• Journal of the Korean Institute of Landscape Architecture
• /
• v.40 no.6
• /
• pp.1-12
• /
• 2012

This study aims to suggest ways to improve sustainability on housing complexes. This study sampled eight housing projects in Seoul and GyeongGi-Do in Korea, which were completed in June 2007 and June 2008. Then, are retention and maintenance on "constructed greens for ecological environment" including "green structures substitutes retaining walls", "green roofs", and "green walls." Study methods are field investigations of the sampled sites, and Post Occupancy Analysis. Major findings were; 1) "constructed greens" are not well retained in more sites and and this implies the GBCS(Green Building Certification System) does not meet its objectives well, 2) User showed lower user satisfaction to "constructed greens". User satisfaction concerning "green structures substitute retaining walls" was higher than the satisfaction on the other constructed green type. Satisfaction Assessment Criteria lower 1han average were "level of quality", "meet the design objectives", "vegetation management status", "vegetation maintenance". 3) User satisfaction was strongly correlated on the level of quality factor of "constructed green". In addition, tue other factors are the significant correlations between the satisfactions. The present GBCS has inadequate assessment standards for maintenance, which lead to lower the entire satisfaction. Therefore, periodic recertification system, education and information providing for the managing personals, and incentives for good maintenance or disincentive for poor maintenance of the "constructed greens" are suggested to improve the GBCS.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.28 no.1
• /
• pp.40-45
• /
• 2015

Electrode systems: a protrusion on conductor (POC), a protrusion on enclosure (POE), a crack in epoxy plate and a free particle (FP) were fabricated to simulate insulation defects in a gas insulated switchgear (GIS). $SF_6$ gas was filled in the electrode systems by 3 bar and/or 5 bar, respectively. Partial discharge (PD) pulses were detected through a $50{\Omega}$ non-inductive resistor. A calibration test was carried out according to IEC 60270, and the sensitivity was 0.25 pC/mV. PD pulses were distributed in the phase of $50^{\circ}{\sim}135^{\circ}$ and over 95% of them existed in the phase of $55^{\circ}{\sim}120^{\circ}$ for the POC. PD pulses were distributed in the phase of $230^{\circ}{\sim}310^{\circ}$ and over 90% of them existed in phase of $220^{\circ}{\sim}300^{\circ}$ for the POE. PD pulses occurred in the phase of $40^{\circ}{\sim}60^{\circ}$ and $220^{\circ}{\sim}300^{\circ}$ for the crack, and pulse counts were 25% higher in negative polarity than in positive polarity. PD pulses were distributed in every phase unlike to other three electrode systems and the peak magnitude was measured at $118^{\circ}$ and $260^{\circ}$ for the FP. As described above, PD pulses were observed in positive polarity for the POC, in negative one for the POE, in both one for the crack and the FP. In conclusion, it is expected that the identification rate of defect type can be improved by considering the polarity ratio of PD pulses on the PRPDA method.

• Journal of the Korean Applied Science and Technology
• /
• v.33 no.1
• /
• pp.51-57
• /
• 2016

In this study, we synthesized reactive surfactant which have functional radical group for effective chemical reaction. Reactive surfactant have been synthesized using synthesis of polyoxyethylene lauryl ether(POE 23) which is nonionic surfactant and methacrylic acid, acrylic acid. benzene was used as the solvent, p-TsOH was used as the catalyst. synthesized surfactant was confirmed by FT-IR, $^1H$-NMR spectra, and elemental analysis. Evaluation of physical properties was measured HLB, cloud point, surface tension, the critical micelle concentration, emulsifying power. HLB number was evaluated 11.62 to 12.09 range. The Critical Micelle Concentration(cmc) values evaluated was $1{\times}10^{-4}{\sim}5{\times}10^{-4}mol/L$ by surface tension method. The cloud point was $35^{\circ}C$, $39^{\circ}C$ each. The emulsifymvcqa ing properties of the synthesized surfactants was lower than polyoxyethylene lauryl ether. In addition, soybean oil was better than benzene. The experimental results confirmed the ester bond, the yield of 93.27%, 94.49% was found.

• Applied Chemistry for Engineering
• /
• v.28 no.4
• /
• pp.454-459
• /
• 2017

In this study, aqueous acrylic emulsion adhesives were prepared using various surfactants and their properties were also investigated. Solids content, conversion, particle size distribution and initial adhesion properties of the prepared adhesives were compared with each other. The solid content of the adhesives was evaluated 60% and the conversion rate of the emulsion polymerization was 97% at 2 wt% concentration of synthesized surfactants. The particle size distribution analysis revealed that the size distribution of adhesive particles was 290~470 nm when the synthesized cationic surfactant was added. The initial adhesion and adhesion time were also improved. The maximum adhesive strength was found to be 2.55 kgf when using a single surfactant (POE 23), and superior to that of using other surfactants. It was confirmed that the corrosion inhibition of the adhesive prepared by adding the cationic gemini surfactant was maintained for 48 hours.

