• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.62 no.7
• /
• pp.969-973
• /
• 2013

To simulate the effect of high dose-rate radiation on semiconductor devices, device modeling work has been performed especially in the area of photo-current generation by a PIN diode. The resultant analytical values were compared with experimental ones that were specially designed and performed to benchmark the simulation results. Initial results showed 27.85% error between the simulation and the experiment. The error can be further reduced by improvement both in simulation and in related experiments. The developed technique from the study can be applicable to radiation dosimetry and to analysis on the radiation effects in electronics.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.65 no.4
• /
• pp.268-272
• /
• 2016

A brush-less type synchronous generator is driven by an internal-combustion engine that is used for emergency source. This kind of generator has to maintain output voltage in a range of some degree under the abrupt load irregular conditions such as a full load trip. This paper suggests a suppression method of increasing the output voltage over the rating. Automatic voltage regulator detects excessive rising of output voltage of the generator and supplies the signals to a switch installed in the rotating exciter through the photo-coupler. The current of main field rapidly decreases by additional resistor of the main filed circuit. Therefore, the output voltage of the generator is maintained effectively. The experimental results verified that the excessive value of the output voltage is limited in the range of 7% of the rated voltage.

• Journal of Korean Vacuum Science & Technology
• /
• v.6 no.4
• /
• pp.143-148
• /
• 2002

Method of plasma-immersion ion deposition of hydrogenated DLC films on relatively thick flat dielectric substrates from plasma of not-self-sustained low-pressure gas arc discharge is suggested. Coating properties have been investigated experimentally, average energy Per a deposited carbon atom depending on discharge current has been calculated. Optimum deposition parameters lot obtaining sufficiently hard and transparent high-adhesive a-C:H films on a 4-mm thick glass substrates have been determined. Possibility to use these coatings for photo-tools protection from abrasion wear at low operating loads is shown in general.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.478-478
• /
• 2013

Resistance-change Random Access Memory (ReRAM) memory, which utilizes electrochemical control of metal in thin films of solid electrolyte, shows great promise as a future solid state memory. The technology utilizes the electrochemical formation and removal of metallic pathways in thin films of solid electrolyte. Key attributes are low voltage and current operation, excellent scalability, and a simple fabrication sequence. In this work, we investigated the nature of thin films formed by photo doping of Ag+ ions into chalcogenide materials for use in solid electrolyte of Resistance-change RAM devices and switching characteristics.

• Proceedings of the KIEE Conference
• /
• 2005.07a
• /
• pp.498-500
• /
• 2005

Photovoltaic System is clearness source of energy that don't flow out environmental pollution. For effective management of photo- voltaic systems, PVCMS (Photovoltaic Central Monitoring System) is operated in 24 site throughout the country. This paper verifies reliability of the data of CMS by measuring voltage, current, power of PV system and presents coefficient of output. Also, calculated efficiency of PV system is compared with real efficiency.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.11a
• /
• pp.85-86
• /
• 2006

Single crystal $AgGaSe_2$ layers were grown on thoroughly etched semi-insulating GaAs(100) substrate at $420^{\circ}C$ with hot wall epitaxy (HWE) system by evaporating $AgGaSe_2$ source at $630^{\circ}C$. The crystalline structure of the single crystal thin films was investigated by the photoluminescence and double crystal X-ray diffraction (DCXD). The temperature dependence of the energy band gap of the $AgGaSe_2$ obtained from the absorption spectra was well described by the Varshni's relation, $E_g(T)=19501 eV-(879{\times}10^{-4} eV/K)T^2/(T+250 K)$.

• Journal of Fisheries and Marine Sciences Education
• /
• v.23 no.2
• /
• pp.234-243
• /
• 2011

Mindmap is effective method to analyze informations. And, through mindmap, students can be able to grow their ability of logical reconstruction. In Modern society, people have been developing IT technology and variety of portable devices. So, Educational environments have been being changed accordingly, too. In this study, we have implemented mindmap application that based on android to share the group member's thinking. To effective sharing, we have used mindmap technique and photo attachment feature. In this study, expert evaluation has been carried out by elementary current teachers. In result of this expert evaluation, we have obtained positive feedback at sharing function, input technique and information display. Also, teachers have gave feedbacks that they are willing to use this application in class, if classroom environment is possible.

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.1423-1426
• /
• 2005

Map building is the most important thing for the mobile robots navigation. It requires specific vision system such as CCD camera, range finding system, and many other things. Laser range finder has highly collimated beams can be obtained easily, thus achieving lateral resolution. Laser Diode is used for a continuous laser source. The Automatic Current Control Circuit and the Bias-T is used for mix AC signal with DC bias. This signal is used for driving Laser Diode. The main idea of the calculating distance is detecting phase shift between reference signal and detected signal by photo detector. For the signal processing, the Lock-in amplifier system is addressed in this paper. We used a diffused reflected beam to detect phase shift in this system. But this beam is minuteness signal so it can be easily buried in nose. Lock-in amplifier is used to measure the amplitude and phase of signals which are buried in noise.

• Proceedings of the KIEE Conference
• /
• 1998.07d
• /
• pp.1432-1435
• /
• 1998

Influences of carbon black contents on the tracking resistance, tan $\delta$ and dielectric constant volume resistivity and dielectric strength of EPDM compounds before and after a exposure to UV radiation were investigated. Carbon black content up to 1.5 phr have a positive effect to improve the resistance to tracking and erosion, since carbon black diminish the leakage current. Results from the study reveal that both tan $\delta$ and dielectric constant volume resistivity and dielectric strength are unaffected by adding of carbon black up to 2.0 phr and carbon black have a significant effect to suppress the photo-degradation of EPDM compounds.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.340-340
• /
• 2010

본 연구에서는 유도결합형 플라즈마(ICP)를 이용하여, HBr/Ar 가스의 조성비 변화에 따른 Pb(Zr,Ti)$O_3$ 박막에 대한 식각특성을 연구 하였다. PZT박막의 식각속도와 Oxide($SiO_2$), Photo resister(PR)에 대한 식각선택비를 추출하였으며, 식각 메카니즘을 규명하기 위하여 optical emission spectroscopy(OES)와 double Langmuir prove(DLP) 이용하여 라디칼 특성변화와 이온 전류밀도(Ion current density)를 측정하였다.