• Journal of the Korean GEO-environmental Society
• /
• v.13 no.10
• /
• pp.63-68
• /
• 2012

This study was performed to determine optimum conditions of batch type cultivation of Isochrysis galbana cultivated under various wavelengths of light emitting dioes (LEDs). Among LEDs used in the cultivation, white LED was found to be the most effective light source, and light intensity of 3,000Lux resulted in the most effective for the cultivation of Isochyrysis galbana. Comparison with common light source, fluorescent light, showed less effective than that with white LED. Four different air flow rates were tested to overcome shading effects due to denser cell concentration in the solution. In results, cell growth rates and maximum cell concentrations were similar regardless of air flow rates. Three times greater cell concentrations, however, were observed when air was applied.

• Korean Journal of Materials Research
• /
• v.21 no.1
• /
• pp.46-49
• /
• 2011

Bi co-doped ZnS:Mn,Bi yellow phosphors for white light emitting diodes were prepared by the conventional solidstate reaction method. The optical and structural properties of ZnS:Mn,Bi phosphors were investigated by x-ray diffraction, scanning electro microscopy and photoluminescence. ZnS:Mn,Bi phosphors showed XRD patterns of hexagonal structure. The photoluminescence of ZnS:Mn,Bi phosphors showed spectra extending from 480 to 700 nm, peaking at 580 nm. The photoluminescence of 580 nm in the ZnS:Mn,Bi phosphors was associated with the 4T1 ${\rightarrow}$ 6A1 transition of the Mn2+ ions. The highest photoluminescent intensity of the phosphors under 405 nm and 450 nm excitation was obtained at Bi concentration of 7mol%. The optimum mixing conditions with epoxy and yellow phosphor for white light emitting diodes were observed in a ratio of epoxy:yellow phosphor of 1:3.5. The CIE chromaticity of the white LED at the 1:3.5 ratio was X = 0.3454 and Y = 0.2449.

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.6
• /
• pp.530-534
• /
• 2008

The LGP with nanometer structures resulted in enhancement of optical efficiency. Its fundamental mechanism is to recycle the polarized light via one round-trip through QWP(Quarter-wave Plate) but the maximum efficiency to reach with this method is limited up to 2. To get the larger efficiency than this a LGP with 1D PC(one-dimensional photonic crystal) nanometer-patterned on its top and bottom surfaces is suggested. For its optimum design the computer simulation is performed and suggests a grating that the spatial frequency between adjacent patterns is 500nm, its height 250nm, duty cycle 50%, and its cross section is rectangular. The angles of transmitted light are nearly the same as the results expected from the generalized Snell's law. Thus the Mathematica code, developed in this experiment, will be applied to designing the optimized LGP. The LGP with nanometer-patterened 1D PC LGP on its both surfaces shows the enhancement of transmitted intensity distribution up to 5.7 times.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2010.10a
• /
• pp.757-758
• /
• 2010

At the time of medical treatment and surgical operation, halogen lamp and plasma lamp were mainly used as luminous source for lighting. These two luminous sources have drawbacks that the life of lamps are not long, various problems are brought about due to excessive heat generation and its volume is very big because of cooling device. Accordingly, in this research a ring light was developed so that a partial shadowless shooting for the patient's affected area at the medical treatment room and surgical operation room using high luminance LED for which attention is being paid as new lighting parts for medical purpose. LED which was applied to the development used high luminance three color LED for full color for which various color materialization and the adjustment of radiation intensity are possible and we can get white light in order to emphasize the delicate expression for generic tone of shooting object, strong highlight, simple shadow and three dimensional effect at the time of close-up shadowless shooting of the affected area.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.3A
• /
• pp.168-177
• /
• 2005

