• The Transactions of the Korean Institute of Power Electronics
• /
• v.22 no.1
• /
• pp.53-59
• /
• 2017

The information on the actual voltages and actual currents of the motor is required for the sensorless control of a permanent magnet synchronous motor without rotor position sensors. In the model-based rotor position estimator of a PM synchronous motor, the reference voltages, which are the outputs of the current controller, are commonly used. The reference voltages in over-modulation regions for high-speed operation differ from the actual voltages applied to the motor. Consequently, the estimated rotor position and rotor speed may fail to track the real rotor position and real rotor speed. In this paper, the sensorless control for a PM synchronous motor in over-modulation regions for high-speed operation is proposed. The three-phase voltages applied to the motor are measured by using additional voltage detection circuits, and the performance of the rotor position estimator based on the measured three-phase voltages is validated through the experimental results.

• Journal of the Optical Society of Korea
• /
• v.13 no.3
• /
• pp.354-360
• /
• 2009

We investigate theoretically the tolerance of 40 Gbps phase-modulated (PM) duobinary signals using a vestigial sideband (VSB) filter on impairments which occurred in dense wavelength-division multiplexing (DWDM) systems, compared to the conventional duobinary signals. Our simulation results show that PM duobinary signals can't have the gain on the spectral efficiency achieved by utilizing the VSB filtering technique. In order to increase the spectral efficiency, they indispensably require to be transmitted at the optimum bandwidth of multiplexer (MUX) and demultiplexer (DEMUX) since they are susceptible to inter-channel crosstalk. It is also shown that the PM duobinary modulation format has a large tolerance on self-phase modulation (SPM) and cross-phase modulation (XPM) under the condition which MUX and DEMUX have been tuned at an optimum bandwidth; it has 1.2 dB power penalty at the fiber launching power (FLP) of 15 dBm and the channel spacing of 50 GHz.

• International Journal of Precision Engineering and Manufacturing
• /
• v.8 no.2
• /
• pp.80-84
• /
• 2007

We propose a new displacement measurement method using a phase modulation homodyne interferometer and a tunable laser diode as a light source to determine an arbitrary length with a resolution in the order of 10 pm. In the proposed instrument, the displacement of a movable mirror in the interferometer can be converted to a frequency shift of the tunable laser diode. We discuss the principles of the proposed method, the instrumentation, and the experimental results, and compare the proposed method with two commercial displacement sensors. The commercial sensors used are a heterodyne interferometer, the interpolation error of which is also measured, and a capacitive sensor.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.4 no.3
• /
• pp.18-29
• /
• 1993

In single mode fiber optic transmission systems(FOT's) operated at high modulation rates over long fiber spans, chromatic dispersion can produce distortion in the demodulated waveforms, resulting in intersymbol interference(ISI) in the received signal and a reduction of transmission system performance. In this paper, chromatic dispersion limitations for intensity modulation and direct detection(IM-DD) systems are studied by considering the effect of phase modulation to amplitude modulation (PM-AM) conversion noise. Laser phase noise conversion to amplitude noise due to fiber chromatic dispersion is analyzed by deriving the noise power spectral density. We first derive the noise power spectral density of the laser phase noise to intensity noise conver- sion. Next, also evaluate the system power penalty and the transmitter laser linewidth required to avoid PM-AM conversion noise penalties in long-haul nonregenerative transmission system using an external modulator and optical amplifiers. For such system with optical amplifiers, transmission sys- tem length is limited due to fiber chromatic dispersion, even if an ideal external modulator is used.

• International journal of advanced smart convergence
• /
• v.10 no.4
• /
• pp.45-51
• /
• 2021

Polar transmitter can support multi-band and multi-mode operation. The efficiency of frequency usage can be increased if polar transmitters can transmit multi-carrier signals. In this paper the configuration of polar transmitters is investigated to generate multi-carrier signals. Spectrum and CCDF Simulation results of two-carrier signals generated by the polar transmitter can be used to design of PM and AM path in a polar transmitter.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.18 no.5
• /
• pp.151-155
• /
• 2004

Millimeterwave OFDM wireless LAN system has been modeled for ACPR analysis. With simple AM-to-PM modeling for power amplifier and system simulation technique, power amplifier ACPR is simulated for OFDM modulation, Also, amplifier back-off value satisfying the required ACPR and the ACPR degradation have been predicted with the measured and modeled AM-tn-PM distortion.

