• Geophysics and Geophysical Exploration
• /
• v.3 no.1
• /
• pp.19-24
• /
• 2000

Seismic reflection data was obtained by using 28 and 100 Hz geophones at the ground subsidence sites in an old coal mine area. Frequency spectrum of the geophone analyzed with offset revealed that 1) In the near offset ($1\~10m$), the signals in the 100 Hz geophone data contains higher frequency components (up to 300 Hz) than that of the 28 Hz (<200 Hz), 2) In the intermediate offset ($11\~39m$), although the 28 Hz geophone data showed very similar frequency characteristics as the near offset data, the 100Hz geophone data seemed to be contaminated by noise at high frequency zone (>200 Hz). In the far offset ($\geq40\;m$), the signals in both the 28 and 100 Hz geophone data are attenuated to noise level at high frequency Bone more than 150 Hz.

• IEIE Transactions on Smart Processing and Computing
• /
• v.4 no.3
• /
• pp.158-162
• /
• 2015

A low phase noise CMOS voltage controlled oscillator(VCO) for multi-band/multi-standard RF Transceivers is presented. For both wide tunability and low phase noise characteristics, Hybrid inductor which uses both bondwire inductor and planar spiral inductor in the same area, is proposed. This approach reduces inductance variation and presents high quality factor without custom-designed single-turn inductor occupying large area, which improves phase noise and tuning range characteristics without additional area loss. An LC VCO is designed in a 0.13um CMOS technology to demonstrate the hybrid inductor concept. The measured phase noise is -121dBc/Hz at 400KHz offset and -142dBc/Hz at 3MHz offset from a 900MHz carrier frequency after divider. The tuning range of about 28%(3.15 to 4.18GHz) is measured. The VCO consumes 7.5mA from 1.3V supply and meets the requirements for GSM/EDGE and WCDMA standard.

• Journal of KSNVE
• /
• v.9 no.5
• /
• pp.914-921
• /
• 1999

There are many theoretical investigations to analyze higher order mode of reactive type single expansion chambers with offset inlet/outlet locations. But the conventional method has the restriction that the ratio between the area of inlet(or outlet) pipe and that of chamber must be natural number. In the paper, a new method was suggested to apply the Kim's method to silencer with circular cross-section. Not only the offset location but also the magnitude of cross-section area of inlet/outlet pipe can be considered by the suggested method. The predictions by this new method also compared with those by the finite element method and Munjal's method in order to verify the accuracy of the suggested method presented here.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.49 no.7
• /
• pp.30-38
• /
• 2012

This paper presents packet detection, frequency offset estimation architecture and performance analysis for OFDM-based wireless personal area network (WPAN) systems. Packet detection structure is used to find the start point of a packet exactly in WPAN system as the correlation value passes the constant threshold value. The applied autocorrelation structure of the algorithm can be implemented simply compared to conventional packet detection algorithms. The proposed frequency offset estimation architecture is designed for phase rotation process structure, internal bit reduction to reduce hardware size and the frequency offset adjustment block to reduce look-up table size unlike the conventional structure. If the received signal can be compensated by estimated frequency offset through the correction block, it can reduce the impact on the frequency offset. Through the performance result, the proposed structure has lower hardware complexity and gate count compared to the conventional structure. Thus, the proposed structure for OFDM-based WPAN systems can be applied to the initial synchronization process and high-speed low-power WPAN chips.

• The Journal of the Acoustical Society of Korea
• /
• v.14 no.3
• /
• pp.105-113
• /
• 1995

For the case of using analog FM system and CDMA system together in the mobile communications, we experimentally calculate the appropriate frequency offset to improve the frequency efficiency by analizing the interference between both systems. As the results of the analysis, we obtained that frequency offset is 840KHz(Path Loss : 80dB) and 720KHz(Path Loss : 120dB) for the Path Loss when a output of CDMA Base Station is 0.91 W ERP. Therefore, to minimize the frequency offset, a output of Base Station will be controlled corresponding to Cover Area.

