• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.10
• /
• pp.1825-1832
• /
• 2000

Column experiments were conducted by using soil columns, to investigate feasibility and efficiency of in-situ ozone enhanced remediation for diesel-contaminated soil. The injection of gaseous ozone into soil column revealed the enhanced decomposition of ozone due to the catalytic reaction between ozone and metal (e.g., Fe, Mn etc.) oxides as evidenced by as much as 25 times shorter half-life of ozone in a sand packed column than in a glass beads packed column. Substantial retardation in the transport of and the consumption of ozone were observed in the diesel contaminated field soil and sand packed columns. After 16 hrs ozonation, 80% of the initial mass of diesel (as diesel range organic) concentration of $800{\pm}50mg/kg$, was removed under the conditions of the flow rate of 50mL/min and $6mg-O_3/min$. Whereas, less than 30% of diesel was removed in the case of air injection. Analysis of the residual TPH(total petroleum hydrocarbon) and selected 8 aliphatics of diesel compounds in the inlet and the outlet of the column confirmed that diesel nonselectively reacted with ozone and then shifted to lower carbon numbered molecules. Water content also was found to be an important parameter in employing ozone to the hydrocarbon-contaminated soil.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.1 no.3 s.3
• /
• pp.83-92
• /
• 2001

Field investigations for subsurface soil and groundwater at a gas station showed that the site was severely contaminated and even petroleum compounds as free liquid state were observed. Pilot-scale soil flushing and soil vapor extraction process(SVE) were applied to evaluate the effectiveness of pollutants removal. Surfactant solution, Tween 80, was used to enhance the solubility of petroleum compounds and resulted in about 10 times increase on TPH(Total Petroleum Hydrocarbon) concentration. As for SVE method, maximum concentration of TPH and BTEX reached within 24 hours of extraction and then continuously decreased. Considerations on the groundwater level and the kinetic limitation for volatilization of contaminants have to be taken into account for the effective application of SVE process.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.22 no.2
• /
• pp.67-75
• /
• 2014

Biodiesel as alternative fuels has been widely studied due to biodiesel merits such as lower sulfur, lower aromatic hydrocarbon and higher oxygen content. But biodiesels could be easily oxidized by several conditions. In this study, various antioxidants such as propyl gallate, TBHA, TBHQ, DTBHQ, butyl-amin, aniline and pyrogallol were added in the biodiesel produced by the used cooking oil, then the material property test and the vehicle emissions test were conducted in accordance with test method. From the results of material property test, all antioxidants were suitable for the quality standard of density and kinematic viscosity, but Propyl gallate and Pyrogallol, as a type of Gallate additives, showed that the result of TAN increased rapidly according to the increase of the amount of additives. In the oxidation stability test, TBHQ, Butyl-amine and Aniline showed the excellent oxidation stability. Also, when considering the material property test, TBHQ was verified to the most excellent additives. In case of the vehicle emissions test, the testing was conducted by using the biodiesel added by TBHQ and was conducted by using two light duty diesel vehicles suitable for the EURO 4 and EURO 5 emission regulation. The result of testing showed that when the TBHQ was added, the amounts of CO, NOx and NMHC+NOx were decreased but the amount of $CO_2$ was increased.

• Strategy21
• /
• s.37
• /
• pp.193-241
• /
• 2015

China, Japan and Korea are the world's top 10 energy consumers, and so very interested in the development of seabed hydrocarbon resources in order to meet their energy demands. The East China Sea is the tri-junction area where three countries' entitlements on the maritime boundaries are overlapped. There are abundant oil reserves in the East China Sea, and therefore competitions among countries are growing to get control of them. Although these countries have concluded the bilateral agreements to jointly develop resources in the East China Sea, they do not function as well. Because joint development and management of seabed petroleum resources can lead to stable development system, and to lower possibility of legal and political disputes, the needs for joint development agreement among three countries are urgent. Meanwhile, Northeast Asian seas are semi-closed seas, which are geographically closed and vulnerable to marine pollution. Moreover there are a lot of nuclear power plants in coastal area, and seabed petroleum resources are being developed. So it is likely to occur nuclear and oil spill accidents. Fukushima nuclear disaster and Bohai Bay oil spill accident in 2011 are the cases to exhibit the potential of major marine pollution accidents in this area. It is anticipated that the risks become higher because power plants and offshore oil platforms are extending gradually. Therefore, the ways to seek the joint marine environmental protection agreement focused on regulation of nuclear power plant and offshore oil platform have to be considered. In this paper, we try to find the way to make joint development and joint environmental protection agreement in Northeast Asian seas. We concentrate on the measure to drive joint development of seabed petroleum deposits in East China Sea's overlap area, despite of maritime delimitation and territorial disputes, and we try to drive joint marine environmental protection system to respond to marine pollution and accidents due to offshore oil platform and nuclear power plants. Through these consideration, we seek solutions to deal with lack of energy, disputes of maritime territorial and boundary delimitation, and marine pollution in Northeast Asia.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.34 no.3
• /
• pp.885-893
• /
• 2014

