• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 추계학술대회 논문집 Vol.19
• /
• pp.162-163
• /
• 2006

XLPE is used to insulator for Ultra High Voltage power cable. It is easy to processing also has a good insulating property. The study for diagnosis of lifetime and improvement is proceeding continuously. In this paper, it is investigated partial discharge distribution according to slope of needle electrode 0, 20, $40^{\circ}$. Applied voltage is 0.5 [kV/s] by step form for inception voltage. As the result of study, we conformed that increase of slope led to reduce of discharge number and total discharge quantity.

• 한국표면공학회지
• /
• 제25권4호
• /
• pp.189-206
• /
• 1992

The effect of activation and electroless nickel plating conditions on contact properties was investi-gated for selective electroless nickel plating of Si wafers in order to obtain an optimum condition of con-tact hole filling. According to RCA prosess, p-type silicon (100) surface was cleaned out and activated. The effects of temperature, DMAB concentration, time, and strirring were investigated for activation of p-type Si(100) surface. The optimal activation condition was 0.2M HF, 1mM PdCl2, 2mM EDTA,$ 70^{\circ}C$, and 90sec under ultrasonic vibration. In electroless nickel plating, the effect of temperature, DMAB concentra-tion, pH, and plating time were studied. The optimal plating condition found was 0.10M NiSO4.H2O, 0.11M Citrate, pH 6.8, $60^{\circ}C$, 30minutes. The contact resistance of films was comparatively low. It took 30minutes to obtain 1$\mu\textrm{m}$ thick film with 8mM DMAB concentration. The film surface roughness was improved with decreasing temperature and decreasing pH of the plating solution. The best quality of the film was obtained at the condition of temperature $60^{\circ}C$ and pH 6.0. The micro-vickers hardness of film was about 800Hv. Plating rate of nickel on the hole pattern was slower than that of nickel on the line pattern.

• 한국정보통신학회논문지
• /
• 제8권7호
• /
• pp.1576-1580
• /
• 2004

최근 정보통신의 흐름은 사용자의 다양한 정보 욕구를 만족시키기 위한 통신 서비스의 개발에 주력하고 있다. 근거리망의 통신에 광송신 모듈은 850nm, 1310nm의 파장대역을 사용하며, 광원의 구조는 LD를 사용하였지만, 장파장 및 Gbps급에서는 데이터 처리 능력이 뛰어난 수직공진형 표면발광 레이저(Vertical Cavity Surface Emitting Laser : VCSEL)을 많이 사용한다. 본 연구에서는 기본적인 광특성을 분석한 후 GHz급 이상에서 동작이 가능하도록 광전송 모듈을 개발하고 펄스 패턴 발생구를 이용하여 2.5GHz, 3GHz에서의 전송 특성을 분석하였다.

• Journal of Electrical Engineering and Technology
• /
• 제2권1호
• /
• pp.118-122
• /
• 2007

In this work, experimental investigation is carried out in order to design and fabricate the UHF sensor that is able to detect the partial discharges produced from 10 artificial defects introduced into the real scale 70kV GIS mock-up under high voltage within a well shielded room. As well, in order to verify the on-site applicability of our method, the newly proposed CAPD (chaos analysis of partial discharge) is combined with spectral analysis for identifying the nature of 10 artificial defects under investigation. The PD pattern recognition of each defect has been fulfilled by applying our ANN software. The result indicates that the recognition rate reaches up to 80% by the newly proposed method while the traditional PRPD analysis method allows us to obtain 41%. In consequence, it can be pointed out that the proposed method seems likely to be applicable to the real GIS at the site.

• 대한건축학회논문집:계획계
• /
• 제34권2호
• /
• pp.13-21
• /
• 2018

The elderly are more likely to experience passive emotions such as loneliness, anxiety, and depression due to decreased physiological function and low participation in social activities. Therefore, the purpose of this study is to seek how to apply biophilic design from a healing perspective considering mental health to the residential space for the elderly. Biophilic design has a positive effect on the psychological stability of human being and the creation of a human-centered environment that provides various benefits to people's health through the combination with natural elements. The method of this study is as follows. First, survey tools are developed by reviewing literature related to biophilic design and planning factors in housing. Second, we conduct the survey around mental health status and preference of applying biophilic design patterns to the elderly and pre-elderly. Third, we propose a plan to apply biophilic design patterns in houses based on the analyzed results. The biophilic design pattern covered in this study is meaningful in that it seeks clues, the housing plan to create healing environment for the elderly with the nature friendly view.

