• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.42 no.5
• /
• pp.430-436
• /
• 2014

The mission objective of STEP Cube Lab. (Cube Laboratory for Space Technology Experimental Project) classified as a pico-class satellite is to verify the technical effectiveness of payloads such as variable emittance radiator, SMA washer, oscillating heat pipe and MEMS based solid propellant thruster researched at domestic universities. In addition, the MEMS concentrating photovoltaic power system and the non-explosive holding and separation mechanism with the advantages of high constraint force and low shock level will be developed as the primary payloads for on-orbit verification. In this study, the feasibility of the mission actualization has been confirmed by the preliminary system design.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.8
• /
• pp.37-51
• /
• 2013

An energy pile encases heat exchange pipes to exchange thermal energy with the surrounding ground formation by circulating working fluid through the pipes. An energy pile has many advantages in terms of economic feasibility and constructability over conventional Ground Heat Exchangers (GHEXs). In this paper, a coil-type PHC energy pile was constructed in a test bed and its thermal performance was experimentally and numerically evaluated to make a preliminary design. An in-situ thermal response test (TRT) was performed on the coil-type PHC energy pile and its results were compared with the solid cylinder source model presented by Man et al. (2010). In addition, a CFD numerical analysis using FLUNET was carried out to back-analyze the thermal conductivity of the ground formation from the Ttype PHC energy RT result. To study effects of a coil pitch of the coil-type heat exchange pipe, a thermal interference between the heat exchange pipes in PHC energy piles was parametrically studied by performing the CFD numerical analysis, then the effect of the coil pitch on thermal performance and efficiency of heat exchange were evaluated. Finally, an equivalent heat exchange efficiency factor for the coil-type PHC energy pile in comparison with a common multiple U-type PHC energy pile was obtained to facilitate a preliminary design method for the coil-type PHC energy pile by adopting the PILESIM2 program.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.47 no.3
• /
• pp.22-30
• /
• 2019

The demand for National Woodland Burial Grounds is expected to increase as interest in natural burial, including woodland burial, is increasing. This study was performed to provide evaluation criteria applying weighting factors to the evaluation for location selection. Through literature review, location selection evaluation factors for forest facilities, similar to forest welfare facilities, were reviewed and analyzed. As a result of the analysis, 74 preliminary evaluation criteria were selected. Based on the results, three expert groups (public servants in central and local governments and other public agencies in charge of forest welfare facility, related field researchers, and civil experts) reviewed the preliminary evaluation factors. Evaluation factors were classified into two categories, 6 sub-categories, and 22 segments. The selected evaluation factors were layered for the second preference survey. They were classified into Forest Environment and Human Environment, and those categories were further classified into three categories. Then they were further classified into segments. After segmentation, the experts who participated in the first survey checked the differences in the significance of the layered factors by utilizing AHP. The site evaluation criteria table was prepared using the evaluation criteria and the significance of each layer. In order to apply it to the candidate sites, 10 sites including the existing National Woodland Burial Grounds and 9 candidate sites considered in the previous studies were compared and analyzed including Ulju County Ulsan City, Suncheon City Jeollanam-do and Janggun-myeon Sejeong City.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.49 no.10
• /
• pp.202-208
• /
• 2012

Fetal heart rate monitoring is important information to assess fetal well-being. Non-invasive fetal ECG (electrocardiography) can be derived from maternal abdominal signal. And various promising signal processing methods have been introduced to extract fetal ECG from mother's composite abdominal signal. However, non-invasive fetal ECG monitoring still has not been widely used in clinical practice due to insufficient reliable measurement and difficulty of signal processing. In application of signal processing method to extract fetal ECG, it might be lower signal to noise ratio due to time varying white Gaussian noise. In this paper, time varying Kalman smoother is proposed to remove white noise in fetal ECG and its feasibility is confirmed. Wiener process was set as Kalman system model and covariance matrix was modified according to white Gaussian noise level. Modified error covariance matrix changed Kalman gain and degree of smoothness. Optimal covariance matrix according to various amplitude in Gaussian white noise was extracted by 5 channel fetal ECG model, and feasibility of proposed method could be confirmed.

