• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.21 no.4
• /
• pp.158-163
• /
• 2011

$CuInS_2$ thin films were prepared using a sol-gel spin-coating method. That makes large scale substrate coating, simple equipment, easy composition control available. The structural and optical properties of $CuInS_2$ thin films that include less toxic materials (S) instead of Se, tetragonal chalcopyrite structure. Copper acetate monohydrate ($Cu(CH_3COO)_2{\cdot}H2O$) and indium acetate ($In(CH_3COO)_3$) were dissolved into 2-propanol and l-propanol, respectively. The two solutions were mixed into a starting solution. The solution was dropped onto glass substrate, rotated at 3000 rpm, and dried at $300^{\circ}C$ for Cu-In as-grown films. The as-grown films were sulfurized inside a graphite container box and chalcopyrite phase of $CuInS_2$ was observed. To determine the optical properties measured optical transmittance of visible light region (380~770 nm) were less than 30 % in the overall. The XRD pattern shows that main peak was observed at Cu/In ratio 1.0 and its orientation was (112). As annealing temperature increases, the intensity of (112) plane increases. The unit cell constant are a = 5.5032 and c = 11.1064 $\AA$, and this was well matched with JCPDS card. The optical transmittance of visible region was below than 30 %.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.5
• /
• pp.15-20
• /
• 2007

We fabricated ZnO thin films on quartz substrate using pulsed laser deposition method and investigated structural and optical properties of ZnO thin films with various substrate temperatures. Regardless of the substrate temperature variation, all ZnO thin films had grown to (002) and the thin film deposited at 400 $^{\circ}C$ exhibited an excellent crystallinity having 0.24$^{\circ}$ of Full-Width-Half-Maximum (FWHM). In the result of photoluminescence property, UV and deep-level emission peaks were observed in all ZnO films and the emission peaks were changed with various substrate temperatures. An highest UV emission was exhibited on the specimen deposited at 400 $^{\circ}C$ and the FWHM of UV peak was 14 nm. The optical transmittance was about 85 % in visible region regardless of the substrate temperature. The comparison result of the bandgap energies obtained from optical transmittance and UV emission centers, the two values were about the same. From these results, it is found that UV emission center has close relationship with near band edge emission of ZnO thin film.

• Korean Journal of Optics and Photonics
• /
• v.25 no.6
• /
• pp.311-314
• /
• 2014

In this paper, we design a helical fin structure for the heat sink for a high-power LED lighting module, and analyze its thermal properties. By means of the helical fin structure, we can obtain about 14% larger surface area for the limited volume and it can decrease the LED chip temperature by about 12%. Because this helical fin heat sink has 15% less total volume than a conventional one, we can also expect to reduce the production cost due to these structural properties.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.03a
• /
• pp.99-99
• /
• 2003

The growth of GaN on Si is of great interest due to the several advantages : low cost, large size and high-quality wafer availability as well as its matured technology. The crystal quality of GaN is known to be much influenced by the surface pretreatment of Si substrate[1]. In this work, the properties of GaN overlayer grown on ion beam modified Si(111) have been investigated. Si(111) surface was treated RIB with 1KeV-N$_2$$\^$+/(at 1.9 ${\times}$ 10$\^$-5/) to dose ranging from 5${\times}$10$\^$15/ to 1${\times}$10$\^$17/ prior to film growth. GaN epilayers were grown at 1100$^{\circ}C$ for 1 hour after growing AlN buffer layers for 5∼30 minutes at 1100$^{\circ}C$ in Metal Organic Chemical Vapor Deposition (MOCVD). The properties of GaN epilayers were evaluated by X-Ray Diffraction(XRD), Raman spectroscopy, Photoluminescence(PL) and Hall measurement. The results showed that the ion modified treatment markedly affected to the structural, optical and electrical characteristic of GaN layers.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.3
• /
• pp.691-698
• /
• 2010

In this study Al-doped ZnO (AZO) thin films have been fabricated on Eagle 2000 glass substrates at various substrate temperature ($100{\sim}500^{\circ}C$) and working pressure (10 ~ 40 mTorr) by RF magnetron sputtering in order to investigate the structural, electrical, and optical properties of the AZO thin films. The obtained films were polycrystalline with a hexagonal wurtzite structure and preferentially oriented in the (002) crystallographic direction. The AZO thin films, which were deposited at $T=300^{\circ}C$ for 10 mTorr, shows the highest (002) orientation, and the full width at half maximum (FWHM) of the (002) diffraction peak is $0.42^{\circ}$. The lowest resistivity ($2.64{\times}10^{-3}\;{\Omega}cm$) with the highest cartier concentration ($5.29{\times}10^{20}\;cm^{-3}$) and a Hall mobility of ($6.23\;cm^2/Vs$) are obtained in the AZO thin films deposited at $T=300^{\circ}C$ for 10 mTorr. The optical transmittance in the visible region is approximately 80%, regardless of process conditions. The optical band-gap depends on the Al doping level as the substrate temperature increases and the working pressure decrease. The optical band-gap widening is proportional to cartier concentration due to the Burstein-Moss effect.