• Proceedings of the KSRS Conference
• /
• 2007.10a
• /
• pp.504-507
• /
• 2007

The KOMPSAT-2 satellite is a push-broom system with MSC (Multi Spectral Camera) which contains a panchromatic band and four multi-spectral bands covering the spectral range from 450nm to 900nm. The PAN band is composed of six CCD array with 2528 pixels. And the MS band has one CCD array with 3792 pixels. Raw imagery generated from a push-broom sensor contains vertical streaks caused by variability in detector response, variability in lens falloff, pixel area, output amplifiers and especially electrical gain and offset. Relative radiometric calibration is necessary to account for the detector-to-detector non-uniformity in this raw imagery. Non-uniformity correction (NUC) is that the process of performing on-board relative correction of gain and offset for each pixel to improve data compressibility and to reduce banding and streaking from aggregation or re-sampling in the imagery. A relative gain and offset are calculated for each detector using scenes from uniform target area such as a large desert, forest, sea. In the NUC of KOMPSAT-2, The NUC table for each pixel are divided as HF NUC (high frequency NUC) and LF NUC (low frequency NUC) to apply to few restricted facts in the operating system ofKOMPSAT-2. This work presents the algorithm and process of NUC table generation and shows the imagery to compare with and without calibration.

• Proceedings of the KIEE Conference
• /
• 2011.07a
• /
• pp.420-421
• /
• 2011

In generally, the small harmonic current has not influence on the power system because of offset effect. But the bulk harmonic current has not an offset effect, so that influences on the other customer. This paper describes the measurement power quality in the industrial area, and data analysis result. Also this effect has verified by PACAD/EMTDC simulation tool.

• Journal of the Korean Graphic Arts Communication Society
• /
• v.14 no.2
• /
• pp.21-36
• /
• 1996

With increased use of halftone dot overprints for offset color printing, it is important to study the density and ink trap of the overprints. In this research the equation to predict the density and the method to evaluate ideally the fractional ink trap are preposed. And also the halftone dot overprinting experiments of Magenta over Cyan or Cyan over Magenta under wet-on-wet or wet-on-dry overprinting using 2-color offset press show the above proposals are reasonable, and show the effect of overprinting sequence on the density and ink trap.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.1578-1581
• /
• 2009

This work describes a power and area efficient switched-capacitor cyclic DAC for mobile display drivers. The proposed DAC can be simply implemented with one opamp two capacitors and several switches. Furthermore, the op-amp input referred offset is attenuated at the DAC output without additional offset cancellation circuitry. The operation of the cyclic DAC is verified through circuit level simulations.

• The Journal of the Korea Contents Association
• /
• v.9 no.7
• /
• pp.76-85
• /
• 2009

UWB signal with high resolution capability can be used to estimate ranging and positioning in wireless personal area network. The node works on its local clock and the frequency differences of nodes have serious affects on ranging algorithms estimating locations of mobile nodes. The low rate UWB, IEEE802.15.4a, describes asynchronous two way ranging methods such as TWR and SDS-TWR working without any additional network synchronization, but the algorithms can not eliminate the effect of clock frequency differences. Therefore, the mechanisms to characterize the crystal difference is essential in typical UWB PHY implementations. In high rate UWB, characterizing of crystal offset with tracking loop is not required. But, detection of the clock frequency offset between the local clock and remote clock can be performed if there is little noise induced jitter. In this paper, we complete related ranging equations of high rate UWB based on TWR with relative frequency offset, and analyze a residual error in the ideal equations. We also evaluate the performance of the relative frequency offset algorithm by simulation and analyze the ranging errors according to the number of TWR to compensate coarse clock resolution. The results show that the relative frequency offset compensation and many times of TWR enhance the performance to converge to a limited ranging errors even with coarse clock resolutions.