• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2004년도 춘계학술대회
• /
• pp.1505-1509
• /
• 2004

A novel technique for fine particle beam focusing under the atmospheric pressure is introduced using a radiation pressure assisted aerodynamic lens. To introduce the radiation pressure in the aerodynamic focusing system, a 25 mm plano-convex lens having 2.5 mm hole at its center is used as an orifice. The particle beam width is measured for various laser power, particle size, and flow velocity. In addition, the effect of the laser characteristics on the beam focusing is evaluated comparing an Ar-Ion continuous wave laser and a pulsed Nd-YAG laser. For the pure aerodynamic focusing system, the particle beam width was decreased as increasing particle size and Reynolds number. For the particle diameter of 0.5 ${\mu}m$, the particle beam was broken due to the secondary flow at Reynolds number of 694. Using the Ar-Ion CW laser, the particle beam width becomes smaller than that of the pure aerodynamic focusing system about 16 %, 11.4 % and 9.6 % for PSL particle size of 2.5 ${\mu}m$, 1.0 ${\mu}m$, and 0.5 ${\mu}m$ respectively at the Reynolds number of 320. Particle beam width was minimized around the laser power of 0.2 W. However, as increasing the laser power higher than 0.4 W, the particle beam width was increased a little and it approached almost a constant value which is still smaller than that of the pure aerodynamic focusing system. The radiation pressure effect on the particle beam width is intensified as Reynolds number decreases or particle size increases relatively. On the other hand, using 30 Hz pulsed Nd-YAG laser, the effect of the radiation pressure on the particle beam width was not distinct unlike Ar-Ion CW laser.

• 한국지반공학회논문집
• /
• 제20권8호
• /
• pp.103-111
• /
• 2004

화강풍화토는 특유의 파쇄성과 압축성이 높은 이유로 일반적으로 사용되는 산정식에 의해 지지력 등을 산출하기 곤란한 문제점이 있다. 이러한 화강풍화토의 공학적 특성을 보다 상세히 밝히기 위해서는 우선 미시적인 입자자체의 특성을 충분히 검토한 후, 입자 집합체의 거시적인 거동특성과의 관련성을 우선 규명하여 한다. 그러나 지금까지 지반공학 분야에서는 하나하나의 입자에 작용하는 응력상태의 중요성에 대한 인식이 없었고, 또한 일련의 법칙성을 발견하기 어렵다는 이유로 단일의 입자특성은 다루어지지 않았다. 그러나 특유한 입자파쇄성과 고압축성을 갖는 화강풍화토의 정확하고 자세한 역학특성을 밝히기 위해서는 미시적인 입자의 특성을 조사해 지반거동에 미치는 영향을 조사할 필요가 있다. 또한 지반내에서의 수분의 존재는 입자파쇄의 활성화를 촉진시키고, 그 결과 압축성의 증가와 전단강도의 저하를 일으키는 요인이 된다. 사실상 실제로, 화강풍화토를 재료로 한 성토지반에서 지반침하가 심각한 문제로 대두되는 경우는 주로 화강풍화토 지반의 함수비 변화에 따른 압축특성의 민감한 변화의 결과로 추정하고 있다. 본 연구에서는 현미경 관찰을 통한 미시적인 입자형상 분석과 단입자 강도시험을 통한 입자강도특성을 조사하여 화강풍화토의 압축특성과의 관련성 및 입자의 파쇄성과 화강풍화토의 압축특성에 미치는 수분의 영향에 대하여 조사하였다.

• 한국군사과학기술학회지
• /
• 제21권5호
• /
• pp.591-598
• /
• 2018

The reaction characteristics of aluminum-copper(II) oxide composites initiated by the electrostatic discharge were studied as changing the aluminum particle size. Three different sizes of aluminum particles with nano-size copper(II)-oxide particle were used in the study. These composites were manufactured by two methods i.e. a shock-gel method and a self-assembly method. The larger aluminum particle size was, the less sensitive and less violent these composites were based on the electrostatic test. On the analysis of high speed camera about ignition appearances and burning time, the burning speed was faster when aluminum particle size was smaller.

