• 산업기술연구
• /
• 제26권B호
• /
• pp.173-181
• /
• 2006

We analyzed systematically particle growth in the pulsed $SiH_4$ plasmas by a numerical method and investigated the effects of pulse modulations (pulse frequencies, duty ratios) on the particle growth. We considered effects of particle charging on the particle growth by coagulation during plasma-on. During plasma-on ($t_{on}$), the particle size distribution in plasma reactor becomes bimodal (small sized and large sized particles groups). During plasma-off ($t_{off}$), there is a single mode of large sized particles which is widely dispersed in the particle size distribution. During plasma on, the large sized particles grows more quickly by fast coagulation between small and large sized particles than during plasma-off. As the pulse frequency decreases, or as the duty ratio increases, $t_{on}$ increases and the large sized particles grow faster. On the basis of these results, the pulsed plasma process can be a good method to suppress efficiently the generation and growth of particles in $SiH_4$ PCVD process. This systematical analysis can be applied to design a pulsed plasma process for the preparation of high quality thin films.

• 한국분말재료학회지
• /
• 제20권1호
• /
• pp.19-23
• /
• 2013

Ru films were successfully prepared by plasma-enhanced atomic layer deposition (PEALD) using $Ru(EtCp)_2$ and $NH_3$ plasma. To optimize Ru PEALD process, the effect of growth temperature, $NH_3$ plasma power and $NH_3$ plasma time on the growth rate and preferred orientation of the deposited film was systemically investigated. At a growth temperature of $270^{\circ}C$ and $NH_3$ plasma power of 100W, the saturated growth rate of 0.038 nm/cycle was obtained on the flat $SiO_2$/Si substrate when the $Ru(EtCp)_2$ and $NH_3$ plasma time was 7 and 10 sec, respectively. When the growth temperature was decreased, however, an increased $NH_3$ plasma time was required to obtain a saturated growth rate of 0.038 nm/cycle. Also, $NH_3$ plasma power higher than 40 W was required to obtain a saturated growth rate of 0.038 nm/cycle even at a growth temperature of $270^{\circ}C$. However, (002) preferred orientation of Ru film was only observed at higher plasma power than 100W. Moreover, the saturation condition obtained on the flat $SiO_2$/Si substrate resulted in poor step coverage of Ru on the trench pattern with an aspect ratio of 8:1, and longer $NH_3$ plasma time improved the step coverage.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2014년도 제46회 동계 정기학술대회 초록집
• /
• pp.253.1-253.1
• /
• 2014

Plasma technology has been widely used for decontamination, differentiation, and disease treatment. Recently, studies show that plasma has effects on increasing seed germination and plant growth. In spite of increasing number of studies about plasma effects, the interaction between plasma and plants has been rarely informed. In this study, we have analyzed the effects of nonthermal atmospheric pressure plasma on seed germination and growth of coriander (Coriandum sativum), a medicinal plant. We used to Ar, air, and N2 plasma on seed as feeding gases. Plasma was discharged at 0.62 kV, 200 mA, 9.2 W. Seed germination was increased over time when treated with N2 based DBD plasma for exposure times of 30 seconds and 1 minute, everyday. After 7 days, about 80~100% of seeds were germinated in the treatment with N2 based DBD plasma, compared to control (about 40%, only gas treated seeds). In order to elucidate the mechanism of increased germination, we have analyzed characteristics of changes in plant hormones and seed surface structure by SEM.

• Asian-Australasian Journal of Animal Sciences
• /
• 제9권1호
• /
• pp.57-61
• /
• 1996

Four castrated Corriedale sheep were used in an experiment to observe the changes in insulin, growth hormone and cortisol in blood plasma following a prolonged infusion of a high rate of somatostatin (SRIF). The animals wee infused with either saline, 25 or $50{\mu}g/kg/h$ of SRIF for 3 hours. Blood samples wee taken every 20 minutes until 1 hour following the end of the SRIF infusion. Both SRIF infusion levels suppressed the release of insulin into plasma to approximately 3.5 mU/l. The SRIF infusions reduced the concentration of growth hormone to barely detectable levels. Following the withdrawal of SRIF there was a massive release of growth hormone. The plasma concentration of growth hormone reached 60 ng/ml within 20 minutes, the length of the growth hormone discharge was in excess of 1 hour. The extent of the discharge of growth hormone following the SRIF infusions was greater than that suppressed by the infusion. The SRIF apparently caused an increase in the plasma concentration of cortisol at the end of the infusion and following is withdrawal. This is possibly associated with some change in the metabolic rate associated with the suppression of insulin or glucagons release. The present experiment demonstrates that a high rate of SRIF infusion can not completely inhibit the release of insulin into the plasma.

