• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.48 no.4
• /
• pp.47-53
• /
• 2011

The Electric Multiple Unit (EMU) has many types of door system such as sliding door, plug door etc.al. according to customer's requirements. The sliding door is widely used in Korea but has weak point in the noise problem. In the low operation speed, the noise coming from outer side of the EMU is not an important factor. As the speed is higher than before, noise is increased and make a problem. The main cause of noise is the imperfect air tightness in the EMU. The plug door system has advantages for the noise reduction characteristic in the high speed area. We have been developing electric plug-in door. The door is controlled by Door Control Unit(DCU) following the order of Automatic Train Protection (ATP) that is a kind of train signalling system. DCU has to simultaneously open and close the doors and the operation of it is related to the passengers safety. So DCU is a safety device that is important to reliability and safety. DCU is composed of several devices of control, motor driving, Input/Output, communication and power. In this paper, we will describe the functions, characteristic, requirement, subsystem and test results of DCU used for the electric plug-in door.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.3
• /
• pp.69-76
• /
• 2008

This work proposes a 12b 1kS/s 65uA 0.35um CMOS algorithmic ADC for sensor interface applications such as accelerometers and gyro sensors requiring high resolution, ultra-low power, and small size simultaneously. The proposed ADC is based on an algorithmic architecture with recycling techniques to optimize sampling rate, resolution, chip area, and power consumption. Two versions of ADCs are fabricated with a conventional open-loop sampling scheme and a closed-loop sampling scheme to investigate the effects of offset and 1/f noise during dynamic operation. Switched bias power-reduction techniques and bias circuit sharing reduce the power consumption of amplifiers in the SHA and MDAC. The current and voltage references are implemented on chip with optional of-chip voltage references for low-power SoC applications. The prototype ADC in a 0.35um 2P4M CMOS technology demonstrates a measured DNL and INL within 0.78LSB and 2.24LSB, and shows a maximum SNDR and SFDR of 60dB and 70dB in versionl, and 63dB and 75dB in version2 at 1kS/s. The versionl and version2 ADCs with an active die area of $0.78mm^2$ and $0.81mm^2$ consume 0.163mW and 0.176mW at 1kS/s and 2.5V, respectively.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.36 no.2
• /
• pp.129-136
• /
• 2010

In order to evaluate anti-wrinkle activity of Carex humilis extract, free radical scavenging activity, elastase inhibitory activity and reduction of expression Matrix metalloproteinase-1 (MMP-1) mRNA and MMP-1 protein were investigated. The roots of Carex humilis were extracted with 95 % ethanol and successively partitioned with organic solvents with increasing polarity of the solvents. Each fraction of organic solvent were investigated by using free radical scavenging activity and elastase inhibitory activity test. Among them, EtOAc fraction showed antioxidant activity ($SC_{50}$=4.89 ${\mu}g/mL$) and elastase inhibitory activity ($IC_{50}$=23.5 ${\mu}g/mL$). EtOAc fraction was developed on silica gel by open-column chromatography and consecutively re-developed on C18 resin by prep-HPLC to give ${\alpha}$-viniferin as a major component, which was confirmed by spectrometric analysis. In the assay on expression of MMP-1 mRNA by RT-PCR and protein by western-blot, EtOAc layer (10 ~ 100 ${\mu}g/mL$) was reduced about 50 ~ 60 %, 50 ~ 65 % respectively and ${\alpha}$-viniferin (0.5 ~ 2 ${\mu}g/mL$) was inhibited about 60 ~ 75 %, 55 ~ 65 % respectively in human fibroblast. Therefore, our findings suggest that EtOAc layer of Carex humilis containing ${\alpha}$-viniferin can be useful as an active ingredient for cosmeceuticals of anti-wrinkle effects.

• Journal of Korea Water Resources Association
• /
• v.41 no.3
• /
• pp.305-314
• /
• 2008

Urban sewer systems are designed to operate in open-channel flow regime and energy loss at circular manholes are usually not significant. However, the energy loss at manholes, often exceeding the friction loss of pipes under surcharge flow, is considered as one of the major causes of inundation in urban area. Therefore, it is necessary to analyze the head loss associated with manholes, especially in surcharge flow. Hydraulic experimental apparatus which can be changed the invert type(CASE A, B, C) and step height(CASE I, II, III) was installed for this study. The range of the experimental discharges were from $1.0{\ell}/sec$ to $5.6\;{\ell}/sec$. As the manhole diameter ratio($D_m/D_{in}$) increases, head loss coefficient increases due to strong horizontal swirl motion. Head loss coefficient was maximum because of strong oscillation of water surface when the range of manhole depth ratios($h_m/D_{in}$) were from 1.0 to 1.5. The average head loss coefficients for CASE A, B, and C were 0.45, 0.37, and 0.30, respectively. Accordingly, U-invert is most effective for energy loss reduction at circular manhole. This head loss coefficients could be available to design the urban sewer system with surcharge flow.