• 제어로봇시스템학회:학술대회논문집
• /
• 2003.10a
• /
• pp.2274-2277
• /
• 2003

A cylindrical permanent magnet inside the four-phase permanent magnet (PM) stepping motor is employed as the rotor. The stator has four teeth around, which its coils are wound. The mode of excitation can be classified into 3 modes: single-phase excitation, two-phase excitation and ministep excitation. The ministep drive is a method to subdivide one step into several small steps by means of electronics. The paper presents the programmable ministep technique drive. This technique decodes the results obtained from the counter to locate the data in Read Only Memory (ROM). The Sinusoidal Pulse Width Modulation (SPWM) is transformed to binary file and saved to the ROM. The experiment is performed with the four-phase PM stepping motor and drives from a two-phase programmable sinusoidal ministep signal, instead of square wave. The results show that the performances of the proposed programmable ministep technique drive have high efficiency, smooth step motion, and high speed response. Moreover, the resolution of sinusoidal ministep signal can be controlled by the input frequency (f command).

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.11 no.11
• /
• pp.5610-5624
• /
• 2017

A novel scheme based on polarization modulation and the weighted fractional Fourier transform (PM-WFRFT) is proposed in this paper to enhance the physical layer security of dual-polarized satellite systems. This scheme utilizes the amplitude and phase of the carrier as information-bearing parameters to transmit the normal signal and conceals the confidential information in the carrier's polarization state (PS). After being processed by WFRFT, the characteristics of the transmit signal (including amplitude, phase and polarization state) vary randomly and in nearly Gaussian distribution. This makes the signal very difficult for an eavesdropper to recognize or capture. The WFRFT parameter is also encrypted by a pseudo-random sequence and updated in real time, which enhances its anti-interception performance. Furthermore, to prevent the polarization-based impairment to PM-WFRFT caused by depolarization in the wireless channel, two components of the polarized signal are transmitted respectively in two symbol periods; this prevents any mutual interference between the two orthogonally polarized components. Demodulation performance in the system was also assessed, then the proposed scheme was validated with a simulated dual-polarized satellite system.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.2 no.4
• /
• pp.42-51
• /
• 2003

In this paper, we are going to analyze on relation of an output spectrum along phase distortion of power amplifier in wireless LAN system, and then considered an ACPR characteristic of power amplifier and consideration of an OFDM method for this. Also, we did implementation for OFDM modulation and transmission section of an IEEE 802.11a standard to have transmission speed of the maximum 54Mbps in order to know an OFDM modulation method and relation of non-linear characteristic of power amplifier. The non-linear characteristic of power amplifier did modeling with AM-to-AM and AM-to-PM, and we analyzed an output spectrum characteristic along phase distortion composed input signal supply for power amplifier. When output spectrum analysis results phase distortion increased, and an AM-to-PM characteristic of power amplifier in 5 degrees, the output spectrum was satisfied with a demand spectrum in P1 dB, but 10-20 degrees were able to confirm what cannot be satisfied with a demand spectrum in phase distortion. Also, an output spectrum of power amplifier by frequency re-growth generated by a non-linear characteristic of power amplifier did not satisfied in P1dE. therefore, a back-off value was requested according to an AM-to-PM distortion degree, and smaller back-off value were able to know what demand became in case of modulation section that used OFDM.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.2
• /
• pp.1-6
• /
• 2011

This paper describes a phase modulation I/O (PMIO) serial interface circuit that supports 1Gbps transfer rate with 12mW power consumption at 1.2V supply. The proposed PMIO which consists of TX and RX blocks utilizes a phase modulation technique. The rising edge is fixed to get the clock phase information and falling edge has multi positions for the multi-data information to increase the transfer rate. The designed circuit use the 16 possible falling edge positions. The data transfer rate is four times faster than the clock rate. The circuit has been implemented using $0.13{\mu}m$ CMOS process. Measured results show the circuit exhibits peak-to-peak jitters of transfer data (phase data) and recovery data.