• International Journal of Fluid Machinery and Systems
• /
• v.8 no.3
• /
• pp.202-208
• /
• 2015

For a prototype turbine operating under part load conditions, the turbine output is fluctuating strongly, leading to the power station incapable of connecting to the grid. The field test of the prototype turbine shows that the main reason is the resonance between the draft tube vortex frequency and the generator natural vibration frequency. In order to reduce the fluctuation of power output, different measures including the air admission, water admission and adding flow deflectors in the draft tube are put forward. CFD method is adopted to simulate the three-dimensional unsteady flow in the Francis turbine, to calculate pressure fluctuations in draft tube under three schemes and to compare with the field test result of the prototype turbine. Calculation results show that all the three measures can reduce the pressure pulsation amplitude in the draft tube. The method of water supply and adding flow deflector both can effectively change the frequency and avoid resonance, thus solving the output fluctuation problem. However, the method of air admission could not change the pressure fluctuation frequency.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.7 no.4
• /
• pp.632-650
• /
• 2013

The paper considers a spectrum sharing cognitive radio (CR) network coexisting with a primary network under the average interference power constraint. In particular, the secondary user (SU) is assumed to carry delay-sensitive services and thus shall satisfy a given delay quality-of-service (QoS) constraint. The secondary receiver is also assumed to be equipped with multiple antennas to perform maximal ratio combining (MRC) to enhance SU performance. We investigate the effective capacity of the SU with MRC diversity under aforementioned constraints in Nakagami fading environments. Particularly, we derive the optimal power allocation to achieve the maximum effective capacity of the SU, and further derive the effective capacity in closed-form. In addition, we further obtain the closed-form expressions for the effective capacities under three widely used power and rate adaptive transmission schemes, namely, optimal simultaneous power and rate adaptation (opra), truncated channel inversion with fixed rate (tifr) and channel inversion with fixed rate without truncation (cifr). Numerical results supported by simulations are presented to consolidate our studies. The impacts on the effective capacity of various system parameters such as the number of antennas, the average interference power constraint and the delay QoS constraint are investigated in detail. It is shown that MRC diversity can significantly improve the effective capacity of the SU especially for cifr transmission scheme.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.12
• /
• pp.1021-1029
• /
• 2013

In this paper, we propose a new indoor location estimation method which combines the fingerprint technique with the propagation prediction model. The wireless LAN (WLAN) access points (APs) deployed indoors are divided into public APs and private APs. While the fingerprint method can be easily used to public APs usually installed in fixed location, it is difficult to apply the fingerprint scheme to private APs whose location can be freely changed. In the proposed approach, the accuracy of user location estimation is improved by simultaneously utilizing public and private APs. Specifically, the fingerprint method is used to the received signals from public APs and the propagation prediction model is employed to the signals from private APs. The performance of the proposed method is compared with that of conventional indoor location estimation schemes through measurements and numerical simulations in WLAN environments.

• Journal of KIISE:Information Networking
• /
• v.34 no.1
• /
• pp.41-47
• /
• 2007

The Hierarchical Mobile IPv6 (HMIPv6) has been proposed to accommodate frequent mobility of the Mobile Node and to reduce the signaling load. A Mobility Anchor Point is a router located in a network visited by the Mobile Node. The Mobile Node uses the Mobile Anchor Point as a local Home Agent. The absence of any protections between Mobile Node and Mobile Anchor Point may lead to malicious Mobile Nodes impersonating other legitimate ones or impersonating a Mobile Anchor Point. In this paper, we propose a mechanism of the secure Mobile Anther Point discovery in HMIPv6. The performance analysis and the numerical results presented in this paper show that our proposal has superior performance to other methods.

• Journal of Biomedical Engineering Research
• /
• v.28 no.1
• /
• pp.8-16
• /
• 2007

Finite element analysis (FEA) is an effective means for the analysis of bioelectromagnetism. It has been successfully applied to various problems over conventional methods such as boundary element analysis and finite difference analysis. However, its utilization has been limited due to the overwhelming computational load despite of its analytical power. We have previously developed a novel mesh generation scheme that produces FE meshes that are content-adaptive to given MR images. MRI content-adaptive FE meshes (cMeshes) represent the electrically conducting domain more effectively with far less number of nodes and elements, thus lessen the computational load. In general, the cMesh generation is affected by the quality of feature maps derived from MRI. In this study, we have tested various feature maps created based on the improved differential geometry measures for more effective cMesh head models. As performance indices, correlation coefficient (CC), root mean squared error (RMSE), relative error (RE), and the quality of cMesh triangle elements are used. The results show that there is a significant variation according to the characteristics of specific feature maps on cMesh generation, and offer additional choices of feature maps to yield more effective and efficient generation of cMeshes. We believe that cMeshes with specific and improved feature map generation schemes should be useful in the FEA of bioelectromagnetic problems.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.7
• /
• pp.2414-2434
• /
• 2015