• The Korean Journal of Rehabilitation Nursing
• /
• v.6 no.1
• /
• pp.79-89
• /
• 2003

Purpose: This research with one group pre-post design was carried out to test the practical feasibility to administrate the Music Movement program developed for the stroke patients. Subjects: 12 stroke survivors at "J" Public Health Center in Seoul. were participated in. The average age was 68 years old, the ratio of sex was almost 5.8:4.2, the duration of was almost over 1 year. Method: Music Movement program was conducted for 2 hours ${\times}$ 1day ${\times}$ 6 weeks. The contents of Music Movement program were consisted of the preparatory activities, main activities and the wrap up activities. The preparatory activities are ice braking, greeting, explanation of the aims of music movement program, and introduction of stroke disease and ROM exercise. The main activities are the body motions with singing and playing musical instruments. The wrap up activities are stretching and joints and discussion of home activities. Data Collection: The outcome variables are muscle strength, finger pinch power, ROMs, flexibility, depression, and life satisfaction. Depression was measured by CES-D(Kim, I. J., 1999), life satisfaction by ladder scale(McDowell & Newell, 1996), and ADL state(Holbrook & Skilbeck, 1983). Data Analysis: SPSS/PC 10.0 for Window was used. Wilcoxon Signed Ranks Test was used to analyze outcome measures. The level of statistical significance was set at p<.05. Results: This program was effective to decrease the depression level of subjects(p<.05). The muscle strength, hand grip power, ROMs, life satisfaction, and rehabilitation state of the subjects were slightly increased but no significant differences were found between the pre and post test. Additionally every patient replied that they were very satisfied and expressed their appreciation for this program very much. Of course they strongly want to continue to participate in and meet the peer group again. Conclusion: Considering these results, the practical feasibility of Music Movement program can be supported. Therefore, this Music Movement program can be examined with the quasi-experimental design with control group and ongoing reviews. After that, this program would be applied in public health centers, medical institutes, and welfare centers for the rehabilitation of stroke patients.

• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.2
• /
• pp.84-95
• /
• 2014

Recently, as a variety of techniques of CMF (Compressed media filter) that has advantages of high porosity and compressibility have been developed in the U.S. and Japan. Therefore, the interest of intensive wastewater treatment using CMF has grown. This study examined the feasibility of CMF with varying sewage water quality to determine the optimum operating conditions. A preliminary tracer test that investigated the filtering process under various compression and flow rate conditions was performed. In a high compression condition, different porosities were applied to each depth of the column. Therefore, a distinct difference between a theoretical value and results of tracer test was observed. For the TSS (Total suspended solid) removal and particle size distribution of CMF for pre-treatment water under the various compression conditions, the compression ratio of 30 percent as the optimal condition showed greater than 70% removal efficiency. In addition, the compression ratio of >15% was required to remove small-sized particles. Also, an additional process such as coagulation is necessary to increase the removal efficiency for < $10{\mu}m$ particles, since these small particles significantly influence the effluent concentration. Modeling results showed that as the compression rate was increased, TSS removal efficiency in accordance with each particle size in the initial filtration was noticeably observed. The modeling results according to the depth of column targeting $10{\mu}m$ particles having the largest percentage in particle size distribution showed that 150-300 mm in filter media layer was the most active with respect to the filtering.

• Radiation Oncology Journal
• /
• v.21 no.2
• /
• pp.158-166
• /
• 2003

Purpose: To propose a conceptual design of a novel source for intensity modulated brachytherapy. Materials and Methods: The source design incorporates both radioactive and shielding materials (stainless steel or tungsten), to provide an asymmetric dose intensity in the azimuthal direction. The intensity modulated intravascular brachytherapy was performed by combining a series of dwell positions and times, distributed along the azimuthal coordinates. Two simple designs for the beta-emitting sources, with similar physical dimensions to a $^{90}Sr/Y$ Novoste Beat-Cath source, were considered in the dosimetric feasibility study. In the first design, the radioactive and materials each occupy half of the cylinder and in the second, the radioactive material occupies only a quater of the cylinder. The radial and azimuthal dose distributions around each source were calculated using the MCNP Monte Carlo code. Results: The preliminary hypothetical simulation and optimization results demonstrated the 87$\%$ difference between the maximum and minimum doses to the lumen wall, due to off-centering of the radiation source, could be reduced to less than 7$\%$ by optimizing the azimuthal dwell positions and times of the partially shielded intravascular brachytherapy sources. Conclusion: The novel brachytherapy source design, and conceptual source delivery system, proposed in this study show promising dosimetric characteristics for the realization of intensity modulated brachytherapy in intravascular treatment. Further development of this concept will center on building a delivery system that can precisely control the angular motion of a radiation source in a small-diameter catheter.

