• Proceedings of the KIPE Conference
• /
• 2001.07a
• /
• pp.685-688
• /
• 2001

This paper proposes an SSSC based on multi-bridge inverters. The dynamic characteristic of the proposed SSSC was analyzed by EMTP simulation and a scaled handware model, assuming that the SSSC is inserted in the transmission line of the one-machine-infinite-bus power system. The proposed SSSC has 6 multi-bridge inverters per phase, which generates 13 pulses for each half period of power frequency. The proposed SSSC generates a quasi-simusoidal output voltage by 90 degree phase shift to the line current The proposed SSSC does not require the coupling transformer for voltage injection, and has a flexibility in operation voltage by increasing the number of series connection.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.8
• /
• pp.1145-1151
• /
• 1989

New method to calculate the characteristics of the dominant and higher order modes of waveguide latching phase shifters are presented. Due to the tensor permeability, E and H fields inside the ferrite are expanded in terms of the LSE and LSM eigenmodes of the dielectric-slab-loaded waveguide. The equivalent coupled transmission line equations on the transverse plane are derived to obtain the dispersion characteristics and the E and H field distributions. Numerical results at X-band are compared with those published previously. The derived field distributions can be used to suppress the higher order modes of the latching phase shifters, so that the phase shift from the dominant mode only contributes the performance of the phase shifters.

• Journal of Sensor Science and Technology
• /
• v.16 no.1
• /
• pp.39-43
• /
• 2007

This paper presents characteristics of surface acoustic wave (SAW) gas sensor for detecting volatile gases such as acetone, methanol, and ethanol by measuring phase shift of output signal. A delay-line by combining with a center frequency of 200 MHz was fabricated on S-T Quartz substrates. Using gas chromatography column, the selectivity of the SAW gas sensor were introduced. Experimental results, which show the phase change of output signal under the absorption of volatile gas on sensor surface, were presented. This SAW gas sensor system may be well suited for a high performance electronic nose system.

• Journal of Sensor Science and Technology
• /
• v.16 no.5
• /
• pp.349-354
• /
• 2007

This paper presents characteristics of surface acoustic wave (SAW) gas sensor for detecting volatile gases such as ethanol gas by measuring the phase shift of output signal. A delay-line with a center frequency of 400 MHz was fabricated on $128^{\circ}$ Y-Z $LiNbO_{3}$ substrates. Experimental results, which showed the phase change of the output signal under the absorption of volatile gas on sensor surface, were presented. The sensitivities of SAW delay lines coated with polyurethane films were greatly increased compared to those for uncoated devices. This SAW gas sensor system may be well suited for a high sensitivity electronic nose system.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.364-364
• /
• 2007

This paper presents characteristics of surface acoustic wave (SAW) gas sensor for detecting volatile gases such as ethanol gas by measuring phase shift of output signal. A delay-line with a center frequency of 400MHz was fabricated on 128o Y-Z $LiNbO_3$ substrates. Experimental results, which show the phase change of output signal under the absorption of volatile gas on sensor surface, were presented. The sensitivities of SAW delay lines coated with polyurethane films are greatly increased compared to those for uncoated devices. This SAW gas sensor system may be well suited for a high sensitivity electronic nose system.

• Information and Communications Magazine
• /
• v.16 no.10
• /
• pp.112-124
• /
• 1999

