• Journal of electromagnetic engineering and science
• /
• v.4 no.1
• /
• pp.43-49
• /
• 2004

A low-frequency coaxial reflectometer(LCR) with a thin-wire inner conductor is designed and constructed to measure nondestructively the absorbing performance of electromagnetic absorbers in the frequency range of 10 MHz to 200 MHz. The LCR consists of a square coaxial transmission line and a network analyzer with a time-domain measurement capability. Inherent characteristics of a square coaxial line with a thin-wire inner conductor which deteriorate the impedance matching of the input port of the LCR are addressed. And the characteristics are improved by employing a multiwire inner conductor. Measured and calculated reflection losses of a flat ferrite tile absorber are presented.

• Journal of the Optical Society of Korea
• /
• v.12 no.3
• /
• pp.157-161
• /
• 2008

A wavelength-selective reflector, composed of a double-ring-resonator add/drop filter and a loop-back mirror at the drop port to be used for a hybrid-integrated tunable laser is designed and fabricated. High-index-contrast polymer waveguide is used to realize a compact device as small as $2mm{\times}0.4mm$. The radii of the rings are slightly different from each other to obtain a wide wavelength tuning via a vernier effect. Peak reflectivity is measured to be 52% for TE mode and polarization-dependent wavelength shift is 0.95 nm. The tuning range is measured to be about 42 nm for applied current as small as 46 mA.

• International Journal of Internet, Broadcasting and Communication
• /
• v.6 no.1
• /
• pp.13-15
• /
• 2014

We develop a method to fabricate a flexible thin film audio systems using polyvinylidene fluoride(PVDF). The system we designed showed the properties of increased flexibility, transparency, and sound pressure levels. As an input port of two terminals, transparent oxide thin film with a low resistivity is adopted. In order to provide dielectric insulation, a transparent insulating oxide thin film is coated to obtain double-layered structure. In the range of visible light, the output from the output of the system showed a increased and improved sound pressure level. The piezoelectric polymer film of PVDF is used to produce mechanical vibration due to the applied electrical voltage signal. An analog electric voltage signal is transformed into sound waves in the audio system.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.09a
• /
• pp.1246-1249
• /
• 2009

Liquefaction hazard caused by earthquake is the damage in a wide range. Until now, liquefaction hazard potential at a small area or most structure in Korea was assessed by modified Seed & Idriss method. However, it has been known that this method is not proper for metropolitan area due to a lot of time and data to perform the related ground response analyses such as Shake program. For these reasons, the current method has been used facilities or structures, not metropolitan area. In this study, several contents in seismic design of Eurocode and Korean seismic design standard for Port and Harbor were introduced and applied for assessing the liquefaction potential and mapping the liquefaction hazard by LPI(Liquefaction Potential Index). Finally, Ulsan metropolitan city was practically drawn in two dimensional space.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.12 no.2
• /
• pp.181-189
• /
• 2000

The scroll compressor used for heat pump has a wide range of operation condition. To cover both heating and cooling modes, the operating Pressure ratio ranges from 1.5 to 6.8. Since the scroll compressor, however, is a type of compressor whose pressure ratio is fixed, some loss in the compression work is caused by the operation at the pressure ratio different from the built-in pressure ratio. A way of avoiding this problem is to introduce by-Pass holes in compression chambers, so that the compressed gas of pressure higher than the discharge pressure, yet not reached to the discharge port can be released earlier through the by-Pass holes. In this paper, an optimum Positioning of the by-Pass hole and the effect of the by-pass valve on the compressor performance are studied.

• Journal of the Korean Institute of Navigation
• /
• v.15 no.3
• /
• pp.99-106
• /
• 1991

In order to grow InGaAsP epitaxial layer on GaAs by LPE, an accurate phase diagram for In-Ga-As-P quarternary compounds is required. But the short wavelength InGaAsP/GaAs phase diagram for full wavelength range was not yet reported. In this study, therefore, a theoretical calculation has been carried out by using thermodynamic's equation for InGaAsP/GaAs in order to get the relation between the mole fraction of the sloute and solid phase compounds. And the calculation being compared with the dta of Kawanishi et. al, the result has been shown that his phase diagram obtained by the calculation can apply to growing InGaAsP/GaAs by LPE.

• Journal of the Korean Institute of Navigation
• /
• v.20 no.4
• /
• pp.111-128
• /
• 1996

This paper is focused on the desirable improvement schemes of the local network of information and telecommunication network. In this study, we examined whether polices of information and telecommunication of government have been carried out a desirable programme to meet the public interest, found out several problems in the these policies. Such problems as follows : (1) a system of local information & telecommunication is developing by a Model of Top-Down. In the present management system, an interest of the public of local society about the local telecommunication network is a much lower level, (2) there is no general controlling roll of the local information & telecommunication, (3) there is no service controlling system of local telecommuni-cation, and (4) there is no organic coordinating system of inter-departments in the central government level. In order to resolve these problems, this study suggests a few desirable sxhemes for the local telecommunication : (1) an establishment of middle-long range planning for the integrated future network of info-telecommunication, (2) an organizing of telecommunication network being suitable for the local characteristics toward B-ISDN.

• Journal of the Korean Institute of Navigation
• /
• v.4 no.1
• /
• pp.63-84
• /
• 1980

Since 1972 the growth of container services in Korea has been explosive and many shipping lines have heavily committed themselves to containerization as a means of lowering their operational costs by introducing capital-intensive methods to the traditionally labour-intensive field of general cargoes. However, by the lack of comprehensive long-range planning for the reception of containerization there has been bottle-neck at some of the stages along which import-export cargo may pass through a berth to shippers' premises. The aim of this article is to examine the present status of containerization in Korea and assess the implications of containerization for the location of the various distributive facilities: ports, inland container transport, inland clearance depots, groupage terminals, distribution depots at the national level.

• Journal of the Korean Society for Precision Engineering
• /
• v.21 no.9
• /
• pp.119-126
• /
• 2004

In this paper, we design a wedge type rail clamp which can protect container crane from a sudden strong blast with constant clamping force regardless of the operating period. When we design wedge type rail clamp, it is important to determine the angle of wedge and analyze a contact condition of roller and wedge so that we might develop a wedge type rail clamp for parking devices of port cargo working system with variable capacity. Therefore, this paper suggests a process to decide wedge angles within feasible range which could be obtained using load analysis and FEA of wedge type rail clamp

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.29 no.6
• /
• pp.389-398
• /
• 2017

The re-analysis on the stable weight of the concrete armor unit (CAU) at the roundhead and the suggestion of the covering range at the roundhead with the increased weight of CAU were conducted. Tetrapods were applied to the tests and the three dimensional hydraulic tests were performed. The test results for the stable weight at the roundhead area were similar to the guides from Korean Design Standard for Harbour and Fishery Port (MOF, 2014) and Coastal Engineering Manual (USACE, 2005). The investigation of covering range at the roundhead of rubble mound structures armoured with Tetrapods was suggested that the length of five times of the design wave height from the tip of the superstructure was needed and appropriate. Both sides of the superstructure should be covered with increasing weighted CAU to satisfy the stability at roundhead area.