• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.38 no.2
• /
• pp.1-5
• /
• 2001

We propose an optical performance monitoring method for WDM optical transmission systems. By assigning a pair of AWG ports to each optical signal channel. the optical power, optical signal-to-noise ratio (OSNIO, and wavelength of all the signal channels are observed simultaneously. The output power ratio of the AWG port pair depended on the wavelength variation of the channel with sensitivity of 1dB/0.026nm. The OSNH results were deviated no more than 0.7dB from the results measured by optical signal analyzer (OSA).

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.8
• /
• pp.69-75
• /
• 1998

We demonstrate wavelength conversion of 2.5Gb/s optical signals by four-wave mixing (FWM) in a semiconductor optical amplifier (SOA). We investigate the effect of input pump and signal powers on the coversion efficiency, optical signal-to-noise ratio (OSNR) and extinction ratio to be a measure of performance in a wavelength converter. As a result, we show that the maximum bit error rate (BER) performance can be obtained by co promising among high-vonversion efficiency (minimum Pprobe), high-OSNR (maximum Pprobe) and low-cross-gain saturation effects (Pprobe kept at least 6dB weaker than Ppump). In our experiment, we obtain optimum performance at +3 dBm pump power and -6dBm signal power. The power penalty incurred in the wavelength conversion can be minimized by careful selection of the input pump and signal powers. We show that about 0.5dB power penalty for 3.2nm wavelength coversion at 10-10 BER is achievable.

• ETRI Journal
• /
• v.28 no.6
• /
• pp.826-829
• /
• 2006

A novel method for optical phase shaped binary transmission (PSBT) generation has been recently reported and experimentally evaluated. An amelioration of the optical signal-to-noise ratio (OSNR) sensitivity of the optical PSBT modulation format is proposed with the application of the concepts of enhanced electrical PSBT signal generation. Enhanced optical PSBT is proposed here as a modulation format producing a 0.7 dB gain in OSNR sensitivity compared to OPSBT, while maintaining a good robustness to group velocity dispersion: 100 ps/nm for enhanced optical PSBT and 120 ps/nm for optical PSBT, compared to 50 ps/nm for standard NRZ signals.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.39 no.10
• /
• pp.43-47
• /
• 2002

A simple optical signal to noise ratio monitoring method using fiber Bragg grating is proposed for monitoring performance of OADM. OSNR of each channel is determined by monitoring the optical power transmitted and reflected from fiber Bragg gratings, simultaneously. We have obtained OSNR with accuracy better than 0.8㏈ compared with OSA of 0.1nm optical resolution in the wide input power range between -6 ㏈m and -23㏈m per channel.

• International Journal of Internet, Broadcasting and Communication
• /
• v.11 no.4
• /
• pp.43-48
• /
• 2019

We design a reconfigurable optical node for metropolitan WDM networks, and numerically study the capability of the node in the optical signal level. Unlike a long-haul WDM system, major limitations of metropolitan WDM systems are power loss, fiber dispersion and optical signal-to-noise ratio(OSNR) degradation due to EDFAs. Therefore, we include the behaviors of transmitter and receiver, and fiber, EDFAs, and optical filters(MUX/DeMux) in numerical simulations with varying parameters over wide range. From simulation results, we can identify the maximum span numbers for OC-48 and OC-192 to achieve $BER<10^{-12}$ using the node structure at various received powers and residual dispersions.

• Journal of the Optical Society of Korea
• /
• v.18 no.5
• /
• pp.436-441
• /
• 2014

We have demonstrated an amplified wavelength-division multiplexed (WDM) passive optical network (PON) by using broadband light source (BLS) seeded optical sources and chirped fiber Bragg gratings (FBGs) based dispersion compensators. Chirped FBGs located at central office (CO) were fabricated and used as channel-by-channel dispersion compensators in order to mitigate the dispersion-induced distortion of both downstream and upstream signals. Owing to a low insertion loss of chirped FBG based dispersion compensator, the optical signal-to-noise ratio (OSNR) of the downstream signal could be improved to be ~28 dB. Thus, we re-confirmed that an error-free transmission of 1.25 Gb/s signals over a 100 km single-mode fiber (SMF) link could be achieved with a proposed amplified WDM-PON architecture. We have also evaluated the impact of various noises on the system's performance, and found that the low OSNR of the downstream signal would be a main limiting factor on the maximum reach of the proposed amplified WDM-PON architecture. From the measured ~13 dB improvement in OSNR of the downstream signal compared to our previously-proposed dispersion compensating module based scheme, we believe that the proposed architecture can accommodate a reach of longer than 100 km SMF link easily.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.6B
• /
• pp.568-574
• /
• 2009

320km optical transmission link for 128 channel DWDM (dense wavelength-division-multiplexing) signals is simulated and fabricated. An optical fiber amplifier for the link is composed of a distributed Raman amplifier and dual C/L-band EDFAs which are optimized for the performances of an optical amplifier obtained from the simulation. Gain and NF of the optimized EDFAs are above 19dB and below 7.5dB, respectively. The resultant OSNRs (optical signal to noise ratios) of the link are average 25dB on each band.

• Korean Journal of Optics and Photonics
• /
• v.10 no.1
• /
• pp.64-67
• /
• 1999

We have been implemented 10 Gb/s-320 km of dispersion-shifted fiber (DSF) transmission. The optical link consists of a 10 Gb/s optical transceiver, an optical booster amplifier, 3 sets of optical in-line amplifiers, an optical preamplifier and transmission fibers. Firstly, we investigated the Q-factor characteristics in terms of optical signal to noise ratio (OSNR) of 320 km of DSF, measured receiver sensitivity is -27 dBm and power penalty is 2 dB, respectively. We concluded that optical SNR degradation and path penalty gives rise to 1 dB penalty, respectively.