• Economic and Environmental Geology
• /
• v.54 no.1
• /
• pp.151-160
• /
• 2021

2:1 clay minerals such as smectite incorporating ammonium were extracted to investigate the ammonium behavior and nitrogen isotope characteristics for two different sediment cores which were collected from shimmering sites on seafloor of the Wakamiko crater, southwestern Japan. Inorganic nitrogen contents in clay fraction were estimated by calibration curve based on consistently decreasing carbon and nitrogen ratio during the treatment to decompose organic materials, after removing inorganic carbon. The results show that the proportions of inorganic nitrogen for total nitrogen in clay fraction of SWS site(Core#1094MR: av. 18.2%) are higher than those in SES site(Core#1093MG: av. 11.5%). Relatively good crystallinity of the former suggests that exchangeable ammonium was transformed to non-exchangeable ammonium during more evolving diagenetic process. Nitrogen isotope variance of clay fraction(SES site: Core#1093MG: -4.4 ~ +0.2 ‰, av. -2.4 ‰; SWS site: Core#1094MR: -0.7 ~ +3.0 ‰, av. +1.5 ‰) during sequential decomposition of exchangeable ammonium suggests that heat flow derived from deep magma led to nitrogen isotope fractionation between dissolved ammonium and ammonia in the fluids involved in the formation of 2:1 clay mineral incorporating ammonium with local temperature variation.

• Journal of Bio-Environment Control
• /
• v.22 no.2
• /
• pp.175-181
• /
• 2013

These studies were identified the effect of four types of non-perforated breathable (NPB) packing film and three sizes on storage ability of fresh-cut for ready to eat packaging at $5^{\circ}C$ for 25 days and $10^{\circ}C$ for 15 days storage in Salicornia herbacea. The fresh weight loss was less than 2% in every films at $5^{\circ}C$ condition after 25 days storage, and the $10^{\circ}C$ also had same result on 15 days storage except 100,000 cc NPB film. Compare with storage after 15 days, storage condition at $5^{\circ}C$ had shown better result under the 1% fresh weight loss rate. The 5,000 cc and $5^{\circ}C$ condition had been shown the characteristics of MA packaging in carbon dioxide and oxygen concentrations. The ethylene concentration in vacuum film was higher 10 to 100 times than in NPB film treatments during storage. But ethylene concentration was not statistically significant differences among size treatments. Every conditions had been measured the anti-oxidant activity by DPPH method after storage at $5^{\circ}C$ for 25 days and $10^{\circ}C$ for 15 days. S. herbacea at $5^{\circ}C$ had been more than twice of activity compare with that at $10^{\circ}C$. 100,000 cc NPB film had been higher contents of anti-oxidant activity at $5^{\circ}C$ and $10^{\circ}C$. As the fresh-cut sizes, 3 cm and 5 cm sizes had changed depending on film types but 10 cm were not effected by the film types in the DPPH activity. When panel test had been tried to measure the visual quality and off-flavor after storage, $5^{\circ}C$ with a filme of 5,000 cc treatment had established higher value than other treated conditions. As these results, it's may be suggested that the $5^{\circ}C$ with 5,000 cc non-perforated breathable film for MA storage in Salicornia herbacea at fresh cut distribution system. Fresh cut size 10 cm with 100,000 cc NPB film also had the good quality for 15 dyas storage at $10^{\circ}C$, and this result can be applied for short term distribution system in Korea.

• Journal of Mushroom
• /
• v.11 no.4
• /
• pp.208-213
• /
• 2013

The contents of raw materials which are components of mixed substrate for mushroom cultivation were analyzed to optimize the composition. The pure protein(amino acid) level of soybean meal was the highest, 44.02% followed by those of soybean curd residue(31.5%) and cotton seeds meal(30.6%). The non protein nitrogen(NPN) contents in crude protein of main nitrogen materials were 2.4% for soybean meal and 5.6% for dried soybean curd residue, while those of wheat bran and rice bran used as the carbon source were relatively higher, 17.6% compared to that of nitrogen supplying media. Crude protein content per price was 6.0 for rapeseed meal, indicating that it is high crude protein content per price. Nitrogen-free extract(NFE) considering as an ingredient for mycelial growth were high in alphacorn(72.9%) and wheat bran B(57.2%). Acid detergent fiber(ADF) was high in corncob, 51.88%, its use for cultivation of brown rot fungi including Lentinus lepideus should pay attention because the fungi lack complete lignin degradation activity.