This research reports the enhanced Electrokinetic (EK) with $H_2O_2$ and sodium dodecyl surfate (SDS), which are commonly used in Fenton oxidation and soil flushing method, in order to remediate soil contaminated with heavy metals and Total Petroleum Hydrocarbons (TPH) simultaneously. In addition, influences of property of soil and concentration of chemical solution were investigated through experiments of different types of soils and varying concentration of chemical reagents. The results indicated, in the experiments using artificially contaminated soil, the highest removal efficiency of heavy metals using 10% $H_2O_2$ and 20mM SDS as electrolytes. However, in the experiments using Yong-San soils (study area), remediation efficiency of heavy metals was decreased because high acid buffering capacity. Through experiment of 20% $H_2O_2$ and 40mM SDS, increased electric current influences the remediation of heavy metals due to decrease in the soil pH. In the experiments of Yong-San soils, the remediation efficiency of TPH was decreased compared with artificially spiked soils because high acid buffering capacity and organic carbon contents. Furthermore, the scavenger effect of SDS influenced TPH oxidation efficiency under the conditions of injected 40mM SDS in the soils. Therefore, the property of soil and concentration of chemical reagents cause the electroosmotic flow, soil pH, remediation efficiency of heavy metals and TPH.

• Korean Journal of Food Science and Technology
• /
• v.4 no.3
• /
• pp.200-205
• /
• 1972

Effects of several different petroleum fractions (LGO, HGO, VGO, Diesel oil, SP(E), HGO-wax, L/M-wax), stepwise addition of calculated amounts of HGO at defined intervals, recycling of spent media on cell growth of Candida tropicalis KIST 351 were studied using $2.5{\ell}$ fermenter by batch process. In addition, continuous cultivation of the yeast was also performed in the light of biomass production using $28{\ell}$ fermenter with LGO. 1) Cell concentration, yield on the basis of gas oil and n-paraffin with the petroleum fractions were in the range of $11{\sim}15g/{\ell}$, $10{\sim}12%$ and $77{\sim}82%$, respectively. 2) By stepwise addition of the gas oil, cell concentration and yield on the oil were increased up to 18.9 g/land 13%, respectively. 3) Spent medium slowed emulsifying ability of hydrocarbon and stimulating effect on the cell growth. Without additional supplementation of $Mg^{++}$ up to 20% of spent medium could be reused, while by adding of the $Mg^{++}$, 50% of medium could be recycled. 4) Optimum condition of continuous cultivation for biomass production was attained at the dilution rate of $D=0.1{\sim}0.125\;hr^{-1}$. Maximum yield coefficient on consumed n-paraffin was 0.94 at $D=0.1\;hr^{-1}$, however, 24% of supplied n-paraffin in the media was not utilized at this dilution rate.

• The Korean Journal of Petroleum Geology
• /
• v.14 no.1
• /
• pp.36-44
• /
• 2008

Natural gas in tight reservoirs, one of unconventional hydrocarbon resources, has become a significant exploration and exploitation targets. Tight gas reservoirs are the gas-bearing rocks that commonly have a permeability of less than 0.1 millidarcy (mD). Tight gas reservoirs are characterized by extensive and deep locations as well as abnormal pressure such as over- or under-pressure. The tight gas reservoirs are independent of structural or stratigraphic traps, whereas conventional gases normally occur at these traps. Tight gas reservoirs can be productive when stimulated by hydraulic fracturing. Better production areas within the tight reservoir beds are referred to as sweet spots that are commonly caused by natural fractures, which should be understood and identified to enhance the recovery of the gas from tight reservoirs. The exploration and production techniques allow the commercial production of tight gas, one of environmentally friendly resources. Slant and horizontal wells have best production when they intersect the fractures. Gas production from the tight reservoirs has rapidly grown in U.S. and Canada. Indeed, the U.S. gas production of tight sandstones increases from 11.1% in 1990 to 24.1% in 2005. The presence of tight gas reservoirs has been suggested on the Korean offshore block 6-1. Paradigm shift from conventional to unconventional tight reservoir is required to develop the tight gas from the block.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.31 no.8
• /
• pp.672-679
• /
• 2007

