• Journal of Satellite, Information and Communications
• /
• v.10 no.4
• /
• pp.1-5
• /
• 2015

The ESD(electrostatic discharge) protection performance of PPS(PMOS pass structure) embedded N-type silicon controlled rectifier(NSCR_PPS) device with different partial p-well(PPW) structure was discussed for high voltage I/O applications. A conventional NSCR_PPS standard device shows typical SCR-like characteristics with low on-resistance, low snapback holding voltage and low thermal breakdown voltage, which may cause latch-up problem during normal operation. However, our proposed NSCR_PPS devices with modified PPW_PGM(primary gate middle) and optimal CPS(counter pocket source) implant demonstrate the stable ESD protection performance with high latch-up immunity.

• Journal of Satellite, Information and Communications
• /
• v.8 no.4
• /
• pp.124-129
• /
• 2013

An electrostatic discharge (ESD) protection device, so called, N-type SCR with P-type MOSFET pass structure (NSCR_PPS), was analyzed for high voltage I/O applications. A conventional NSCR_PPS device shows typical SCR-like characteristics with extremely low snapback holding voltage, which may cause latch-up problem during normal operation. However, a modified NSCR_PPS device with counter pocket source(CPS) and partial p-type well(PPW) structure demonstrates highly latch-up immune current-voltage characteristics.

• Journal of the Semiconductor & Display Technology
• /
• v.11 no.2
• /
• pp.75-80
• /
• 2012

Polymer composites which have electrical properties have been studied in various industries. The Multi-walled carbon nanotube (MWCNT) are thought to be reinforcements for polymers because of their high aspect ratio and specially mechanical, thermal and electrical properties. We introduced MWCNT and impact modifier in order to improve thermal and mechanical properties of Polyphenylene sulfide (PPS) and give electric characteristic to PPS. The thermal properties were investigated by Differential scanning calorimeter (DSC) and Thermogravimetric analysis (TGA). The morphology, mechanical properties and electrical characteristic were performed by Field emission scanning electron microscopy (FE-SEM), Izod impact tester and surface resistance meter. As a result, we could find that the PPS/MWCNT composites have high conductivity and good mechanical properties than neat PPS resin.

• Journal of the Semiconductor & Display Technology
• /
• v.18 no.1
• /
• pp.59-64
• /
• 2019

Recently, time synchronous has become important for satellite launch control facilities, multiple thermal power plants, and power system facilities. Information from time synchronous at each of these industrial sites requires time synchronization to control or monitor the system with correlation. In this paper, IRIG-B codes, which can be used for time synchronous, are used as specifications in IRIG standard 200-16. Signals from IRIG-B120 (Analog), IRIG-B000 (Digital), and one PPS are output from GPS receiver. Using the signal from IRIG-B120 (Analog), it passes through the signal from the analog amplifier and generates one PPS signal using the field-programmable gate array. The FPGA is used cyclone EPM570T100I5N. According to IEEE regulations, the error of one PPS is specified within 1us, but in this paper, the error is within 100ns. The output of the one PPS signal was then compared and tested against the one PPS signal on the GPS receiver to verify accuracy and reliability. In addition, the proposed time synchronous is simple to construct and structure, easy to implement, and provides high time precision compared to typical time synchronous. The output of the one PPS signals and IRIG-B000 signal will be used in many industry sectors.

• Journal of Cadastre & Land InformatiX
• /
• v.51 no.1
• /
• pp.23-38
• /
• 2021

In this paper, we analyzed the possibility of utilizing LX-PPS GNSS permanent stations whose antennas are installed on the building rooftop for the purpose of high-precision GNSS positioning services. We picked 15 pairs of adjacent GNSS permanent stations operated by LX-PPS and NGII, and then produced 3-year-long time series using the high-precision data processing software called GIPSY. Patterns and trends of position estimates were compared and analyzed. Horizontal and vertical deviations including the linear velocities coincide with the well-known crustal deformation rates of the Korean peninsula. We also observed almost the same annual or seasonal patterns from those nearby sites. After detrending the linear velocity, the amplitude and phase of annual signals almost perfectly match each other within the baseline length of 2 km. By subtracting seasonal signals, the RMS and standard deviations in LX-PPS PPGR with respect to NGII KANR are about 1, 2, and 5 mm in the north-south, east-west, and vertical directions, respectively. From this analysis it can be concluded that the rooftop-installed LX-PPS sites show similar level of stability and positioning performance comparable to those ground-mounted NGII stations.