• Convergence Security Journal
• /
• v.2 no.1
• /
• pp.87-97
• /
• 2002

Many firms are utilizing the Internet and various information technologies to effectively manage their business operations with a goal of gaining a competitive advantage in the rapidly changing business environments. Today, the business is characterized as digital economy where information freely flows and business processes are improved with the use of information technologies. Internet technology is playing a key role in transforming the organization and creating new business models. It has become the infrastructure of choice for electronic commerce because it provides process efficiency, cost reduction, and open standards that can easily be adopted by different organizations. Here, the vast amount of data and information slow among the related parties and security issues are very critical matter of research interests by academicians and practitioners. In this research, we address the importance of security framework in managing the data shared among the related parties in the e-business and suggest the security architecture for effectively supporting the needs of e-business in an organization. This research provides valuable contributions both in academics and industry in terms of how security framework and architecture should be set in order to provide the necessary e-business.

• Journal of Korean Foot and Ankle Society
• /
• v.2 no.1
• /
• pp.19-29
• /
• 1998

The characteristics of the patients after the calcaneal fracture that were associated with an unsatisfactory outcome were subtalar incongruity, decreased Bohler angle ratio of the fractured to the normal side, an age of more than fifty years, work involving strenuous labor, and increased time missed from work due to the injury. The purpose of this study was to examine the reliability of measurements of the range of motion of the subtalar joint. To determine reliability, evaluates of the correlatioinship between the degree of the displacement of the subtalar joint and Circle draw test after the calcaneal fracture. Fifty patients who had had fifty five calcaneal fractures were managed with open reduction and internal fixation. The results were reviewed retrospectively, between 4months and three years after the operation, with use of an evaluation system for the subtalar joint and with plain radiographs. At follow up evaluation, the result was assessed on the basis of restoration of anatomy and function of the subtalar joint. We evaluated the subtalar joint with plain films that consist of anteroposterior projection, lateral projection, calcaneal axial view, and Broden's view, and the measurements of the displacement of the subtalar joint surface after the calcaneal fracture. And we evaluated the range of motion of the subtalar joint with Circle draw test for physical evaluation. Circle draw test was evaluated and demonstrated the motion of flexion-supination-adduction and extension-pronation-abduction of the subtalar joint. And there are correlationship between the degree of the displacement and range of motion of the subtalar joint after the calcaneal fracture. The report critically reviews methords used to measure Circle draw test for physical examination of the follow up after the calcaneal fracture.

• Journal of Environmental Health Sciences
• /
• v.36 no.5
• /
• pp.391-401
• /
• 2010

A reduction in risk of occupational exposure to chemical hazards within the workplace has been the focus of attention both through industry initiatives and legislation. The aims of this study were to develop an exposure matrix by industry and process, and to apply this matrix to control the risk of occupational exposure to Dichloromethane (DCM). The exposure matrix is a tool to convert information on industry and process into information on occupational risk. The exposure matrix comprised industries and processes involving DCM, based on an exposure database provided by KOSHA (the Korean Occupational Safety and Health Agency), which was gathered from a workplace hazards evaluation program in Korea. The risk assessment of the exposure matrix was performed using Hallmark risk assessment tool. The results of the risk assessment were indicated by a Danger Value (DV) calculated from the combination of hazard rating (HR), duration of use rating (DUR), and risk probability rating (RPR) of exposure to the chemical, and were divided into four control bands which were related to control measures. The applicability of the risk assessment of the exposure matrix was evaluated by a field study, and survey of the employees of the exposure matrix groups. Among 45 industries examined, this study found that greater attention should be paid to two industries: the manufacture of other optical instruments and photographic equipment, and the manufacture of printing ink, and to one process among 47 examined, the packing process in the manufacture of printing ink, because these were regarded as carrying the highest risk. This tool of a risk assessment for the exposure matrix can be applied as a general exposure information system for hazard control, risk quantification, setting the occupational exposure limit, and hazard surveillance. The exposure matrix includes workforce data, and it provides information on the numbers of exposed workers in Korea by agent, occupation, and level of exposure and risk.

