• Membrane and Water Treatment
• /
• v.14 no.1
• /
• pp.1-10
• /
• 2023

This study explored the feasibility of calcium-rich food waste, Mactra veneriformis shells (MVS), as an adsorbent for phosphate removal, and its removal efficiency was enhanced by the thermal activation process. The CaCO3 in MVS was converted to CaO by thermal activation (>800 ℃), which is more favorable for adsorbing phosphate. Thermal activation did not noticeably influence the specific surface area of MVS. The MVS thermally activated at 800 ℃ (MVS-800), showed the highest phosphate adsorption capacity, was used for further adsorption experiments, including kinetics, equilibrium isotherms, and thermodynamic adsorption. The effects of environmental factors, including pH, competing anions, and adsorbent dosage, were also studied. Phosphate adsorption by MVS-800 reached equilibrium within 48h, and the kinetic adsorption data were well explained by the pseudo-first-order model. The Langmuir model was a better fit for phosphate adsorption by MVS-800 than the Freundlich model, and the maximum adsorption capacity of MVS-800 obtained via the Langmuir model was 188.86 mg/g. Phosphate adsorption is an endothermic and involuntary process. As the pH increased, the phosphate adsorption decreased, and a sharp decrease was observed between pH 7 and 9. The presence of anions had a negative impact on phosphate removal, and their impact followed the decreasing order CO₃^2- > SO₄²- > NO₃^- > Cl^-. The increase in adsorbent dosage increased phosphate removal percentage, and 6.67 g/L of MVS-800 dose achieved 99.9% of phosphate removal. It can be concluded that the thermally treated MVS-800 can be used as an effective adsorbent for removing phosphate.

• Korean Chemical Engineering Research
• /
• v.53 no.5
• /
• pp.576-583
• /
• 2015

This paper aims to investigate the potential use of cempedak durian peel (CDP) from Negara Brunei Darussalam, which is low-cost, locally available, eco-friendly and highly efficient to remove methyl violet (MV) dye from aqueous solutions. The time required for equilibrium to be reached is 2.0 h with no adjustment of pH necessary. FTIR analysis was indicative of the involvement of -COOH and C=O functional groups in adsorption process. The Langmuir model provided the best fit with maximum adsorption capacity of $0.606mmol\;g^{-1}$. Thermodynamics data indicate that the adsorption is spontaneous, feasible and endothermic in nature. Best regeneration of CDP's adsorption ability is achieved by base solution, showing about 95% removal efficiency of MV even after 5 cycles, indicating that CDP can be regenerated and reused. This, together with its high adsorption capacity, makes CDP a potential adsorbent for the removal of MV in wastewater.

• Journal of Environmental Science International
• /
• v.25 no.8
• /
• pp.1155-1163
• /
• 2016

The treatment efficiencies of domestic sewage treatment processes were analysed and assessed to suggest and design a suitable technology for coal seam gas (CSG) water treatment. Two sewage treatment plants (S and G in Busan) were selected. The former operates with standard activated sludge and modified Ludzak Ettinger processes while the later uses the combination of $A_2/O$ and gravity fiber filtration. For both plants, the concentrations of BOD, $COD_{Mn}$, T-N and T-P were about 5.0, 19.0, 5.0, 11.0 and 1.0 ppm, respectively, which satisfy the discharge standards. Therefore, although sewage treatment processes seems to be applicable for CSG water treatment, additional processes to remove total dissolved solids and ionic compounds (i.e. bicarbonate) need to be introduced to produce fit-for-purpose water resources for beneficial use (in accordance with Water ACT 2013). This, for the CSG treatment process design, it is necessary to align the operating conditions with merging methods of combinable unit technology obtained from sewage treatment processes.

• Advances in nano research
• /
• v.11 no.6
• /
• pp.667-678
• /
• 2021

Multiwalled carbon nanotubes (MWCNTs) were first oxidized (O-CNTs) to introduce carboxylic group and then further functionalized (F-CNTs) with m-phenylenediamine, which was confirmed by FTIR and SEM. It was used as an effective adsorbent for the adsorptive removal of diclofenac drug from water. Under optimum conditions of pH 6, stirring speed 600 rpm, the maximum adsorption capacity obtained was 532 mg g^-1 which is superior to the values reported in literature. The adsorption was quite rapid as 25 mg L^-1 drug solution was adsorbed in only 3 minutes of contact time with 10 mg of adsorbent dose. The adsorption kinetics and isotherms were studied using various models to evaluate the adsorption process. The results showed that the data best fit in kinetics pseudo-second order and Langmuir isotherm model. Furthermore, the oxidized and functionalized MWCNTs were applied on gram-negative Escherichia coli and gram-positive Staphylococcus aureus using agar disc diffusion assay to validate their anti-microbial activity. Results were unique as both oxidized and functionalized MWCNTs were equally active against both E. coli and S. aureus. The newly synthesized F-CNTs have great potential in water treatment, with their dual action of removing drug and pathogens from water, makes it potential applicant to save environment.

