• Current Optics and Photonics
• /
• v.4 no.3
• /
• pp.186-192
• /
• 2020

This paper describes a real-time monitoring system in Ethernet passive optical networks (EPON) that uses burst-mode fiber Bragg grating (FBG) optical sensors. The FBG interrogation unit in the optical line terminal (OLT) transmits the monitoring wavelength to optical network units (ONUs). The FBG sensor unit in each ONU returns a burst-mode monitoring signal to the OLT. As the system applies time division multiple access (TDMA), a uniform Bragg wavelength can be used to monitor the EPON system. The FBG interrogation unit analyzes the received burst-mode monitoring signals and outputs fault information on the ONU branches in EPON. The simulation results show the effectiveness of the proposed monitoring system based on TDMA. In addition, we compared the proposed TDMA-based monitoring system with a WDMA-based monitoring system.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.2 no.4
• /
• pp.5-16
• /
• 2003

We have analyzed the performance of optical matched filters in the fiber-optic code division multiple access (FO-CDMA) system based on optical parallel coupler access encoder (PCAE) and parallel coupler access decoder (PCAD) by experiment. In previous studies, the performance evaluation of the FO-CDMA system using SCAE and SCAD was not sufficiently accurate because they analyzed system performance only considering the first order signals. Since optical SCAE and SCAD intrinsically have high order signals of various patterns as the number of coupler increases, they change auto- and cross-correlation intensities. Thus, it is necessary to investigate properties of the PCAE and PCAD so that we may analyze the exact performance of system. In this paper, it is found that the peak to sidelobe ratio using the PCAE and PCAD increases as $\alpha$ (coupling coefficient) value increases. Also, we found that the proposed PCAE and PCAD are superior to SCAE and SCAD in performance improvement.

• 한국정보통신설비학회:학술대회논문집
• /
• 2005.08a
• /
• pp.48-52
• /
• 2005

본고에서는 WDM-PON 기반의 FTTH 망구축 사례를 소개하고 실제 망구축에서 발생할 수 있는 문제점들을 분석하여, 향후 FTTH 활성화에 대비하고자 한다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.11B
• /
• pp.1016-1022
• /
• 2003

The EPON has been actively studied as one of the access networks for the economic configuration of FTTH. The EPON must support the dynamic bandwidth allocation to the subscribers in order to support the QoS due to its base on Ethernet technology EFM SG, which is actively working for the standardization of EPON, also recently decided to select DBA. Therefore in this paper, we designed a ONU buffer scheduling algorithm(AIWFQ) and a scheme of DBA(Class-based FCFS) for the OLT suitable for embodying MPCP of the EPON. In this paper, we proposed methods that the EPON system can make use of by measuring end to end process delay time and the buffer size in order to implement the algorithm by using the OPNET.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.2B
• /
• pp.272-278
• /
• 2004

The EPON has been actively studied as one of the access networks for the economic configuration of FTTH. The EPON must support the dynamic bandwidth allocation to the subscribers in order to support the QoS due to its base on Ethernet technology. EFM SG, which is actively working for the standardization of EPON, also recently decided to select DBA. Therefore in this paper, we designed a ONU buffer scheduling algorithm (AIWFQ) and a scheme of DBA(Class-based FCFS) for the OLT suitable for embodying MPCP of the EPON. In this paper, we proposed methods that the EPON system can make use of by measuring end to end process delay time and the buffer size in order to implement the algorithm by using the OPNET.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2002.11b
• /
• pp.1503-1506
• /
• 2002

기존 가입자망은 다양한 멀티미디어 서비스 트래픽에 대해 병목으로 작용하였으며 이에 대한 대안으로 광가입자망 기술 대두되었다. 광가입자망은 초기 설치비용이 매우 고가이기 때문에 기술 개발과 설치가 지연되었으나, 비용대비 효율성이 좋은 Passive Optical Network(PON) 기술이 개발됨에 따라 활기를 띠고 있다. 본 고에서는 MPLS/IP 백본으로 연결되는 Ethernet-PON 기반의 광가입자망에서, L2/L3 MPLS 기반의 망사업자가 제공하는 VPN 기술 개발을 위해 Optical Network Unit(ONU) 및 Optical Line Terminal(OLT)에서 지원해야 되는 기능에 대해 연구한다.

