• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1999년도 봄 학술발표회 논문집(I)
• /
• pp.209-214
• /
• 1999

Strength provisions in Korea Concrete Institute code are more conservative that those in ACI code by increasing load factors and decreasing capacity reduction factors. Cement content of mix design in construction field is usually higher than the modified for standard deviation because of rigorous inspection. Higher cement content increases not only strengths but also heat of hydration, shrinkage and brittleness which are not beneficial. To reduce and optimize the cement content in current mix design of Korean Highway Corporation, properties of fresh and hardened concrete for 16 different mix proportions have been investigated. It is found that the chemical admixture and cement of current mix proportions for highway construction are somewhat higher than the optimum amount. Therefore, the optimum mix design for 16 different purposes has been proposed.

• 한국농공학회논문집
• /
• 제55권3호
• /
• pp.25-33
• /
• 2013

In this study, the optimum mix proportions of rain garden structure concrete were decided and the mechanical properties were evaluated. Experimental parameters were blast furnace slag, hwang-toh, recycled aggregates and natural jute fibers. The target compressive strength and chloride ion penetration were more than 24 MPa and less than 1000 coulombs, respectively. The response surface method was used for statistical optimization of experimental results. The optimal mixing ratios of the blast furnace slag, hwang-toh, recycled coarse aggregate and jute fiber volume fraction were determined 59.98 %, 8.74 %, 12.12 % and 0.2 %, respectively. The compressive strength, flexural strength and chloride ion penetration test results of optimum mix ratio showed that the 24.56 MPa, 3.88 MPa and 999.08 columbs, respectively.

• 콘크리트학회논문집
• /
• 제17권2호
• /
• pp.293-302
• /
• 2005

This study describes data from determination of the optimum mix proportion and site application of the mass concrete placed in bottom slab and side wall having a large depth and section as main structures of LNG in-ground tank. This concrete requires low heat hydration, excellent balance between workability and consistency because concreting work of LNG in-ground tank is usually classified by under-pumping, adaptation of longer vertical and horizontal pumping line than ordinary pumping condition. For this purpose, low heat Portland cement and lime stone powder as cementitious materials are selected and design factors including unit cement and water content, water-binder ratio, fine aggregate ratio and adiabatic temperature rising are tested in the laboratory and batch plant. As experimental results, the optimum unit cement and water content are selected under $270kg/m^3$ and $l55{\~}l60 kg/m^3$ separately to control adiabatic temperature rising below $30^{\circ}C$ and to improve properties of the fresh and hardened concrete. Also, considering test results of the confined water ratio($\beta$p) and deformable coefficient(Ep), $30\%$ of lime stone powder by cement weight is selected as the optimum replacement ratio. After mix proportions of 5cases are tested and compared the adiabatic temperature rising($Q^{\infty}$, r), tensile and compressive strength, modulus of elasticity, teases satisfied with the required performances are chosen as the optimum mix design proportions of the side wall and bottom slab concrete. $Q^{\infty}$ and r are proved smaller than those of another project. Before application in the site, properties of the fresh concrete and actual mixing time by its ampere load are checked in the batch plant. Based on the results of this study, the optimum mix proportions of the massive concrete are applied successfully to the bottom slab and side wall in LNG in-ground tank.

• 한국건축시공학회지
• /
• 제3권3호
• /
• pp.91-97
• /
• 2003

At present, the antiwashout underwater concretes are used as popular construction materials in European countries, the United States and Japan. The water-soluble polymers in the antiwashout underwater concretes provide excellent segregation or washout resistance, self-compaction and self-leveling property to the concretes. The purpose of this study is to recommend to optimum mix proportions of antiwashout underwater concretes according to compressive strength of 300kgf/$\textrm{cm}^2$ to 500kgf/$\textrm{cm}^2$. The antiwashout underwater concretes are prepared with various unit cement content, unit water content, sand-aggregate ratio, unit antiwashout agent and superplasticizer content. And they are tested for flowability, and compressive strength. From the test results, it is possible to recommend the optimum mix proportions of antiwashout underwater concretes according to compressive strengths within the range of 300kgf/$\textrm{cm}^2$ to 500kgf/$\textrm{cm}^2$.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2009년도 춘계 학술대회 제21권1호
• /
• pp.369-370
• /
• 2009

본 연구의 목적은 영구지보재로서 적용될 폐석탄회를 사용한 고성능 숏콘크리트의 적정배합비를 도출 하는데 있다. 플라이애시의 다양한 함량에 따른 압축강도를 비교분석하였다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1998년도 봄 학술발표회 논문집(I)
• /
• pp.237-242
• /
• 1998

Covering mortar as a filter for permeable polymer concrete is necessary for good permeability from filtration continuously. Therefore, this paper is intended as an evaluation of the mechanical properties and permeability of permeable polymer concrete covered with polymer mortar as a filter. An optimum permeable polymer concrete is selected in various mix proportions, and three different polymer mortars were cast immediately following on the casting of the base permeable polymer concrete. And they are tested for compressive and flexural strengths, adhesion in tension, hardening shrinkage and permeability . From the test results, binder and filler contents in mix proportions had a great influence on the permeability of polymer concretes. The mechanical properties of permeable polymer concretes covered with polymer mortars using crushed stone are superior to other filters, and hardening shrinkage is the smallest in filters. It is apparent that adhesion between the base permeable polymer concrete and polymer mortar is affected by the degree of hardening shrinkage. From this study, proper mix proportions can be recommended in the consideration of properties of the permeable polymer concrete.

