• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.955_956
• /
• 2009

계통의 전력품질을 향상시키기 위해서는 비선형부하로 인해 발생되는 무효전력을 보상해야 한다. 이러한 무효전력을 보상하는 알고리즘에서 지령치를 생성하기 위해 평균전력 또는 순시전력을 이용한다. 평균전력을 이용하는 방법은 매 한주기마다 평균전력을 계산하여 지령치를 생성하는 방법으로 필연적으로 지연시간이 발생하게 된다. 이에 반해 순시전력을 이용하는 방법은 매 스위칭 순간에 무효전력을 보상할 수 있어 시스템 응답속도가 빠른 장점을 가진다. 또한 유효전력과 무효전력을 계산하기 위해 디지털 필터를 이용하게 되면 회로구성이 간편하고 제어가 용이한 장점이 있다. 본 논문에서는 계통의 전력품질을 개선시키기 위해 1개의 LPF(Low Pass Filter)와 2개의 곱셈블럭으로 구성되는 디지털 필터를 사용하였다. 이의 유용성을 확인하기 위해 단상 능동전력 필터(active power filter)에 적용하여 시뮬레이션을 수행하였다.

• Proceedings of the KIEE Conference
• /
• 2000.07a
• /
• pp.366-368
• /
• 2000

When faults occur in transmission lines, the classification of faults is very important. If the fault is HIF(High Impedance Fault), it cannot be detected or removed by conventional overcurrent relays (OCRs), and results in fire hazards and causes damages in electrical equipment or personal threat. The fast discrimination of fault needs to effective protection and treatment and is important problem for power system protection. This paper proposes the fault detection and discrimination algorithm for LIFs(Low Impedance Faults) and HIFs(High Impedance Faults). This algorithm uses artificial neural networks and variation of 3-phase maximum currents per period while faults. A double lines-to-ground and line-to-line faults can be detected using Neural Network. Also, the other faults can be detected using the value of variation of maximum current. Test results show that the proposed algorithms discriminate LIFs and HIFs accurately within a half cycle.

• Korean Journal of Optics and Photonics
• /
• v.10 no.5
• /
• pp.357-363
• /
• 1999

A frequency domain spectroscopic system was constructed to investigate the optical properties of multiple scattering media. The alternating current (AC) and phase lag components of backscattered light were measured by using the heterodyne detection method. Absorption and transport scattering coefficients were computed from the values based on diffusion theory. Predictions showed excellent matches in comparison with actual values of absorption and scattering. Predictable ranges of the optical coefficients were analyzed in terms of the distance between light source and detector, and modulation frequencies. A proposed compact experimental set-up using laser diodes can be utilized to estimate non-invasively the optical properties of multiple scattering media such as biological tissues.

• Journal of the Optical Society of Korea
• /
• v.11 no.1
• /
• pp.26-33
• /
• 2007

We demonstrate the capability of differential-phase optical coherence tomography (DP-OCT) to detect superparamagnetic iron oxide (SPIO) nanoparticles taken up by liver parenchymeal macrophages (Kupffer cells). We apply an external time-varying high-intensity focused magnetic field. Our experiments demonstrate a novel diagnostic modality to detect macrophages that have taken up SPIO nanoparticles. Magnetic force acting on the nanoparticles was varied by applying a sinusoidal current to a solenoid containing a conical iron core that substantially increased and focused the magnetic field strength ($B_{max}$ = 2 Tesla). $ApoE^{-/-}$ mice were sacrificed 2 days post intravenous injections of different SPIO doses (1.0, and 0.1 mmol Fe/kg body weight). Livers of $ApoE^{-/-}$ mice with and without injection of SPIO nanoparticles were investigated using DP-OCT, which detects tissue movement with nanometer resolution. Frequency response of iron-laden liver movement was twice the stimulus frequency. Movement was not observed in livers of control mice. Results of our experiments indicate DP-OCT is a candidate methodology to detect tissue based macrophages containing SPIO nanoparticles excited by an external focused magnetic field.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.24 no.8
• /
• pp.55-61
• /
• 2010

In this paper, we proposed selective extraction method of frequency information and PCA-ELM based diagnosis system for three-phase induction motors. As the first step for diagnosis procedure, DFT is performed to transform the acquired current signal into frequency domain. And then, frequency components are selected according to discriminate order calculated by variance As the next step, feature extraction is performed by principal component analysis (PCA). Finally, we used the classifier based on Extreme Learning Machine (ELM) with fast learning procedure. To show the effectiveness, the proposed diagnostic system has been intensively tested with the various data acquired under different electrical and mechanical faults with varying load.