Among numerous localization schemes proposed specifically for Wireless Sensor Network (WSN), the range-free localization algorithms based on the received signal strength indication (RSSI) have attracted considerable research interest for their simplicity and low cost. As a typical range-free algorithm, Approximate Point In Triangulation test (APIT) suffers from significant estimation errors due to its theoretical defects and RSSI inaccuracy. To address these problems, a novel localization method called FIAPIT, which is a combination of an improved APIT (IAPIT) and a fuzzy logic system, is proposed. The proposed IAPIT addresses the theoretical defects of APIT in near (it's defined as a point adjacent to a sensor is closer to three vertexes of a triangle area where the sensor resides simultaneously) and far (the opposite case of the near case) cases partly. To compensate for negative effects of RSSI inaccuracy, a fuzzy system, whose logic inference is based on IAPIT, is applied. Finally, the sensor's coordinates are estimated as the weighted average of centers of gravity (COGs) of triangles' intersection areas. Each COG has a different weight inferred by FIAPIT. Numerical simulations were performed to compare four algorithms with varying system parameters. The results show that IAPIT corrects the defects of APIT when adjacent nodes are enough, and FIAPIT is better than others when RSSI is inaccuracy.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.7
• /
• pp.3207-3215
• /
• 2012

In this paper, we study the bending and free vibration analysis of nano plate, using a nonlocal elasticity theory of Eringen with a third-order shear deformation theory. This theory has ability to capture the both small scale effects and quadratic variation of shear strain and consequently shear stress through the plate thickness. Analytical solutions of bending and vibration of a laminated composite nano plate are presented using this theory to illustrate the effect of nonlocal theory on deflection of the nano plates. The relations between nonlocal third-order and local theories are discussed by numerical results. Further, effects of (i) nonlocal parameters, (ii) laminate schemes, (iii) directions of the fiber angle and (iv) number of layers on nondimensional deflections are investigated. In order to validate the present solutions, the reference solutions are used and discussed. The results of anisotropic nano plates using the nonlocal theory may be the benchmark test for the bending analysis.

• Structural Engineering and Mechanics
• /
• v.67 no.6
• /
• pp.643-658
• /
• 2018

In this paper, we introduce a new framework for running the finite element (FE) packages inside an online Loop together with MATLAB. Contrary to the Hardware-in-the-Loop techniques (HiL), in the proposed Software-in-the-Loop framework (SiL), the FE package represents a simulation platform replicating the real system which can be out of access due to several strategic reasons, e.g., costs and accessibility. Practically, SiL for sophisticated structural design and multi-physical simulations provides a platform for preliminary tests before prototyping and mass production. This feature may reduce the new product's costs significantly and may add several flexibilities in implementing different instruments with the goal of shortlisting the most cost-effective ones before moving to real-time experiments for the civil and mechanical systems. The proposed SiL interconnection is not limited to ABAQUS as long as the host FE package is capable of executing user-defined commands in FORTRAN language. The focal point of this research is on using the compiled FORTRAN subroutine as a messenger between ABAQUS/CAE kernel and MATLAB Engine. In order to show the generality of the proposed scheme, the limitations of the available SiL schemes in the literature are addressed in this paper. Additionally, all technical details for establishing the connection between FEM and MATLAB are provided for the interested reader. Finally, two numerical sub-problems are defined for offline and online post-processing, i.e., offline optimization and closed-loop system performance analysis in control theory.

• Journal of the Korean Society for information Management
• /
• v.35 no.1
• /
• pp.231-250
• /
• 2018

In this paper, we propose a new methodology for extracting and formalizing subjective topics at a specific time using a set of keywords extracted automatically from online news articles. To do this, we first extracted a set of keywords by applying TF-IDF methods selected by a series of comparative experiments on various statistical weighting schemes that can measure the importance of individual words in a large set of texts. In order to effectively calculate the semantic relation between extracted keywords, a set of word embedding vectors was constructed by using about 1,000,000 news articles collected separately. Individual keywords extracted were quantified in the form of numerical vectors and clustered by K-means algorithm. As a result of qualitative in-depth analysis of each keyword cluster finally obtained, we witnessed that most of the clusters were evaluated as appropriate topics with sufficient semantic concentration for us to easily assign labels to them.

• Journal of KIISE:Information Networking
• /
• v.27 no.1
• /
• pp.68-75
• /
• 2000

In this paper, a media access control protocol is proposed for voice/data integrated services in the packet CDMA network, and the performance of the proposed protocol is analyzed. The proposed protocol uses the spreading code sensing and the reservation schemes. This protocol gives higher priority to the delay-sensitive voice traffic than to the data traffic. A voice terminal can reserve an available spreading code during a talkspurt to transmit multiple voice packets. On the other hand, whenever a data packet is generated, the data terminal transmits the packet through one of the available spreading codes that are not used by the voice terminals. In this protocol, the voice packets do not come into collision with the data packets. The numerical results show that this protocol can increase the maximum number of voice terminals. The performance for the data traffic degrades by increasing the voice traffic load because of the low priority. But it shows that the data traffic performance can be increased in proportion to the number of spreading codes.