• 한국결정성장학회지
• /
• 제15권5호
• /
• pp.198-201
• /
• 2005

Carbon nanofibers were formed on silicon substrate which was applied by negative direct current (DC) bias voltage using microwave plasma-enhanced chemical vapor deposition method. Formation of carbon nanofibers were varied according to the variation of the applied bias voltage. At -250 V, we found that the growth direction of carbon nanofibers followed the applied direction of the bias voltage. Based on these results, we suggest one of the possible techniques to control the growth direction of the carbon nanofibers.

• 한국결정성장학회:학술대회논문집
• /
• 한국결정성장학회 1999년도 PROCEEDINGS OF 99 INTERNATIONAL CONFERENCE OF THE KACG AND 6TH KOREA·JAPAN EMG SYMPOSIUM (ELECTRONIC MATERIALS GROWTH SYMPOSIUM), HANYANG UNIVERSITY, SEOUL, 06월 09일 JUNE 1999
• /
• pp.337-350
• /
• 1999

Thick diamond film having ~700${\mu}{\textrm}{m}$ thickness was deposited on polycrystalline molybdenum (Mo) substrate using high power (4kW) microwave plasma enhanced chemical vapor deposition (MPECVD) system. We could achieve free-standing diamond film via detaching as-deposited diamond film from the substrate by rapid cooling them under vacuum. We investigated the variation of photoconductivity after exposing the film surface to either oxygen or hydrogen plasma. At as-grown state, the growth side (the as-grown surface of the film) showed noticeable photoconductivity. The oxygen plasma treatment of this side led to the insulator. After exposing the film surface to hydrogen plasma, on the other hand, we could observe the reappearing of photoconductivity at the growth side. Based on these results, we suggest that the hydrogen plasma treatment may enhance the photoconductivity of free-standing diamond film.

• 한국결정성장학회지
• /
• 제9권4호
• /
• pp.441-445
• /
• 1999

Thick diamond film having $~700\mu\textrm{m}$ thickness was deposited on polycrystalline molybdenum(Mo) substrate using high power (4 kW) microwave plasma-enhanced chemical vapor depostion (MPECVD) system. We could achieve free-standing diamond film via detaching as-deposited diamond film from the substrate by rapid cooling them under vacuum. We investigated the variation of photoconductivity after exposing the film surface to either oxygen or hydrogen plasma. At as-grown state, the growth side (the as-grown surface of the film) showed noticeable photoconcuctivity. The oxygen plasma treatment of this side led to the insulator. After exposing the film surface to hydrogen plasma, on the other hand, we could observe the reappearing of photoconductivity at the growth side. Based on these results, we suggest that the hydrogen plasma treatment may enhance the photoconductivity of free-standing diamond film.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제44회 동계 정기학술대회 초록집
• /
• pp.183-184
• /
• 2013

