• Journal of the Korean Geotechnical Society
• /
• v.29 no.9
• /
• pp.43-54
• /
• 2013

This study proposed a new embankment stability control method to analyze the measurement data on the slope activities of the soft ground, using the Stability Control Index (SCI) obtained from the p-q stress paths. In order to validate this new technique, the data from triaxial compression tests (CU) and field measurement were compared. SCI is calculated from the current path of the effective stress points ($p^{\prime}=p-{\Delta}u$) using the relative position between the Total Stress Path $p_{max}$ and the point of $k_f$ line $p_f$. From this result, the point of effective stress $p^{\prime}(=p-{\Delta}u)$ will have access to the point $p_f$ of $k_f$ line when the pore water pressure occurs or the point of total stress pass $p^{\prime}_{max}$ when the pore pressure dissipates. Thus, the Stability Control Index (SCI) can evaluate quantitatively the safety of embankment from the relative position of the effective stress path.

• Food Science of Animal Resources
• /
• v.38 no.2
• /
• pp.273-281
• /
• 2018

Preheating conditions (low-, medium-, and high heat-) did not significantly affect the buffering capacity (BC) of skim milk powder (SMP), whereas the level of demineralization significantly affected the BC of whey powders (WP). Heat treatment ($85^{\circ}C$ for 30 min) of both SMP and WP (90% demineralized) mixtures (88:12, 76:24, 64:36 and 52:48; SMP:WP) resulted in a reduced BC, and the extent of this reduction increased with the proportion of WP increased in the samples. High-buffering milk prepared by the addition of phosphate salts (40 mM $NaH_2PO_4$ and 60 mM $Na_2HPO_4$) delayed the rate of pH decline during yoghurt fermentation. The high-buffering yoghurt showed a significantly higher water holding capacity (WHC) than that of control yoghurt (p<0.05), as well as a more uniform and interconnected microstructure with small pore sizes than those of control yoghurt. No significant differences were found between high-buffering and control yoghurt regarding the viable bacterial counts of starter. The manipulation BC can potentially improve the quality characteristics of yoghurts, such as WHC and texture.

• Journal of the East Asian Society of Dietary Life
• /
• v.27 no.2
• /
• pp.114-123
• /
• 2017

This study added black lentil ethanol extract to Yakgwa at ratios of 0%, 0.5%, 1.0%, and 2.0%, and its quality characteristics were compared to those of the synthetic antioxidant BHT added to Yakgwa. Yakgwa with black lentil extract had lower moisture content than Yakgwa with BHT (3.98%) but higher content than the control group (5.72%). Higher black lentil extract resulted in less moisture content (p<0.001) as well as a faster expansion rate and oil absorption rate (p<0.001). Scanning Electron Microscopy (SEM) showed that as black lentil extract content increased, pores merged and collapsed, whereas the number of pores decreased and pore size became larger. For chromaticity, all L, a, and b values of the group containing black lentil extract were higher compared to the control group and group with BHT (p<0.001). For texture, as amount of added black lentil extract increased, hardness (p<0.001) and gumminess (p<0.01) increased while cohesiveness (p<0.01) decreased compared to the control group. For sensory characteristics, Yakgwa with 1.0% black lentil extract showed the best preference for all items except for off-flavor. Thus, 1.0% black lentil added to Yakgwa was the best in terms of functionality including preference.

• Restorative Dentistry and Endodontics
• /
• v.14 no.1
• /
• pp.25-40
• /
• 1989

This study was conducted to evaluate the influence of 5 microfilled composite resin to fibroblast cultivated from human pulp (age 13). Each composite resin was manually mixed and filled in cylinder. Resin filled cylinders were placed in dishes (35mm in diameter) containing 3 ml of ${\alpha}$-MEM. Filters (pore size 0.22 ${\mu}m$) to simulate dentin were also placed between the bottom of cylinder and the dish floor. Then stored in 5% $CO_2$ containing incubator for 1 and 2 weeks at the temperature 36.6 C. The results analysed after 1 and 2 weeks were as follows: 1. Experimental group except group 2, 2 weeks incubation cases showed the cytotoxicity compared to the control group in cell count. 2. After 2 week-incubation of group 1 and group 4, cell count was more decreased than 1 week cases and cytotoxicity seemed to be constantly influenced to the cell multiplication. 3. The cell growth rate of 1 week incubation in group 3 and group 5 was similar to the control group and recognized the cytotoxicities of these groups were mild. 4. The cell multiplication rate of 2 week incubation cases in group 2 was greater than control group.

