• Proceedings of the Korea Society of Environmental Toocicology Conference
• /
• 2003.05a
• /
• pp.149-149
• /
• 2003

To understand environmental paths of the transport and accumulation of endocrine disrupting chemicals (EDCs), a single cell multimedia fate model has been constructed and evaluated. The EDCs of concern were PAHs, Organochlorine Pesticides (OCPs), PCBs, Alkyl phenols, and phthalates. An evaluation model was designed for the multimedia distribution, including air, water, soil, sediment and vegetation. This model was verified using reported values and via monitoring data. Based on collected data, the distribution trends of EDCs with respect to environmental media were analyzed. Those results have applied to the model for the prediction of the spatial and temporal distribution of EDCs in Seoul. Especially, phenol compound, phthalates, PAHs, PCBs and organochlorine pesticides were estimated and the model was verified. This model was successfully conducted to environmental media, such as air (vapor and suspended particles), soils (forest soil, bare soil, and cement-concrete covered soil), water (dissolved and suspended solids), sediment, trees (deciduous and coniferous). The discrepancies between the model prediction and the measured data are approximately within or near a factor of 10 for the PAHs of three rings through that of six rings, implying that multimedia distribution of the PAHs could be predicted with a factor of 10. Concerning about the air equilibrium may be assumed, a fugacity at steady state is similar in all environmental media. Considering the uncertainties of this model, the use of equilibrium models may be sufficient for assessing chemical fates. In this study, a suggestion was made that modeling and estimation of chemicals in environmental multimedia be rigorously evaluated using the measured flux data. In addition, these data should be obtained, for example, from the precise and standardized inventory of the target chemicals. The model (EDC Seoul) will be refined in an on-going research effort and will be used to support decision-making concerning the management of EDCs.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.32 no.E
• /
• pp.1-19
• /
• 1990

Abstract Over the last several decades, crop production in the United States increased largely due to the extensive use of animal waste and fertilizers as plant nutrient supplements, and pesticides for crops pests and weed control. Without the application of animal waste best management, the use of animal waste can result in nonpoint source pollution from agricultural land area. In order to increase nutrient levels and decrease contamination from agricultural lands, nonpoint source pollution is responsible for water quality degradation. Nonpoint source pollutants such as animal waste, ferilizers, and pesticides are transported primarily through runoff from agricultural areas. Nutrients, primarily nitrogen and phosphorus, can be a major water quality problem because they cause eutrophic algae growth. In 1985, it was presented that Watershed/Water Quality Monitoring for Evaluation BMP Effectiveness was implemented for Nomini Creek Watershed, located in Westmoreland County, Virginia. The watershed is predominantly agricultural and has an aerial extent of 1505 ha of land, with 43% under cropland, 54% under woodland, and 3% as homestead and roads. Rainfall data was collected at the watershed from raingages located at sites PNI through PN 7. Streams at stations QN I and QN2 were being measured with V-notch weirs. Water levels at the stream was measured using an FW-l Belfort (Friez FWl). The water quality monitoring system was designed to provide comprehensive assessment of the quality of storm runoff and baseflow as influenced by changes in landuse, agronomic, and cultural practices ill the watershed. As this study was concerned with the Nomini Creek Watershed, the separation of storm runoff and baseflow measured at QNI and QN2 was given by the master depletion curve method, and the loadings of baseflow and storm runoff for TN (Total Nitrogen) and TP (Total Phosphorus) were analyzed from 1987 through 1989. The results were studied for the best management practices to reduce contamination and loss of nutrients, (e.g., total nitrogen and total phosphorus) by nonpoint source pollution from agricultural lands.

• Analytical Science and Technology
• /
• v.23 no.4
• /
• pp.395-404
• /
• 2010

A multi-residual method using gas chromatography coupled with mass spectrometry (GC/MS/ MS) was developed for the analysis of 105 pesticides. This method was tested on lemons, beans and other vegetables. The pretreatment of these pesticides was performed by liquid-liquid partition followed by cleanup with solid phase extraction cartridge (SPE Florisil), after acetonitrile extraction from matrices and sodium chloride (15 g) addition. The recovery ranged from 71.1% to 126.0% except for azinphosmethyl, famoxadone, fenamidone, flufenoxuron and triadimefon in lemons and from 72.5% to 124.5% in bean. In lemon, the limit of detection (LOD) and limit of quantification (LOQ) were 0.001~150 ng/ mL and 0.004~500 ng/mL, respectively.

