• Korean Journal of Environmental Agriculture
• /
• v.11 no.3
• /
• pp.195-200
• /
• 1992

Heavy metal adsorption on peat was studied to examine the utilization of abundant natural resouces as pollution control. The smaller the peat particle size, the more the heavy metals studied were adsorbed. Adsorption of heavy metals on peat was greater in single metal solutions than in mixed solutions, and the order of adsorption amount on peat was Cu > Cd > Zn. The most effective pH range of the adsorption of Cd, Zn, and Cu was between 4 and 6. With increasing the concentration of heavy metals the amount of adsorption on peat was increased, but the adsorption ratio was decreased. The adsorption of heavy metals on peat was fitted to the Freundlich isotherm and peat was appeared to be an effective adsorbent of the heavy metals. The treatment of polyethyleneimine(PEI) on the peat surface effectively increased adsorption capacity of the heavy metals. Because of its higher energy content, the heavy metal adsorbed peat could be utilized as a energy source. After burning the peat, the reduced peat volume could be save the expenses for waste disposal.

• Asian Journal of Turfgrass Science
• /
• v.6 no.2
• /
• pp.83-88
• /
• 1992

This study was carried out to determine the effect of peat and chemical fertilizer application on the growth of manilagrass and to obtain basic data for fertilization management of zoysiagrass. The results obtained are summarized as follows ; 1. Application of peat with chemical fertilizer increased the growth of tops and under of Manilareass compared with control or single application of peat or chemical fertilizer through the growing season. 2. The number of shoot was increased with amount of peat applied, and especially over 2 times with the application of peat 3,000 kg with compound fertilizer application plot compared with the control. 3. The higher amount of peat application, pH and organic matter content in soil where increased at the end of experiment. 4. Calcium and magnesium contents of soil in plot were increased as the amount of peat were applied, but sodium content appeared to be little difference according to the amount of peat applied.

• Geomechanics and Engineering
• /
• v.29 no.1
• /
• pp.13-23
• /
• 2022

Peat soil has the characteristics of high moisture content, large void ratio and low shear strength. In this study, unconfined compressive strength and SEM tests are conducted to investigate the effects of ultrahigh moisture content, cement content, organic content and pH value on the strength of solidified peat. As an increase in the cement content and curing period, the failure mode of solidified peat soil changes from ductile failure to brittle failure. The influence of moisture content on the strength of solidified peat is greater than the cement content. As cement content increases from 10% to 30%, strength of solidified peat at a curing age of 28 days increases by 161%~485%. By increasing water content by 100%, decreases of solidified peat at a curing age of 28 days is 42%~79%. Compared with the strength of solidified peat with a pH value of 5.5, the strength of peat with a pH value of 3.5 reduces by 10% ~ 46%, while the strength of peat with a pH value of 7.0 increases by 8% ~ 38%. It is recommended to use filler materials for stabilizing peat soil with moisture content greater than 200%. Because of small size of clay particles, clay added in the cement solidified peat can improve much higher strength that that of sand.

• Korean Journal of Soil Science and Fertilizer
• /
• v.27 no.4
• /
• pp.315-320
• /
• 1994

This survey report introduced briefly peat deposits in SAKHALIN island of eastern SIBERIA continent. Peat industry was promoted as leading resources for development in this island by national control economic plan of central government before CIS. But development of deposit was left suspension of operation due to investment now. In southern area, about 10km from Yuzunosakhalinsk, two deposits of peat field were explored. One of them (Troisk) was suspended at begining stage of peat harvest from 300ha field and the other(Missilop) was producing the compact peat through drying and pulverizing from 350ha peat field which showed long run harvest activities. There are plenty of peat deposits near the Polonai Reika (river) in the central area of this island, At Zbaikaritz, 40km nothern area from Polonaisk, 135ha of peat field was developed. This field was left without working but established field preparation and could be able to be harvested any time if machines and utlities were settled. At southern suburb 10km from Polonaisk, about 40ha field of virgin deposit has been established planning for development. The plan involved estimated amount of peat, deposit depth, water level, drainage and leading road. The most of peat deposits accumulated from sphagnum moss. Texture is coarse but it contains more than 95% of organic carbon near to 0.5% of total nitrogen and acidity showed pH4-5.

• Korean Journal of Soil Science and Fertilizer
• /
• v.23 no.4
• /
• pp.302-309
• /
• 1990

World research on production, classification, processing, use, quality control, and components of peat was briefly introduced. Peat research in Korea was reviewed and prospect of peat use and research were discussed, peat will greatly increase soil productivity in korea. Peat research appears to be necessary in view of a new material for high technology agriculture.

