• Journal of Adhesion and Interface
• /
• v.22 no.1
• /
• pp.1-7
• /
• 2021

The importance of high capacity energy storage devices has recently emerged for stable power supply through renewable energy generation. From this point of view, the Na-air battery (NAB), which is a next-generation secondary battery, is receiving huge attention because it can realize a high capacity through abundant and inexpensive raw materials. In this study, activated carbon-based catalysts for hybrid type Na-air batteries were prepared and their characteristics were compared and analysed. In particular, from the viewpoint of resource recycling, activated carbon (Orange-C) was prepared using discarded orange peel, and performance was compared with Vulcan carbon, which is widely used. In addition, a Pt/C catalyst (homemade-Pt/C, HM-Pt/C) was synthesized using a modified polyol method to check whether the prepared activated carbon can be used as a supported catalyst, and a commercial Pt/C catalyst (Commercial Pt/C) and electrochemical performance were compared. The prepared Orange-C exhibited a typical H3 type BET isotherm, which is evidence that micropore and mesopore exist. In addition, in the case of HM-Pt/C, it was confirmed through TEM analysis that Pt particles were evenly distributed on the activated carbon supported catalyst. In particular, the HM-Pt/C-based NAB showed the smallest voltage gap (0.224V) and good voltage efficiency (92.34%) in the 1st galvanostatic charge-discharge test. In addition, the cycle performance test conducted for 20 cycles showed the most stable performance.

• Korean Journal of Metals and Materials
• /
• v.49 no.1
• /
• pp.64-72
• /
• 2011

The spot weldability of dissimilar metal joints between austenitic stainless steels (STS316)/IF steels and ferritic stainless steels (STS430)/IF steels was investigated. This study was aimed to determine the spot welding parameters for a dissimilar metal joint and to evaluate the dissimilar metal joint's weldability, including its welding nugget shape, tensile-shear strength, hardness, and microstructure. The comparison of these results was described in terms of fracture behavior. Compared with the weld lobe of similar metal joints, dissimilar metal joints (STS430/IF) had reduced weld current range. However, the weld lobe of STS316/IF steel joint showed increased weld current range. This is because the dilution of chemical composition in the molten weld pool suppressed the heat input being caused by Joule heat with current flow through the samples. The microstructure of the fusion zone was fully martensite and mixture of ferrite and martensite for austenitic stainless steel/IF steel and ferritic stainless steel/IF steel combination, respectively. The experimental results showed that the shape of nugget was asymmetric, in which the fusion zone of the austenitic and ferritic stainless steel sheet was larger due to the higher bulk-resistance. The predicted microstructure by using the Schaeffler diagram was well matched with experimental results. After peel test, the fracture was initiated from heat affected zone of ferritic stainless steel sheet side, however the final fracture was propagated into the IF steel sheet side due to its lower strength.

• Journal of the Microelectronics and Packaging Society
• /
• v.29 no.2
• /
• pp.113-119
• /
• 2022

In order to improve the mechanical reliability of next-generation electronic devices including flexible, wearable devices, a high level of mechanical reliability is required at various flexible joints. Organic adhesive materials such as epoxy for bonding existing polymer substrates inevitably have an increase in the thickness of the joint and involve problems of thermodynamic damage due to repeated deformation and high temperature hardening. Therefore, it is required to develop a low-temperature bonding process to minimize the thickness of the joint and prevent thermal damage for flexible bonding. This study developed flexible laser transmission welding (f-LTW) that allows bonding of flexible substrates with flexibility, robustness, and low thermal damage. Carbon nanotube (CNT) is thin-film coated on a flexible substrate to reduce the thickness of the joint, and a local melt bonding process on the surface of a polymer substrate by heating a CNT dispersion beam laser has been developed. The laser process conditions were constructed to minimize the thermal damage of the substrate and the mechanism of forming a CNT junction with the polymer substrate. In addition, lap shear adhesion test, peel test, and repeated bending experiment were conducted to evaluate the strength and flexibility of the flexible bonding joint.