• Korean Journal of Construction Engineering and Management
• /
• v.7 no.6
• /
• pp.141-150
• /
• 2006

As the law on the private sector investment in social infrastructure was amended in January of 2005, the government is aggressively promoting BTL projects but many trials and errors and problems are occurring. Especially, the Value-For-Money evaluation conducted by the responsible agencies to judge the appropriateness of the project found there was a conspicuous difference between the computed cost and the final contract sum. Accordingly, this study is aimed to grasp the problems in the current Value-For-Money evaluation and to improve it in order to proceed with BTL projects efficiently. To achieve this, through a relative comparison to the final contract sum, a clear standard for the items of Value-For-Money evaluation was presented and thus, a model that can ensure accuracy in computing the Value-For-Money was established so that a delay in negotiations can be avoided. If the Value-For-Money evaluation established in this study is used in assessing the appropriateness of unit prices for BTL projects for education facilities, a reasonable result can be expected to be drawn in selection and negotiations with contractors, and maintenance and Post-Operation-Evaluation(POE) of education facilities as well.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.29 no.7
• /
• pp.429-434
• /
• 2016

This paper deals with the characteristics of partial discharge (PD) for the purpose of a condition based maintenance (CBM) of gas insulated switchgears (GIS) in power equipment. Four types of electrode systems such as a protrusion on enclosure (POE), a particle on spacer (POS), a free particle (FP) and a Floating were designed and fabricated. PD pulses were measured using UHF sensor with a frequency range of 300 MHz~1.4 GHz and a DAQ with a sampling rate of 250 MS/s. Discharge inception voltage (DIV), discharge extinction voltage (DEV), and phase resolved partial discharge (PRPD) were analyzed depending on electrode systems. The average DIV in the POS was 28.8 kV. It was about 1.7 times higher than that in the FP, which was the lowest value of 17.2 kV. The FP shuffled and jumped at the applied voltage of 23.5 kV. Over 95% of PD pulses in the POE were generated in the negative polarity ($181^{\circ}{\sim}360^{\circ}$) of applied voltage. The results showed the phase (${\Phi}$)-magnitude (dBm) of PD pulses by UHF sensor, a cluster was formed separately depending on electrode systems.

• Journal of The Korea Institute of Healthcare Architecture
• /
• v.27 no.3
• /
• pp.39-49
• /
• 2021

Purpose: The negative pressure isolation ward is a key facility in preparedness and response to infectious diseases. For the sustainable operation of the facility, appropriate facility improvement is required. The experience of medical staff responding to infectious diseases in the COVID-19 pandemic provides effective informations for facility planning. Methods: The post occupancy evaluation (POE) was conducted by interviewing medical staff who is working on Nationally designated negative pressure isolation ward in general hospital. Floor plan analysis was conducted before field surveys for identifying facility characteristic and spatial composition. After that, field surveys were conducted at 3 hospitals, and interviews and fieldwork were conducted together. Results: It is necessary to increase the standard size of ward area from 15m² to 20m². The size of the doffing room has to be planned for accommodation of two or more people. Equipment storage, clean storage and waste storage also should be properly planned. There were almost no problems with the circulation in the ward. There was not enough space for medical staff. Implications: For a sustainable and safe negative pressure isolation ward planning, it is necessary to exploit learning from the medical staffs who have many experiences of coping with infectious diseases.

• Proceeding of Spring/Autumn Annual Conference of KHA
• /
• 2009.04a
• /
• pp.73-77
• /
• 2009

The block housing type is coming to fore as a 'low-rise high-density housing type', which can resolve the all sorts of problem caused in Korea apartment housing complex and single-detached residental area in terms of livability, urbanity, and community. To analyze the characteristics of the block housing, the block housing in Eunpyeong New Town, in Korea was analyzed as a sample for post occupancy evaluation. The analysis show that the block housing is useful low-rise and high-density housing type, which ensures the livability as well as the urbanity and community. In details the analysis also shows the user satisfaction from the perspective of living and facility use within the block housing and individual unit.

• Journal of the Korean Institute of Traditional Landscape Architecture
• /
• v.28 no.4
• /
• pp.105-111
• /
• 2010

This research aims to grasp the main factors of the image of Xi'an Ming City Wall Park and the harmony level with city walls and moat based on citizen's consciousness to improve the future design, field survey and the POE method are employed to analyze the image factor and harmony level of the Xi'an Ming City Wall Park. In the literature survey, the related materials were collected to obtain the most useful information for references, POE study of the Xi'an Ming City Wall Park were conducted. The instrument for survey is a questionnaire that includes a portion of questions regarding Xi'an Ming City Wall Park and the design intention of the surroundings of city wall. Data were analyzed using the Statistical Package for the Social Science (SPSS17.0 for Windows). Multiple regression analysis, and correlation analysis were employed along with the use of general descriptive data analysis. The factor analysis of the image of Xi'an Ming City Wall Park identified three factors, "environment" factor, "convenience" factor, "cultural aesthetics" factor, and the most important factor is "environment" factor. Among 14 landscape elements, paving, garden architectures and entrance spaces were identified as important variables which significantly affect the overall level of harmony with the city wall, and the space for rest; waterscape and paving were identified as important variables which significantly affect the overall level of harmony with the moat.

• Korean Institute of Interior Design Journal
• /
• v.17 no.1
• /
• pp.50-59
• /
• 2008

The study aims to establish the systematic residential satisfaction index which reflected perception of high rise residents are demand on the Apartment housing. Apartment house is developed to reduce the housing shortage caused by urbanism after industrialization in Korea. It has increased constantly since the 1970s and has become the most common residential type of Korean city dwellers. It shows Korean dwelling pattern and culture. Furthermore, it can be an index of private wealth. The main purpose of the thesis is the highlight on systematic planning process for actual users' needs. In other words, city planners are eager to reflect each individual preference when he/she designs a house. More practical and accurate research in user's satisfaction of housing can be helpful to overcome limitations of city planner's personal preference which can't provide certain evidences. First, the study has carried out the survey of importance of design elements which were selected on the basis of the results of the POE, Residential Quality, Quality Of Life which were carried out for the same subject. Then, the data were analyzed by SPSS 12+ program package in terms of frequency, factor analysis and reliability analysis. The results reveals that the Residential Satisfaction Index of Apartment housing are consisted of 8 factors which had been sorted out in factor analysis which can be interpreted to be closely related to the Physical, Social psychological and General environment.