Spectrophotometer confirm the formation of monolayer h-BN. Quantitative XPS analysis for the ratio of boron and nitrogen and CS-corrected HRTEM image of atomic resolution hexagonal lattices indicate a high quality stoichiometric h-BN. The method presented here provides a promising technique for the synthesis of high quality monolayer h-BN free of BN nanoparticles.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.11
• /
• pp.5879-5884
• /
• 2013

With the rapid industrialization and economical development, the electricity demands of the industrial facilities and densely populated large cities are continuing to increase in Korea. The increase in the power consumption requires the extension of power facilities, but it is difficult to secure spaces for equipment installation in the limited space of urban areas. In addition, the 154 kV or 345 kV transmission systems in Korea has a short transmission distance, and are connected to one another in network structures that ensure the high reliability and stability of power supply. This structure reduces the impedance during the fault in power system, and increases the magnitude of in the short circuit fault current. The superconducting fault current limiter (SFCL) was devised to effectively address these existing problems. The SFCL is a new-concept eco-friendly protective device that ensures fast operation and recovery time for the fault current and does not need additional fault detection devices. Therefore, many studies are being conducted around the world. In this paper, based on the wiring method the initial fault current characteristics, current limiting characteristics, according to the incident angle and the change in inductance current limiting characteristics were analyzed in a multifaceted methods.

• Journal of radiological science and technology
• /
• v.38 no.4
• /
• pp.331-336
• /
• 2015

Medical electrical equipment - Part 1: General requirement for basic safety and essential performance of MFDS was revised as 3th edition and Medical electrical equipment Part 2-54: Particular requirements for the basic safety and essential performance of X-ray equipment will be expected to be announced as notification. Therefore this technical report was written to introduce provision of the particular requirements, replacement, addition, amendment. The purpose of this particular requirements is to secure requirements for basic safety and essential performance of X-ray equipment for radiography and radioscopy. X-ray high voltage generator, mechanical protective device, protection against radiation is included in this particular requirements. Medical electrical equipment - Part 1, Part 1-2, Part 1-3 is applied to this particular requirements. If the requirements is announced as notification, It is expected to widen understanding for basic safety and essential performance of X-ray equipment for radiography and radioscopy and play a part to internationalize of medical equipments.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.44 no.2
• /
• pp.111-116
• /
• 2018

In cosmetics market, anti-pollution products recently come up with new solution for skin health. Environmental oxidation mechanisms are realized as bio-marker of atmospheric pollution upon skin by environmental pollutant such as ozone, UV rays, particulate matter (PM) as well as cigarette smoke. The exposure of cigarette smoke directly or indirectly causes the oxidation of the stratum corneum skin lipids, resulting in the conversion of squalene to squalene monohydroperoxide and/or generation of malondialdehyde (MDA) as a product of lipid peroxidation. The aim of this study is to see whether new cosmetics product containing red beet has anti-oxidation effect on skin exposed by cigarette smoke. So as to determine oxidative damage to human skin at biochemical level, each unit area of volar forearms was exposed to cigarette smoke through device (3.3 cm, diameter) for fifteen minutes, then measured MDA using standardized TBARS assay kit. Compared to negative control (untreated and unexposed area), the level of MDA was significantly increased at positive control (untreated and exposed area) more than 3.7 times, indicating the pollutant induced-oxidative damage on the skin barrier. Whereas, the pre-applied area with the cosmetics products containing red beet revealed a decrease of 25% compared with positive control. As reports, these data demonstrated that cigarette smoke induce peroxidation of stratum corneum skin lipids. Conclusively, we suggest that anti-pollution effect of the cosmetics product containing red beet is beneficial to prevent the oxidation of skin lipids by atmospheric pollution.

• Journal of agricultural medicine and community health
• /
• v.34 no.2
• /
• pp.202-213
• /
• 2009

Objectives: The aim of this study was to compare health related behaviors among adolescents in the rural area with those in the urban area in Korea. Methods: The data source was the Korea Youth Risk Behavior Web-based Survey in 2005. With two stage cluster sampling, a total of 58,224 sample was selected from 799 middle and high schools nationwide. The area was classified into county area, small to medium city, and large city, and then the county area was considered as a rural area. Data was analyzed with STATA 9.0 using the method of complex survey data analysis considering sampling weight, strata, and primary sampling unit. Results: The prevalence of health related behaviors among adolescents in the rural area was higher than the city area as following health behaviors: smoking behaviors of smoking experience, smoking experience before entrance to middle school; drinking behaviors of frequent drinking, high risk behaviors with drinking; dietary behaviors of omitting of lunch or dinner, less intake of fruits or milk, more intake of cooky; oral hygiene of less tooth brushing, less preventive oral care, more oral symptoms and less dentist visit; safety behaviors of less wearing of safety belt or protective device; general hygiene of less hand washing before meal or after visiting rest room. Conclusions: The health behaviors among adolescents in the rural area were generally poorer than the city area. The results showed national health program for adolescents should be conducted primarily for those in rural areas. Further study is needed to explore the factors related with the discrepancy of health behaviors between the rural and urban area.