• Korean Journal of Ecology and Environment
• /
• v.54 no.4
• /
• pp.327-333
• /
• 2021

The two main hypotheses that explain why invasive alien plants successfully colonize new environments are: 1) invasive alien plants are functionally different from native plants in a community, and 2) the plants can adapt well to new environments because they are functionally similar to native plants. The present study investigated the functional traits of naturalized alien herbaceous plants and their native neighbors in a riparian park area near the Hapcheon-Changyeong weir along the Nakdong River to determine which of the two hypotheses applied to the study area. According to the results, leaf functional traits, such as leaf area, specific leaf area, leaf thickness, leaf dry matter content, leaf nitrogen content, and leaf carbon content differed between naturalized alien and native plants, which could be attributed to the higher leaf nitrogen contents in naturalized alien plants than in native plants. The high leaf nitrogen contents are associated with high photosynthetic rates, which lead to effective resource use and rapid growth; therefore, naturalized alien plants growing in the study area were considered to have such functional traits. The results of the present study support the hypothesis that the successful establishment of invasive alien plants is attributed to the functional trait differences between invasive and native plants.

• Journal of the Korean Wood Science and Technology
• /
• v.34 no.6
• /
• pp.36-43
• /
• 2006

Using fluidized bed type fast pyrolysis system (capacity 400 g/h) bio-oils were produced from beech (Fagus sylvatica) and softwood mixture (spruce and larch, 50:50). The pyrolysis was performed for 1~2 s at the temperature of $470{\pm}5^{\circ}C$. Pyrolysis products consisted of liquid form of bio-oil, char and gases. In beech wood bio-oil was formed to ca. 60% based on dry biomass weight and the yield of bio-oil was 49% in soft wood mixture. The moisture contents in both bio-oils were ranged between 17% and 22% and the bio-oil's density was measured to $1.2kg/{\ell}$. Bio-oils were composed of 45% carbon, 47% oxygen, 7% hydrogen and lower than 1% nitrogen,which was very similar to those of original biomass. In comparison with oils from fossil resources, oxygen content was very high in bio-oils, while no sulfur was found. More than 90 low molecular weight components, classified to aromatic and non aromatic compounds, were identified in bio-oils by gas chromatographic analysis, which amounted to 31~33% based on the dry weight of bio-oils.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.20 no.4
• /
• pp.159-168
• /
• 2015

Forty-four surface sediments from Doam Bay were analyzed for total organic carbon (TOC), total nitrogen (TN), total metal (Al, Fe, Mn, Cr, Cu, Ni, Pb, Zn) and further chemical partitioning of metals were carried out in some samples. The TOC (0.32~3.10%) and TN (0.03~0.26%) values of the samples were similar to those of other coastal area. The C/N ratios ranged from 7.9 to 11.9 with an average 9.3 which revealed that contribution of terrestrial organic matters was relatively rare. Contents of analysed metals showed a level lower than threshold effects level (TEL) in sediment quality guidelines. Based on the chemical speciation of metals, the lattice fractions were found in the order Cr > Cu > Ni > Zn > Pb > Mn, while Mn and Pb are the ratio of the non-lattice fractions accounted for more than 50%. The average baseline values were obtained relative cumulative frequency curves and linear regression analysis. The respective baseline concentrations for Cu, Ni, Pb, Zn, Cr and Mn were 11.8, 23.1, 26.8, 76.6, 56.7, 585 mg/kg, respectively. Based on geoaccumulation index ($I_{geo}$) with a baseline values of Mn showed that face the contamination phase from estuarine stations. However, in case of Zn and Pb, although there is no sign of contamination, it could be release from sediment when there is a change in the environment, which is caused from the high ratio of non-lattice fractions.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.16 no.3
• /
• pp.213-218
• /
• 2014