• Journal of the Korean Vacuum Society
• /
• v.16 no.2
• /
• pp.134-140
• /
• 2007

Optical structure of $V_{2}O_{5}$ thin films were analyzed and confirmed, the films were deposited in oxygen partial pressure 0% and 10% by RF magnetron sputtering system. Measurements of the elliptic constants were made in the range of $0.75{\sim}4.0\;eV$ by using phase modulated spectroscopic ellipsometer. The elliptic constants of the thin films were analyze by Double Amorphous dispersion relation. The calculated n, k spectra of $V_{2}O_{5}$ layer were obtained over the range of $0.75{\sim}4.0\;eV$ photon energy. SEM and XRD measurements were also made to validate the ellipsometric analysis and they give good agreement with the structural properties of the films. It was found that optical structure of the $V_{2}O_{5}$ layer has a 3 phase(roughness/film/substrate) and optical absorption properties are greatly depend on the partial pressure of the oxygen.

• Journal of the Korean Ceramic Society
• /
• v.34 no.2
• /
• pp.209-215
• /
• 1997

Aluminum nitride(AIN) thin films were deposited by reactive single ion beam sputtering using N2 or NH3 as reactive gas. The structural, compositional and optical properties of AIN thin films were characterized by XRD, GAXRD, TEM, SEM, XPS UV/VIS spectrophotometer, and FT-IR. All the deposited AIN thin films were amorphous by the analysis fo XRD and GAXRD. However, TEM analysis showed that AIN nano-crystallites were uniformly distributed in the films. The presence of Al-N bonds were also confirmed by FT-IR and XPS analyses. The optical bandgap of AIN films increased up to 6.2 eV and the transmittance was a-bout 100% in visible range with approaching the stoichimetric composition. Irrespective of using N2 or NH3 as reactive gas, the deposited AIN thin films had very smooth surface morphologies. Their refractive index ranged from 1.6 to 1.7.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.11a
• /
• pp.42.2-42.2
• /
• 2010

Transparent conducting oxides (TCOs) are of significant importance for their applications in various devices, such as light-emitting diodes, thin-film solar cells, organic light-emitting diodes, liquid crystal displays, and so on. In order for TCOs to contribute to the performance improvement of these devices, TCOs should have high transmittance and good electrical properties simultaneously. Sn-doped $In_2O_3$ (ITO) is the most commonly used TCO. However, indium is toxic and scarce in nature. Thus, ZnO has attracted a lot of attention because of the possibility for replacing ITO. In particular, group III impurity-doped ZnO showed the optoelectronic properties comparable to those of ITO electrodes. Al-doped ZnO exhibited the best performance among various doped ZnO films because of the high substitutional doping efficiency. However, in order for the Al-doped ZnO to replace ITO in electronic devices, their electrical and optical properties should further significantly be improved. In this connection, different ways such as a variation of deposition conditions, different deposition techniques, and post-deposition annealing processes have been investigated so far. Among the deposition methods, RF magnetron sputtering has been extensively used because of the easiness in controlling deposition parameters and its fast deposition rate. In addition, when combined with post-deposition annealing in a reducing ambient, the optoelectronic properties of Al-doped ZnO films were found to be further improved. In this presentation, we deposited Al-doped ZnO (ZnO:$Al_2O_3$ = 98:2 wt%) thin films on the glass and sapphire substrates using RF magnetron sputtering as a function of substrate temperature. In addition, the ZnO samples were annealed in different conditions, e.g., rapid thermal annealing (RTA) at $900^{\circ}C$ in $N_2$ ambient for 1 min, tube-furnace annealing at $500^{\circ}C$ in $N_2:H_2$=9:1 gas flow for 1 hour, or RTA combined with tube-furnace annealing. It is found that the mobilities and carrier concentrations of the samples are dependent on growth temperature followed by one of three subsequent post-deposition annealing conditions.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2009.08a
• /
• pp.185-185
• /
• 2009

• Proceedings of the Korean Vacuum Society Conference
• /
• 2009.08a
• /
• pp.190-190
• /
• 2009