• The Korea Journal of Herbology
• /
• v.36 no.6
• /
• pp.9-16
• /
• 2021

Objectives : The researcher had investigated the efficacy of ginseng using Microneedle Therapy System (MTS) and confirmed the effect of ginseng Cold Process (CP) soap just before and after washing face. The purpose of this study was to find out what kind of effect appeared through a period of 6 weeks when environmental factors were involved using ginseng CP soap. Methods : The researcher selected 47 subjects, 37 as the experimental group and 10 as the control group. The researcher asked participants to wash their face twice a day in the morning and evening using ginseng CP soap, and the period was set for 6 weeks. The researcher had the people who selected as the control group use a commercially available foam cleanser. They performed a skin test before the start of the test, and the change status was continuously investigated 2 weeks, 4 weeks, and 6 weeks after using the soap. Results : In the case of T-zone oil, there was a significant decrease in the use of foam cleansing and ginseng CP soap, and in the case of pores and pigmentation, a significant decrease was observed only in the use of ginseng CP soap. In skin tone change, there was a significant effect in both the experimental group and the control group, but the significance was greatly increased in the case of ginseng CP soap compared to foam cleansing. Conclusions : Ginseng CP soap is considered to be a more suitable cleanser for skin care compared to foam cleansing.

• The Korea Journal of Herbology
• /
• v.38 no.2
• /
• pp.9-16
• /
• 2023

Objectives : Many people use natural soap instead of commercially available bar type general soap for skin care. They tend to prefer cp (cold process) type soaps that go through a sufficient maturation process in formulation. The purpose of this study was to investigate the efficacy of PCPS (placenta cp soap). Methods : The researcher selected 36 subjects, 28 as the experimental group and 8 as the control group. I asked participants to wash their face twice a day in the morning and evening, and the period was set for 6 weeks. The researcher had the people who were selected as the control group use a commercially available foam cleanser, meanwhile the experimental group use PCPS. They performed a skin test before the start of the test, and the change status was continuously investigated after 2 weeks, 4 weeks, and 6 weeks after using the soap. Results : In the case of U zone oil and pores, there was a significant decrease and in the case of skin tone, there was a significant increase in the group of using PCPS. In T zone oil change, there was no significant effect in both the experimental group and the control group. Conclusion : In the case of PCPS, it is recommended to use it in the effect of reducing the size of pores and increasing skin tone, but it can reduce u-zone oil content.

• Journal of Dental Rehabilitation and Applied Science
• /
• v.22 no.4
• /
• pp.349-365
• /
• 2006

State of problem : A number of investigation about increase of surface area via various surface treatments and modification of surface constituent have been carried out. Purpose : The surface characteristics and stability of implants treated with anodic oxidation, fluoride ion incorporation, and groups treated with both methods were evaluated. Material and method : Specimens were divided into six groups, group 1 was the control group with machined surface implants, groups 2 and 3 were anodic oxidized implants (group 2 was treated with 1M $H_2SO_4$ and 185V, group 3 was treated with 0.25M $H_2SO_4$ and $H_3PO_4$ and 300V). Groups 4, 5 and 6 were treated with fluoride. Group 4 was machined implants treated with 0.1% HF, and groups 5 and 6 were groups 2 and 3 treated with 10% NaF respectively. Using variable methods, implant surface characteristics were observed, and the implant stability was evaluated on rabbit tibia at 0, 4, 8 and 12 weeks. Result : 1. In comparison of the surface characteristics of anodic oxidized groups, group 2 displayed delicate and uniform oxidation layer with small pore size containing Ti, C, O and showed mainly rutile, but group 3 displayed large pore size and irregular oxidation layer with many crators. 2. In comparison of the surface characteristics of fluoride treated groups 4, 5, 6 and non-fluoride treated groups 1, 2, 3, the configurations were similar but the fluoride treated groups displayed rougher surfaces and composition analysis revealed fluoride in groups 4, 5, 6. 3. The fluoride incorporated anodic oxidized groups showed the highest resonance frequency values and removal torque values, and the values decreased in the order of anodic oxidized groups, fluoride treated group, control group. 4. According to implant stability tests, group 2 and 3 showed significantly higher values than the control group (P<.05). The fluoride treated groups showed relatively higher values than the non fluoride treated groups and there were significant difference between group 4 and group 1 (P<.05). Conclusion : From the results above, it can be considered that the anodic oxidation method is an effective method to increase initial bone stability and osseointegration and fluoride containing implant surfaces enhance new bone formation. Implants containing both of these methods should increase osseointegration, and reduce the healing period.