• Food Science and Preservation
• /
• v.24 no.7
• /
• pp.898-907
• /
• 2017

This study was aimed to test harvest time effect with polyethylene (PE) film liner, 1-methylcyclopropene (1-MCP) and aminoethoxyvinylglycine (AVG) treatments on fruit quality attributes in 'Sangjudungsi' persimmon fruit during cold storage. The fruits were harvested 10 days earlier in 2016 than the mature harvest time in 2015. The ethylene production was significantly lower in early harvested fruits than in mature harvested ones. Flesh firmness was maintained higher in 1-MCP treated fruit than in other treatments during cold storage. The rate of fruit weight loss was significantly inhibited by PE film liner treatment during storage, regardless of harvest time. 1-MCP treatment showed less change in fruit peel color variables ($L^*$ and $b^*$) from the calyx-end and equatorial regions during cold storage, compared with those from the control and PE film treatments. The incidence rate of fruit decay and softening was higher in PE film treated fruits than in the other treatments. However, there was no decay detected in AVG treated fruit. The early harvested fruits were maintained higher flesh firmness, compared with mature harvested fruits. Nevertheless, the mature harvested fruits showed much higher soluble solids content, the redness (Hunter a value) of the fruit peel and respiration rate, compared with early harvested fruits. Furthermore, the rate of weight loss in the fruit was remarkably inhibited in the PE film treatment.

• Journal of fish pathology
• /
• v.32 no.2
• /
• pp.105-111
• /
• 2019

Citurs unshiu Markovich is a medicinal product of dried tangerine peel (DTP). It is effective on antioxidation, and getting fame as a medicine and functional food. By utilizing DTP as a feed additive, we aim to enhance the growth rate, innate immunity, and bacterial infection resistance to Tilapia. The DTP extract was added to the feed weight by 0.1, 0.5, 1, 5% and then fed to tilapia for 7 days to evaluate the innate immunity parameter, growth rate and anti-bacterial activity. Innate immunity parameter results showed that the ROI was significantly higher in the 5% group added at high concentration, while showing decrease or no differences in other experimental groups. In other parameters, all the experimental groups showed no significant difference or decreased compared to the control group. The challenge test showed a high survival rate of 71% in the 0.5% group and the lowest in the control group (36%). For the growth rate, the feed efficiency was improved in all groups except for the 0.1% group compared to the control group. In conclusion, DTP extract has bacterial resistant effect in while not affecting innate immune system of fish. Also, it has shown the potential as a possible feed additive as it has brought the improvement on feed efficiency ratio.

• Korean Journal of Food Science and Technology
• /
• v.23 no.4
• /
• pp.433-436
• /
• 1991

Natural compounds which could improve the oxidative stability of fish oil was screened from spices, herbs and naturally occurring antioxidants. Induction period of fish oil determined from oxidation curve by Rancimat ($80^{\circ}C$) was hardly affected with the addition of water-soluble and lipid-soluble fractions of garlic, leek, sesame leave and orange peel, and of organic acids such as citric acid, EDTA and selenium. Caffeic acid, catechin, quercetin and gallic acid laurylester, however, could extend the induction periods by $2.2{\sim}3.8$ times with the addition level of 0.1%(w/w). Rosemary extract and sesamol have a marked effect in retarding oxidation of fish oil. For example, induction periods of the oil samples stabilized with 0.1 rosemary extract and 0.1 sesamol were 16.4 hr and 11.6 hr, respectively, as compared to 4.0 hr of a control. When rosemary extract was used in combination with ascorbic acid (0.02%) or 8-tocopherol (0.2%), induction period could be extended to ca. 28 hr due to the synergism.

• Applied Biological Chemistry
• /
• v.32 no.4
• /
• pp.416-423
• /
• 1989

In order to produce clear and favorable citrus wine from Citrus unshiu produced in Cheju island, chemical and microbiological processes for alcoholic fermentation were investigated. The ratio of pressed juice passed below 100 mesh sieve and peel of mandarin orange were 55.9% and 25.6% respectively. Orange juice for fermentation source contained 8.85% total sugar, 1.43% total acid and 0.056% volatile acid. Pressed juice was adjusted to 24 degree Brix with cane sugar, and was fermented at $20^{\circ}C$ for one month. Starter screened and selected was Saccharomyces cerevisiae IAM 4274. As principal fermentation proceeded for one week, suspended solids began to precipitate slowly after then. After fermentation, clear citrus wine consisted of about 8 degree Brix residual sugar, $13.3{\sim}14.4%$ ethanol, $0.78{\sim}1.11%$ total acid, $0.05{\sim}0.07%$ methanol and $2.25{\sim}3.29%$ extract, was obtained. Color, flavor and taste of citrus wine found good with panel test. Citrus wine which was treated with fungal enzyme derived from Aspergillus niger CCM-4 was cleared much faster, and could be filtered more rapidly than the untreated. The enzyme-producing strain was isolated from field soil of Cheju island and identified.