• Journal of electromagnetic engineering and science
• /
• v.4 no.2
• /
• pp.72-78
• /
• 2004

In this paper, we evaluate the performance of the digital modulation schemes described in the APCO Project 25 FDMA specifications which can be used for applying the ultra-narrowband technology to the current domestic simple two-way radio systems, and discuss difficulties in the DSP implementation of the systems. We analyze the effect on the systems' BER performance of receiver non-matched filter and frequency-offset between the transmitter and receiver oscillators. And we present a frequency offset compensation method for improving the system performance. The results of performance analysis showed that the CQPSK of APCO Project 25 using non-matched filter degraded the BER by 0.5～1.0 ㏈ comparing with PI/4 DQPSK using matched filter. In the event of 2 % frequency offset, about 1 ㏈ performance loss was produced at the BER of $$10^{-3}TEX>. With the frequency-offset compensation method implemented in the systems using phase recovery scheme of PSK synchronization detection, the performance degradation of about 1.0 ㏈ was occurred at the BER of $$10^{-3}TEX> for 10 % of frequency offset. The proposed method can be used for the improvement of system performance.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.4
• /
• pp.1614-1622
• /
• 2018

The research related to fault diagnosis in permanent magnet synchronous motors (PMSMs) has attracted considerable attention in recent years because various faults such as permanent magnet demagnetization and short-circuited turns can occur and result in unexpected failure of motor related system. Several conventional current and back electromotive force (BEMF) analysis techniques were proposed to detect certain faults in PMSMs; however, they generally deal with a single fault only. On the contrary, cases of multiple faults are common in PMSMs. We propose a fault diagnosis method for PMSMs with single and multiple combined faults. Our method uses three phase BEMF voltages based on the fast Fourier transform (FFT), support vector machine(SVM), and visualization tools for identifying fault types and severities in PMSMs. Principal component analysis (PCA) and t-distributed stochastic neighbor embedding (t-SNE) are used to visualize the high-dimensional data into two-dimensional space. Experimental results show good visualization performance and high classification accuracy to identify fault types and severities for single and multiple faults in PMSMs.

• Current Optics and Photonics
• /
• v.8 no.1
• /
• pp.30-37
• /
• 2024

Implemented at the Geochang Observatory in South Korea, our slope detection and ranging (SLO-DAR) system features a 508 mm Cassegrain telescope (f /7.8), incorporating two Shack-Hartmann wave-front sensors (WFS) for precise measurements of atmospheric phase distortions, particularly from nearby binary or double stars, utilizing an 8 × 8 grid of sampling points. With an ability to reconstruct eight-layer vertical atmospheric profiles, the system quantifies the refractive index structure function (C_n²) through the crossed-beam method. Adaptable in vertical profiling altitude, ranging from a few hundred meters to several kilometers, contingent on the separation angle of binary stars, the system operates in both wide (2.5 to 12.5 arcminute separation angle) and narrow modes (11 to 15 arcsecond separation angle), covering altitudes from 122.3 to 611.5 meters and 6.1 to 8.3 kilometers, respectively. Initial measurements at the Geochang Observatory indicated C_n² values up to 181.7 meters with a Fried parameter (r₀) of 8.4 centimeters in wide mode and up to 7.8 kilometers with an r₀ of 8.0 centimeters in narrow mode, suggesting similar seeing conditions to the Bohyun Observatory and aligning with a comparable 2014-2015 seeing profiling campaign in South Korea.

• Food Science of Animal Resources
• /
• v.30 no.1
• /
• pp.73-86
• /
• 2010

The current study was designed to optimize solid phase microextraction (SPME)-GC-MS conditions for extraction and analysis of volatile components for Hanwoo beef and to establish a tentative database of flavor components. Samples were taken from Hanwoo longissimus muscle (30 mon old steer, $1^+B$ carcass grade) at 24 h postmortem. Results indicated that the optimum adsorption time for $75{\mu}m$ CAR/PDMS fiber was 60 min at $60^{\circ}C$. Thermal cleaning at $250^{\circ}C$ for 60 min was the best practice for decontamination of the fiber. A short analysis program with a sharp oven temperature ramp resulted in a better resolution and higher number of measurable volatile components. With these conditions, 96 volatile compounds were identified with little variation including 22 aldehydes, 8 ketones, 31 hydrocarbons, 12 alcohols, 8 nitrogen- and sulfurcontaining compounds, 5 pyrazines and 10 furans. A noticeable observation was the high number of hydrocarbons, aldehydes, ketones, alcohols and 2-alkylfurans which were generated from lipid decomposition especially the oxidation and degradation of unsaturated and saturate fatty acids. This implies that these compounds can be candidates for flavor specification of highly marbled beef such as Hanwoo flavor.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.37 no.6
• /
• pp.64-72
• /
• 2000

This paper deals with the parallel operation of two PWM converters for auxiliary block of high speed train. The parallel operation of AC/DC PWM converter controlled by 3-level PWM switching method to operate switching devices to realize a high power factor and reduce the primary side of the transformer current harmonics is proposed. In this paper, it is presented the phase shift technique between two converters switching phase, solution to eliminate the coupling effects due to the transformer and zero crossing detection method for synchronized with the source and controller. Experimental results for laboratory system with TMS320C31 microprocessor and 10［kVA］PWM converter confirm the validity of the proposed algorithm.