Effects of elevated $CO_2$ on leaf phenology of Quercus acutissima were examined using open-top chambers, which had ambient and elevated $CO_2$ concentrations (ambient ${\times}1.4$, ambient ${\times}1.8$). To analyze the effect of chamber, non-treatment block was established near outside of the chambers. In 2013, budburst, leaf unfolding, coloring, and shedding were surveyed, and spring phenology was surveyed in 2014. Thermal sum (base temperature $+5^{\circ}C$) of each phenological event occurred was recorded. In addition, bud samples were collected and analyzed for carbohydrate contents in March 2014. Elevated $CO_2$ concentration advanced budburst and leaf unfolding, and delayed shedding in 2013. However, in 2014, the temperature of the spring season was high, and there was no significant effect of elevated $CO_2$ concentration on spring phenology. Carbohydrates content, such as starch, total non-structural carbohydrate and total soluble sugar, were significantly increased in response to elevated $CO_2$ concentration. It has been proposed that elevated $CO_2$ concentration could extend the growing season of temperate species with increased possibility of frost damage due to early bud opening and leaf unfolding. However, our analysis showed that the increased carbohydrate concentration in bud under elevated $CO_2$ would reduce the possibility of early spring frost damage by acting as cryoprotectant.

• Clean Technology
• /
• v.30 no.1
• /
• pp.37-46
• /
• 2024

Environmental problems caused by plastic waste have been continuously growing around the world, and plastic waste is increasing even faster after COVID-19. In particular, PP and PE account for more than half of all plastic production, and the amount of waste from these two materials is at a serious level. As a result, researchers are searching for an alternative method to plastic recycling, and plastic pyrolysis is one such alternative. In this paper, a numerical study was conducted on the pyrolysis behavior of non-condensable gas to predict the chemical reaction behavior of the pyrolysis gas. Based on gas products estimated from preceding literature, the behavior of non-condensable gas was analyzed according to temperature and residence time. Numerical analysis showed that as the temperature and residence time increased, the production of H₂ and heavy hydrocarbons increased through the conversion of the non-condensable gas, and at the same time, the CH₄ and C₆H₆ species decreased by participating in the reaction. In addition, analysis of the production rate showed that the decomposition reaction of C₂H₄ was the dominant reaction for H₂ generation. Also, it was found that more H₂ was produced by PE with higher C₂H₄ contents. As a future work, an experiment is needed to confirm how to increase the conversion rate of H₂ and carbon in plastics through the various operating conditions derived from this study's numerical analysis results.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.4
• /
• pp.1-10
• /
• 2011

According to the worldwide efforts to reduce greenhouse gases consequent upon climatic change, the field of road traffic is also making diverse efforts to reduce the emissions of greenhouse gases. Among these, the exhaust gases from vehicles, the so-called main culprit of the greenhouse gases will take place the more as delay and tie-up of vehicles ever take place. Accordingly, as a scheme for reducing the delay & tie-up of vehicles, it's possible to bring up the idea of supply of new facilities and management of the existing facilities; recently, a lot more focus is being put on the management of the existing facilities due to enormous amounts of construction cost. In the midst of growing concern for traffic demand management policy, it's about the time we should do research on the tollbooth metering on the expressway whose research is almost non-existent home and abroad. As a traffic demand management policy coming to happen in case of the management of pay expressway like Japan and Korea, this research analyzed the contents of tollbooth metering, its effect and its subsequent convenience. Especially as a tool for effect analysis, this research made an analysis using VISSIM-a micro-simulation tool. As the tollbooth metering promoted, as a part of green traffic promotion strategy, is expected to contribute to improvement in traffic flow and reduction in carbon emissions, etc. It seems that there needs to be continuous research work on the management plan & revitalization plan for maximization of its effect later as well.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.29 no.5
• /
• pp.488-496
• /
• 2023

Ship and bridge structures are a type of long box-shaped structure, and resistance to vertical bending moment is a key factor in their structural design. In particular, because box girders are repeatedly exposed to irregular wave loads for a long time, the continuous collapse behavior of structural members must be accurately predicted. In this study, plastic collapse behavior, including buckling according to load changes of the box girder receiving pure bending moments, was analyzed using a numerical analysis method. The analysis targets were selected as three box girders used in the Gordo experiment. The cause of the difference was considered by comparing the results of the structural strength experiment with those of non-linear finite element analysis. This study proposed a combination of the entire and local sagging shape to reflect the effect of the initial sagging caused by welding heat that is inevitably used to manufacture carbon steel materials. The procedures reviewed in the study and the contents of the initial sagging configuration can be used as a good guide for analyzing the final strength of similar structures in the future.