In this paper, we numerically investigated the optimum pump light power resulting best compensation of pulse distortion due to both chromatic dispersion and self phase modulation (SPM) in long-haul 3×40 Gbps wavelength division multiplexing (WDM) systems. We used mid-span spectral inversion (MSSI) method with path-averaged intensity approximation (PAIA) as compensation approach, which have highly nonlinear dispersion shifted fiber (HNL-DSF) as nonlinear medium of optical phase conjugator (OPC) in the mid-way of total transmission line. We confirmed that HNL-DSF is an useful nonlinear medium in OPC for wideband WDM transmission, and in order to achieve the excellent compensation the pump light power is selected to equal the conjugated light power into the latter half fiber section with the input light power of WDM channel depending on total transmission length. Also we confirmed that compensation degree of WDM channel with small conversion efficiency is improved by using pump light power increasing power conversion ratio upper than 1.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.5A
• /
• pp.473-483
• /
• 2004

In this paper, we numerically investigated the optimum pump light power best compensating for pulse distortion due to both chromatic dispersion and self phase modulation (SPM) as a function of channel input power in 8 channel ${\times}$ 40 Gbps wavelength division multiplexing (WDM systems. Also we investigated the allowable maximum channel input power dependence on modulation format and fiber dispersion coefficient in the various pump light power of OPC. The considered WDM transmission system is based on path-averaged intensity approximation (PAIA) mid-span spectral inversion (MSSI) compensation method, which has highly-nonlinear dispersion shifted fiber (HNL-SDF) as nonlinear medium of optical phase conjugator (OPC) in the mid-way of total transmission line. We confirmed that optimal pump light power of HNL-DSF OPC depend on modulation format, initial channel input power, total transmission length and fiber dispersion. But optimal pump light power of HNL-DSF OPC must be selected to make power conversion ratio to almost unity. And we confirmed that, if we allow a 1 dB eye opening penalty (EOP), the tolerable maximum channel input power is increased by using RZ than NRZ as modulation format when pump light power of HNL-DSF OPC is not optimal value but another values.

• Journal of Ginseng Research
• /
• v.4 no.2
• /
• pp.197-221
• /
• 1980

Habitat observation, cultural experience of old and present plantation, weather factors in relation to crop stand and water physiology of root and leaf were reviewed. According to habitat observation ginseng plants love water but plate wit talus well grow at drained place with high moisture content in air and soil while ginseng plants were not found in dry or wet place. According to cultivation experience ginseng plants require abundant water in nursery and main field but most old planters believe that ginseng plaints are draught-loving thus require little water. The experience that rain especially in summer i.e unfavorable might be due to mechanical damage of leaves arid leaf disease infection, or severe leaf fall which is caused by high air temperature and coinsided with rain. According to crop stand observation in relation to weather factors abunsant water increased each root weight but decreased total yield indicating tile increase of missing root rate. Rain in summer was unfavorable too. Though rain in June was favorable for high yield general experience that cloudy day and rain were unfavorable might be due to low light intensity under shade. Present leading planters also do loot consider the importance of water in main field. Water content is higher in top than in root and highest in central portion of root and in stem of top. For seedling the heavier the weight of root is tile higher the water content while it reveries from two years old. Water potential of intact root appeared to be -2.89 bar suggesting high sensitivity to water environment. Under water stress water content severly decreased only in leaf. Water content of leaf appeared to be 78% for optimum, below 72% for functional damage and 68% for perm anent wilting. Transpiration or curs Principally through stomata in lower side of leaf thus contribution of upper side transpiration decreased with the increase of intensity. Transpiration is greater in the leaves grown under high light intensity. Thus water content is lower with high light inte nsity under field condition indicating that light is probable cause of water stress in field. Transpiration reached maximum at 10K1ut The decrease of transpiration at higher temperature seems to be due to the decrease of stomata aperture caused by water stress. Severe decrease of photosynthesis under water stress seems to be principally due to functional damage which is not caused by high temperature and Partly due to poor CO2 supply. Water potential of leaf appeared to be -16.8 bar suggesting weakness in draught tolerance. Ginseng leaves absorb water under high humidity. Water free space of leaf disc is %mailer than that of soybean leaf and water uptake appears to be more than two steps.

