• Transactions on Electrical and Electronic Materials
• /
• v.14 no.4
• /
• pp.177-181
• /
• 2013

In this paper, silicon solar cells are analyzed regarding power conversion efficiency by changed capacitance in the depletion region. For the capacitance control in the depletion region of silicon solar cell was applied for 10, 20, 40, 80, 160 and 320 Hz frequency band character and alternating current(AC) voltage with square wave of 0.2~1.4 V. Academically, symmetry formation of positive and negative change of the p-n junction is similar to the physical effect of capacitance. According to the experiment result, because input of square wave with alternating current(AC) voltage could be observed to changed capacitance effect by indirectly method through non-linear power conversion (Voltage-Current) output. In addition, when input alternating current(AC) voltage in the silicon solar cell, changed capacitance of depletion region with the forward bias condition and reverse bias condition gave a direct effect to the charge mobility.

• Current Optics and Photonics
• /
• v.7 no.4
• /
• pp.378-386
• /
• 2023

A wideband instantaneous frequency measurement (IFM) system is been proposed, designed and analyzed. Phase modulation to intensity modulation conversion is implemented based on the stimulated Brillouin scattering (SBS) effect, and the microwave frequency can be measured by detecting the change in output power. Theoretical analysis shows that the frequency measurement range can be extended to 4f_b by adjusting the two sweeping signals of the phase modulators with a difference of 2f_b. The IFM system is set up using VPI transmission maker software and the performances are simulated and analyzed. The simulation results show that the measurement range is 0.5-45.96 GHz with a maximum measurement error of less than 9.9 MHz. The proposed IFM system has a wider measurement range than the existing SBS-based IFM system.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.12
• /
• pp.133-138
• /
• 2008

A 50-60GHz continuous-wave(cw) millimeter-wave(MMW) was converted(generated) by applying optical technology for future wireless and ubiquitous communications. The optical power of 22.5mW was injected into optical waveguide in this experiment. The generated MMW signals were radiated in a millimeter waveguide and detected through a millimeter detector on the inside of a millimeter waveguide in this experiment. The spectral linewidth of the MMW signals was less than 1 kHz. The power fluctuation of the MMW was less than 1.2 dBm over 50-60 GHz range.

• Proceedings of the Optical Society of Korea Conference
• /
• 2003.02a
• /
• pp.218-219
• /
• 2003

Wavelength Division Multiplexed (WDM)과 Time Division Multiplexed (TDM) 광 네트워크에서 전광 파장변환은 미래 초고속통신의 핵심 기술이다. 파장변환장치는 정보 소통량 관리에 유연성을 부여함과 동시에 광 네트워크의 동적 재구성을 용이하게 한다. 최근에 주기적 분극을 가진 LiNbO$_3$ 도파로를 이용한 몇몇 파장변환실험들이 성공적으로 수행됨으로써, Difference Frequency Generation (DFG)와 같은 2차 비선형 분극을 이용한 파장변환 장치에 대한 관심이 증대되고 있다. (중략)

• Korean Journal of Optics and Photonics
• /
• v.15 no.5
• /
• pp.399-404
• /
• 2004

We present a quantum interference experiment with frequency-entangled pairs of photons with wavelength of 640 nm and 660 nm produced in the process of parametric down-conversion. When photon pairs in different angular frequencies $\omega$$_1$and $\omega$$_2$are registered by two detectors the coincidence counts exhibits a two-photon fringe as a function of relative time delay $\delta$$\tau$ of two photons within the coherence time depending on the arrangement of the detector pairs.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.589-589
• /
• 2012

Indium sulfide thin films have been grown onto glass substrates using radio frequency magnetron sputtering at room temperature. The as-deposited film were annealed in nitrogen atmosphere at different temperatures of 100, 200, 300, 400 and $500^{\circ}C$ with an 1 h annealing time. The effect of annealing temperature on composition, structure, morphology and optical properties of the as-grown In2S3 films has been studied. The XRD results indicate that the as-deposited films are composed by a mixture of both cubic ${\alpha}$ and ${\beta}$ crystalline phases, with some fraction of tetragonal phase. The thermal annealing on the films produces the conversion of the cubic crystalline phases to the tetragonal ${\beta}$ one and a crystalline reorientation of the latter phase. The surface morphological analysis reveals that the films grown at $300^{\circ}C$ have an average grain size of ~ 58 nm. These films show a S/In ratio of 0.99. The optical band gap is found to be direct and the films grown at $300^{\circ}C$ shows a higher optical transmittance of 80% and an energy band gap of 2.52 eV.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.4 no.1
• /
• pp.105-110
• /
• 1994

L-arginine phosphate monohydrate (LAP) and tris(hydroxymethyl)aminomethane sulfate (THAMS) are new organic nonlinear optical materials for the device application such as the frequency conversion of laser radiation. In this work the single crystals of LAP and THAMS have been grown by the falling temperature method and the temperature difference method. The conditions of the growth parameters were presented and the grown crystals were characterized by means of optical microscopy, XRD and FTIR.

• Journal of Sensor Science and Technology
• /
• v.29 no.1
• /
• pp.51-58
• /
• 2020

In this study, a novel method for sweeping automatic linearization of wavelength swept laser is proposed. Through the test performed on the implemented laser, the linear sweeping is held up well with a 97% decrease in nonlinearity, and 60 nm sweeping range, 1 kHz sweeping frequency, and 8.8 mW average optical power were obtained. The proposed method uses fiber Bragg grating array, optical-electronic conversion circuit, FPGA embedded module, and a LabVIEW program to generate new compensated wave patterns which were applied to the fiber Fabry-Perot tunable filter. Linear sweeping can reduce the cumbersome and time-consuming recalibration process required for nonlinear sweeping. Additionally, the proposed method provides more accurate measurement results for the structure safety monitoring system.

• Proceedings of the Optical Society of Korea Conference
• /
• 2003.02a
• /
• pp.224-225
• /
• 2003

Since group velocity (GV) mismatch significantly limits the efficiency of nonlinear interactions such as second harmonic generation (SHG), several techniques have been developed to compensate GV mismatch. The simplest way to avoid the GV mismatch problem is to reduce the device length. However, it results in a poor trade-off between the SHG spectral bandwidth and the conversion efficiency. (omitted)

• Journal of Sensor Science and Technology
• /
• v.29 no.6
• /
• pp.412-419
• /
• 2020

In this study, a PID control method for sweeping automatic linearization of a wavelength swept laser is proposed. First, the closedloop transfer function embodying the PID control is derived. Through the simulation of the function, K_p = 0.022, K_i = 0.008, K_d = 0.002 were obtained as the best PID coefficients for fast linear sweeping. The performance test using the PID coefficients showed that linear sweeping was held up well with a 98.7% decrement in nonlinearity after the 10th feedback, and 45 nm sweeping range, 1 kHz sweeping frequency, and 8.8 mW average optical power were obtained. The equipment consists of a fiber Bragg grating array, an optical-electronic conversion circuit, and a LabVIEW FPGA program. Every 5s, automatic feedback and PID control generate a new compensated waveform and produce a better linear sweeping than before. Compared with nonlinear sweeping, linear sweeping can reduce the cumbersome and time-consuming recalibration processes and produce more accurate measurement results.