Two main MBE growth techniques have been used: plasma-assisted MBE (PA-MBE), which utilizes a rf plasma to supply active nitrogen, and ammonia MBE, in which nitrogen is supplied by pyrolysis of NH3 on the sample surface during growth. PA-MBE is typically performed under metal-rich growth conditions, which results in the formation of gallium droplets on the sample surface and a narrow range of conditions for optimal growth. In contrast, high-quality GaN films can be grown by ammonia MBE under an excess nitrogen flux, which in principle should result in improved device uniformity due to the elimination of droplets and wider range of stable growth conditions. A drawback of ammonia MBE, on the other hand, is a serious memory effect of NH3 condensed on the cryo-panels and the vicinity of heaters, which ruins the control of critical growth stages, i.e. the native oxide desorption and the surface reconstruction, and the accurate control of V/III ratio, especially in the initial stage of seed layer growth. In this paper, we demonstrate that the reliable and reproducible growth of GaN on Si (110) substrates is successfully achieved by combining two MBE growth technologies using rf plasma and ammonia and setting a proper growth protocol. Samples were grown in a MBE system equipped with both a nitrogen rf plasma source (SVT) and an ammonia source. The ammonia gas purity was ＞99.9999% and further purified by using a getter filter. The custom-made injector designed to focus the ammonia flux onto the substrate was used for the gas delivery, while aluminum and gallium were provided via conventional effusion cells. The growth sequence to minimize the residual ammonia and subsequent memory effects is the following: (1) Native oxides are desorbed at $750^{\circ}C$ (Fig. (a) for [$1^-10$] and [001] azimuth) (2) 40 nm thick AlN is first grown using nitrogen rf plasma source at $900^{\circ}C$ nder the optimized condition to maintain the layer by layer growth of AlN buffer layer and slightly Al-rich condition. (Fig. (b)) (3) After switching to ammonia source, GaN growth is initiated with different V/III ratio and temperature conditions. A streaky RHEED pattern with an appearance of a weak ($2{\times}2$) reconstruction characteristic of Ga-polarity is observed all along the growth of subsequent GaN layer under optimized conditions. (Fig. (c)) The structural properties as well as dislocation densities as a function of growth conditions have been investigated using symmetrical and asymmetrical x-ray rocking curves. The electrical characteristics as a function of buffer and GaN layer growth conditions as well as the growth sequence will be also discussed. Figure: (a) RHEED pattern after oxide desorption (b) after 40 nm thick AlN growth using nitrogen rf plasma source and (c) after 600 nm thick GaN growth using ammonia source for (upper) [110] and (lower) [001] azimuth.

• Asian-Australasian Journal of Animal Sciences
• /
• 제8권1호
• /
• pp.51-58
• /
• 1995

To examine whether colostral growth factors are transferred to the general circulation, concentrations of plasma cortisol, insulin, prolactin, growth hormone, insulin-like growth factors(IGFs) -I and -II, IGF-binding proteins(IGFBPs) and total protein were measured in newborn calves fed colostrums, milk of milk replacer before and after feeding at 12 h intervals during the first two days after birth. Plasma protein concentrations increased with time after than in milk- or milk replacer-fed calves. The mean protein concentration was greater in colostrum-fed than in milk- or milk replacer-fed calves. Plasma cortisol levels transiently declined after each feeding regardless of the type of diet, while insulin levels tended to increase. Mean concentrations of these hormones did not differ between dietary groups, nor did they change with time after birth. Plasma concentrations of prolactin and growth hormone did not differ between dietary groups and also did not change with time after birth or after feeding. Concentrations of IGF-I and IGF-II transiently increased at the second feeding period, but these, as well as plasma IGFBP profiles, were not different between groups or before and after feeding. Results did not indicate significant transfer of colostral growth factors across the newborn ruminant small intestine.

• 공업화학
• /
• 제32권1호
• /
• pp.49-54
• /
• 2021

메틸 메타크릴레이트 분자를 전구체로 사용하여 원격 플라즈마 방식으로 중합체를 합성하는 반응에서 플라즈마 출력, 반응 압력 및 직접-간접 플라즈마 방식이 필름의 성장속도 및 화학결합 구조에 미치는 영향을 조사하였으며, FT-IR, XPS 등 분광학적 분석과 Langmvir 탐침을 사용한 플라즈마 특성 진단 결과와 함께 고찰하였다. 플라즈마 출력과 반응 압력이 증가하면 성장속도가 증가하지만 특정 영역을 넘어서면 식각 효과와 잦은 충돌로 인해 활성화 효율이 낮아져 다시 감소하였다. 중합 필름의 FT-IR과 XPS 분석 결과, 필름 내 탄소/산소 조성비는 플라즈마 출력이 커질수록 증가하였으며, 탄화수소성 C-C 탄소 조성비는 증가하는 반면 에스터성 COO 탄소 조성비는 감소하였다. 직접 플라즈마법이 간접 플라즈마법에 비해 필름의 성장속도는 2~5배 빠르지만, 전구체의 분자 구조를 유지하기 위해서는 간접 플라즈마법이 유리함을 확인하였다.