• Geomechanics and Engineering
• /
• v.9 no.4
• /
• pp.415-426
• /
• 2015

Researches have been done to discover ways to strengthen peat soil deposits. In this model study, fibrous peat that is the most compressible types of peat has been reinforced with precast peat columns stabilized with ordinary Portland cement and polypropylene fibres. Rowe cell consolidation tests as well as plate load tests (PLTs) were conducted on various types of test samples to evaluate the strength and deformation of untreated peat and peat reinforced by various types of columns. PLTs were conducted in a specially designed and fabricated circular steel test tank. The compression index ($C_c$) and recompression index ($C_r$) of fibrous peat samples reduced considerably upon use of precast columns. Also, PLT results confirmed the results obtained from Rowe cell tests. Use of polypropylene fibres added to cement further decreased ($C_c$) and ($C_r$) and increased load bearing capacity of untreated peat. Finite element method (FEM) using Plaxis 3D was carried out to evaluate the stress distributions along various types of tested samples and also, to compare the deformations obtained from FEM analysis with the actual maximum deformations found from PLTs. FEM results indicate that most of the induced stresses are taken on the upper portion of tested samples and reach their maximum values below the loading plate. Also, a close agreement was found between actual deformation values obtained from PLTs and values resulted from FEM analysis for various types of tested samples.

• Geomechanics and Engineering
• /
• v.5 no.6
• /
• pp.575-594
• /
• 2013

Organic soils exhibit problematic properties such as high compressibility and low shear strength; these properties may cause differential settlement or failure in structures built on such soils. Organic soil removal or stabilization are the most important methods to overcome geotechnical problems related to peat soils' engineering characteristics. This paper presents soil mechanical intervention for stabilization of peat with sand columns and focuses on a comparison between the mechanical characteristics of undisturbed peat and peat stabilized with 20%, 30% and 40% of sand on the laboratory scale. Cylindrical columns were extruded in different diameters through a nearly undisturbed peat sample in the laboratory and filled with sand. By adding sand columns to peat, higher permeability, higher shear strength and a faster consolidation was achieved. The sample with 70% peat and 30% sand displayed the most reliable compressibility properties. This can be attributed to proper drainage provided by sand columns for peat in this specific percentage. It was observed that the granular texture of sand also increased the friction angle of peat. The addition of 30% sand led to the highest shear strength among all mixtures considered. The peat samples with 40% sand were sampled with two and three sand columns and tested in direct shear and consolidation tests to evaluate the influence of the number and geometry of sand columns. Samples with three sand columns showed higher compressibility and shear strength. Following the results of this laboratory study it appears that the introduction of sand columns could be suitable for geotechnical peat stabilization in the field scale.

• Korean Journal of Veterinary Service
• /
• v.45 no.2
• /
• pp.111-116
• /
• 2022

The purpose of this study is to evaluate the reduction effect of microbially activated peat on odor generated by livestock farms. The odor gas was measured by stirring the livestock manure sample with the existing litter and the microbially activated peat (Healtha Peat) was developed by this research team. In outdoor farm experiment, the measurements were performed by comparing broilers farm using rice husks and microbially activated peat as litter. The weight, mortality, shipment date, and odor levels (NH₃) were measured before and after experiment. The result showed that NH₃ levels were reduced by 100% in the Healtha Peat mixed group, Healtha Peat and rice husks mixed group. In the peat mixed group, Healtha Peat and saw dust mixed group showed reduce value at 99.6% and 99.1%, respectively. However the rice husks mixed group and saw dust mixed group showed a relatively weak NH₃ reduction effect with values of 57.5% and 84.8%, respectively. After 3 months, the Healtha Peat mixed group and Healtha Peat and rice husks mixed group showed the highest NH₃ reduction effect persistence. In the outdoor farm experiment, NH₃ was present in farms using rice husks, but not in farms using Healtha Peat. In farms using Healtha Peat, the mortality and NH₃ were reduced by 75% and >90%, respectively. The average body weight increased 18% and resulted to 10% decrease in the shipping date. These results implied that microbially activated peat has a clear effect on farm NH₃ reduction and affects the productivity of farm animals.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.10 no.1
• /
• pp.61-67
• /
• 2002

Sawdust, peat, and sawdust+peat were used as bulking agent in the compost production process using three different origin of manure; cow, pig, and chicken. The organic content and individual N, P, K content of the final manure compost were higher when peat or peat+sawdust were used to control the moisture. The carbon to nitrogen ratio and moisture content were low when peat or peat+sawdust were employed. In the case of cow and pig manure compost produced with peat or peat+sawdust, beneficial microorganism content was also higher than that of the manure samples produced with sawdust only. These results indicate that peat can be a useful component in the production of high quality manure compost.

• Korean Journal of Environmental Agriculture
• /
• v.19 no.3
• /
• pp.191-193
• /
• 2000

To find out the countermeasure to plant damage at soil contaminated with oil, several adsorbents such as muck, peat, sawdust and PEAT SORB were treated at diesel oil contaminated soil. As the results, sawdust and PEAT SORB showed better effect of oil adsorption than muck and peat. Removal rate of diesel oil with sawdust treatment was higher than 95% at the condition which the ratio of adsorbent amount to oil was higher than 1:2(w/v). And the releasing amount of oil from adsorbent-oil complex was very small. With the oil treatment of $4,000\;L{\cdot}ha^{-1}$ at tillering stage, rice plant height and chlorophyll content were lower than control at non-adsorbent treatment, but those were increased at sawdust treatment.