• Korean Journal of Environmental Agriculture
• /
• v.30 no.4
• /
• pp.357-366
• /
• 2011

BACKGROUND: Mathematical model such as GLEAMS have been developed and successfully applied to upland fields to estimate the level of pesticide residues in soil. But, the GLEAMS model rarely applied to the Korean conditions. METHODS AND RESULTS: To evaluate pesticide transport in soil residue using the GLEAMS model from pepper plot, Alachlor, Endosulfan, Cypermethrin and Fenvalerate were applied for standard and double rate. Soil sampling was conducted and decaying patterns of pesticides were investigated. Observed climate data such as temperature and irrigation amount were used for hydrology simulation. The observed pesticide residue data of 2008 were used for parameter calibration, and validation of GLEAMS model was conducted with observed data of 2009. After calibration, the $K_{oc}$ (Organic carbon distribution coefficient) and WSHFRC (Washoff fraction) parameters were identified as key parameters. The simulated concentrations of the pesticides except Fenvalerate were sensitive to $K_{oc}$ parameter. Overall, soil residue concentrations of Alachlor, Cypermethrin and Fenvalerate were fairly simulated compared to those of Endosulfan. The applicability of the GLEAMS model was also confirmed by statistical analysis. CONCLUSION(s): GLEAMS model was eligible for evaluation of pesticide soil residue for Alachlor, Cypermethrin and Fenvalerate.

• Korean Journal of Environment and Ecology
• /
• v.33 no.2
• /
• pp.178-186
• /
• 2019

This study used the probit analysis to evaluate the toxicity of three chemicals - benomyl (Germicide), carbofuran (insecticide), and thiobencarb (herbicide) - with the FETAX (Frog Embryo Teratogenesis Assay-Xenopus) protocol using the incubated embryos of tree frog, Hyla japonica. The results showed that the larval body length decreased while the mortality and malformation rates increased as the concentrations of benomyl, carbofuran, and thiobencarb increased. The teratogenic concentration ($EC_{50}$) of benomyl, carbofuran, and thiobencarb were 1.00, 0.58, 4.75 mg/L, respectively, indicating that the malformation of larvae was the most sensitive to carbofuran. The embryo lethal concentration ($LC_{50}$) was 7.04, 28.71, and 16.12mg/L, respectively, indicating that benomyl showed the lowest embryo lethal concentration. The teratogenic index (TI) was 7.04 in Benomyl, 49.50 in Carbofuran, and 3.39 in Thiobencarb, indicating that the TI values were above 1.5, which is the criterion of teratogenicity, for all three chemicals. All three pesticides examined by this study were considered to be the most teratogenic substances, and the carbofuran was the most potent teratogen.

• The Korean Journal of Pesticide Science
• /
• v.17 no.1
• /
• pp.65-71
• /
• 2013

The modified QuEChERS method was evaluated for rapid determination of pesticide residues in spinach by gas chromatography-nitrogen phosphorous detector (NPD) and electron capture detector (ECD). Fifty GC-amenable pesticides which were most frequently detected in monitoring were selected in the current study. Matrix-matched calibration was performed. The detector response for all pesticides was linear with determination coefficients higher than 0.995. LODs for most compounds ranged between 0.001 and 0.1 ug/g, and about 90% of the compounds had LODs of less than 0.05 ug/g. LOQs ranged from 0.001 to 0.32 ug/g, which were well below the MRLs permitted for most of pesticides. In the majority of cases, the recoveries (80-120%) and relative standard deviations (RSDs) (less than 20%) were within acceptable levels except for dichlorvos, propamocarb, chlorothalonil, dichlofluanid, cyhalothrin and fenvalerate. Also, this method which is applied to routine samples showed good results when comparing with traditional multi-residue method.

• Journal of Food Hygiene and Safety
• /
• v.33 no.1
• /
• pp.23-30
• /
• 2018

The purpose of this research was to introduce network analysis method for analyzing pesticide residues in incongruity commercial agricultural commodities. Based on the "results in pesticide residues on incongruity commercial agricultural commodities" on "Guidelines for food safety management 2017", we used centrality analysis for pesticide residues via degree, closeness and betweenness centrality measurement. In case of degree centrality result, chlorpyrifos and diazinon were the most highly "connected node" in pesticide network. For the closeness centrality result, the most pesticides showed the similar closeness trend except for 19 species of pesticides. Fludioxonil and chlorpyrifos are recognized as the "bridge" of pesticides network with their high betweenness centrality. The results of network analysis show the "relation" data, which could not represent through out the conventional statistical analysis, among the pesticide residues. We hope that the network analysis method will be appropriate and precise tool for analyzing pesticide residues via elaboration and optimization.

