• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.5
• /
• pp.410-416
• /
• 2001

KLN thin films were fabricated on Pt coated Si(100) wafer using an rf-magnetron sputtering method. The grown KLN thin film consists of 4-fold grains. In this experiment, the structure of 4-fold grained thin film was investigated using XRD and SEM measurements. Pt layer was also deposited using the rf-magnetron sputtering method,. XRD measurement showed that he Pt thin film has Gaussian distribution form with strong (111) direction orientation. The KLN thin film has preferred-orientation of (001) direction, and the peak consists of 2 separate peaks; one with broad FWHM and the other with narrow FWHM. The sharp peak is due to single crystal, and combining with Em results, the 4-fold grain consists of singel crystals with c-axis normal to substrate.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.358-361
• /
• 1999

This paper describes on the fabrication and characteristics of hot-film type micro-flowsensors integrated with Pt-RTD\`s and micro-heater on the Si substrate, in which MgO thin-films were used as medium layer in order to improve adhesion of Pt thin-films to SiO$_2$ layer The MgO layer improved adhesion of Pt thin-films to SiO$_2$` layer without any chemical reactions to Pt thin-films under high as gas flow rate and its conductivity increased due to increase of heat-loss from sensor to external. Output voltage was 82 mV at N2 flow rate of 2000 sccm/min, heating power of 1.2W. The respons time was about 100 msec when input flow was step-input

• Journal of the Korean Ceramic Society
• /
• v.37 no.11
• /
• pp.1126-1129
• /
• 2000

The crystallographic orientations of $Ba_{0.6}$S $r_{0.4}$Ti $O_3$(BST) thin film deposited by a metal-organic chemical vapor deposition on (111) textured Pt electrode were studied with a transmission electron microscopy. The fully crystallized BST thin film (50nm) has (100) and (110) preferred orientations. A high resolution transmission electron microscopy study has revealed the crystallographic orientation relationships between BST thin film and Pt electrode. These relationships explained the preferred orientation of BST film on (111) textured Pt electrode. With these results, we could represent the atomic arrangement at the BST/Pt interface.e.e.

• Journal of the Korean Magnetics Society
• /
• v.5 no.5
• /
• pp.362-365
• /
• 1995

The magnetic properties for $Fe_{24}Pt_{76}\;and\;Fe_{26}Pt_{74}$ have been investigated. The temperature vs. magnetic susceptibility curve for $Fe_{24}Pt_{76}$ had no peak near the Neel temperature. The magnetization proccess at 4.2 K showed only a linear variation up to the high magnetic field of 240 kOe. That for $Fe_{26}Pt_{74}$ at 77 K showed a metamagnetic transition at 100 kOe. These properties were discussed on the basis of a band picture.

• Journal of Chest Surgery
• /
• v.25 no.6
• /
• pp.661-671
• /
• 1992

From March 1988 to May 1991, 140 CarboMedics cardiac valve prostheses[75 mitral, 9 aortic and 28 double aortic-mitral] were implanted in 112 consecutive patients[mean age 36.7$\pm$11.6 years, male/female 48/76] by one surgical team operating on adult cardiac patients at Kyoungpook University Hospital Associated Surgical procedures were performed in 19 patients[16.9%]. Total follow up represented 2,345 patient-months[mean 22.4 months] and was 100% complete. Eighty-two patients[73%] were in NYHA functional class IIIor IV preoperatively and 102 patients [95%] were in class I or II postoperatively. Hospital[30 day] mortality was 4.4%, [3/75 mitral, 1/9 aortic, 1/28 double valve replacement] and late death was 1.7%. [1 /74 mitral, 1 /28 double valve replacement] The actuarial survival at 36 months was 94.0% after mitral, 80% after aortic, 92% after double valve replacement, and 93.2% for the total group. The linearized incidence of valve relater death, prosthetic valve thrombosis, anticoagulant related hemorrhage, and reoperation was 1.00%/pt-yr, 0.51%/pt/yr, 0.51%/pt-yr, and 0.51%/pt-yr respectively. The 36 month rates of freedom from valve replated death, thromboembolism, endocarditis, anti-coagulant related hemorrages, and reoperation were 98.75%, 99.08%, 100%, 99.04%, and 99.08% respectively. The 36 month rate of freedom from all valve related complications and deaths including hospital mortality was 90.2%. These fact suggest that the CarboMedics heart valve has excellent short-term result, low incidence of valve-related complications and valve dysfunction, and additional long term follow up study is necessary.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.7 no.8
• /
• pp.34-42
• /
• 1999

In late 1997, the portion of registered light-duty diesel vehicle was 25.3% and its emission rate was 17.1% in Korea. Especially, diesel particulate matters(DPM) and NOx are hazardous air pollutants to human health and environment in urban area. The reduction technologies of exhaust emissions from diesel engines are improvement of engine combustion, fuel quality and development of diesel exhaust after treatment , In this study , a light-duty diesel oxidation catalyst(DOC) that is one of the diesel exhaust after treatment was made for performance evaluation and the emission characteristics were tested on CVS-75 mode. And the analysis of the particle size distribution with scanning mobility particle 100, 67.6% and 66.7, 10.0% for Pt and Pt-V catalyst .And for Pt catalyst, the PM increased 7.8% because of increasing sulfate but Pt-V catalyst reduced the PM to 23.0% . Test results of particle size distribution showed that peak values of number and mass densities are respectively 100∼200nm their distribution trend independent of vehicle speed.

