• Applied Biological Chemistry
• /
• 제2권
• /
• pp.45-52
• /
• 1961

The decomposition of malathion in dust for mulations prepared from four Korean tales as carriers during storage period has been studied. Amberlite CG-120, a cation exchange resin . which has higher cation exchange capacity than tales, was also used as a carrier in hope of finding out the effect of nagative charge upon the decomposition of malathion. Besides the original talc powders obtained directly from the mines, the hydrogen ion saturated forms were also used as carriers for comparisonal study. The saturated ions for the resin were hydrogen, sodium and magnesium. As the physical properties of the tales, colloid content, water adsorption capacity, PH, specific surface, phosphate fixing capacity and exchangeable canons were determined, and these properties were correlated with the amount of the decomposition. Following results were obtained from the experiment. 1. The malathion in the talc in dust was found to decompose around 10-15% ofthe total withina month. About 50% of the decom position that took place after a month was found to occur within a week. 2. The resin which has higher cation exchange capacity than the tales was highly effective in the decomposition of malathion compared with the tales. 3. In every case the saturation of the exchange complexes with hydrogen ion greatly accelerated the decomposition of malathion. 4. The most highly correlated physical properties with the decomposition were colloid content and specific surface of the tales. 5. The water adsorption and phosphate fixing capacities of the tales were found not to correlate with the amount of malathion decomposed. From the experimental results it was concluded that the active negative spots on the colloidal tales or the resin attract the electropositive phosphorus atom in a malathion molecule thereby inducing the decomposition easier. The presence of hydrogen ion nearby might cause a catalytic effect in the decomposition of malathion.

• 한국환경과학회지
• /
• 제14권9호
• /
• pp.835-842
• /
• 2005

The three-dimensional eco-hydrodynamic model was applied to estimate the physical process in terms of COD (chemical oxygen demand) and net supply(or decomposition) rate of COD in Kamak Bay to find proper management plan for oxygen demanding organic matters. The estimation results of the physical process in terms of COD showed that transportation of COD is dominant in surface level while accumulation of COD is dominant in bottom level. In the case of surface level, the net supply rate of COD was 0 -0.50 mg/m2/day. The net decomposition rate of COD was 0 -0.04 mg/m2/day in middle level(3 -6m) and 0.05 -0.1 5 mg/m2/day in bottom level(6m -bottom). These results indicates that the biological decomposition and physical accumulation of COD are occurred predominantly at the northern part of bottom level. Therefore, it is important to consider both allochthonous and autochthonous oxygen demanding organic matters in the region.

• 한국환경과학회지
• /
• 제11권7호
• /
• pp.749-755
• /
• 2002

The effects of noble gas (such as helium, neon, argon, krypton, and xenon) on the sonolytic decomposition of water and 2-methyl-2-propanol(t-butanol) with 200 KHz high power ultrasound were investigated. The physical properties of the noble gas have an effect on the formation rate of products $(H_2O_2,\;H_2,\;O_2)$ and the decomposition rate on the sonolytic decomposition of water. The pyrolysis products, such as methane, ethane, ethylene, and acetylene are formed during the sonolytic decomposition of t-butanol. From the estimation of the ratio $[C_2H_4+C_2H_2] / [C_2H_6]$, the cavitation temperature would be varied by the used noble gas. In all cases for the sonolytic decomposition of water, t-butanol, and diethyl phthalate, the decomposition rates were xenon > krypton > argon > neon > helium with a significant difference and were closely correlated with the formation rate of OH radical and high temperature inside the cavitation bubble under each noble gas.