• 한국대기환경학회지
• /
• 제11권3호
• /
• pp.263-272
• /
• 1995

Characteristics of anbient at Korean, Cheju Island have been studied during the intensive field study period on March 11 .sim. 17, 1994 in collaboration with other research organizations from Korea and abroad. The particle size distribution was measured using an Electrical Aerosol Analyzer(EAA) and an Optical particle Counter(OPC). Fine particles(PM1 and PM3) have been collected by filter pack samplers and their ionic compositions have been analyzed. sampling errors inherent to the filter pack sampling method are discussed and the method to analyze those errors are presented. The rine mass concentrations of this study show very similar mass concentrations when Seoul is clear. This is somewhat surprising result, because the most of researchers believe that Kosan is one of the cleanest area in Korea. Bimodal volume size distributions with peak values around 0.1 .sim. 0.2.mu.m and 3.mu.m in particle dimeter were observed for most of the measurement period, particle mass loadings and ionic composition data show a large fraction of particles are from non-sea salt origins. Estimation of water content and acidity of particles based on measurement by a gas/particle equilibrium model, SCAPE, reveals that the pH values of particles are comparable to or lower than those estimated based on measurements in Los Angeles, U.S.A. during the SCAQS study. These findings with the meteorological conditions during the study period suggest that the particles collected during the period have originated from outside Cheju Island.

• 한국대기환경학회지
• /
• 제15권6호
• /
• pp.799-804
• /
• 1999

Particle collection characteristics of the MOUDI cascade impactor has been studied for coarse particles in the range of 2 to 20$mu extrm{m}$ in aerodynamic diameter. A vibrating orifice aerosol generator was empolyed to generate monodisperse test aerosols. The oleic acid and sodium chloride(NaCl) particles were used as test aerosols. Aluminum foil and Teflon filter were selected as impaction media. The sampling flow rate was changed from 25 to 35L/min. Particle collection efficiency for single stage was examined for liquid particles. The stage response was obtained experimentally for the cascade impactor composed of three stages and a backup filter. The results showed that most of particle collection efficiencies measured in this work are similar to the efficiency curves obtained by Marple et al.(1991). For particles less than cut-off size of the stage, the collection efficiencies of solid particles are similar to those of loquid particles. However, the collection efficiency of solid particles decreases with mereasing particle diameter for the particles greater than the actual cut-off size of the impactor. The particle collection efficiency increases with increasing sampling flow rate at the same particel size. However, the collection efficiency curves seem not to be greatly shifted with the flow rate. The stage responses obtained by direct measurements in this work are in good agreement with those derived from the collection efficiency curves for single stage.

• 한국자동차공학회논문집
• /
• 제7권8호
• /
• pp.34-42
• /
• 1999

In late 1997, the portion of registered light-duty diesel vehicle was 25.3% and its emission rate was 17.1% in Korea. Especially, diesel particulate matters(DPM) and NOx are hazardous air pollutants to human health and environment in urban area. The reduction technologies of exhaust emissions from diesel engines are improvement of engine combustion, fuel quality and development of diesel exhaust after treatment , In this study , a light-duty diesel oxidation catalyst(DOC) that is one of the diesel exhaust after treatment was made for performance evaluation and the emission characteristics were tested on CVS-75 mode. And the analysis of the particle size distribution with scanning mobility particle 100, 67.6% and 66.7, 10.0% for Pt and Pt-V catalyst .And for Pt catalyst, the PM increased 7.8% because of increasing sulfate but Pt-V catalyst reduced the PM to 23.0% . Test results of particle size distribution showed that peak values of number and mass densities are respectively 100∼200nm their distribution trend independent of vehicle speed.