• The Journal of Korean Medicine Ophthalmology and Otolaryngology and Dermatology
• /
• v.26 no.3
• /
• pp.1-19
• /
• 2013

Objective : The primary purpose of present study is to evaluate the effect of herbal cosmetics containing Cortex Betulae Platyphyllae extract complex on acne. The second is to comparatively evaluate safety of this cosmetics. Methods : We opened collecting of applicant that men and women(the 18~35-year-old) with acne on face. We selected subjects who came up to entire inclusion criteria and were not included in the exclusion criteria. We checked changes of Acne Global score, skin sebum, moisture, pores counts, Skindex-29 for 8 weeks. Results : 1. Comparison of changes in Global score, it declined in both experimental group and control group. But Experimental group showed a statistically significant decline than control group. 2. Comparison of changes in sebum and moisture, it declined in both experimental group and control group. But there was no statistically significant difference between those two groups. 3. Comparison of changes in erythema normal area, it declined in both experimental group and control group. But there was no statistically significant difference between those two groups. 4. Comparison of changes in pore counts, it increased statistically significantly in both experimental group and control group. 5. Comparison of changes in Skindex-29, it declined in both experimental group and control group. But there was no statistically significant difference between those two groups. Conclusion : Considering the above experiments, it is suggested that herbal cosmetics containing Cortex Betulae Platyphyllae extract complex have a positive effect on acne.

• Korean Journal of Human Ecology
• /
• v.8 no.1
• /
• pp.33-48
• /
• 2005

The purpose of this is to agar powder addition to retard retragradation for making Backsulgi. Backsulgi is manufactured promptly by adding ingredients having agar powder and then observation of sensory and texture characteristics. Then Backsulgi determinded in storing at the temperatures of 20 and Celsius degrees for 0, 24, 48 and 72 hours, respectively. The results from this study are as follow; 1. Moisture absorption of control show 34.4%, compared with, Backsulgi with agar powder added 3%, 6%, 9%, 12%, 15% show higher 37.03%, 39.28%, 41.72%, 43.5%, 44.70%, respectively. 2. In terms of chromaticity, lightness of control show $70.68{\pm}7.248{\sim}61.25{\pm}0.90$, the longer time is and much agar powder Backsulgi show lower and 15% agar powder added Backsulgi show $51.53{\pm}0.921{\sim}54.715$. Then redness(a) of control show $-0.70{\pm}0.14$, compared with 15% agar powder added Backsulgi show $-0.32{\pm}0.047$. 15% agar powder Backsulgi show $9.03{\pm}0.313$ higher in yellowness than control $5.47{\pm}0.40$. 3. Control and agar powder Backsulgi was shown pH 6.1~6.3, the longer time is, all Backsulgi was shown pH 5.5~5.9 and much agar powder Backsulgi was shown an weakly acidity. 4. Swelling and pore ratio of control was shown 85.36% and 118.32%, compared with, agar powder added Backsulgi was higher a rate of increase. 5. For a sensory evaluation, the longer time is, adding agar powder rice cake is more perfected at 20$^{\circ}C$ in times if smooth, inner moisture, chewiness, after selling, overall quality. 6. Determination of texture characteristics by a reometer shows that Backsulgi with agar powder added change more in hardness that controls, indicating that effect of retarding retrogadation is higher when storage time is longer. 7. The correlation of hardness, springness between sensory and instrumental evaluation showed significantly positive function.

• Journal of the Korean Geosynthetics Society
• /
• v.15 no.3
• /
• pp.1-12
• /
• 2016

In this study, the impact of sand and weathered granite soil is analyzed by changing the internal temperature from $20^{\circ}C{\sim}70^{\circ}C$C by installing a heating coil inside the triaxial cell. To check the effect on weathered granite soil due to increase of temperature and number of heating-coiling cycles are analyzed by measuring the temperature by using thermometer installed inside the triaxial cell and due to that deviator stress also occurred during the consolidated undrained test. To analyze the effect of weathered granite soil with change of temperature during undrained testing. The deviator stress and pore pressure is measured. As a result, pore pressure increases and the deviator stress decreases with rise of temperature.