• KIPS Transactions on Computer and Communication Systems
• /
• v.9 no.3
• /
• pp.45-58
• /
• 2020

In the current trend of increasing network traffic due to the popularization of cloud service and mobile devices, WAN bandwidth is very low compared to LAN bandwidth. In a WAN environment, a WAN optimizer is needed to overcome performance problems caused by transmission protocol, packet loss, and network bandwidth limitations. In this paper, we analyze the data deduplication algorithm of WANProxy, an open source WAN optimizer, and evaluate its performance in terms of network latency and WAN bandwidth. Also, we evaluate the performance of the two-stage compression method of WANProxy and Zstandard. We propose a new method to improve the performance of WANProxy by revising its data deduplication algorithm and evaluate its performance improvement. We perform experiments using 12 data files of Silesia with a data segment size of 2048 bytes. Experimental results show that the average compression rate by WANProxy is 150.6, and the average network latency reduction rates by WANProxy are 95.2% for a 10 Mbps WAN environment and 60.7% for a 100 Mbps WAN environment, respectively. Compared with WANProxy, the two-stage compression of WANProxy and Zstandard increases the average compression rate by 33%. However, it increases the average network latency by 2.1% for a 10 Mbps WAN environment and 5.27% for a 100 Mbps WAN environment, respectively. Compared with WANProxy, our proposed method increases the average compression rate by 34.8% and reduces the average network latency by 13.8% for a 10 Mbps WAN and 12.9% for a 100 Mbps WAN, respectively. Performance analysis results of WANProxy show that its performance improvement in terms of network latency and WAN bandwidth is excellent in a 10Mbps or less WAN environment while superior in a 100 Mbps WAN environment.

• Clinics in Shoulder and Elbow
• /
• v.10 no.2
• /
• pp.220-226
• /
• 2007

Purpose: The distal clavicle has a biomechanical structure different from that of the proximal or middle 1/3 clavicle, and delayed union or nonunion occurs frequently in a distal clavicle fracture. The authors obtained favorable results from an open reduction and bone grafting of the distal clavicle nonunion. We report the results together with review of the relevant literature. Materials and Methods: The subjects were 8 patients(average age, 38.9) who had undergone surgery for distal clavicle nonunion from August 2003 to May 2006. Nonunion occurred after surgical treatment in 4 cases, and after conservative treatment in the other 4. In all cases, the patients complained of pain. Results: The mean follow-up duration was 14 months, and radiological union was observed in 8 weeks on average. In all cases, the range of shoulder joint motion was normal at the end of the follow-up observation. In the functional evaluation, 7 cases showed excellent results and 1 case showed good results. Conclusion: Surgical treatment is a safe and reliable treatment for distal clavicle fracture nonunion because it can achieve early rehabilitation and union.

• Economic and Environmental Geology
• /
• v.42 no.1
• /
• pp.73-84
• /
• 2009

The stone Buddha and Shrine of Unjusa temple (Korean Treasure No. 797) at Hwasun formed in Koryo Dynasty is unique style which faces each other the back parts of south and north within the stone Shrine. The stone Buddha and Shrine is highly evaluated in historical, artistic and academic respects. But, the stone properties have been exposed in the open system various aspects of degradations weathered for a long time without specific protective facilities. To inquire into relative deterioration and environmental factor, air temperature and relative humidity of the stone Buddha and Shrine were monitored for a year of the indoor and outdoor, respectively. As a result, the temperature shows increase and decrease according to the seasons in the tendency to clear. While the relative humidity is high to keep all four seasons. Highly relative humidity environment induces dew condensation on the interior of stone Buddha and Shrine. The dew condensation is recorded at the spring, summer and winter season. The summer season is double the total of spring and winter season. In the case of summer, dew condensation is long time continued due to high temperature and relative humidity that is kept by more than nearly 100%. There is progress towards chemical weathering throughout dissolve rock properties and alteration on the rock surface. In the case of winter, dew condensation is not kept for a long time as summer. In the winter, which showing a below zero may add physical weathering throughout moisture that happen by dew condensation to repeat freezing and thawing. Therefore, the reduction plan of the relative humidity effect on dew condensation should be prepared.