• Proceedings of the Korean Vacuum Society Conference
• /
• 1996.06a
• /
• pp.180-181
• /
• 1996

적외선 센서의 재료로 활용되고 있는 ppLT 박막(두께:8000~9000$\AA$)을 ppt/MgO(100)의 하부 구조상에 50$0^{\circ}C$ 및 $600^{\circ}C$에서 스퍼터링 증착하여 결정성 및 전기적 특성을 조사하였다. $600^{\circ}C$로 in-situ 성장된 ppLT 박막은 c-축(00l) 방향으로 배향 성장되었 고, 비유전상수(r)와 유전정접(tan)의 값이 10kHz~100kHz의 주파수에서 $\varepsilon$r≒35와 tan$\delta$≒ 0.01로 나타났다. 잔류분극량(2ppr)과 초전계수(${\gamma}$)는 상온부근에서 2ppr≒5$\mu$C/cm2, ${\gamma}$≒4$\times$ 10-8C/cm2.$^{\circ}C$로 비교적 양호한 초전박막의 전기적 특성을 나타내었다.

• Transactions of the Korean hydrogen and new energy society
• /
• v.23 no.6
• /
• pp.654-659
• /
• 2012

The interest in water gas shift (WGS) reaction has grown significantly, as a result of the recent advances in fuel cell technology and the need to develop small-scale fuel processors. Recently, researchers have tried to overcome the disadvantages of the commercial WGS catalysts. As a consequence, supported Pt catalysts have attracted a lot of researchers due to high activity and stability for WGS at low temperatures. In this study, $Pt-Na/Ce_{(1-x)}Zr_{(x)}O_2$ catalysts with various Ce/Zr ratio have been applied to WGS at a gas hourly space velocity (GHSV) of $45,515h^{-1}$. According to TPR patterns of $Pt-Na/Ce_{(1-x)}Zr_{(x)}O_2$ catalysts, the reducibility increases with decreasing the $ZrO_2$ content. As a result, Cubic structure $Pt-Na/Ce_{(1-x)}Zr_{(x)}O_2$ catalysts exhibited higher CO conversion than tetragonal structure $Pt-Na/Ce_{(1-x)}Zr_{(x)}O_2$ catalysts. Expecially, Pt-Na/$CeO_2$ exhibited the highest CO conversion as well as 100% selectivity to $CO_2$. Moreover, Pt-Na/$CeO_2$ catalyst showed relatively stable activity with time on stream. The high activity of cubic structure Pt-Na/$CeO_2$ catalyst was correlated to its higher oxygen storage capacity (OSC) of $CeO_2$ and easier reducibility of Pt/$CeO_2$.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.1539_1540
• /
• 2009

본 논문에서는 Porous Au-Pt 전극을 기반으로 연료전극과 공기전극으로 구성된 초소형 메탄올 센서를 설계 및 제작하고 그 특성을 분석해 보았다. 제안된 Porous Au-Pt 전극은 Porous 구조의 금속을 만드는 방법 중 하나인 Templating기법을 적용하여 수백나노 크기의 Pore들을 가진 Porous Au 전극을 제작하였고 그 위에 수 나노 크기의 Pt particles을 전해 도금하여 제작되었다. 고분자 전해질막 층으로서 Nafion film은 전해 도금한 Porous Au-Pt 전극 사이에 삽입하고 hot Pressing 통하여 센서를 구성하였다. Porous Au-Pt 전극을 기반으로한 전기화학 메탄올 센서는 $0.25\;cm^2$ 의 작은 전극 면적에도 불구하고 넓은 온도 범위 ($20^{\circ}C-100^{\circ}C$) 에서 온도에 따른 뛰어난 선형성(Correlation coefficient = 0.986)을 보였으며, 특히, 일정온도 ($60^{\circ}C$)에서 메탄올 농도 0 M에서 2 M 까지의 전류응답 특성을 측정, 분석 결과 메탄올 농도에 따른 9.6 mA/$mM{\cdot}cm^2$ 의 민감도 및 10 초 이내의 응답시간 특성을 보였다.

• Proceedings of the Korean Magnestics Society Conference
• /
• 2005.12a
• /
• pp.154-155
• /
• 2005

Multi-layer film of $MgO/(FePt-B)_{50nm}/ MgO$ was deposited on Si(100) substrates by RF magnetron sputtering. The boron chips were uniformly placed oil tile FePt target. The boron content of thin film was found to be about 5, 10, 15, 25 and $33 at\%$ by using a CAMECA SX-51 wavelength dispersive spectroscopy (WDX). It is observed that X-ray diffraction patterns of FePt-B film by post-annealing exhibited a transformation from disordered fcc structure to ordered $Ll_0$ phase with fct structure from around $400^{\circ}C$. By adding B, annealing temperature for ordering is about $200^{\circ}C$ lower than that of pure FePt. This remarkable decrease of the annealing temperature is closely related to the high diffusivities of Fe and Pt associated with the defects caused by movements of B atoms. The maximum coercivity(Hc) for FePt films was found to be ${\~}$13 kOe after annealing at $600^{\circ}C$ for 1hr.