The combustion characteristics of a liquefied petroleum gas-di-methyl ether (LPG-DME) compression ignition engine was investigated under homogeneous charge and stratified charge conditions. LPG was used as the main fuel and injected into the combustion chamber directly. DME was used as an ignition promoter and injected into the intake port. Different LPG injection timings were tested to verify the combustion characteristics of the LPG-DME compression ignition engine. The combustion was divided into three region which are homogeneous charge, stratified charge, and diffusion flame region according to the injection timing of LPG. The hydrocarbon emission of stratified charge combustion was lower than that of homogeneous charge combustion. However, the carbon monoxide and nitrogen oxide emission of stratified charge combustion were slightly higher than those of the homogeneous charge region. The indicated mean effective pressure was reduced at stratified charge region, while it was almost same level as the homogeneous charge combustion region at diffusion combustion region. The start of combustion timing of the stratified charge combustion and diffusion combustion region were advanced compared to the homogeneous charge combustion. It attributed to the higher cetane number and mixture temperature distribution which locally stratified. However, the knock intensity was varied as the homogeneity of charge was increased.

• Journal of Soil and Groundwater Environment
• /
• v.19 no.5
• /
• pp.9-17
• /
• 2014

This paper reported the use of real-time polymerase chain reaction (PCR), denaturing gradient gel electrophoresis (DGGE), and the culture-based method in the intrinsic bioremediation study at a petroleum contaminated site. The study showed that phenol hydroxylase gene was detected in groundwater contaminated with benzene, toluene, ethylbenzene, xylene isomers (BTEX) and methyl tert-butyl ether (MTBE). This indicated that intrinsic bioremediation occurred at the site. DGGE analyses revealed that the petroleum-hydrocarbon plume caused the variation in microbial communities. MTBE degraders including Pseudomonas sp. NKNU01, Bacillus sp. NKNU01, Klebsiella sp. NKNU01, Enterobacter sp. NKNU01, and Enterobacter sp. NKNU02 were isolated from the contaminated groundwater using the cultured-based method. Among these five strains, Enterobacter sp. NKNU02 is the most effective stain at degrading MTBE without the addition of pentane. The MTBE biodegradation experiment indicated that the isolated bacteria were affected by propane. Biodegradation of MTBE was decreased but not totally inhibited in the mixtures of BTEX. Enterobacter sp. NKNU02 degraded about 60% of MTBE in the bioreactor study. Tert-butyl alcohol (TBA), acetic acid, 2-propanol, and propenoic acid were detected using gas chromatography/mass spectrometry during MTBE degraded by the rest cells of Enterobacter sp. NKNU02. The effectiveness of bioremediation of MTBE was assessed for potential field-scale application.

• Journal of Environmental Science International
• /
• v.18 no.11
• /
• pp.1261-1270
• /
• 2009

Fifty hydrocarbon-metabolizing microorganisms were isolated from soil samples polluted by the petroleum oils in Gamman-dong, Busan. Among them, strain 2-3A, showing strong emulsification activity, was selected by oil film-collapsing method. This bacterium was identified as Acinetobacter sp. and designated as Acinetobacter sp. 2-3A. The optimum temperature and pH on the growth of Acinetobacter sp. 2-3A were $25^{\circ}C$ and pH 7.0, respectively. The carbon and nitrogen sources for the most effective emulsification activity were 3.0% olive oil and 0.5% peptone, respectively. The 0.15% potassium phosphate was the most effective emulsification activity as a phosphate source. The optimum emulsification activity condition was $20^{\circ}C$, pH 7.0, and 2.0% NaCl. The optimum time for the best production of biosurfactant was 27 hrs. The emulsification stability was maintained at the temperature range from $4^{\circ}C$ to $100^{\circ}C$, pH range from 6.0 to 10.0, and NaCl range from 0% to 10%. For the oil resolvability of the biosurfactant, the residual oils were investigated by gas chromatography. As a result, it was verified that the biosurfactant decreased and decomposed crude oils from $_nC_{10}$ to $_nC_{32}$.