• Applied Biological Chemistry
• /
• v.40 no.4
• /
• pp.313-317
• /
• 1997

To assess the physiochemical characteristics of greenhouse Satsuma mandarin (Citrus unshiu Marc. var, miyakawa) produced in Cheju, were analyzed chemical compositions for fruits, external and internal factors influencing the edible quality. Changes in organoleptic value according to brix and acid content were also evaluated. The ratios of sucrose : glucose : fructose in citrus juice were 2 : 2 : 1.5. Citric acid as the main acid in the juice represented about 70% of total organic acid. Most of the amino acids were found to be nonessential amino acids. Deep yellow color of the citrus peel showed a significant relationship(r=0.563) with brix/acid ratio of the citrus juice, indicating the ripeness of the fruit. Since the acid content showed highly negative statistical relationship(r= -0.882) with the pH value of the juice, the pH value appears to be a simple indicator for the sourness of the fruit in the field test. The fruits were divided into 9 groups based on the brix/acid contents for sensory evaluation. The palatability patterns of each group changed depending on the acid content. The optimal ranges of brix/acid content for acceptable taste were 11 and $0.5{\sim}1.0$, respectively.

• Korean Journal of Food Science and Technology
• /
• v.33 no.1
• /
• pp.12-18
• /
• 2001

The water-soluble extracts of plants used as tea materials were investigated for their antioxidant activities and active components(total phenolics, ascorbate and selenium). Antioxidant activities of the plant extracts were determined by measuring the changes in both peroxide values(POV method) during storage(36 day, $55^{\circ}C$) and conductivity of soybean oil at $110^{\circ}C$(Rancimat method). Soybean oil without any additive was used as a control. Soybean oil treated with 0.02% BHT was used as a positive control. The test samples were prepared by mixing the plant extracts with soybean oil in 0.02% concentration by weight. The water-soluble extracts of lycii fructus(23 d), oolong tea(23 d), orange peel(23 d), citron(22 d), and apricot(22 d) showed longer induction periods, compared to control(21 d) and BHT(21 d) by POV method. Also water-soluble extracts of oolong tea(12 h), instant coffee(11 h), citron(10 h), cinnamomi cortex(10 h), schizandrae fructus(10 h), lycii fructus(10 h) and apricot(10 h) demonstrated longer induction periods, compared to control(8 h) and BHT(8 h) by Rancimat method. The contents of total phenolic compounds were observed to be high in water-soluble extracts of oolong tea, green tea, black tea, coffee, cinnamomi cortex, and cassiae semen. Ascorbate contents were found to be high in coffee, eucommiae cortex, black tea, ganoderma, cinnamomi cortex, persimmon leaf, chicory, green tea and oolong tea extracts. The selenium contents were not detected in all the extracts. The antioxidative effects of some plant extacts were seemed to be the combined effects of various antioxidant components such as phenolics and ascorbate.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.30 no.4
• /
• pp.635-640
• /
• 2001

These studies were carried out to develop sausage using extracts from waste resources. The changes of pH and moisture contents were tended to be a similar to control, respectively ranged in pH 6.0~6.4 and 62~60% in moisture content. However, the water holding capacity of sausage added with chitosan and sesamol gradually were tended to be a little high, compared to control. The treatments using natural resource by-product revealed a low TBARS value, compared to control. This means that sausage added with natural by-product seem to be extend its shelf-life during storage. At the same time, the TBARS values were very similar to sausage added with 0.5% potassium sorbate. The residual nitrite contents of sausage added with natural resource by-product were tended to be a little lower than that of control. As storage time goes by, the nitrite contents of sausage product gradually were a little more decreased during storage at 3$0^{\circ}C$ than those of storage at 1$0^{\circ}C$. The lightness of sausage color gradually were a little more decreased during storage at 3$0^{\circ}C$ than those of storage at 1$0^{\circ}C$. The redness of sausage added with chitosan were a little highter, compared to control Sensory test suggested that the changes of sausage color, flavor, texture and taste were tended to be decreased gradually. In conclusion, sausage added with natural resource by-product was effective on the basis of the reduction in residual nitrite content and lipid oxidation.