• 대한건축학회논문집:계획계
• /
• 제34권3호
• /
• pp.129-138
• /
• 2018

The purpose of this study is to analyze the daily living area of the elderly using the vast amount of travel route data collected through smart phones. In order to analyze the utilization status of the elderly into the visiting area and the living area, the subway station influence area was typed based on the number and ratio of the elderly visiting and the elderly living there. The characteristics of the elderly visiting area and the living area of the subway station area were derived by analyzing the walking route data for the three types of subway station influence areas where the elderly visit and live. First, we derive the range of visiting area and living area of the elderly near the subway station. Second, we derive the characteristic of moving distance which causes the linked walking of the elderly. Third, destination distribution and facility utilization are influenced by the subject of use, movement pattern, and facility awareness.

• BMB Reports
• /
• 제40권5호
• /
• pp.684-689
• /
• 2007

The endogenous neurotoxin, 1-methyl-6,7-dihydroxy-1,2,3,4-tetrahydroisoquinoline (salsolinol), has been considered a potential causative factor for the pathogenesis of Parkinson's disease (PD). In the present study, we examined the pattern of human Cu,Zn-superoxide dismutase (SOD) modification elicited by salsolinol. When Cu,Zn-SOD was incubated with salsolinol, some protein fragmentation and some higher molecular weight aggregates were occurred. Salsolinol led to inactivation of Cu,Zn-SOD in a concentration-dependent manner. Free radical scavengers and catalase inhibited the salsolinol-mediated Cu,Zn-SOD modificaiton. Exposure of Cu,Zn-SOD to salsolinol led also to the generation of protein carbonyl compounds. The deoxyribose assay showed that hydroxyl radicals were generated during the oxidation of salsolinol in the presence of Cu,Zn-SOD. Therefore, the results indicate that free radical may play a role in the modification and inactivation of Cu,Zn-SOD by salsolinol.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1993년도 추계학술대회 논문집
• /
• pp.49-54
• /
• 1993

This paper discusses the reliability of solder joints of electronic devices on printed circuit board. Solder application is usually done by screen printing method for the bonding between outer leads of devices and thick film(Ag/Pd) pattern on Hybrid IC as wel1 as Cu lands on PCB. As result of thermal stresses generated at the solder joints due to the differences of thermal expansion coefficients between packge body and PCB, Micro cracking often occurs due to thermal fatigue failure at solder joints. The initiation and the propagate of solder joint crack depends on the environmental conditions, such as storage temperature and thermal cycling. The principal mechanisms of the cracking pheno- mana are the formation of kirkendal void caused by the differences in diffusion rate of materials, ant the thermal fatigue effect due to the differences of thermal expansion coefficient between package body and PCB. Finally, This paper experimentally shows a way to supress solder joints cracks by using low-${\alpha}$ PCB and the packages with thin lead frame, and investigates the phenomena of diffusion near the bonding interfaces.

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 2012년도 춘계학술발표대회
• /
• pp.90.1-90.1
• /
• 2012

1934년 J. R. Winkler에 의해 처음으로 개발된 pulse current 도금은 연속적인 직류 단속을 이용한 전기도금으로써 종래의 연속적인 직류(direct current) 전기 도금이 가지는 다공성 및 거친 도금 등의 한계를 극복하기 위해 연구되고 있다. 최근 전기 전자 산업의 급속한 발달과 함께 Au, Pd, Rh 등의 귀금속 도금에 있어서 Pulse 도금은 광택, 다공도, 내부 응력, 불순물 및 수소 함유량의 감소와 같은 특성 향상을 가질 수 있으며 기존 DC 전기 도금의 문제점 해결책으로서 많은 연구가 이루어지고 있다. 하지만 현재까지 Pulse 도금의 정확한 기구(mechanism)에 대한 명확한 정립이 되어 있지 않아 모든 도금계에 적용할 수 있는 standard pattern이 없는 실정이다. 본 연구에서는 귀금속 도금 중 Ag pulse 도금에 있어서 Peak current density, duty cycle, time이 Ag 도금의 표면 형상, 두께, 열전도율에 미치는 영향에 대해 연구하였다.

• 조명전기설비학회논문지
• /
• 제14권2호
• /
• pp.8-17
• /
• 2000

본 연구에서는 부분방전의 인식을 위한 두가지 접근법을 제안하였다. 첫 번째로는 백프로파게이션 알고리즘을 적용한 신경회로망이구 두 번째로는 두 연산자 백터간의 사이각 계산이다. 부분방전신호는 IEC(b), 침대평판 및 CIGRE method II 등 3가지 전극계로부터 각각 검출되었다. 신경회로망과 벡터의 사이각을 이용한 방법 모두 이리 학습된 패턴에 대해서는 양호한 인식능력을 보였다. 그려고 사용되는 연산자의 수가 미학습패턴의 인식능력에 큰 영향올 미쳤다.