본 논문에서는 FTTC/VDSL (Fiber-to-the-Curb/Very High-speed Digital Subscriber Line) 전송시스템의 개발동향과 ANSI, ETSI, ITU등의 표준화 위원회에서 현재 진행중인 VDSL 시스템의 표준화 작업에 대해 기술하였다. 특히, POTS (Plain Old Telephone Service), BA-ISDA(Basic Access Integrated Services Digital Network), HDSL(High-rate Digital Subscriber Line), SDSL (Single-pair HDSL), ADSL(Asymmetric Digital Subscriber Line) 등의 다양한 xDSL (Digital Subscriber Line) 서비스들에서 발생하는 NEXT (Near-end Crosstalk)/FEXT (Far-end Crosstalk)와 같은 crosstalk를 최소화하기 위해 제안된 VDSL시스템의 주파수 대역과 PSD (Power Spectral Density) mask에 관해 설명하고, 순방향(down-stream) 채널과 역방향(upstream) 채널의 데이터 전송률이 대칭적인 VDSL전송시스템과 비대칭적인 VDSL 전송시스템 간의 주파수대역의 호환성 문제, RFI(Radio Frequency Interference) ingress/egress 문제의 해결 방안에 관해 기술하였다. 또한, 현재 VDSL Coalition과 VDSL Alliance 간에 논의 중인 VDSL 전송시스템의 변복조 방식에 관한 표준화 작업과정 및 순방향과 역방향에 할당될 band 개수에 따른 시스템 성능의 장단점 등에 관해 살펴보았다. 끝으로 현재 국내에서 개발되고 있는 FTTC/VDSL 전송시스템의 전체구조를 요약하고, 네트워크에서 가입자쪽으로 순방향 데이터 전송에 사용된 51.84 Mb/s 19-CAP (Carrierless Amplitude/Phase Modulation) 전송시스템과 가입자 댁내에서 네트워크 방향으로 역방향 데이터 전송에 사용된 1.62 Mb/s QPSK (Quadrature Phase Shift Keying) burst-mode TDMA (Time Division Multiple Access) 전송시스템 등의 동작 원리 및 구조를 기술하였다.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.10 no.4
• /
• pp.304-308
• /
• 2005

The response of IPTG induction was investigated through the monitoring of the alkali consumption rate and buffer capacity during the cultivation of recombinant E. coli BL21 (DE3) harboring the plasmid pRSET-LacZ under the control of lac promoter. The rate of alkali consumption increased along with cell growth, but declined suddenly after approximately 0.2 h of IPTG induction. The buffer capacity also declined after 0.9 h of IPTG induction. The profile of buffer capacity seems to correlate with the level of acetate production. The IPTG response was monitored only when introduced into the mid-exponential phase of bacterial cell growth. The minimum concentration of IPTG for induction, which was found out to be 0.1 mM, can also be monitored on-line and in-situ. Therefore, the on-line monitoring of alkali consumption rate and buffer capacity can be an indicator of the metabolic shift initiated by IPTG supplement, as well as for the physiological state of cell growth.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.39 no.9
• /
• pp.11-18
• /
• 2002

This paper presents a CPW phase shifter and shunt stub with air-bridge on a 10-${\mu}m$-thick oxidized porous silicon(OPS) substrate using surface micromachining. The line dimensions of the CPW phase shifter was designed with S-W-Sg = 100-30-400 ${\mu}m$. And the width and length of the air-bridge with "ㄷ“ shape were 100 ${\mu}m$ and 400-460-400 ${\mu}m$, respectively. In order to achieve low attenuation, stepped air-bridge CPW phase shift was proposed. The insertion loss of the stepped air-bridge CPW phase shift is more improved than that of no stepped air-bridge CPW phase shift. The measured phase characteristic of the fabricated CPW phase shifter is close to 180$^{\circ}$ over a very broad frequency range of 28 GHz. The measured working frequency of short-end series stub is 28.7 GHz and the return loss is - 20 dB. And the measured working frequency of short-end shunt stub is 28.9 GHz and the return loss is - 23 dB at midband. As a result, the pattering of stub in the center conductor of CPW lines can offer size reduction and lead to high density chip layouts.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.2
• /
• pp.47-54
• /
• 1990

In this paper, we design the 4-bit phase shifter which have $22.5^{\circ},45^{\circ},90^{\circ}$ and $180^{\circ}$ phase shift by applying the loaded line and switched network phase shifter. Its phase shift is variable with changing of the stub and passive device parameters. The experiments show the 6.5 dB average insertion loss and $10^{\circ}$ average phase error at center frequency, 6GHz. The results of experiment agree well with the theories except $180^{\circ}$ phase shifter.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.23 no.2
• /
• pp.128-132
• /
• 2010

Photonic crystal is dielectric materials or a set of different dielectric materials with periodic structure. Line defect is obtained by leaving out a row of rods along the $\Gamma$-X direction. We showed the change of group velocity in waveguide mode and found resultant small group velocity. Characteristics of the small group velocity were described by electric field distribution. Investigating the phase shift, it is confirmed if small group velocity is positive or negative.