• Journal of the Korean Statistical Society
• /
• v.31 no.2
• /
• pp.143-152
• /
• 2002

In an effort to make a right choice among ratio estimation strategies and PPS sampling strategies, we conduct an empirical investigation of the relative performances of three ratio estimation strategies and four PPS estimation strategies using a set of 12 natural populations. The quality of a strategy is measured in the traditional way, namely with the consideration of efficiency, achieved coverage rate of the nominal 99% confidence interval and approach to normality (asymmetry).

• Korean Journal of Microbiology
• /
• v.8 no.4
• /
• pp.173-177
• /
• 1970

In this study the effect of aerosol for the control of the parasitic Aspergilli in the sericultural room was investigated. The results obtained are summarized as follows : 1) The aerosol of PPS-A and PPS-B were quite effective for the control of parasitic Aspergilli in the room of sericulture, while the solution of formalin and chlor kalk, on the other hand, were inconclusive. 2) The activities of the aerosol of PPS-A and PPS-B are more effective when it is applied on the upper part of the room than the lower.

• Journal of the Korean Society of Industry Convergence
• /
• v.4 no.1
• /
• pp.77-85
• /
• 2001

This paper was to investigate the preparation of polysulfone(PS), polyethersulfone(PES) and polyphenylsulfone(PPS) membrane. The thermal property of PPS was higher than that of others. From the result of SEM, the concentration of polymer was found to have a significant effect on the structure of membrane, and the structure of membrane made of PES is found to have regular micell form of asymmetry. Permeability and selectivity for oxygen and nitrogen gas in the air were analyzed by GC. Permeabilities of the membrane made of PES for oxygen and nitrogen in air, 1.5 and $0.7(x10^9[cm^3(STP)cm/cm^2seccmHg]) $, respectively was higher than that of others. and Selectivity of the membrane made of PPS for oxygen to nitrogen gas in air was 2.9.

• Preventive Nutrition and Food Science
• /
• v.3 no.3
• /
• pp.272-276
• /
• 1998

Polysaccharide content in protein-polysaccharides (PPS) extracted from sea mustard, sea tangle and fusiform were 40.61, 38.42 and 52.80% , respectively. 5% of sea tangle PPS showed highest inhibitory activity on 4-nitorquinoline -1-oxide(4-NQO) against Salmonella typhimurium TA100 compared to the other seaweed PPS. 5% of sea mustard PPS showed highest inhibition ration of 62% on 2-nitrofluorene(2-NF)against Salmonella typhimurium TA98. These PPS extracts showed cytotoxic activity against human colon cancer cell (SW-480), and showed mild cytotoxic activity on human stomach cancer cell(SNU-1) and human hepatic cancer cell(HepG 2).

• Textile Coloration and Finishing
• /
• v.6 no.4
• /
• pp.1-8
• /
• 1994

To improve the antimicrobial activity and crease resistance of Korean traditional Hansan ramie fabrics, partially saponified polyethylene(PPS) was used as a softening water repellent agent and 3-(trimethoxysilyl)propyl dimethyl octadecyl ammonium chloride(QAC) as a antimicrobial agent. The antimicrobial activity was effective by treatments of PPS, QAC and PPS/QAC for shake flask test. For the halo test, PPS/QAC showed good antimicrobial activity. It was found that the desirable composition of H$_{2}$O/PPS/QAC is 98/1/1 for improving the antimicrobial activity and crease resistance of the fabrics.