• Nuclear Engineering and Technology
• /
• v.26 no.1
• /
• pp.78-89
• /
• 1994

The radionuclide release rates from the engineered barrier composed of concrete structure and clay-based backfill in a low and intermediate level waste repository were assessed. Four types of release pathway were considered, and the contribution of each pathway to the total release were analyzed. To quantify the effect of uncertainties of input parameter values on the assessment of radionuclide release rates, the Latin Hypercube sampling method was used, and the resulting release rate distribution were determined through a goodness-of-fit test. Finally, the ranges of maxi-mum release rates ore estimated statistically with a confidence level of 95%.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.7 no.4
• /
• pp.673-680
• /
• 1997

NaOH, $Na_2CO_3, CaO, Ca(OH)_2$ and $CaCO_3$ are widely used counteractives for neoutralizing the waste sulphuric acid produced during the metal surface treatment process and/or the metal refining process. To reduce the tremendous expenses for the neutralization treatment of the waste sulphuric acid, the sludge from calcination plant and the stainless refining dust in POSCO (Pohang Iron ＆ Steel co. Ltd.) was utilized. For the sludge, it will be effective to use calcined and then hydrated sludge in strong acid region (pH<2) and to use the sludge itself in weak acid region (pH>2), The gypsum, the by-product of this treatment, was tested to fit the industrial standard of gypsum, so it is expected that it will solve the lack of gypsum supply. For the stainless refining dust, the phase and the morphology of produced gypsum from waste suiphuric acid neutralization was compared with those from pure sulphuric acid. Because of high reactivity and reaction temperature, $CaSO_4$ non-hydrate was obtained in pure sulphuric acid. But $CaSO_4$ dihydrate was obtained in waste sulphuric acid. It is also judged to be a good material for a counteractive of the waste sulphuric acid.

• Publications of The Korean Astronomical Society
• /
• v.30 no.2
• /
• pp.591-592
• /
• 2015

X1822-371 is a low mass X-ray binary with an accretion disk corona exhibiting partial eclipses and pulsations in the X-ray band. We update its orbital ephemeris by combining new RXTE observations and historical records, with a total time span of 34 years. There were 11 RXTE observations in 2011 but the eclipsing profile can be seen in only 4 of them. The eclipsing center times were obtained by fitting the profile with the same model as previous studies. Combined with the eclipsing center times reported by Iaria et al. (2011), the O-C analysis was processed. A quadratic model was applied to fit the O-C results and produced a mean orbital period derivative of $\dot{P}_{orb}=1.339(25){\times}10^{-10}s/s$, which is slightly smaller than previous records. In addition to the orbital modulation from the orbital profile, we also present our preliminary results for measuring the orbital parameters using the orbital Doppler effect from the pulsation of the neutron star in X1822-371. The updated orbital parameters from eclipsing profiles will be further compared with the ones from pulsar timing.

• Asian-Australasian Journal of Animal Sciences
• /
• v.30 no.7
• /
• pp.985-993
• /
• 2017