• Journal of the Optical Society of Korea
• /
• v.12 no.4
• /
• pp.355-358
• /
• 2008

In the current GPON market and standard, the line bit rate requirement is changing from 1.25 Gbps to 2.5 Gbps. We fabricate a 2.5 Gbps burst-mode receiver with commercially available blocks and optimize it with an APD bias control. A burst-mode measurement setup is made for the full compliance test with the GPON standard. The device meets the partially defined 2.5 Gbps specs in the current ITU G.984.2 standard, also, supports 1.25 Gbps specs for the coexistence issue in an access network. The full-compliant measurement values can be used as a guideline for fixing "for further study" specs in the current GPON standard at 2.5 Gbps.

• Journal of the Korea Society of Computer and Information
• /
• v.18 no.10
• /
• pp.47-54
• /
• 2013

In this paper, the structural design of optical Internet is analyzed and by using UNI (User Network Interface) signaling protocol an optical transmission experiment was performed. The hierarchical structure of the basic optical Internet consists of the backbone network, the service network and the access network. The necessary functions for each layer were described as follows: Control structure of the optical transport layer, network operation and management structure, internetworking technology of sub networks, routing and signaling technology. By using UNI signaling protocol from OIF (Optical Internetworking Forum), the optical transmission in the proposed structure of the optical Internet network was experimented. By the traffic generation of LSP (Label Switched Path) data packets along the route-configuration was delivered to UNI. Finally, by showing the value of TCP (Transmission Control Protocol) packets the optical transmission was completely and successfully demonstrated.

• Journal of the Optical Society of Korea
• /
• v.13 no.3
• /
• pp.361-366
• /
• 2009

We propose the performance enhancing method optimization of an asynchronous 2.5 Gbps/1.25 Gbps optical subscriber network with inverse RZ (Return to Zero) coded downstream and NRZ (Non Return to Zero) upstream re-modulation by adjusting threshold level control of a receiver. We theoretically analyze the BER (Bit Error Rate) performance by modeling the occurrence of BER by simulation with MATLAB according to the types of downstream data. The results have shown that the normalized threshold level in an optical receiver could be saturated at 1/3 as the SNR (Signal to Noise Ratio) increases. The needed SNR for obtaining the BER $10^{-9}$ can be reduced by $\sim$5 dB by optimizing the normalized threshold level at 1/3 instead of by using the conventional receiver with threshold level of 0.5. The proposed system can be a useful technology for asynchronous optical access networks with asymmetric upstream and downstream data rates, because the improved minimum receiving power could replace a light source with a source with lower power and lower cost in an OLT (Optical Line Termination).

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.38 no.10
• /
• pp.1-9
• /
• 2001

The MAC (Medium Access Control) protocol is needed for the OLT(Optical Line Termination) to allocate bandwidth to ONUs(Optical Network Units) and ONTs(Optical Network Terminations) dynamically in the ATM PON(Passive Optical Network). With the protocol, the OLT gathers ONUs' informations and provides grants efficiently to each ONU. Two important functions of the MAC protocol is the grant request procedure and the grant distribution algrithm. The latter has the greatest arithmetic portion in the TC(Transmission Convergence) module, occupies a relatively large portion of the overall chip area, has often been the limiting factor in terms of speed, and should be designed to guarantee the quality of service for various traffics. In this paper, we implement the MAC with the FPGA which can allocate grants dynamically according to the queue length information and the number of active ONUs and distribute grants uniformly to minimize the cell delay variation for each ONU. The structure of the MAC scheduler for the dynamic bandwidth assignment has a programmable look-up table. Also, it has a simple structure, the less chip area, and the lower delay time.