• Journal of Korean Society of Environmental Engineers
• /
• v.33 no.8
• /
• pp.591-597
• /
• 2011

The purpose of this study was to determine optimum conditions for the cultivation of Chlorella sp. FC-21 using light emitting diodes (LEDs). Specific growth rate and cell concentration were measured for the reactors at the illuminations of different wavelengths of LEDs. Among various types of LEDs, red LEDs were the most effective light source, and also greatest increases of specific growth rate and cell concentrations were obtained when light intensity of red LEDs increased. The specific growth rate decreased when initial cell concentration increased due to the shading effect of each cell in the reactor. To determine beneficial effect of aeration to cell cultivation, micro-air bubbles were aerated at 0.35 vvm in the reactor at the illumination of red LEDs. Two and ten times greater specific growth rate and cell concentration were obtained when aeration was applied. From this study, we found that red LEDs with aeration were the most appropriate light source for the cultivation of Chlorella sp. FC-21.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.18 no.4
• /
• pp.73-85
• /
• 1991

Rhododendron mucronulatum for. albiflorum, native species is a shrub that has white flowers on May to June, and rare species endangered by people's rash digging or cutting. But its physiological ecological characteristics and propagation method are not being known at all. Therefore, this study was executed to utilize this species as the planting material for landscaping by analysing its habitat environment and growth form, and also experimenting its seed and vegetative propagation, and it field culture and utilization. The results are as follows; 1. The elevation, gradient and direction of this species were 295-1,350m, 10-36$^{\circ}$, northwest respectively. It was found that the species is shade-liking plant that grows under forest cover of average 51.33%. 2. The soil pH and water content of its habitat were 5.4, 25.41% respectively. The organic matter content was 6.29% that was higher than 3.2%, the average organic matter content of forest soil in Korea. 3. Representative plant community within which this species was living was Quercus mongolica community, and its main neighboring species were Lindea obtusiloba, Fraxinus sieboldiana, Rhus trichocarpa, Rhododendron Schlippenbachii, Rododendron mucronulatum. 4. The leaf length and width of this species were 39.18mm, 12.60mm respectively. This result showed that generally its leaf size was larger than that of R. micranthum, R. yedoense var. poukhanense and R. mucronulatum var. ciliatum and smaller than that of R. mucronulatum and R. schlippenbachii. 5. The whole size of its pollen was, as 59${\times}$61$\mu\textrm{m}$, the largest of plants of Rhododendron family including R. mucronulatum and R. mucronulatum var. ciliatum. 6. The result of seed germination experiment at intervals of 5$^{\circ}C$ from 15$^{\circ}C$ to 30$^{\circ}C$ presented the highest germination rate of 94.7% at 20$^{\circ}C$ numerically, but high percent germination at all temperature levels without significant difference. And the seed of this plant proved to be sun-liking seed at requiring dormancy in germination. 7. Through seed germination experiment by treatment of growth regulators such as GA. Thiourea and Kinetin under dark condition, it was found that the effect of GA treatment on germination increase and acceleration was the highest. 8. In greenwood cutting, rooted rate by treatment of various concentration of IBA and NAA on clay and vermiculite bed was not wholly high, but 100ppm plots of both IBA and NAA of clay bed showed relatively good rooted rate. 9. As result of field culture experiment for finding out optimum growth temperature and light intensity, growth conditions such as height, number of leaves, fresh weight and chlorophyll contents were the best at night/day temperature of 20/25$^{\circ}C$ and under 1/2sun. Also, the photosynthetic rate was the highest at 25$^{\circ}C$. Accordingly, it was found that optimum temperature and light intensity for growth of this plant are 25$^{\circ}C$ (day temperature), 50% of natural light respectively.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.29 no.8
• /
• pp.494-498
• /
• 2016

In this paper, we proposed the 3-dimenstional (3D) analysis for calculating the optical characteristics of an autostereoscopic display with electric field driven liquid crystal (ELC) lens. From 3D analysis considering the slanting of lens, we calculate the cross-talk of each images and the distortion of viewing zone. Using geometric opics and extended Jones matrix method (EJMM), phase retardation of ELC lens according to position is calcuated and then optical path difference in 3D space considering tilt and azimuth angle of incident light is gotten. Then, intensity distribution is presented in the space. Through camparing the intensity distribution using ideal lens with the ELC lens, we identify the noise and image distortion of ELC lens. As a result, this analysis is expected to provide optimum design conditions for realistic and rigorous 3D display with ELC lens.