• 한국가시화정보학회:학술대회논문집
• /
• 한국가시화정보학회 2006년도 추계학술대회 논문집
• /
• pp.7-10
• /
• 2006

An experimental study has been conducted to quantitatively characterize the motion of neutrally buoyant particles in 2-dimensional Poiseuille flow through the micron-sized circular capillaries in the range of Re (Reynolds number) $\approx0.1\sim100$. $A{\mu}-PTV$ (Particle Tracking Velocimetry) system is adopted, which consists of a double-headed Nd:YAG laser, an epi-fluorescence microscope and a cooled CCD camera. Since high shear rate can be induced due to the scale effect even at low Re, it is shown that in micro scale neutrally buoyant particles in Poiseuille flow drift away from the wall and away from the center of the capillary. Consequently, particles accumulate at the equilibrium position of $0.52\sim0.64R$ with R being the radius of the capillary, which is analogous to that of tube flow in macro scale. There is a plateau in equilibrium position at small Re, while equilibrium position starts increasing at $Re\approx30$. The outermost edge of particle cluster is closer to the center of the capillary than that in previous studies due to low Re effect. The present study quantitatively presents characteristics of particle motion in circular capillaries. Furthermore, it is expected to give optimum factors for designing microfluidic systems that are to be used fur plasma separation from the blood.

• 한국분말재료학회지
• /
• 제30권4호
• /
• pp.332-338
• /
• 2023

Thermite welding is an exceptional process that does not require additional energy supplies, resulting in welded joints that exhibit mechanical properties and conductivity equivalent to those of the parent materials. The global adoption of thermite welding is growing across various industries. However, in Korea, limited research is being conducted on the core technology of thermite welding. Currently, domestic production of thermite powder in Korea involves recycling copper oxide (CuO). Unfortunately, controlling the particle size of waste CuO poses challenges, leading to the unwanted formation of pores and cracks during thermite welding. In this study, we investigate the influence of powder particle size on thermite welding in the production of Cu-thermite powder using waste CuO. We conduct the ball milling process for 0.5-24 h using recycled CuO. The evolution of the powder shape and size is analyzed using particle size analysis and scanning electron microscopy (SEM). Furthermore, we examine the thermal reaction characteristics through differential scanning calorimetry. Additionally, the microstructures of the welded samples are observed using optical microscopy and SEM to evaluate the impact of powder particle size on weldability. Lastly, hardness measurements are performed to assess the strengths of the welded materials.

• 한국식생활문화학회지
• /
• 제22권5호
• /
• pp.609-614
• /
• 2007

Quality characteristics of dasik were studied with varied the levels of rice grain particle size and green tea powder and compared them with commercially sold dasik. Among the samples with the same number of grinding times, the sample groups with the higher amount of green tea showed significantly the less mosture content(p<0.05). Hardness was higher in the samples containing higher amount of green tea among the ones with the same grain size (p<0.05). The M13G0.5 was evaluated to have the highest savory aroma with significance (p<0.05), and C1 to have the highest sweetness by sensory analysis. The developed dasik samples with lower rice grain particle size had significantly lower adhesiveness, chewiness, gumminess, and cohesiveness compared to those of commercial sample groups. In sensory tests, the compared groups showed significantly the higher savory aroma and flavor and very lower hardness when compared to those of commercial sample groups. With the results above, dasik with with varied the levels of rice grain particle size and green tea powder were developed with improved qualities compared to those of commercially sold dasik.

• 한국지반환경공학회 논문집
• /
• 제15권3호
• /
• pp.49-55
• /
• 2014

준설매립지반은 다양한 현장조건과 준설토의 침강-퇴적-자중압밀 과정에서 형성되기 때문에 현장조건 및 준설토의 특성에 따라 준설매립지반의 거동이 좌우된다. 준설매립지반은 준설토의 특성에 따라 서로 다른 분리퇴적층이 조성되기 때문에 다양한 현장조건과 준설토의 침강-퇴적-자중압밀특성을 고려할 수 있는 실험방법이 필요하다. 이에 본 연구에서는 현장조건인 펌프의 투기속도와 준설토의 특성에 따른 준설토의 침강-퇴적 양상을 확인하기 위하여 원심모형실험과 Laser Particle Size Analyzer를 수행하였다. 그 결과 모래 준설토 및 조립질과 세립질 흙이 혼합된 준설토는 입자에 따라 분리 퇴적되는 양상으로 나타났으며, 점성 준설토는 매립공간의 바닥면과 평행하게 퇴적되는 양상으로 나타났다.