• The Korean Journal of Emergency Medical Services
• /
• v.12 no.3
• /
• pp.99-113
• /
• 2008

In order to protect Rescue 119 workers exposed on the spot from potential infection, this study identified their awareness and practices of infection control so that it could help preventing them from infection and also provide basic materials necessary for pre-hospital infection control. This study applied questionnaire survey to total 215 Rescue 119 workers at fire stations in Jeonbuk province, Jeonnam province and Gwangju city from July 14 to Sept. 14, 2006 for the benefit of data collection. The questionnaire about possible associations between awareness and practices of infection control consisted of total 46 times across 6 categories such as washing hands during emergency activities ; fluid therapy and injection ; respirator maintenance; individual hygienics ; disinfectant supplies and equipments maintenance ; and control of infectious wastes. And collected data were processed using SPSS statistic program to analyze frequency and percentage, mean and standard deviation, Pearson's correlation coefficient, t-test and one-way ANOVA. As a result, this study came to the following conclusions : In terms of awareness about infection control, our respondents showed highest awareness about infectious waste control, and also showed highest level of practices in washing hands during emergency activities. Throughout all domains, awareness means were higher than practice means. In particular, infectious waste control was the domain of significant differences between awareness and practices. In terms of associations between awareness and individual characteristics, it was found that female rescue worker group and hospital/general hospital career group (before joining the Rescue 119) showed significantly higher awareness on statistic level. In regard to associations between individual characteristics and practices, it was found that female rescue worker group showed higher level of practices than male group on statistic level. This study also analyzed correlations between rescue workers' awareness and practice of infection control. As a result, it was found that the higher awareness was in correlations with the higher practices across all 6 domains including washing hands. In addition, the higher awareness of a questionnaire item was in significantly positive correlations with the higher practice of other items. However, our respondents showed high awareness about anti-infection, but low practices in reality. This indicates necessity of devising possible solutions to improve the practices as much as awareness. Especially, it was noted that major reasons for insufficient practices of infection control guideline come from unhabituated practices and lack of supports for infection-preventing supplies and protective device (mask, etc). Hence, it is necessary to provide more infection-preventing supplies for local rescue workers sufficiently, in parallel with steady habituation of infection control. Furthermore, it is required to manage and study infection control policies even at pre-hospital step in efforts for effective infection control, education and activities.

• Journal of Korean Neurosurgical Society
• /
• v.38 no.3
• /
• pp.215-220
• /
• 2005

Objective : Many researchers believe that the hypothermia shows neuro-protective effect on brain injury. To understand the molecular mechanism of the hypothermic treatment, this study investigated its effects on the expression of cell death or survival related proteins such as p53, Bcl-2 and Bax in the rat traumatic brain injury[TBI] model. Methods : Twenty rats [Spraque Dawley, $200{\sim}250g$] were subjected to the brain injury of moderate severity [$2.4{\sim}2.6atm$] using the fluid percussion injury device and five rats were received only same surgery as controls. During 30minutes after the brain injury, the hypothermia group was maintained the body temperature around $34^{\circ}C$ while the control group were maintained that of $36^{\circ}C$. Five rats in each group were sacrificed 12h or 24h after brain injury and their brain sections was analyzed for physical damages by H-E stains and the extent of apoptosis by TUNEL assay and immunohistochemical stains. The tissue damage after TBI was mainly observed in the ipsilateral cortex and partly in the hippocampus. Results : Apoptosis was observed by TUNEL assay and the Bax protein was detected in both sample which harvested 12h and 24h after TBI. In the hypothermia treatment group, tissue damage and apoptosis were reduced in HE stains and TUNEL assay. In hypothermia treatment group rat shows more expression of the Bcl-2 protein and shows less expression of the Bax protein, at both 12h and 24h after TBI. Conclusion : These results show that the hypothermia treatment is an effective treatment after TBI, by reducing the apoptotic process. Therefore, it could be suggested that hypothermia has a high therapeutic value for treating tissue damages after TBI.

• Journal of the Korea Institute of Construction Safety
• /
• v.1 no.1
• /
• pp.31-39
• /
• 2018

It is reported that about 20 % of all fires in Korea are caused by the electric equipment and installations. In complex and large-scale buildings, the sizes of electric fires are becoming larger as property damage and casualties increase. Among the causes of various electric fires, fire by short circuit accounts for about 71.5% of overall fires, and in the classification by electric equipment and installation, fire caused by wiring and wiring equipment accounts for approximately 38.3% of overall fires. The purpose of this study is to propose methods to prevent electric fires due to short circuit by improving indoor wiring currently in use and to find the fundamental measures to prevent wiring equipment caused fires by improving the socket and plug which are commonly used in wiring equipment. It is expected that the electric fire prevention measures presented through this study can be used as a measure to protect many people and properties by eliminating the root cause of electric fire.