• The Korean Journal of Pesticide Science
• /
• v.20 no.1
• /
• pp.23-29
• /
• 2016

This study was carried out to survey residual characteristics of pesticide in fresh ginsengs collected from 45 markets at 15 regions in Korea using multiresidue analysis with a GC-MS/MS and an LC-MS/MS. After residue analysis was performed, the pesticides detected from ginsengs were quantitated using their analytical methods validated by recovery tests with a GC-ECD/NPD. As a results of analysis of pesticide residue, cypermethrin, fenitrothion, fludioxonil, thifluzamide, and tolclofos-methyl were detected from 16 samples among 45 samples in total, indicating detection rate was 35.6%. Tolclofos-methyl was found to be highest in detection frequency in ginseng. Fenitrothion that has not established maximum residue limit and pre-harvest interval for ginseng was detected. The amounts of all pesticides detected were less than their MRLs. Ratios of estimated daily intakes to acceptable daily intakes of the detected pesticides in ginseng were found to be from 0.03 to 16.67%.

• Korean Journal of Food Science and Technology
• /
• v.42 no.6
• /
• pp.664-675
• /
• 2010

This survey was carried out to estimate pesticide residue levels in commercial agricultural products in the year 2009. Residues were examined in 16 commodities (rice, foxtail millet, buckwheat, kidney beans, peanuts, sesame, oranges, grapefruit, kiwifruit, spinach, perilla leaves, leeks, garlic stem, garlic, ginger, and oak mushroom) collected from 22 provinces in Korea. Analyses were performed by multi-methods capable of detecting up to 60 pesticides by LC/MS/MS. A total of 510 samples were collected and analyzed. Of the samples, 96.1% contained no detectable pesticide residues. Detectable residues at or below the MRLs were found in 3.5% of the samples. However, in 0.4% of the samples (spinach and leeks), residue (ethaboxam and fluquinconazole) levels exceeded the MRLs. Furthermore, intake assessments of 7 kinds of pesticide residues were carried out, excluding those exceeding the MRLs. The results showed that the ratios of EDI (estimated daily intake) to ADI (acceptable daily intake) were 0.0001-0.0006%, which indicates that the detected pesticide residues were in a safe range. It is concluded that residual pesticides in agricultural products are properly controlled in Korea.

• Journal of Korea Society of Waste Management
• /
• v.35 no.8
• /
• pp.744-753
• /
• 2018

The Stockholm Convention, which was adopted in Sweden in 2001 to protect human health and the environment, includes regulations for Persistent Organic Pollutant Rotors such as toxic and bioaccumulatives. Currently, there are 28 types of materials. This prohibits and limits the production, use, and manufacture of products. Korea is a member of the Convention, and it is necessary to prepare management and treatment plans to address the POP trends. Thus, we experimentally investigate whether the environmentally stable incineration is achieved when the sample is thermally treated using the Lab-scale (1 kg/hr). The target samples is pesticides in liquid phase and solid phase. In this study, organic chlorinated pesticides and their thermal characteristics were analyzed. We calculated the theoretical air volume based on the element analysis results. Because the interior of the reactor is small, more than 10 times of the air ratio was injected. The retention time was set to at least 4 seconds using a margin. The incineration temperature was $850^{\circ}C$ and $1100^{\circ}C$. Thus, we experimentally investigated whether the environmentally stable incineration was achieved when the sample was thermally treated using the Lab-scale (1 kg/hr). We analyzed five types of exhaust gas; the 02 concentration was high, but the CO amount decreased. Complete combustion is difficult because of the small size of the furnace due to the nature of Lab-scale. The organic chlorine-containing pesticide had an average decomposition rate of 99.9935%. Considering the decomposition rates of organic chlorine-containing pesticide in this study, the incineration treatment at over 2 ton/hour, which is typical for a conventional incinerator, is possible. Considering the occurrence of dioxins and unintentional persistent organic pollutants, it can operate at more than $1,100^{\circ}C$.