• 콘크리트학회논문집
• /
• 제17권4호
• /
• pp.559-567
• /
• 2005

본 연구는 혼화재료(실리카퓸, 플라이애쉬, 고로슬래그)를 사용하여 교면 포장에 적용할 고성능 콘크리트의 최적배합비를 도출하기 위하여 실시되었다. 최적배합비를 도출하기 위하여 실리카퓸, 플라이애쉬, 고로슬래그의 세가지 혼화재료를 고려하여 통계학의 최적화 기법인 Box Behnken 설계 방법을 사용하였다. 압축강도와 염소이온투과저항성 시험을 실시하였으며 시험 결과를 기초로 최적의 배합비를 도출하였다. 도출된 최적배합은 기술적으로 분석하였으며 시험 결과는 교면포장을 위한 고성능 콘크리트 성능 기준과 비교하였다. 최적배합은 만족할 만한 성능을 보여주었다. 또한 최적배합으로 도출된 고성능 교면포장 콘크리트는 재료의 가격뿐만 아니라 모빌믹서를 사용하지 않고 일반 믹서를 사용하기 때문에 시공비용도 감소시킬 수 있다.

• 대한토목학회논문집
• /
• 제29권1A호
• /
• pp.95-100
• /
• 2009

본 연구에서는 신속개방형 포장 콘크리트의 적정배합비를 도출하기 위한 실험을 실시하였다. 콘크리트 타설 후 8시간 후 교통개방을 하기 위해 조강제 및 조강시멘트를 사용하였으며 조강제의 적정 혼입량을 결정하기 위해 예비실험을 실시하였다. 이를 바탕으로 시멘트 및 잔골재율을 변수로 공기량, 슬럼프 경시변화, 응결시험, 압축강도, 휨강도 시험을 실시하였다. 실험 결과 8시간 목표 압축강도 21 MPa, 휨강도 3.8 MPa를 만족하는 신속개방형 교통개방 포장 콘크리트의 적정배합비를 도출하였다.

• 한국농공학회논문집
• /
• 제49권3호
• /
• pp.43-50
• /
• 2007

The purpose of this study was to determine the optimum mix proportion of latex modified mortar for agricultural underwater concrete structures repair. The experimental variables included a latex and antiwashout admixture amount, binder-sand ratio, water-binder ratio. This study were evaluated a repair performance and environment effect of latex modified repair mortar for agricultural underwater concrete structures. The pH test was conducted to evaluated the environmental effect and the flow test was peformed to evaluated the workability. Also, compressive, flexural and bond tests were conducted. Test results show that the optimum mix proportion of latex modified repair mortar for agricultural underwater concrete structures, was achieved by 1:1.5 binder-sand ratio, 5% latex ratio (weight of binder), 1.3% antiwashout admixture ratio (weight of binder), 0.33 water-binder ratio and 10% silica lune replacement ratio (weight of cement). The environmental effect and repair performance of optimum mix proportion satisfied all target performance.

• 한국건설순환자원학회논문집
• /
• 제2권3호
• /
• pp.196-201
• /
• 2014

최근 국내외 정세의 변화와 함께 예상하지 못한 테러 등의 극한의 하중의 발생가능성이 증대하고 있다. 또한 국외 건설시장의 활성화와 함께 몇몇 중동국가를 포함하여 정세가 불안정한 국가로의 진출이 잦아지고 있어 신규 또는 기존 사회기반시설 및 건축물의 물리적인 안전성이 많이 요구되고 있다. 따라서 기존의 콘크리트나 강재로는 저항이 불가한 폭발 또는 충격하중의 저항성이 건설재료로서의 중요성이 증가하고 있는 실정이다. 본 연구는 이러한 폭발 및 충격하중에 저항하기 위한 초고성능 강섬유보강 시멘트 복합체를 개발하기 위한 기초연구로서 고혼입량의 강섬유를 우선 도포하고 내부를 충전하기 위한 슬러리의 최적배합의 결정을 위한 연구이다. 이러한 고혼입량의 강섬유의 내부를 충전하기 위한 슬러리의 기초특성을 분석하고자 재료혼입을 변수로 하여 컨시스턴시, 흐름도, J-Fiber Penetration, 블리딩 및 레올로지 특성 및 역학적 특성으로 압축강도와 휨강도를 측정하였다.