• Korean Journal of Otorhinolaryngology-Head and Neck Surgery
• /
• v.61 no.11
• /
• pp.573-579
• /
• 2018

Background and Objectives Cochlear dead region (CDR) is a region in the cochlear where hearing loss has occurred due to damage to the inner hair cells and/or neurons. Recently, a subjective test involving a pure-tone test in the presence of threshold-equalizing noise (TEN) was introduced to identify CDR. However, for uncooperative patients, such a subjective method would be unsuitable and objective methods would be needed instead to detect CDR. The acoustic change complex (ACC) is an evoked potential elicited by changes in the ongoing sound. In this study, we developed an objective method of identifying CDR by combining ACC response with a TEN test, namely the TEN-ACC test, and investigated its feasibility in normal-hearing listeners. Subjects and Method Ten normal-hearing subjects participated in this study. All subjects underwent both behavioral TEN test and electrophysiological TEN-ACC test. The stimuli for the TEN-ACC test consisted of TEN and embedded pure tones with different frequencies/signals to noise ratios (SNRs). To identify the thresholds, the range SNR of stimulation was varied from 0 to 20 dB, in stages of 4 dB. Results The ACC responses of all subjects who participated in this study were well elicited by stimuli developed for the TEN-ACC test. We confirm that the pure-tones embedded in TEN elicited the objective ACC response. Conclusion The results of this study suggest that the novel TEN-ACC test can be applied to evoke ACC in normal-hearing listeners. Future research should incorporate hearing-impaired listeners to determine the feasibility of the TEN-ACC test as an objective method to identify CDR.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.13 no.2
• /
• pp.156-163
• /
• 2008

Luminescent bacterial toxicity test was first introduced in the early 1980s, registered as international standard method in 1998 and now widely used as a common toxicity test method. This toxicity test uses luminescent bacterium, Vibrio fischeri, originated from marine environment as a test organism. The degree of toxicity can be evaluated from the comparison of luminescent emission intensity between control and treatment groups to toxicants and materials from various environmental matrix for 30 min. This test can be carried out by using commercial products and its results are sensitive and precise. This research is on the feasibility of adopting luminescent bacterial test as a domestic standard test protocol. Using commercial products, a series of experiments were conducted to identify the precision and accuracy of injection volume and light emission, and to evaluate concentration-response relationship between chemical concentrations and light emissions. Also, the feasibility of the application to environmental media and quality assurance/quality control were checked. The results of serial toxicity tests revealed that the preliminary luminescent bacterial toxicity test was robust and suitable as a standard method.

• Asian-Australasian Journal of Animal Sciences
• /
• v.20 no.8
• /
• pp.1243-1251
• /
• 2007

This study was conducted to evaluate the feasibility of using L. reuteri Pg4, a strain isolated from the gastrointestinal (GI) tract of healthy broilers, as a probiotic. In preliminary in vitro studies the Pg4 strain was proven capable of tolerating acid and bile salts, inhibiting pathogenic bacteria and can adhere to intestinal epithelial cells. The probiotic properties were then evaluated on the basis of the broiler's growth performance, intestinal microbial population and cecal volatile fatty acid and lactic acid concentrations under conventional feeding. Dietary supplementation of dried L. reuteri Pg4 decreased significantly feed intake in grower chickens and improved significantly the feed conversion by 5% in a 0-6 weeks feeding period compared with the control group. The Lactobacillus counts in the crop, ileum, and cecum of the probiotic group were higher than in the control group. The L. reuteri Pg4 strain was traceable in the GI tract of probiotic supplemented chicks and showed capability of survival in the intestine for a protracted period. The probiotic group had a higher lactic acid concentration and lower pH value in the cecum than the control chicks. Probiotic supplement also affected the histology of the intestinal mucosa of chicks. The present findings demonstrated that L. reuteri Pg4 possesses probiotic characteristics and it is suggested, therefore, that the organism could be a candidate for a new probiotic strain.