Objective: The objective of this study was to evaluate increasing doses of a novel microbial phytase (Cibenza Phytaverse, Novus International, St. Charles, MO, USA) on standardized total tract digestibility (STTD) of P in canola meal (CM), corn, corn-derived distiller's dried grains with solubles (DDGS), rice bran (RB), sorghum, soybean meal (SBM), sunflower meal (SFM), and wheat. Methods: Two cohorts of 36 pigs each (initial body weight = $78.5{\pm}3.7kg$) were randomly assigned to 2 rooms, each housing 36 pigs, and then allotted to 6 diets with 6 replicates per diet in a randomized complete block design. Test ingredient was the only dietary source of P and diets contained 6 concentrations of phytase (0, 125, 250, 500, 1,000, or 2,000 phytase units [FTU]/kg) with 0.4% of $TiO_2$ as a digestibility marker. Feeding schedule for each ingredient was 5 d acclimation, 5 d fecal collection, and 4 d washout. The STTD of P increased (linear or exponential $p{\leq}0.001$) with the inclusion of phytase for all ingredients. Results: Basal STTD of P was 37.6% for CM, 37.6% for corn, 68.6% for DDGS, 10.3% for RB, 41.2% for sorghum, 36.7% for SBM, 26.2% for SFM, and 55.1% for wheat. The efficiency of this novel phytase to hydrolyze phytate is best described with a broken-line model for corn, an exponential model for CM, RB, SBM, SFM, and wheat, and a linear model for DDGS and sorghum. Based on best-fit model the phytase dose (FTU/kg) needed for highest STTD of P (%), respectively, was 735 for 64.3% in CM, 550 for 69.4% in corn, 160 for 55.5% in SBM, 1,219 for 57.8% in SFM, and 881 for 64.0% in wheat, whereas a maximum response was not obtained for sorghum, DDGS and RB within the evaluated phytase range of 0 to 2,000 FTU/kg. These differences in the phytase concentration needed to maximize the STTD of P clearly indicate that the enzyme does not have the same hydrolysis efficiency among the evaluated ingredients. Conclusion: Variations in enzyme efficacy to release P from phytate in various feedstuffs need to be taken into consideration when determining the matrix value for phytase in a mixed diet, which likely depends on the type and inclusion concentration of ingredients used in mixed diets for pigs. The use of a fixed P matrix value across different diet types for a given phytase concentration is discouraged as it may result in inaccurate diet formulation.

• Journal of Korean Physical Therapy Science
• /
• v.25 no.2
• /
• pp.47-54
• /
• 2018

Purpose: The purpose of this study was to investigate the most effective exercise position of Latissimus dorsi's activities during Pull up, Push up and Lat pull down among few positions of hand grips(pronation, Supination and neutral grip) and grip widths(30cm, 60cm) based on EMG activities. Method: 10 healthy adults were participated in this study and the surface EMG activities of the Latissimus dorsi were measured during Pull up, Push up and Lat pull down exercise according to specific hand grip and grip width positions. The maximum and mean value of Latissimus dorsi's EMG activities at all positions were recorded and analysed by ONE-WAY REAPTED ANOVA. Results: The showed that the most Latissimus dorsi's activities is during Pull up exercise. Main results are as follows 1)maximum value: For Pull up, among all studied positions, Rt Latissumus dorsi, position of Supinated grip and 60cm grip width showed strongest muscle activation based on maximum EMG value. Statistical significance was assumed at p<.05. 2)mean value: For Pull up, among all studied positions, Both Latissimus dorsi, position of pronated grip and 60cm grip width showed strongest muscle activation based on mean EMG value. Statistical significance was assumed at p<.05. Conclusion: Therefore, taking the results of this study, Pull up exercise would be the best exercise of Latissimus dorsi's activation. It is recommended to do in pronated grip position and 60cm grip width during Pull up to make body fit.

• Food Science and Preservation
• /
• v.18 no.5
• /
• pp.721-728
• /
• 2011

1(3)-palmitoyl-2-oleoyl-3(1)-stearoyl-(POS)-glycerol-enriched reaction products were synthesized from camellia oil, palmitic ethyl ester, and stearic ethyl ester via lipase-catalyzed interesterification. Response surface methodology (RSM) was employed to optimize the production of the POS-enriched reaction product (Y1, %) and the stearicand palmitic-acid contents at the sn-2 position due to acyl migration (Y2, %). The reaction factors were the enzyme amount (X1, 2-6%), reaction time (X2, 60-360 min), and substrate molar ratio of camellia oil to palmitic ethyl ester and stearic ethyl ester (X3, 1-3 mol). The predictive models for Y1 and Y2 were adequate and reproducible as no lack of fit was signified (0.128 and 0.237) and as there were satisfactory levels of R2 (0.968 and 0.990, respectively). The optimal conditions for the reaction product for maximizing Y1 while minimizing Y2 were predicted at the reaction combination of 5.86% enzyme amount, 60 min reaction time, and 1:3 substrate molar ratio (3 moles of palmitic ethyl ester and 3 moles of stearic ethyl ester). Actual reaction was performed under the same conditions as above, and the resulting product contained 20.19% TAG-P/O/S and 12.71% saturated fatty acids at the sn-2 position.