• Journal of Ecology and Environment
• /
• 제38권4호
• /
• pp.517-528
• /
• 2015

Litter decomposition is an important process in terrestrial ecosystem. However, studies on decomposition are rare, especially in evergreen broadleaf trees. We collected the leaf litter of five evergreen broadleaf trees (Daphniphyllum macropodum, Dendropanax morbifera, Castanopsis cuspidata var. thunbergii, Machilus thunbergii and Quercus acuta), and carried out a decomposition experiment using the litterbag method in Ju-do, Wando-gun, Korea for 731 days from December 25, 2011 to December 25, 2013. Among the five experimental tree species, C. cuspidata var. thunbergii distribution was limited in Jeju Island, and D. macropodum was distributed at the highest latitude at Mt. Baekyang (N 35°40′). About 2% of the initial litter mass of D. macropodum and D. morbifera remained, while 20.9% remained for C. cuspidata var. thunbergii, 30.4% for M. thunbergii, and 31.6% for Q. acuta. D. macropodum litter decayed four times faster (k = 2.02 yr^-1) than the litter of Q. acuta (k = 0.58 yr^-1). The decomposition of litter was positively influenced by thermal climate such as accumulated mean daily air temperature (year day index) and precipitation, as well as by physical characteristics such as thickness (R²=0.939, P = 0.007) and specific leaf area (SLA) (R² = 0.964, P = 0.003). The characteristics of chemical composition such as lignin (R² = 0.939, P = 0.007) and water-soluble materials (R² = 0.898, P = 0.014) showed significant correlations with litter decomposition. However, the nutrients in litter showed complicated species-specific trends. The litter of D. macropodum and D. morbifera had fast decomposition despite their low nitrogen concentration and high C/N ratio. This means that the litter decomposition was more strongly affected by physical characteristics than chemical composition and nutrient content. On the other hand, the litter of Q. acuta which had the slowest decay rate had a high amount of N and low C/N ratio. Thus, the decomposition of Q. acuta litter was more affected by the P content of the litter than the N content, although all litter had similar physical characteristics.

• Elastomers and Composites
• /
• 제36권1호
• /
• pp.52-60
• /
• 2001

발포체의 물성은 발포체의 밀도, 사용된 폴리머의 기계적 물성과 열린 셀(open cell) 함량, 셀 크기, 셀 크기 분포, 셀 형태, 격벽의 두께 등을 포함하는 셀 구조에 의존하며 이러한 발포체의 밀도는 사용된 폴리머의 종류와 가교제의 농도, 발포제의 농도 그리고 가공 기술 및가공 조건 같은 다양한 원료물질과 가교조건에 영향을 받는다. Ethylene vinyl acetate coplymer (EVA) 발포체는 가교 발포체로서 가교속도와 발포제의 분해속도에 의해 발포특성에 영향을 받으며 이에 따라 발포체 물성에도 영향을 미친다. 본 연구에서는 가공 온도인 $155^{\circ}C$에서의 시간에 따른 발포제의 분해 속도 차이와 이에 따른 발포특성과 발포체의 물성에 대한 영향을 평가하였다. 발포제 분해 속도가 보다 느린 경우, 발포제 분해속도가 빠른 경우와 비교하여 낮은 밀도를 보여주었으며, 우수한 충격흡수성을 나타내었고 발포체의 셀 크기는 보다 균일하였다.

• 한국환경과학회지
• /
• 제16권12호
• /
• pp.1369-1382
• /
• 2007

To find proper water quality management strategy for oxygen consumption organic matters in Jinhae bay, the physical process and net supply/decomposition in terms of COD was estimated by three-dimensional eco-hydrodynamic modeling. The estimation results of physical process in terms of COD showed that transportation of COD was dominant in loading area from land to sea, while accumulation of COD was dominant in $middle{\sim}bottom$ level. In case of surface level, the net supply rate of COD was $0{\sim}60\;mg/m^2/day$. The net decomposition rate of COD was $0{\sim}-0.05\;mg/m^2/day$($-5{\sim}-10$ m, in depth) to 2 level, and $-0.05{\sim}-0.20\;mg/m^2/day(10m{\sim})$ to bottom level. These results indicate that the biological decomposition and physical accumulation of COD are occurred for the most part of Jinhae Bay bottom. The variation of net supply or net decomposition rate of COD as reducing land based input loading is also remarkable. Therefore, it is important to consider both allochthonous and autochthonous oxygen demanding organic matters to improve the water quality of Jinhae Bay.

• ETRI Journal
• /
• 제40권4호
• /
• pp.421-434
• /
• 2018

The application of deep neural networks (DNNs) to connect the world with cyber physical systems (CPSs) has attracted much attention. However, DNNs require a large amount of memory and computational cost, which hinders their use in the relatively low-end smart devices that are widely used in CPSs. In this paper, we aim to determine whether DNNs can be efficiently deployed and operated in low-end smart devices. To do this, we develop a method to reduce the memory requirement of DNNs and increase the inference speed, while maintaining the performance (for example, accuracy) close to the original level. The parameters of DNNs are decomposed using a hybrid of canonical polyadic-singular value decomposition, approximated using a tensor power method, and fine-tuned by performing iterative one-shot hybrid fine-tuning to recover from a decreased accuracy. In this study, we evaluate our method on frequently used networks. We also present results from extensive experiments on the effects of several fine-tuning methods, the importance of iterative fine-tuning, and decomposition techniques. We demonstrate the effectiveness of the proposed method by deploying compressed networks in smartphones.

• Nuclear Engineering and Technology
• /
• 제55권10호
• /
• pp.3808-3814
• /
• 2023

The thermal stability of nitric acid solutions after contact with non-irradiated and irradiated tributyl phosphate (TBP) and its solution in Isopar-M has been studied. It has been established that exothermic processes occur during heating due to the interaction of soluble radiolysis products and the decomposition of the extractant with nitric acid. Such processes can occur at temperatures below 100 ℃, but unlike a thermal explosion that occurs in seconds, they are longer in time and are accompanied by weak heat evolution. Their intensity depends on the composition of the extractant, the concentration of HNO₃, and the volume ratio of the organic and aqueous phases. The presence of extractant degradation products in raffinates does not pose a risk of a rapid evolution of gaseous products during evaporation, however, the presence of reducing agents can significantly increase the intensity of the exothermic decomposition of raffinates.

• Journal of Forest and Environmental Science
• /
• 제29권1호
• /
• pp.38-48
• /
• 2013

Decomposition of plant material is an important component in the study of forest ecosystem because of its critical role in nutrient cycling. Different tree species has different nutrient release patterns, which are related to leaf litter quantitative traits and seasonal environmental factors. The quantitative traits of leaf litter are important predictors of decomposition and decomposition rates increase with greater nutrient availability in the forest ecosystems. At the ecosystem level, litter quantitative traits are most often related to the physical and chemical characteristics of the litter, for example, leaf toughness and leaf mass per unit area, and lignin content tannin and total phenolics. Thus, the analysis of litter quantitative traits and decomposition are highly important for the understanding of nutrient cycling in forest ecosystems. By studying the role of litter quantitative traits on decomposition and nutrient cycling in forest ecosystems will provide a valuable insight to how quantitative traits influence ecosystem nutrient dynamics. Such knowledge will contribute to future forest management and conservation practices.

• 공업화학
• /
• 제28권2호
• /
• pp.214-220
• /
• 2017

결정화/응집(drowning-out/agglomeration, D/A) 공정을 이용하여 평균 입도 $550{\mu}m$인 구형 Al/RDX/AP 에너지 복합체를 제조하였다. SEM과 X-선 분광분석을 이용해 복합체의 표면 구조와 Al의 분포를 분석하였다. 열분석 결과 D/A 공정에 의해 제조된 Al/RDX/AP 복합체는 물리적 혼합에 의한 복합체와 비교하여 분해 개시 온도가 약 $50^{\circ}C$ 정도 낮아졌으며, 동시에 활성화 에너지의 증가에 의해 열적 안정성도 상승하는 것으로 확인되었다. AP의 1차 분해 구간에서는 물리적 혼합과 D/A 공정에 의한 복합체 모두 Prout-Tompkins 모델에 의해 잘 모사되었다. 그러나 AP의 2차 분해 구간에서는 물리적 혼합에 의해 제조된 복합체는 zero-order 모델로 해석되는 반면, D/A 공정에 의해 제조된 복합체는 contracting volume 모델로 해석됨을 알 수 있었다.